• Proceedings of the KIPE Conference
• /
• 1998.07a
• /
• pp.212-216
• /
• 1998

For a Switched Reluctance Motor(SRM) drive, the important things are 1) reducing torque ripple, 2) improving efficiency, 3) sensorless speed control, 4) accurate position. The position information impotant for the efficiency and smoothness drives. Since SRMs characteristics are nonlinear. It is difficult to estimated phase current in saturation region. This paper describes a method for indirect sensing of the rotor position in SRM which use both voltage and current. The method obtains rotor position by using unconducting phase. The information about the rotor position is achieved by differentiating the unconducting phase current or the voltage gradient. And then, this paper presents a torque control with indirect rotor position detection methods. This torque control is achieved by developing a detailed nonlinear model of the motor.

• Proceedings of the Optical Society of Korea Conference
• /
• 2003.02a
• /
• pp.232-233
• /
• 2003

Quasi-phase-match (QPM) can be realized by means of one-dimensional spatial modulation of second-order nonlinear susceptibility and has advantages over the conventional bulk phase-matching method because QPM can not only utilize the largest component of second-order nonlinear susceptibility tensor, but also can circumvent walk-off effect. (omitted)

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.6
• /
• pp.1443-1447
• /
• 2012

In this paper, the characteristic of temperature variation was reviewed according to pattern variation. In order to degrade of diagnosis of power supply by using time series data for temperature measured by infrared camera it was transformed into 2 dimension phase plane using Takens embedding method. As a simulation results we cannot completely confirm the characteristic behaviors of nonlinear dynamics in phase plane. However these results has a certain patterns, it requires verification method through additional research in the future.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.4
• /
• pp.622-629
• /
• 2001

An engineering model VCO with a good phase noise for Ku-band satellite transponder is designed using a nonlinear design methodology. It generates frequencies from 1,745 and 1,755 MHz with control voltages from 0 to 5 V DC. This unit requires 7 mA of current from 5 V DC supply voltage. Phase noise characteristics of the manufactured VCO exhibit -114 dBc/Hz @10 kHz offset and -131 dBc/Hz @100 kHz of offset and its output power is 5 dBm.

• Journal of Power Electronics
• /
• v.2 no.1
• /
• pp.1-10
• /
• 2002

An advanced active power filter for the compensation of instantaneous harmonic current components in nonlinear current load is presented in this paper. A novel signal processing technique using an adaptive neural network algorithm is applied for the detection of harmonic components generated by three-phase nonlinear current loads and this method can efficiently determine the instantaneous harmonic components in real time. The control strategy of the switching signals to compensate current harmonics of the three-phase inverter is also discussed and its switching signals are generated with the space voltage vector modulation scheme. The validity of this active filtering processing system to compensate current harmonics is substantiated on the basis of simulation results.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.8 no.11
• /
• pp.1691-1696
• /
• 2013

In this paper, an analysis of behavior is performed in the circular hybrid energy harvesting device. This analysis of behavior is to confirm with or without an existence of nonlinear system because its system is required to produce the more energy. To do this, first of all the phase portrait is reconstructed through Taken's embedding method, and then Poincare map is organized by using phase portrait and finally Lyapunov exponent is analyzed.

• Journal of Power Electronics
• /
• v.18 no.6
• /
• pp.1634-1641
• /
• 2018

This study focuses on a high-performance direct active and reactive power controller design that is successfully applicable to three-phase pulse width modulation (PWM) AC/DC converters used in renewable distributed energy generation systems. The proposed controller can overcome the sluggish transient dynamic response of conventional controllers to rapid power command changes. Desired active and reactive powers can be thoroughly obtained at the end of each PWM period through a deadbeat solution. The proposed controller achieves an exact nonlinear cross-coupling decoupling of system power without using a predefined switching table or bang/bang hysteresis control. A graphical and analytical analysis that naturally leads to a control voltage vector selection is provided to confirm the finding. The proposed control strategy is evaluated on a 3 kW PWM AC/DC converter in the simulation and experiment.

• Bulletin of the Korean Mathematical Society
• /
• v.35 no.4
• /
• pp.689-700
• /
• 1998

We consider an infinite dimensional dynamical system what is called Lattice Dynamical System given by a discrete nonlinear diffusion equation. By assuming the nonlinearity to be a general nonlinear function with mild restrictions, we show that as the diffusion parameter changes the stationery state of the given system undergoes bifurcations from the zero state to a bounded invariant set or a 3- or 4-periodic state in the global phase space of the given system according to the values of the coefficients of the linear part of the given nonlinearity.

• 제어로봇시스템학회:학술대회논문집
• /
• 1993.10a
• /
• pp.1213-1218
• /
• 1993

Variable structure control is applied to the robust output tracking control problem of general nonlinear multi-input multi-output (MIMO) systems. Using the concept of relative degree and minimum phase, input/output(I/O) linearization is undertaken. For I/O the linearized system, a new sliding hyperplanes design method is proposed. In this procedure, we can construct very robust and efficient sliding mode controller for general nonlinear systems of relative degree higher than two. The control results are illustrated by adopting a numerical example.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.492-494
• /
• 2006

Neutral line current is analyzed by the neutral line CF in nonlinear load balanced and unbalanced conditions. The worst nonlinear load condition is nonlinear balanced load condition, and It is below CFNL=1.194 that a neutral line current could not excess the rated value