• Progress in Superconductivity and Cryogenics
• /
• v.7 no.2
• /
• pp.7-10
• /
• 2005

The magnetic properties of a series of both annealed (biaxially textured) and as-rolled (non-textured) Ni-xW alloy tapes with compositions x = 0,1,3, and 5 at.$\%$, were studied. Characterization methods included XRD analyses to investigate the biaxial cube texturing of the annealed Ni-W alloy tapes and studies of the magnetization M for both annealed and as-rolled Ni-W alloy tapes. Both the isothermal mass magnetizations M(H) of a series of samples at different fixed temperatures and M(T) in fixed field, employing a PPMS-9 (Quantum Design), were measured. The Ni-W alloys have shown much reduced ferromagnetism as W-content x increases. Both the saturation magnetization Msat and Curie temperature Tc decrease linearly with W-content x, and both Msat and Tc go to zero at critical concentration of Xc - 9.50 at. $\%$ W.

• Journal of Radiation Protection and Research
• /
• v.29 no.4
• /
• pp.257-261
• /
• 2004

A coded-aperture gamma camera was developed to increase the sensitivity of a pin hole camera made with a pixellated CsI(Tl) scintillator and a position-sensitive photomultiplier tube. The modified round-hole uniformly redundant array of pixel size $13{\times}11$ was chosen as a coded mask considering the detector spatial resolution. The performance of the coded-aperture camera was compared with the pin hole camera using various forms of Tc-99m source to see the improvement of signal-to-noise ratio or the improvement of the sensitivity. The image quality is much improved despite of a slight degradation of the spatial resolution. Though the camera and the test were made for low energy case, but the concept of the coded-aperture gamma camera could be effectively used for the radioactive environmental monitoring and other applications.

• Journal of Radiation Protection and Research
• /
• v.31 no.1
• /
• pp.17-23
• /
• 2006

The purpose of this study is to provide the guidance necessary for making a selection of error distributions by analyzing influence of statistical distribution for a type of bioassay measurement error on the intake estimation. For this purpose, intakes were estimated using maximum likelihood method for cases that error distributions are normal and lognormal, and comparisons between two distributions for the estimated intakes were made. According to the results of this study, in case that measurement results for lung retention are somewhat greater than the limit of detection it appeared that distribution types have negligible influence on the results. Whereas in case of measurement results for the daily excretion rate, the results obtained from assumption of a lognormal distribution were 10 % higher than those obtained from assumption of a normal distribution. In view of these facts, in case where uncertainty component is governed by counting statistics it is considered that distribution type have no influence on intake estimation. Whereas in case where the others are predominant, it is concluded that it is clearly desirable to estimate the intake assuming a lognormal distribution.

• Journal of Korean Academy of Nursing
• /
• v.49 no.6
• /
• pp.736-747
• /
• 2019

Purpose: This study aimed to explore public opinion on workplace bullying in the nursing field, by analyzing the keywords and topics of online news comments. Methods: This was a text-mining study that collected, processed, and analyzed text data. A total of 89,951 comments on 650 online news articles, reported between January 1, 2013 and July 31, 2018, were collected via web crawling. The collected unstructured text data were preprocessed and keyword analysis and topic modeling were performed using R programming. Results: The 10 most important keywords were "work" (37121.7), "hospital" (25286.0), "patients" (24600.8), "woman" (24015.6), "physician" (20840.6), "trouble" (18539.4), "time" (17896.3), "money" (16379.9), "new nurses" (14056.8), and "salary" (13084.1). The 22,572 preprocessed key words were categorized into four topics: "poor working environment", "culture among women", "unfair oppression", and "society-level solutions". Conclusion: Public interest in workplace bullying among nurses has continued to increase. The public agreed that negative work environment and nursing shortage could cause workplace bullying. They also considered nurse bullying as a problem that should be resolved at a societal level. It is necessary to conduct further research through gender discrimination perspectives on nurse workplace bullying and the social value of nursing work.

• Korean Journal of Optics and Photonics
• /
• v.15 no.5
• /
• pp.429-434
• /
• 2004

An ophthalmic endoscope which is used in medical applications should have the total diameter less than 1 mm. Its image resolution is limited to 30∼40 lp/mm. Therefore, the image resolution is one of the most important factors to decide image quality of the ophthalmic endoscopic images. This study obtained high resolution and magnifying ophthalmic endoscopic images by a new optical design using a 0.23 pitch GRIN lens and high resolution fiber-optic image guide which has less than 5 ${\mu}{\textrm}{m}$ diameter microfibers. The resolutions of images from existing and from a new type of ophthalmic endoscope are measured and compared using a USAF resolution target.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2008.10a
• /
• pp.149-154
• /
• 2008

We analyzed the Coulomb stress transfer near a small-scale reverse fault. For the modeling we used the geometry of a Quaternary fault in Gyeongju area, Eupcheon fault. For an assumed reverse faulting slip of 10cm, the resulting values of the Coulomb stress change are relatively higher (>2 bar) near the edges (both downward and lateral) of the fault, and diminish slightly upward and downward. The equivalents are negative in the zone immediately below and above the fault, exhibiting a "T" shape of low stress zone in the vertical profile of the fault. This study demonstrates the possible ranges and directions the aftershock energy would propagates after a reverse faulting.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.15 no.4
• /
• pp.567-578
• /
• 2002

The main purpose of this study is to investigate the dynamic behaviour of containment building in nuclear power plant excited by aircraft impact loading using a lower order 8-node solid element. The yield and failure surfaces for concrete material model is formulated on the basis of Drucker-Prager yield criteria and are assumed to be varied by taking account of the visco-plastic energy dissipation. The standard 8-node solid element has prone to exhibit the element deficiencies and the so-called B bar method proposed by Hughes is therefore adopted in this study. The implicit Newmark method is adopted to ensure the numerical stability during the analysis. Finally, the effect of different levels of cracking strain and several types of aircraft loading are examined on the dynamic behaviour of containment building and the results are quantitatively summarized as a future benchmark.

• Corrosion Science and Technology
• /
• v.11 no.6
• /
• pp.213-217
• /
• 2012

The amount of spent fuel from nuclear power plants has been increasing. An effective management plan of the spent fuel becomes a critical issue, because the storage capacity of each plant will reach its storage limit in a few years. The volume of high toxic spent fuel can be reduced through a fuel processing. Advanced Fuel Cycle (AFC) system is considered to be one of the options to reduce the toxicity and volume of the spent fuel. It is necessary to set up a test facility to demonstrate the feasibility of the process at the engineering scale. The objective of the work is a development of the safety evaluation technology for the AFC system. The evaluation technology of the AFC structural integrity and processes were surveyed and reviewed. Key evaluation parameters for the main processes such as electrolytic reduction, electrorefining, and electrowinning were obtained. The survey results may be used for the establishment of the AFC regulatory licensing procedure. The establishment of the licensing criteria minimizes the trials and errors of the AFC facility design. Issues taken from the survey on the regulatory procedure and design safety features for the AFC facility provide a chance to resolve potential issues in advance.

• Animal cells and systems
• /
• v.16 no.2
• /
• pp.87-94
• /
• 2012

Nur77 is a member of the nuclear receptor 4A (NR4A) subgroup, which has been implicated in energy metabolism. Although Nur77 is found in adipose tissue, where TR4 plays a key role in lipid homeostasis, the role of Nur77 in adipogenesis is still controversial. Although the Nur77 responsive element (AAAGGTCA) is partially overlapped with TR4-binding sites (AGGTCA $n$ AGGTCA: $n$=0-6), the regulatory role of Nur77 in TR4 function associated with adipocyte biology remains unclear. Here, we found that Nur77 inhibits adipogenesis and TR4 transcriptional activity. Treatment with a Nur77 agonist, 1,1-bis(3'-indolyl)-1-($p$-anisyl)-methane, during 3T3-L1 adipocyte differentiation reduced adipogenesis. In reporter gene analysis, Nur77 specifically suppressed TR4 transcription activity but had little effect on $PPAR{\gamma}$ transcription activity. Consistently, Nur77 also suppressed TR4-induced promoter activity of the TR4 target gene PEPCK, which is known to be important for glyceroneogenesis in adipose tissue. Furthermore, Nur77 suppressed TR4 binding to TR4 response elements without direct interaction with TR4, suggesting that Nur77 may inhibit TR4 transcription activity via binding competition for TR4-binding sites. Furthermore, DIM-C-$pPhOCH_3$ substantially suppressed TR4-induced PEPCK expression in 3T3-L1 adipocytes. Together, our data demonstrate that Nur77 plays an inhibitory role in TR4-induced PEPCK expression in 3T3-L1 adipocytes.

• Journal of Powder Materials
• /
• v.25 no.1
• /
• pp.43-47
• /
• 2018

Carbon nanofibers (CNF) are widely used as active agents for electrodes in Li-ion secondary battery cells, supercapacitors, and fuel cells. Nanoscale coatings on CNF electrodes can increase the output and lifespan of battery devices. Atomic layer deposition (ALD) can control the coating thickness at the nanoscale regardless of the shape, suitable for coating CNFs. However, because the CNF surface comprises stable C-C bonds, initiating homogeneous nuclear formation is difficult because of the lack of initial nucleation sites. This study introduces uniform nucleation site formation on CNF surfaces to promote a uniform $SnO_2$ layer. We pretreat the CNF surface by introducing $H_2O$ or $Al_2O_3$ (trimethylaluminum + $H_2O$) before the $SnO_2$ ALD process to form active sites on the CNF surface. Transmission electron microscopy and energy-dispersive spectroscopy both identify the $SnO_2$ layer morphology on the CNF. The $Al_2O_3$-pretreated sample shows a uniform $SnO_2$ layer, while island-type $SnO_x$ layers grow sparsely on the $H_2O$-pretreated or untreated CNF.