• Journal of the Korean Ceramic Society
• /
• v.28 no.3
• /
• pp.205-214
• /
• 1991

Calcium carbonate fine powders were synthesized by blowing CO2 gas in CaO or Ca(OH)2 suspension, and the shapes of powders obtained were examined for each synthetic condition. When water was used as a solvent, ultrafine calcite powders with the average size of∼0.03$\mu\textrm{m}$ were obtained. When synthesized using methanol as a solvent, amorphous phase and spherical vaterite phase were obtained by suction filtering and non-filtering, respectively. Reaction did not occured in ethanol medium, but spherical vaterite phase was obtained by adding ethylene glycol in ethanol.

• Corrosion Science and Technology
• /
• v.3 no.3
• /
• pp.98-101
• /
• 2004

The corrosion behavior of Al-Fe coatings was studied in the wet-seal atmosphere of molten carbonate fuel cells (MCFC). Fe-8Al, Fe-16Al, Fe-25Al, Fe-36Al, and Fe-70Al (in at.%) specimens were tested in Li/K carbonate at $650^{\circ}C$ by a single cell test and an immersion test. In general, the corrosion resistance of the Al-Fe coatings was enhanced due to the formation of a protective $LiAlO_2$ layer. However, when the Al-Fe coatings didn't have sufficient content of aluminum enough for maintaining the protective layer, the corrosion resistance of the Al-Fe coatings was severely degraded by the growth of non-protective scales like $LiAlO_2$. The test results revealed that the aluminum contents in the coatings should be higher than 25 at.% in order to form and maintain the protective $LiAlO_2$ layers.

• Geomechanics and Engineering
• /
• v.1 no.4
• /
• pp.307-321
• /
• 2009

The paper employs a feed forward neural network with back-propagation algorithm for modeling time dependent swell in clays containing carbonate in the presence of sulfuric acid. The oedometer swell percent is estimated at a nominal surcharge pressure of 6.25 kPa to develop 612 data sets for modeling. The input parameters used in the network include time, sulfuric acid concentration, carbonate percentage, and liquid limit. Among the total data sets, 280 (46%) were assigned to training, 175 (29%) for testing and the remaining 157 data sets (25%) were relegated to cross validation. The network was programmed to process this information and predict the percent swell at any time, knowing the variable involved. The study demonstrates that it is possible to develop a general BPNN model that can predict time dependent swell with relatively high accuracy with observed data ($R^2$=0.9986). The obtained results are also compared with generated non-linear regression model.

• Cement Symposium
• /
• s.49
• /
• pp.31-32
• /
• 2022

This study is to analyze the difference by comparing the physical properties of general Portland cement (OPC) and low-heat Portland cement (LHC) in the market to develop low-heat cement manufacturing technology that can minimize the amount of limestone by using non-carbonate circulating resources as raw materials. To this end, the mortar is being reviewed by evaluating the properties of the mortar, such as slump, strength, durability, and thermal insulation properties, with a difference in the mixing ratio.

• Applied Chemistry for Engineering
• /
• v.19 no.2
• /
• pp.209-213
• /
• 2008

The fixed bed gasification reactor with 1 m hight and 10.2 cm diameter was utilized for the hydrogen production from biomass wastes. Lauan sawdust was used for non-catalytic and catalytic gasification reaction as a sample in the fixed bed reactor. The fixed bed temperature and catalyst are the major variables affecting the process operation. Thus, the effect of fixed bed temperature and the catalysts on gas composition were studied at the temperature range from $400^{\circ}C$ to $700^{\circ}C$. The yield of hydrogen was increased at higher temperature in the fixed bed reaction. Fractions of hydrogen, carbon monoxide and methane gas in the product gas increased when sodium carbonate ($Na_2CO_3$) and potassium carbonate ($K_2CO_3$) catalysts were used. Furthermore, sodium carbonate catalyst was more effective to obtain higher hydrogen yield compared to potassium carbonate catalyst.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.5
• /
• pp.51-57
• /
• 2012

The purpose of study is to understand the possibility of biogrout of soil induced by bacteria. Microbial Calcium Carbonate Precipitation(MCP) has been analysed using the microorganism Bacillus Pasteurii. In order to understand the biogrout of soft ground treated with microbial calcium carbonate precipitation, four types of specimens(sterilization soil, non-sterilization soil, reaction solution and microorganism solution with pre-treatment mix and reaction solution and microorganism solution with post-treatment mix) were made. Scanning Electron Microscope(SEM), EDX and X-ray diffraction(XRD) analyses were performed on the soft ground specimens. On the basis of the preliminary results, it appears that microbial treatment methods using calcium carbonate precipitation may be possible to improve property of biogrout.

• Economic and Environmental Geology
• /
• v.47 no.5
• /
• pp.467-477
• /
• 2014

Naturally occurring asbestos (NOA) occurs in rocks and soils as a result of natural weathering and human activities. The asbestos have been associated with ultramafic and mafic rocks, and carbonate rock. The previous studies on NOA were mainly limited to ultramafic and mafic rock-hosted asbestos in Korea. But, studies on carbonatehosted asbestos are relatively rare. Therefore, the purposes of this study were to investigate mineralogical characteristics of carbonate-hosted and metapelite-hosted NOA and to examine genesis of NOA occurred in the both rocks. The study area was Daerori, Seosan, Chungnam Province, Korea. The major rock formation consisted of limestone and schist which have been known to contain asbestos. Sampling was performed at outcrop which contained carbonate rock showing acicular asbestos crystals as well as pegmatitic intrusion that contacted with carbonate rock. PLM, XRD, EPMA, and EDS analyses were used to characterize mineral assemblages, mineralogical characteristics, and crystal habits of amphiboles and other minerals. BSEM images were also used to examine the genesis of asbestos minerals. The amphibole group was observed in all of the carbonate rocks, and actinolite and tremolite were identified in all rocks. These mineral habits were mainly micro-acicular crystals or secondary asbestiform minerals on the surface of non-asbestiform minerals appearing split end of columnar crystals produced by weathering. BSEM images showed residual textures of samples. The residual textures of carbonate rocks showed dolomite-tremolite-diopside mineral assemblages that formed during prograde metasomatism stage. Some carbonate rock also showed diopside-tremolite-talc mineral assemblages which were formed during retrograde metasomatism stage, as the residual textures. In result the presence of asbestos actinolite-tremolite in the carbonate rocks were confirmed in the areas where actinolite-tremolite asbestos was influenced by low temperature hydrothermal solution during metasomatism stage. These asbestos minerals showed the acicular asbestiform minerals, but even non-asbestiform minerals, a bundle or columnar shape, could transform to asbestiform minerals as potential NOA by weathering because the end of columnar shape of non-asbestiform minerals appeared as multiple acicular shaped fibers.

• Korean Journal of Food Science and Technology
• /
• v.24 no.3
• /
• pp.247-250
• /
• 1992

Effects of free alkali and moisture on sucrose polyesters (SPE)-possible non calorie fat substitute-synthesis were investigated using a model system composed of sodium oleate, sucrose, potassium carbonate and methyl oleate. Trace amounts of free alkali in sodium oleate were found to interefere with SPE synthesis. When free alkali content in sodium oleate was varied gradually from 0% to 5%(w/w), the yield of SPE production was reduced from 92% to 45.5%. The moisture absorbed in sodium oleate, sucrose and potassium carbonate during storage also interefered with SPE synthesis. The yield (92%) of SPE production with dried ($105^{\circ}C$.6 hrs) reactants and catalysts was higher than that (89%) of SPE production with non-dried. Soybean oil fatty acid sodium soaps (FASS) not containing free alkali could be manufactured with slightly less than molar ratio of sodium hydroxide to soybean oil fatty acid methyl esters (FAME). Practically, 91.7% yield of soybean oil SPE production was outcomed by minimizing free alkali and moisture which were remaining in sucrose, potassium carbonate, soybean oil FASS and soybean oil FAME.

• Journal of Urban Science
• /
• v.9 no.2
• /
• pp.45-50
• /
• 2020

The formation characteristics of calcium carbonates are closely related to the durability and mechanical properties of cement-based materials. In this regard, a deep understanding of the reaction pathway of calcium carbonates is critical. Recently, non-classical nucleation theory was summarized and it was presumed that prenucleation clusters are present. The formation of the prenucleation cluster at undersaturated condition (≈ 0.1 ml) in the present study was investigated via electrical characteristics of an electrolytic solution. Calcium chloride dihydrate (CaCl2·2H2O) and sodium carbonate (Na2CO3) were used as starting materials to supply calcium and carbonate sources, respectively. Furthermore, the reaction pathway of calcium carbonates was investigated by time-resolved polarization and depolarization characteristics of the electrolytic solution. The time-resolved polarization and depolarization tests were conducted by switching polarity with an interval of 20 seconds for 1 hr and by measuring the variation of electrical resistance. It can be inferred from the results obtained in the present study that the reactive constituent for the formation of calcium carbonates was mostly consumed in the period possibly associated with the prenucleation and the reaction pathways may be governed by the monomer-addition mechanism.

• Journal of Nutrition and Health
• /
• v.27 no.5
• /
• pp.473-482
• /
• 1994

This study was to compare the bioavailability of calcium from anchovy and tofu to those of calcium from calcium carbonate(CaCO3)as the control diet and non-fat dry milk(NFDM). Rats weighing 50-60g were placed on experimental diets and deionized water at free access for 4 weeks. Diets contained 0.2% calcium from calcium-carbonate, NFDM, anchovy, tofu or 0.5% calcium as obtained were as follows : 1) No significant differences in the apparent absorption of calcium(62.5%-71.0%) were observed in the rats fed four different calcium sources at the level of 0.2% while 0.5% calcium diet group apparently absorbed calcium less efficiently(52.2%). 2) Bone length of tibia and femur was not significantly different among the groups, though 0.5% calcium of control group showed slightly longer length. 3) Tibia fat-free dry weights of 0.2% calcium of NFDM and anchovy diet groups were not significantly different from that of 0.5% calcium of control group. For femurs NFDM, anchovy and tofu groups were similar in their fat-free dry weight to that of 0.5% calcium group. 4) For calcium contents tibia contents tibia from anchovy treated group showed higher value than calcium-carbonate and tofu groups and the value was not significantly different from that of 0.5% calcium group. In femur NFDM, tofu and calcium-carbonate groups were not significantly different in their calcium content but 0.5% calcium group had higher level of calcium than 0.2% calcium groups. 5) The normalized values(NV) show that there was no significant differences in NV among 0.2% CaCO3 anchovy and tofu groups, while NV of NFDM group was significantly lower than that of calcium-carbonate group. NV of 0.5% calcium group was a little more than 50% of those in 0.2% calcium groups. Though the values obtained for the calcium bioavailability were somewhat variable among experimental products, it was demonstrated that anchovy and tofu are as good as NFDM for the dietary calcium provider when calcium intake is at marginal level.