• Korea-Australia Rheology Journal
• /
• v.11 no.3
• /
• pp.225-232
• /
• 1999

This study presents 1-dimensional simple model for sheet casting or rectangular fiber spinning process. In order to achieve this goal, we introduce the concept of force flux balance at the die exit, which assigns for the extensional flow outside the die the initial condition containing the information of shear flow history inside the die. With the Leonov constitutive equation that predicts non-vanishing second normal stress difference in shear flow, we are able to describe the anisotropic swelling behavior of the extrudate at least qualitatively. In other words, the negative value of the second normal stress difference causes thickness swelling much higher than width of extrudate. This result implies the importance of choosing the rheological model in the analysis of polymer processing operations, since the constitutive equation with the vanishing second normal stress difference is shown to exhibit the characteristic of isotropic swelling, that is, the thickness swell ratio always equal to the ratio in width direction.

• Macromolecular Research
• /
• v.16 no.3
• /
• pp.212-217
• /
• 2008

PVDF ($Kynar^{(R)}$ 761) nanofibers were made by electrospinning with an external voltage of 6-10 kV, a traveling distance of 7-15 cm and a flow rate of 0.4-1 mL/h. Although the mean diameter of the fibers has not changed significantly, the conditions affected the change in diameter distribution. This was attributed to interactions, both attraction and repulsion, between the positive charges on the polymer solutions and the electrically grounded collector. Higher voltages and traveling distance increased the level of attraction between the positive charge on the polymer solution and the electrically grounded collector, resulting in a narrow diameter distribution, In addition, a high flow rate allowed a high population of uniformly charged solutions to travel to the grounded collector, which resulted in a narrow diameter distribution. The optimum conditions for electrospinning of PVDF in DMAc/acetone (3/7 by wt) were a collector voltage of 6 kV, a syringe tip to collector of 7 cm, a flux rate of 0.4 mL/h and 10 kV, 10 cm, 1 mL/h, Since PVDF is widely used as a filtration membrane, it was electrospun on a PET support with a rotating drum as a grounded collector. Surprisingly, some straight nanofibers were separated from the randomly deposited nanofibers. The straight nanofiber area was transparent, while the randomly deposited nanofiber area was opaque. Both straight nanofibers and aligned nanotibers could be obtained by manipulating the PET drum collector. These phenomena were not observed when the support was changed to an Al sheet. This suggests that a pseudo dual collector was generated on the PET sheet. No negative charge was created because the PET sheet was not a conductive material. However, less charge was created when the sheet was not perfectly attached to the metal drum. Hence, the nanotibers jumped from one grounded site to the nearest one, yielding a straight nanofiber.

• Clean Technology
• /
• v.3 no.2
• /
• pp.13-24
• /
• 1997

The present paper aims to give basic information to establish zero emission material cycle including the minimization of emissions from industrial production processes and the area in regional scale. Strategies and methodologies to analyze emissions from the production processes and our human activities and to reduce those emissions by refining and/or replacing the unit process with the alternatives are introduced as well. Quantitative evaluation and management systems of any raw materials and the production process are from vie points of treatment are essential. Estabiishment of a process networking for the recycle of discharged non-products materials by the intra-process, trans-process and the trans-industries are proposed. Procedures and priorities to formulate industrial and regional zero emission system are proposed as well.

• Journal of ILASS-Korea
• /
• v.7 no.2
• /
• pp.7-15
• /
• 2002

A particle flow visualization, electrostatic charging measurement and separation of triboelectrically charged particles in the external electric field by a fluidized bed tribocharger are conducted for the removal of PVC particles from mixed waste plastics. The laboratory-scale triboelectrostatic separation system consists of the fluidized bed tribocharger, a separation chamber, a collection chamber and a controller. PVC and PET particles can be imparted negative and positive surface charges respectively due to the difference of triboelectric charging series between particles and particles in the fluidized bed tribocharger, and can be separated by passing them through an external electric field. To visualize these charged particles, He-Ne laser is used with cylindrical lenses to generate a sheet beam. In the charging measurement, the particle motion analysis system (PMAS), capable of determining particle velocity and diameter. is used to non-intrusively measure particle behavior in high strength electric field. The average charge-to-mass ratios of PVC and PET particles are $1.4\;and\;1.2{\mu}C/kg$, respectively. The highly concentrated PVC (91.9%) can be recovered with a yield of about 96.1% from the mixture of PVC and PET materials for a single-stage processing. The triboelectrostatic separation system using the fluidized tribocharger shows the potential to be an effective method for removing PVC from mixed plastics for waste plastic recycling.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2009.11a
• /
• pp.50-50
• /
• 2009

In this paper, the plasma doping is performed on p-type wafers using $PH_3$ gas(10 %) diluted with He gas(90 %). The wafer is placed in the plasma generated with 200 W and a negative DC bias (1 kV) is applied to the substrate for 60 sec under no substrate heating. the flow rate of the diluted $PH_3$ gas and the process pressure are 100 sccm and 10 mTorr, respectively. In order to diffuse and activate the dopant, annealing process such as rapid thermal annealing (RTA) is performed. RTA process is performed either in $N_2$, $O_2$ or $O_2+N_2$ ambient at $900{\sim}950^{\circ}C$ for 10 sec. The sheet resistance is measured using four point probe. The shallow n+/p doping profiles are investigated using secondary ion mass spectromtry (SIMS). The analysis of crystalline defect is also done using transmission electron microscopy (TEM) and double crystal X-ray diffraction (DXRD).

• Membrane Journal
• /
• v.13 no.4
• /
• pp.257-267
• /
• 2003

For the treatment of reactive phenolic resin waste, a simulation model of pervaporative dehydration process has been developed through hollow fiber membrane module. Some of basic parameters were determined directly from dehydration of the waste liquid through a flat sheet membrane to get realistic values. The simulation model was verified by comparing the simulated values with experimental data obtained from hollow fiber membrane module. Hollow fiber membranes with active layer coated on inside fiber were used, and feed flew through inside hollow fiber. Feed flow rate affected membrane performances and reaction by providing a corresponding temperature distribution of feed along with fiber length. Feed temperature is also a crucial factor to determine dehydration and reaction behavior by two competing ways; increasing temperature increases permeation rate as well as water formation rate. Once the permeate pressure is well below the saturated vapor pressure of feed, permeate pressure had a slightly negative effect on permeation performance by slightly reducing driving force. As the pressure approached the vapor pressure of feed, dehydration performances declined considerably due to the activity ratio of feed and permeate.

• Korean Business Review
• /
• v.11
• /
• pp.241-253
• /
• 1998

One form of the anomalies of stock price changes as reaction to earnings information is believed to be caused by the so-called earnings fixation, which is the overreaction of stock prices to earnings. According to the Sloan (1996) study, stock price changes are positively associated with earnings at the time of earnings releases, but the association becomes negative after that, as the early overreaction is corrected. However, the problem in his study is to use cash flows computed by adjusting earnings with appropriate income statement and balance sheet items. As Bahnson et al. (1996) show, these cash flows substantially deviate from SFAS No. 95 cash flows and the sample used in this study is found to be subject to this substantial measurement error. Therefore, the result of Sloan might be driven by this error and the reexamination of earnings fixation is warranted. The results are generally consistent with those in Sloan. First, earnings is positively associated with stock price changes at the time of earnings releases, but the association becomes negative after that. Second, cash flows show a weak association with stock price changes at the time of earnings releases, but the association become stronger thereafter. Third, when seperated from cash flows, accruals have an incremental explanation about stock price changes beyond that of cash flows, accruals have a negative association later on. This finding is consistent with stock price overreaction to accruals, even when more cleaner cash flow data are used.

• Pediatric Infection and Vaccine
• /
• v.12 no.2
• /
• pp.124-134
• /
• 2005

Purpose : It has been known that the diagnostic confirmation of group A streptococcal pharyngitis is accompanied with the results of throat culture and/or rapid antigen detection test(RADT). This study was designed to evaluate the usefulness and cost benefits of the RADT in patients with a sore throat compared the empirical antibiotic treated group without using RADT or throat culture with the antibiotic treated group according to the results of RADT test and/or throat culture. Methods : From April 2003 to August 2003, total 369 patients were enrolled this study. They were redistributed into two groups. In one group, the RADT test and throat culture were used and the patients received antibiotic treatment according to the results of test and in the other group, no diagnostic examinations were used and the patients were treated with antibiotics which were chosen empirically. The flow sheet with questionnaire was drawing up and obtained the clinical symptoms, signs and the name of antibiotics that were administered. Results : A total of 244 patients were treated after the throat culture and/or RADT, and 125 patients were treated empirically. The prevalence of bacteriologically confirmed group A streptococcal pharyngitis was 20.1%. The sensitivity and specificity of RADT were 89.8% and 86.1%, respectively. Positive predictive value and negative predictive value were 62.0% and 97.1%, respectively. The rate of antibiotic use was high in both groups. Because the physician used the antibiotics even if the result of RADT was negative. So about 37% of reduction of antibiotics use might be possible if we used antibiotics according to the results of RADT. There were no cost differences between the RADT applied group and the empirically treated antibiotic group if we could reduce the price of RADT to 63% of the current price. Conclusion : The RADT could be applied for the easy and rapid diagnosis and prompt treatment for group A streptococcal pharyngitis, and RADT could reduced the number of antibiotics used if the price of RADT was reduced to 63% of current price. For accurate evaluation of efficacy and cost effect, further controlled study is needed.