• Journal of Energy Engineering
• /
• v.12 no.1
• /
• pp.58-64
• /
• 2003

With the 1 ton/day-class entrained-bed gasification system, heavy residual oil from local refinery was gasified at the operating conditions of 1,000~1,20$0^{\circ}C$ and 3 $kg_f$/$\textrm{cm}^2$ in order to determine the variation of syngas composition, carbon conversion, and cold gas efficiency. Produced syngas consists of mainly CO, H$_2$, $CO_2$, and the methane concentrations. Results yielded a maximum syngas composition of 45% H$_2$ and 26%, CO at the 31 kg/hr feeding condition. The maximum carbon conversion and cold gas efficiency were 87% and 68%, respectively at the feeding conditions of 20 kg/hr and oxygen/feed ratio of 1.2. When oxygen feeding amount that is one of the most important operating parameter in gasification was increased, concentration of hydrogen in the syngas is greatly increased comparing to the concentration of CO and $CO_2$. The temperature exhibited about 11$0^{\circ}C$ raise while oxygen/feed ratio changed from 0.6 to 1.2. Methane concentration showed enhanced dropping rate with increase in gasifier temperature and the useful relationship between the gasifier temperature and methane concentration existed such that it can be employed as an indirect measure of inside gasifier temperature.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.9 no.4
• /
• pp.228-233
• /
• 2007

Pear psylla, Caccopsylla pyricola (Homoptera: Psyllidae), is a serious insect pest in pear orchards. C. pyricola overwinters as adults under rough bark scales of pear trees. When the weather warms up in the spring, the overwintered adults become active, climb up to the tree branches, and inhabit on fruit twigs to lay eggs. This study was conducted to develop a forecasting model for the onset of upward-movement of overwintered C. pyricola adults to control them by timely spraying of petroleum oil. The adult population densities were observed under rough barks (B) and on fruit twigs (T) of pear trees. Relative upward-movement rates (R) were calculated as T/(B+T). Low threshold temperatures for the activation of overwintered C. pyricola adults were selected arbitrarily from 5 to $9^{\circ}C$ at a $1^{\circ}C$ interval. Then, the days (D) when daily maximum air temperatures were above each low threshold temperature were counted from 1 February until to the dates with R $\geq$ 0.8. The same methods were applied for the prediction of the first observation of eggs. The variation of coefficients (CV) for the mean Des were lowest with the low threshold temperature of $6^{\circ}C$. At this selected threshold temperature, the upward movement of C. pyricola adults occurred with 12 D and they started laying eggs with 25 D. In the field validation, the model outputs with the $6^{\circ}C$ threshold temperature reasonably well explained the observed data in Suwon and Cheonan in 2002. Practical usages of the model were also discussed.

• Journal of Advanced Marine Engineering and Technology
• /
• v.40 no.5
• /
• pp.447-452
• /
• 2016

The use of gas as fuel, particularly liquefied natural gas (LNG), has increased in recent years owing to its lower sulfur and particulate emissions compared to fuel oil or marine diesel oil. LNG is a low temperature, volatile fuel with very low flash point. The major challenges of using LNG are related to fuel bunkering, storing, and handling during ship operation. The main components of an LNG fuel system are the bunkering equipment, fuel tanks, vaporizers/heaters, pressure build-up units (PBUs), and gas controlling units. Low-pressure dual-fuel (DF) engines are predominant in small LNG-powered vessels and have been operating in many small- and medium-sized ferries or LNG-fueled generators.(Tamura, K., 2010; Esoy, V., 2011[1][2]) Small ships sailing at coast or offshore rarely have continuous operation at constant engine load in contrast to large ships sailing in the ocean. This is because ship operators need to change the engine load frequently due to various obstacles and narrow channels. Therefore, controlling the overall system performance of a gas supply system during transient operations and decision of bunkering time under a very poor infrastructure condition is crucial. In this study, we analyzed the fuel consumption, the system stability, and the dynamic characteristics in supplying fuel gas for operating conditions with frequent engine load changes using a commercial analysis program. For the model ship, we selected the 'Econuri', Asia's first LNG-powered vessel, which is now in operation at Incheon Port of South Korea.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2005.06a
• /
• pp.864-870
• /
• 2005

Hydraulic excavators have been popular devices in construction field because of its multi-workings and economic efficiency. The mathematical models of excavators have many nonlinearities because of nonlinear opening characteristics and dead zone of main control valve, oil temperature variation, etc. The objective of this paper is to develop a simulator for hydraulic excavator using AMESim. Components and whole circuit are expressed graphically. Parameters and nonlinear characteristics are inputted in text style. From the simulation results, fixed spring stiffness of MCV can't satisfy accuracy of spool displacement under whole P-Q diagrams. Closed loop type MCV containing proportional gain is proposed in this paper that can reduce displacement error. The ability of closed loop MCV is verified through comparing with normal type MCV using AMESim simulator. The simulator can be used to forecastexcavator behavior when new components, new mechanical attachments, hydraulic circuit changes, and new control algorithm are applied. The simulator could be a kind of development platform for various new excavators.

• Journal of the Korean Society for Precision Engineering
• /
• v.18 no.4
• /
• pp.78-84
• /
• 2001

This study deals with the heat-treatment technique of SM45C steel with respect to less of deformation in control. The whole process for the production of landing gear must go through with uniformally controlled heat treatment, where as most deformation usually occur in nonuniform cooling environment. When a heated metal is submerged into a certain quenchant, the rate of cooling rapidity can be measured rather slow during the early stage of the procedure due to an Occurrence of a vapor blanked. As the additional course of cooling action is applied and the vapor from a vapor blanked is destroyed simultaneously, the speed of cooling promptness can be considered rather swift. The object of this study is to control the certain deformations as in the procedure of a heat treatment for landing gear by analyzing and improving the conditions of different substance of quenching liquids. Several noticeable curves indicating the temperature variation on the ap-plied metals during the cooling procedures, along with detectable rates of water verses oil and that of different polymer solutions are illustrated.

• Proceedings of the SAREK Conference
• /
• 2006.06a
• /
• pp.789-794
• /
• 2006

The potential impacts of climate change on heating and cooling energy demand were investigated by means of transient building energy simulations and hourly weather data scenarios for Inchon. Future trends for the 21 st century was assessed based oil climate change scenarios with 7 global climate models(GCMs), We constructed hourly weather data from monthly temperatures and total incident solar radiation ($W/m^2$) and then simulated heating and cooling load by Trnsys 16 for Inchon. For 2004-2080, the selected scenarios made by IPCC foresaw a $3.7-5.8^{\circ}C$rise in mean annual air temperature. In 2004-2080, the annual cooling load for a apartment with internal heat gains increased by 75-165% while the heating load fell by 52-71%. Our analysis showed widely varying shifts in future energy demand depending on the season. Heating costs will significantly decrease whereas more expensive electrical energy will be needed of air conditioning during the summer.

• Korean Journal of Ichthyology
• /
• v.26 no.4
• /
• pp.310-321
• /
• 2014

Change in fish species composition after the Hebei Spirit oil spill in December 2007 off Taean were determined by analysis of samples collected in Mailpo beach, 10 km south from the oil spill site and polluted by the crude oil. Fish samples were collected by a beach seine in the shallow water at Malipo beach during the low tide of the new moon from February 2008 to December 2009. Five seine hauls were made during the day and the night in each sampling time. Monthly day and night samples did not show the significant differences in species composition. A total of 21 species, 1,032 individuals and 6,544 g of fish were collected in 2008, and 31 species, 4,206 individuals and 35,659 g of fish in 2009. The species collected were composed of the small-sized fish or juveniles. Abundant fishes were the resident species in coastal water, and the migrants were low in abundance. Among the fish occurred, Chelon haematochelius, Sebastes schlegelii, Takifugu niphobles and Pleuronectes yokohamae were predominated in abundance of both years. Monthly fish abundance and species diversity in 2008 were significantly lower than those in 2009. A few number of resident fish were collected from February to June 2008 showing the lowest in May 2008, and fish abundance increased from July 2008. The number of species and abundance of fish in 2009 were increased in spring as the temperature raised, showed a peak in summer and decreased in autumn. This monthly variation in fish species composition and abundance was similar to those in the non-polluted water in other temperate waters. Low fish abundance during several months after oil spill was considered to be related to the residual oil in the water and habitat disturbance due to oil cleaning activity in the beach. Monthly fish species compositions after September 2008 were similar to those of 2009 suggested that the impact on the shallow water fish by the oil residuals was not too significant at least to the fish species composition after September 2008.

• Economic and Environmental Geology
• /
• v.42 no.5
• /
• pp.427-434
• /
• 2009

Indigenous bacterium which shows a tolerance to high metal toxicity was isolated from soil concomitantly contaminated with oil and heavy metals. The characteristics of the bacterium for Pb and Cd biosorption was investigated under the various experimental conditions such as bacterial growth phase, the initial metal concentration, the input biomass amount, temperature and pH. The Langmuir adsorption isotherm modeling was described to know the capacity and intensity of biosorption. The low initial concentration of heavy metals and high biomass has a maximum heavy metal removal efficiency, but biosorption capacity of Pb and Cd has different values. Biosorption efficiency was highest in the end of the microbial growth stage and under pH 5~9 condition, but was less affected by temperature variation of 25~$35^{\circ}C$. The maximum biosorption capacity for Pb and Cd was 62.11 and 192.31 mg/g, respectively and each $R^2$ was calculated as 0.71 and 0.98 by applying Langmuir isothermal adsorption equation. Biosorption for Cd was considered as monomolecular adsorption to single layer on the surface of cells, whereas biosorption for Pb was considered as accumulation process into the cell by the microbial metabolism and precipitation reaction with anion of bacteria.

• Journal of the Korean Applied Science and Technology
• /
• v.2 no.2
• /
• pp.39-46
• /
• 1985

The study was carried out to investigate interrelationships among the acid, peroxide, iodine, thiobarbituric acid values, and changes of fatty acid compositions of some vegetable oils added to soybean milk. A storage temperature of $100^{\circ}C$ was used for the oxidation of the oils, and to determine of variation of the chemical properties and changes of the fatty acid composition, all the samples were carried out in every 8 hours for 40 hours. The changes in fatty acid compositions of the vegetable oils were measured by high performance liquid chromatography. The results obtained were as follow; 1. The acid values of the fresh soybean, corn, and palm oils added to the soybean milk were 0.05, 0.12, and 0.06, whereas those of the oils stored for 40 hours were 0.08, 0.18, and 0.09, respectively. 2. The peroxide values of the fresh soybean, corn, and palm oils added to the soybean milk were 0.3, 1.0, and 0.3, whereas those of the oils stored for 40 hours were 1.1, 1.1, and 0.9, respectively. 3. The iodine values of the fresh soybean, corn, and palm oils added to the soybean milk were 132.7, 124.1, and 57.0, whereas those of the oils stored for 40 hours were 127.3 108.3, and 52.0, respectively. 4. The thiobarbituric acid values of fresh soybean, corn, and palm oils added to the soybean milk were 0.18, 0.05, and 0.02, whereas those of the oils stored for 40 hours were 0.25, 0.19, and 0.07, respectively. 5. The percent content of the major fatty acids of the soybean, corn, and palm oils freshly added to the soybean milk were 2.3%,2.5%,and 25.2%for palmitic acid, 3.2%,3.2%,and 4.8%for stearic acid, 39.7%, 40.7%, and 59.3% for oleic acid, 49.9%, 53.0%, and 10.5% for linoleic acid, and 4.7%, 0.4%, and 0.7% for linolenic acid, respectively. Those of the oils stored for 40 hours were 2.9%, 4,5%, and 36.7% for palmitic acid, 8.5%, 6.8%, and 7.0% for stearic acid, 37.8%, 38.8%, and 49.2% for oleic acid, 46.2%, 49.5%, and 5.8% for linoleic acid, and 4.2%, 0.1%, and 0.1% for linolenic acid, respectively. The fatty acid compositions changed significantly: the amounts of the unsaturated fatty acid decreased considerably. The rsults of the present study demonstrated greater stability of the palm oil as compared with the stability of soybean oil and corn oil added to the soybean milk.

• Korean Journal of Food Science and Technology
• /
• v.11 no.2
• /
• pp.86-92
• /
• 1979

Antioxidants. BHA, BHT and PG were added to a commercial soybean oil at a level of 200 ppm, and the antioxidant-treated oils and a control oil were subjected to 30 min. heating at $150{\pm}2^{\circ}C$ and 23.5 hr. cooling at room temperature for 6 times. Variations of % antioxidant retention and some physical and chemical properties of the oils were investigated. The results of the present study were as follows. 1. The % retention of BHA, BHT and PG after the second heating and cooling was respectively 60.5, 55.7 and 40.5 %. That of BHA, BHT and PG after the 6th heating and cooling was respectively 5.7, 3.0 and 1.8 %. 2. The refractive indices and viscosity of the oils, including the control, increased slowly at first. but after 4th heating and cooling, these values increased rapidly. The color indices of the oils, including the control, increased very rapidly, but after the 2nd heating and cooling, the rates of the increase diminished considerably. 3. The efficiency of each antioxidant in suppressing peroxide, thiobarbituric acid, and acid value development decreased rapidly as the antioxidant contents of the oils decreased. After the 6th heating and cooling, the peroxide. thiobarbituric acid and acid values of the oils treated initially with the antioxidants did not differ appreciably from those of the control.