• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.36 no.3
• /
• pp.280-285
• /
• 2023

A breakdown voltage and breakdown electric field of the transformer insulating oil of liquid dielectric were studied in uniform electric field and non-uniform electric field and the transformer insulating oil was observed by the process reached breakdown. Insulation performance evaluation of the liquid dielectric was evaluated at the electrode spacing of 2.5 mm under the conditions of domestic and international standards (KS C IEC 60156), so a comparative review was conducted at the electrode spacing of 2.5 mm. When the electrode spacing is 2.5 mm, the average breakdown voltage is 38.5 kV for sphere-sphere electrodes, 26.6 kV for plate-plate electrodes, 22.9 kV for needle-needle electrodes, and 24.3 kV for sphere-needle electrodes. 23.7 kV for the sphere-plate electrode, and 20.7 kV for the needle-plate electrode. From these results, it can be seen that the average value of the breakdown voltage at the electrode spacing of 2.5 mm, in ascending order, is sphere-sphere, plate-plate, sphere-needle, sphere-plate, needle-needle and needle-plate. It was found that the breakdown voltage of the unequal field was lower than that of the equal field.

• Journal of radiological science and technology
• /
• v.10 no.1
• /
• pp.75-83
• /
• 1987

The insulating oil used for X-ray tube housing were degraded by X-ray irrdiation, high temperature and high anode voltage for normal operation. This study was measured the conduction current-X-ray dose, heating degradation, time, temperature and electric field characteristics and the dependense of electrode materials and gap length in the X-ray irradiatied insulating oil under of D.C voltage. The obtained results can be summarized as following. 1. The conduction current of X-ray irradiated insulating oil is more about $2.5{\sim}3$ times as large as than that of non x-ray irradiated, and is become saturation phenomena after some degree. 2. The conduction current of many times heating x-ray irradiated insulating oil is more than that of a few times heating. 3. The higher temperature x-ray irradiated insulating oil is increased, the more conduction current, and that is increased about ten times as large as when it's temperatures is increased to $80^{\circ}C\;at\;30^{\circ}C$, twenty five times at $100^{\circ}C$. 4. The dependence of electrode materials is appeared at the low electric field, and the small gap length with Fe > Cu > Al. 5. The low electric field than 3000 v/cm is appeared Ohm's law region, and the high is become saturation region at the I-E characteristics. 6. The larger gap length is become, the more conduction current is increased at the same electric field.

• Progress in Medical Physics
• /
• v.30 no.4
• /
• pp.89-93
• /
• 2019

Purpose: This study aims to develop new markers based on silicone rubber and urethane rubber to enhance visibility in low magnetic field magnetic resonance (MR) imaging. Methods: Four types of markers were fabricated using two different base materials. Two of the markers were composed of two different types of silicone rubber: DragonSkin™ 10 MEDIUM and BodyDouble™ SILK. The other two markers were composed of types of urethane rubber: PMC™ 780 DRY and VytaFlex™ 20. Silicone oil (KF-96 1000cs) was added to the fabricated markers. The allocated amount of oil was 20% of the weight (wt%) of each respective marker. The MR images of the markers, with and without the silicone oil, were acquired using MRIdian with a low magnetic field of 0.35 T. The signal intensities of each MR image for the markers were analyzed using ImageJ software and the visibility for each was compared. Results: The highest signal intensity was observed in VytaFlex™ 20 (279.67±3.57). Large differences in the signal intensities (e.g., 627% in relative difference between BodyDouble™ SILK and VytaFlex™ 20) among the markers were observed. However, the maximum difference between the signal intensities of the markers with the silicone oil showed only a 62% relative difference between PMC™ 780 DRY and DragonSkin™ 10 MEDIUM. An increase in the signal intensity of the markers with the silicone oil was observed in all markers. Conclusions: New markers were successfully fabricated. Among the markers, DragonSkin™ 10 MEDIUM with silicone oil showed the highest MR signal intensity.

• Geomechanics and Engineering
• /
• v.9 no.5
• /
• pp.645-667
• /
• 2015

Single treatment and staged treatments in vertical wells are widely applied in sandstone and mudstone thin interbedded (SMTI) reservoir to stimulate the reservoir. The keys and difficulties of stimulating this category of formations are to avoid hydraulic fracture propagating through the interface between shale and sand as well as control the fracture height. In this paper, the cohesive zone method was utilized to build the 3-dimensional fracture dynamic propagation model in shale and sand interbedded formation based on the cohesive damage element. Staged treatments and single treatment were simulated by single fracture propagation model and double fractures propagation model respectively. Study on the changes of fracture vicinity stress field during propagation is to compare and analyze the parameters which influence the interfacial induced stresses between two different fracturing methods. As a result, we can prejudge how difficult it is that the fracture propagates along its height direction. The induced stress increases as the pumping rate increasing and it changes as a parabolic function of the fluid viscosity. The optimized pump rate is $4.8m^3/min$ and fluid viscosity is $0.1Pa{\cdot}s$ to avoid the over extending of hydraulic fracture in height direction. The simulation outcomes were applied in the field to optimize the treatment parameters and the staged treatments was suggested to get a better production than single treatment.

• Weed & Turfgrass Science
• /
• v.4 no.2
• /
• pp.129-134
• /
• 2015

White grub damages various crops, trees and they can also be one of the most serious pests of turf grass in golf courses. This study was conducted to determine the biocontrol of white grubs with 18 different kinds (anise, camphor, castor, cinnamon, clove oil, citronella, fennel, geranium, lavender, lemongrass, linseed, neem, peppermint, pine, rosemary, tea-tree, thyme, and turpentine) of plant essential oils in laboratory, green house and field. Anise oil (88.9%), linseed oil (100%), and tea-tree oil (88.9%) were highly effective among tested essential oils against 3rd instar of Bifurcanmala aulax in cap vial experiment. However, anise and linseed oils showed low mortality against $3^{rd}$ instar of Popillia japonica in pot greenhouse experiment. Efficacy of anise, linseed oil, and tea-tree was also different depending on target white grub in field trials. Correlated mortality showed 32.6% only in tea-tree oil treatment against pupae of Adoretus tenuimaculatus however, correlated mortality of anise, linseed and tea-tree oil were 54.8, 51.6 and 56.5% respectively against $3^{rd}$ instar of Exomala orientalis in the field trial in Adelscott Country Club in Hapcheon, Gyeongnam province.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.6
• /
• pp.35-41
• /
• 2015

This paper presents a breakdown voltage and a process of breakdown progress in mineral oil under an quasi-uniform field with decomposition products which occur after the oil discharge. The breakdown voltage in the oil revealed the characteristics of dispersion regardless of an electrode gap. The cumulative probability distribution was used to analyze the dispersion of the breakdown voltage. In addition, the process of breakdown progress in the oil can be reasonably described by the electron breakdown theory based on both electrons emitted from the cathode and ions by field-aided dissociation of the oil. The proposed breakdown process will be used for the basic data to explain the behavior pattern of the decomposition product to cause the dispersion of the breakdown voltage.

• KSBB Journal
• /
• v.25 no.1
• /
• pp.73-78
• /
• 2010

In this study, recovering agent was produced with organic sludge and modified peat moss (MPM) in pilot plant mixer to recover oil contaminated soil, and field test of it was estimated using landfarming method. Oil contaminated soil recovering agent was thought to contain more microorganisms than raw waste sludge and was no problem to come onto the market because there were not any items of specified wastes. According to the results of TPH variation with time, it was observed the initial degradation velocity of oil with produced recovering agent was rapid up to 50% after 4 days, remarkably. Because the microorganisms in the organic sludge discharged from chemical plant already acclimated with oil, therefore, it could be estimated initial degradation velocity of recovering agent might be rapid. It was concluded that the oil contaminated soil recovering agent produced in this study have high marketability because of its two aspects on recycling of wastes and initial rapid degradation capacity.

• Journal of the Korean Society of Tobacco Science
• /
• v.23 no.2
• /
• pp.115-122
• /
• 2001

The effect of mineral oil treatment in Burley 21 tobacco field on the control of potato virus Y(PVY-VN) mostly transmitted by green peach apid(Myzus persicae Sulzer) in nature was studied and the virus infection in some plants including potato, pepper, bramble, radish, etc near the tobacco fields as a virus infection source was tested by capillary tube precipitatioin test with PVY-antibody and bioassay in Xanthi-nc tobacco. The main source of PVY-VN infection in tobacco field in korea was potato(ca. 40% of test plants infected). Pepper and bramble were also infected by PVY-VN. The control level of PVY-VN infection by treatment of 0.75% liquid mineral oil with 3 % nonionic emulsifier to the plants was 84.8 % in case of the artificial transfection with a infected apterous aphid in laboratory. However, the reduction of PVY-VN disease severity in tobacco fields treated with mineral oil at late June was only 35.5%. These results suggest that mineral oil treatment is not so effective for the protection of aphid-born virus(PVY - VN) infection in tobacco fields.

• Proceedings of the KIEE Conference
• /
• 1998.07d
• /
• pp.1436-1437
• /
• 1998

In this paper, the result of experimental investigation into the streaming electrification phenomena of insulating oil under an external dc field effect is described. Energization by positive dc voltage enhanced the streaming electrification. but when the applied voltage was negative, the polarity of streaming current was field strength dependent.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2003.09a
• /
• pp.536-539
• /
• 2003

This study area has been contaminated by oils. To identify contaminated ranges and to assess the possibility of contamination dispersion, monitoring wells were installed and slug test, field soil permeability test, automatic or manual measurement of groundwater table, and groundwater quality analyses in field and laboratory were performed. In addition, a groundwater modeling program was used to assess the possibility of oil contamination dispersion, based on field data and groundwater quality data. The results showed that concentration of oil contaminants in groundwater have been decreased by dispersion and adsorption.