• Membrane Journal
• /
• v.33 no.4
• /
• pp.222-232
• /
• 2023

In this study, a hollow fiber support membrane was prepared by a non-solvent induced phase separation (NIPS) method using a polysulfone (PSf). The prepared hollow fiber support membrane was coated with PDMS and Pebax to prepare a hollow fiber composite membrane. The prepared composite membrane was measured for permeance and selectivity for pure CO₂, H₂, O₂ and N₂. Gas separation performance of the module having the highest selectivity (CO₂/H₂) among the prepared composite membrane modules was measured according to the change in stage cut using simulated gas. The composition of the simulated gas used at this time was 70% CO₂ and 30% H₂. In the 1 stage experiment, it was possible to obtain values of about 60% of H₂ concentration and 12% of H₂ recovery. In order to overcome the low H₂ concentration and recovery, 2 stage serial test was performed, and through this, it was possible to achieve 70% H₂ concentration and 70% recovery. Through this, it was possible to derive a separation process configuration for CO₂/H₂ separation.

• Clean Technology
• /
• v.29 no.1
• /
• pp.71-75
• /
• 2023

In general, the presence of non-selective intercrystalline (grain boundary) defects in polycrystalline metal-organic framework (MOF) or zeolite membranes, which are known to be ca. 1 nm in size, causes lower membrane performance (selectivity) than the intrinsically expected. In this study we show that applying a thin polymeric coating of polydimethylsiloxane (PDMS) on a polycrystalline MOF membrane is effective to cap the non-selective intercrystalline defects and therefore improve membrane performance. To demonstrate the concept, first, polycrystalline UiO-66, one of Zr-based MOFs, membranes were prepared by an in-situ solvothermal growth. By controlling membrane growth condition with respect to growth temperature, we were able to obtain polycrystalline UiO-66 membranes at 150 ℃ with intercrystalline defects of which the quantity is not significant, so it can be plugged by the suggested PDMS deposition. Second, their performances were compared before and after the PDMS deposition. As expected, the PDMS deposition ended up with a noticeable increase in CO₂/N₂ ideal selectivity from 6 to 14, indicating successful intercrystalline defect plugging. However, the enhancement in CO₂/N₂ selectivity was accompanied by a significant reduction in CO₂ permeance from 5700 to 33 GPU because the PDMS deposition not only plugs defects but also forms a continuous coating on membrane surface, adding an additional transport resistance.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.38 no.2
• /
• pp.91-100
• /
• 2002

The field experiments were carried out to examine for the mesh selectivity in trammel net and optimum mesh size, during Aug. 10~13, Non 9~13 2000 in Jumunjin, Kangwon-Do and during Jun. 1~27 2001 in Suyong-Bay, Busan. The experiments in Jumunjin area were conducted by using trammel nets with seven different mesh sizes (60, 75, 90, 105, 135, 150, 180mm) and those in Suyong-Bay were done by using trammel nets and gill nets with three different mesh sizes (60, 75, 90mm) in order to compare two types of nets of same structure. The mesh selectivity analysis was done mainly with flat fish(Eopsetta grigorjewi) that was occupied 60% out of total catches. And the mesh selectivity was written by extension of Kitahara's method included master curve with function type. The results obtained are summarized as follows 1. Total number of catch by, trammel net was 2,331 and that of gill net was 1,433, and flat fishes occupied 59.8 ~60% in total catches. 2. The value of optimum l/m by, trammel net was higher about 0.1 than that of gill net according as trammel net was 2.56, and gill net was 2.47. 3. The 50% selection range by, trammel net was wider about 1.5 time than that of gill net according as trammel net was 1.88~3.36(1.48) and gill net was 2.00~3.02(1.02). 4. The optimum mesh size(OMS) was estimated that trammel net was about 141mm and gill net was about 132mm on first maturity length(FML) 265mm of flat fish. 5. On the optimum mesh size based on the first maturity length of flat fish, The 50% range by, trammel net was wider about 76mm than that of gill net according as trammel net was 265 mm~474mm and gill net was 265mm~398mm.

• Korean Chemical Engineering Research
• /
• v.62 no.2
• /
• pp.147-152
• /
• 2024

Most medical sensors are disposable products. In order to reduce inspection and diagnosis costs, it is more important to develop the inexpensive electrode materials. We fabricated the CuO NPs/PANI/E-PGE as an electrode material for disposable electrochemical sensors and applied it to a non-enzymatic glucose sensor. For surface activation of PGE, pretreatment was performed using chemical and electrochemical methods, respectively. Electrochemical properties according to the pretreatment method were analyzed through chronoamperometry (CA), cyclic voltammetry (CV) and electrochemical impedance (EIS). From these analytical results, the electrochemically pretreated PGE (E-PGE) was finally adopted. The non-enzymatic glucose sensor based on CuO NPs/PANI/E-PGE shows sensitivity of 239.18 mA/mM×cm² (in a linear range of 0.282~2.112 mM) and 36.99 mA/mM×cm² (3.75423~50 mM), detection limit of 17.6 μM and good selectivity. Based on the results of this study, it was confirmed that the modified PGE is a high-performance electrode material. Therefore, these electrodes can be applied to a variety of disposable sensors.

• Journal of Sensor Science and Technology
• /
• v.27 no.2
• /
• pp.132-136
• /
• 2018

We report the development of a room-temperature hydrogen ($H_2$) gas sensor based on carbon nanotubes (CNT) yarn. To detect $H_2$ gas in room temperature, a highly ordered CNT yarn was placed on a substrate from a spin-capable CNT forest, followed by the deposition of a platinum (Pt) layer on surface of the CNT yarn. To examine the effect of the Pt-layer on the response of the CNT sensor, a comparative sensing performance was characterized on both the Pt deposited and non-deposited CNT yarn at room temperature. The Pt-CNT yarn yielded high response, whereas the non-deposited CNT yarn showed negligible response for $H_2$ detection at room temperature. Pt is a reliable and efficient catalyst that can substantially improve the detection of $H_2$ gas by chemical sensitization via a "spillover" effect. It can be efficiently utilized to increase the sensitivity and selectivity as well as to obtain fast response and recovery times.

• Fashion & Textile Research Journal
• /
• v.8 no.5
• /
• pp.577-584
• /
• 2006

The binding of heavy metal ions onto cross-linked chitosan in dilute aqueous solution has been investigated as a function of pH (4.0 and 7.0), agitation period (10-180min) and concentration of various metal cations (5, 10, 50 and 100ppm). In order to obtain adsorbents that are insoluble and stable, and prevent the dissolution loss of chitosan into an acidic aqueous solution, chitosan flakes were cross-linked with epichlorohydrine (ECH) and its adsorption behavior was compared with that of the non cross-linked chitosan. An advantage of ECH is that it does not eliminate the cationic amine functional group of chitosan. In terms of adsorption ratio, the chitosan cross-linked at an ECH was inferior to original chitosan and was found that chitosan has a selectivity much remarkable than the cross-linked chitosan in low concentrated metal solutions. However, no significant decreases in the adsorption ratios were observed between the cross-linked ECH-chitosan and the non cross-linked chitosan concerning the adsorption of $Ni^{2+}$, $Co^{2+}$, $Pb^{2+}$ and $Zn^{2+}$ acidic solution.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.54 no.5
• /
• pp.128-132
• /
• 2017

In this thesis, a BPF(band-pass filter) at the center frequency of 2.14GHz, and bandwidth of 20MHz is designed and implemented using high Q dielectric resonators with ${\varepsilon}_r=38$. The DR(dielectric resonator) is resonated by $TE_{01{\delta}}$-mode and it has a hole in the center of DR. The BPF consists of 6-poles dielectric resonators and the characteristic of elliptic function is obtained by non-adjacent coupling. It has the average insertion loss of 0.97dB and the return loss over 25dB in its passband. In this thesis, the frequency selectivity is more improved by the coupling characteristics between non-adjacent resonators than that of dielectric resonator filters with a Chebyshev response.

• Bulletin of the Korean Chemical Society
• /
• v.21 no.7
• /
• pp.685-689
• /
• 2000

The complexation reaction between Pb2+,TI and Cd2+ions and macrocyclic ligands, 18-crown-6 ( 18C6) and dibenzo- 18-crown-6 (DB 18C6), was studied in dimethylsulfoxide (DMSO)-nitromethane (NM) and dimethyl-formamide (DMF)-nitromethane binary system s by square wave polarography (SWP) technique. The stoichiometry and stability of the complexes were determined by monitoring the shifts in half-waves or peak potentials of the polarographic waves of metal ions against the Iigand concentration. In most cases, the stability constants of complexes increase with increasing amounts of the nitromethane in mixed binary solvents used in this study. The complexes formed between 18C6 and DB18C6 and these metal cations in all cases had a stoichiometry of 1 : 1. The results obtained show that there is an inverse relationship between the formation constant of complexes and the donor number of solvents based on a Gatmann donocity scale and the stability constants show a high sensitivity to the composition of the mixed solvent systems. A linear behavior was observed for variation of log Kf of I8C6 complexes vs the composition of the mixed solvent systems in NM/DMSO and NM/DMF,but a non-linear behavior was observed in the case of DB 18C6 complexes in these binary systems. In most of the systems investigated, the Pb2+ cation forms a more stable complex with the 18C6 than other two cations and the order of selectivity of this Iigand for cations is: Pb2+ > TI+,Cd2+.

• Polymer(Korea)
• /
• v.32 no.2
• /
• pp.138-142
• /
• 2008

Molecularly imprinting technology is an effective method to prepare a synthetic material with a high selectivity to a target molecule. In this study, a molecularly imprinted polymer (MIP) was synthesized via UV-polymerization using theophylline and UV-curable polyester-acrylate resin as a template molecule and a crosslinker, respectively. To elucidate the effects of functional monomer type on the performance of the MIP, each MIP was synthesized using mathacrylic acid, acrylic acid, and acryl amide as functional monomers. Each MIP showed higher rebinding capacity to theophylline than its corresponding non-imprinted polymer (NIP). The MIP synthesized using mathacrylic acid as a functional monomer showed the highest rebinding capacity to theophylline. The selectivity of the MIP was investigated using a solution with caffeine having a very similar structure to theophylline. The binding performance of the MIP to theophylline decreased when distilled water was used as a solvent, which has more polarity than chloroform.

• Proceedings of the Korean Society of Applied Pharmacology
• /
• 1994.04a
• /
• pp.335-335
• /
• 1994

Possibility whether lead ingestion can cause selective toxicity to central serotonergic nervous system in rats was tested. Three groups of wistar rats; 1)Control, 2) Low dose and 3) High dose groups, were prepared. In prenatally lead-exposed rats, until parturition from dams, rat pups were intoxicated via placenta of mother rats having received drinking water containing either 0%(control ), 0.05%(low dose) or 0.2%(high dose) of lead acetate respectively, In postnatally lead-exposed rats, right after parturition from dams rat pups received drinking water containing either 0％ (control), 0.05%(low dose) or 0.2％(high dose) of lead acetate. At 2, 4, 6 and 8 weeks of age, tryptophan hydroxylase (TPH) activity and Na$\^$+//K$\^$+/-ATPase activity were measured in 4 areas of rat brain; Telencephalon, Diencephalon, Midbrain and Pons/Medulla. TPH activities were assayed by modified method of Beevers et al. (1983) using L-(5-$^3$H)-tryptophan as substrate. TPH activity was determined as a criterion of lead poisoning to central serotonergic nervous system and Na$\^$+//K$\^$+/-ATPase activity as a criterion of non specific lead poisoning to any kinds of tissues. Selective toxicity of lead poisoning to central serotonergic nervous system was evaluated by the changes of TPH activities without concomitant changes of Na$\^$+//K$\^$+/-ATPase activities. In prenatally lead-exposed rats. this selectivity was found in Telencephalon (2 weeks of age), Diencephalon/Midbrain (2 weeks of age), Midbrain (4 and 6 weeks of age), Pons/Medulla (2, 4 and 6 weeks of age) In rats exposed to low dose of lead and Pons/Medulla (2 weeks of age) to high dose of lead. In postnatal Iy lead-exposed rats, this selectivity was found in Telencephalon (8 weeks of age), Diencephalon(8 weeks of age), Pons/Medulla (6 and 8 weeks of age) in rats exposed to low dose of lead and Pons/Medulla (8 weeks of age) to high dose of lead. These results suggest that lead poisoning may exhibit selective toxicity to central serotonergic nervous system.