• Journal of the Korean Society for Precision Engineering
• /
• v.16 no.2 s.95
• /
• pp.50-59
• /
• 1999

The effect of a variant drain orifice damping on the characteristics of a servovalve flapper-nozzle stage is analyzed. Steady-state characteristics of flapper-nozzle stage and the linearized dynamics of flapper-nozzle assembly with a spool valve show that the variant drain orifice damping could improve such null performance characteristics as null pressure sensitivity and linearity of gain function. Generalized design criterion and a sufficient condition for servovalve stability are also established.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2001.04a
• /
• pp.161-166
• /
• 2001

The static characteristics of four-nozzle flapper valves are investigated with both constant flow and constant supply pressure. The ranges, in which linearization of these characteristics would be valid, are discussed. Linearized dynamic model is also derived. Numerical simulations of nonlinear dynamic model are carried out by HyPneu to make an assessment of the effect of input step size in both cases of no-load and blocked-load operation.

• Korean Journal of Optics and Photonics
• /
• v.17 no.2
• /
• pp.186-190
• /
• 2006

The use of null optics is proposed as a new concept for the precise alignment of a confocal unstable resonator. The characteristics of the proposed null optics are investigated and analysed with the designed null lens for a real confocal unstable resonator of which the length is 3.5 m. As a result of the analysis, the pupil map data are shown about the despace error of 1.0 mm and tilt error of 1.0 mrad.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.11
• /
• pp.44-51
• /
• 1996

The radiation characteristics of a slot antenna in a plane conductor covered with a miving isotropic plasma layer are analyzed. The radiation null which causes distortion in radiation pattern is explainted by the zero of integrand in an asymptotic integral for radiation fields as a function of the plasma parameter and the plasma velocity. Numerical resutls for a radiation null calculated from various plasma and velocity parameters correspond to the results of two-dimensional problem.

• Journal of the Korean Society for Precision Engineering
• /
• v.17 no.8
• /
• pp.165-171
• /
• 2000

In this study the 4-way spool valve characteristics are clearly defined and clearly defined and proposed new type of spool valve. This paper presents governing equations of the flow through clearances between sleeve and spool as a model of orifice flow for null characteristics analysis and programmed analysis software of it. This software is possible to basically analysis that not only which case of open center closed center or critical center but _ -displacement of spool lab position boundary region and spool opening of the valve and to estimate the pressure variation in the spool and external leak flow variation. We are convinced that the scale of load pressure difference is changed as lab condition of valve and this scale is changed with boundary point on the annular clearance. It is vary useful to designer and user of spool valve with this design data and analysis software.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.37 no.5
• /
• pp.511-517
• /
• 2009

A servo type angle of attack sensor using the null-seeking method is designed and its characteristics are analyzed in this study. Angle-of-attack in the null-seeking method is given by the probe rotation angle with respect to the body reference line when pressure difference measured in two holes on the probe becomes zero. This method provides highly accurate and uniform angle-of-attack measurements over all range. Hence, this kind of angle-of-attack sensor is adequate for unmanned aerial vehicles(UAVs). In this paper, we first analyze the requirements for developing angle-of-attack sensors. And the servo type angle-of-attack sensor is then designed and fabricated. The on-board angle-of-attack calculation algorithm is also developed. Finally, the characteristics of the developed angle-of-attack sensor are identified through MATLAB Simulink and wind tunnel tests.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.19 no.4
• /
• pp.492-499
• /
• 2016

Null pattern synthesis method using the Quantum-inspired Evolutionary Algorithm(QEA) is described in this study. A $12{\times}12$ planar array antenna is considered and each element of the array antenna is controlled by 6-bit phase shifter. The maximum number of iteration of 500 is used in simulation and the rotation angle for updating Q-bit individuals is determined to make the individual converge to the best solution and is summarized in a look-up table. In this study we showed that QEA can satisfactorily synthesize the null pattern using smaller number of individuals compared with the conventional Genetic Algorithm.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.2
• /
• pp.313-319
• /
• 2010

GNSS receiver which uses the weak satellite signal is very vulnerable to the intentional jamming or non-intentional electromagnetic interference. One of the best method to overcome this disadvantage is to use an adaptive array antenna which has the capability of beamforming or nulling to the certain direction. In this paper, the performance of spatial adaptive null pattern control algorithm of 5 element array antenna is analyzed. A control algorithm which is designed in the 5 element array antenna is OPM(Output Power Minimization) which is eliminating the correlation characteristics between a reference antenna and the others. This algorithm can be applied effectively to the satellite navigation's CRPA because the satellite direction is not considered and GNSS signal power is below the thermal noise. The feature of the OPM algorithm is analyzed and the performance is compared with other null pattern control algorithm.

• Proceedings of the KSME Conference
• /
• 2001.06b
• /
• pp.121-126
• /
• 2001

In this study, the 4-way spool valve characteristics are clearly defined and proposed new type of spool valve. This paper presents governing equations of the flow through clearances between sleeve and spool as a model of orifice flow for null characteristic analysis, and programmed analysis software of it. This software is possible to basically analysis that not only which case of open center, closed center or critical center but +,- displacement of spool, lab position, boundary region and spool opening of the valve, and to estimate the pressure variation in the spool and external leak flow variation. We are convinced that the scale of load pressure difference is changed as lab condition of spool valve, and this scale is changed with boundary point on the annular clearance. It is vary useful to designer and user of spool valve with this design data and analysis software.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.22 no.2
• /
• pp.298-305
• /
• 1997

In this paper, the radiation characteristics of a slot annenna in conduction cylinder covered with a moving isotropic plasma layer are analyzed. Integral representations of the eletromagnetic fields in the spectral domain radiated through the plasma layer are derived and converted into the fields in the spacial domain by saddle-point ingegration. Radiation null which brings about distorion in the radiation parrern is explained by the zero of integrand in an asymptotic integral as a function of plasma and velocity parameters. Numerical results for a radiation null calculated from various plasma and velocity parameters correspond to the results of planner structure.