• Journal of Wetlands Research
• /
• v.11 no.3
• /
• pp.37-47
• /
• 2009

This research was conducted at the constructed wetland in Goheung reclaimed land, and water quality components were measured at the 12 points in 15 March 2008 and 10 January 2009, respectively. Temperature, pH, DO, EC and salinity components were measured at the field, and TOC, Cl-, COD, TSS, T-P and TN components were analyzed laboratory. Concentrations of field measured components at inflow points were higher than in constructed wetland. TOC concentration ratio of inflow water to constructed wetland water was higher in January, and Cl concentration ratio of it was higher in March. And, COD concentration ratio of it were 1.37 for March and 1.49 for January, respectively. T-P and T-N concentration ratios of it at inflow points were higher 3 times than in constructed wetland. Constructed wetland attenuated concentration of contaminated components inflow to it. Removal efficiencies of Cl-, T-P and T-N components in inflow water were high at the constructed wetland. removal efficiencies of Cl component were 83% for 1st monitoring and 76% for 2nd monitoring, this removal efficiency be caused by dilution effect of constructed wetland. removal efficiencies of T-P component were 67% for 1st monitoring and 69% for 2nd monitoring, and they of T-N component were 100% for 1st monitoring and 95% for 2nd monitoring. Abnormal removal efficiency of T-N component is caused that nitrogen in inflow water was a little. Removal efficiency of T-P component was higher in January, and T-N component was higher in March. This is caused by environmental difference between growing season and winter.

• Resources Recycling
• /
• v.23 no.2
• /
• pp.37-45
• /
• 2014

Solvent extraction experiments have been performed to separate Nd and Pr from chloride leaching solution of monazite sand using single Cyanex272 and mixed extractants as PC88A+Cyanex272 and PC88A+TBP. For this purpose, the effect of the concentration of extractants on the extraction and separation of the two metals were studied by varying the pH of aqueous solution. In the experimental ranges conducted in this study, the distribution coefficients of Nd were higher than those of Pr. In Cyanex272 system, our results indicated that concentration of extractant and initial pH did not affect distribution coefficients, but separation factor was increased with increasing initial pH. In binary extractant system, distribution coefficients were lower than those of single PC88A system, whereas separation factor was similar in both mixed and single extractant system.

• Resources Recycling
• /
• v.22 no.5
• /
• pp.35-42
• /
• 2013

Solvent extraction experiments have been performed to investigate an optimum condition to separate Nd and Pr from chloride solutions using PC88A and D2EHPA. In our experimental ranges, the distribution coefficients of Nd were higher than those of Pr. In both of PC88A and D2EHPA extractant system, our results indicated that the increase in concentration ratio of extractant to metal had a great effect on the extraction and separation of the two metals. In extraction with saponified D2EHPA, the initial pH of the aqueous solution and saponification degree had some effect on the extraction of the two metals but little effect on the separation factor.

• Korean Chemical Engineering Research
• /
• v.47 no.4
• /
• pp.465-469
• /
• 2009

Characteristics of oxidation reaction of four lanthanide chlorides(Ce, Nd, Pr and $EuCl_3$) in a oxygen-eutectic(LiCl-KCl) salt bubble column was investigated. From the results obtained from the thermochemical calculations by HSC chemistry software, the most stable lanthanide compounds in the oxygen-used rare earth chlorides system were oxychlorides(EuOCl, NdOCl, PrOCl) and oxides($CeO_2$, $PrO_2$), which coincide well with results of the Gibbs free energy of the reaction. In this study, similar to the thermochemical results, regardless of the sparging time and molten salt temperature, oxychlorides for Eu, Nd and Pr and oxides for Ce and Pr were formed as a precipitant by a reaction with oxygen. The structure of the rare earth precipitates was divided into two shapes : small cubic(oxide) and large tetragonal (oxychloride) structures. The conversion efficiencies of the lanthanide elements to their molten salt-insoluble precipitates(or compound) were increased with the sparging time and temperature, and Ce showed the best reactivity. In the conditions of $650^{\circ}C$ of the molten salt temperature and 420 min of the sparging time, the conversion efficiencies were over 99% for all the investigated lanthanide chlorides.

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2018.05a
• /
• pp.53-54
• /
• 2018

U/RE was electrochemically recovered to LCC at $50mA/cm^2$ from LiCl-KCl salt containing $0.5wt%UCl_3$, $0.22wt%NdCl_3$, 0.15wt%$CeCl_3$ and $0.07wt%LaCl_3$. The Cd in the LCC deposit was removed during the distillation using Cd distiller. U/RE product of 107g obtained from the distiller was installed to TG and then heated to $1200^{\circ}C$ to be consolidated. Dense U/RE metal ingot was not acquired through the consolidation process because U/RE product had been partially already oxidized during the distillation process.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 1999.10a
• /
• pp.56-56
• /
• 1999

For advanced TFT-LCD manufacturing processes, dry etching of thin-film layers(a-Si, $SiN_x$, SID & gate electrodes, ITO etc.) is increasingly preferred instead of conventional wet etching processes. To dry etch Al gate electrode which is advantageous for reducing propagation delay time of scan signals, high etch rate, slope angle control, and etch uniformity are required. For the Al gate electrode, some metals such as Ti and Nd are added in Al to prevent hillocks during post-annealing processes in addition to gaining low-resistivity($<10u{\Omega}{\cdot}cm$), high performance to heat tolerance and corrosion tolerance of Al thin films. In the case of AI-Nd alloy films, however, low etch rate and poor selectivity over photoresist are remained as a problem. In this study, to enhance the etch rates together with etch uniformity of AI-Nd alloys, magnetized inductively coupled plasma(MICP) have been used instead of conventional ICP and the effects of various magnets and processes conditions have been studied. MICP was consisted of fourteen pairs of permanent magnets arranged along the inside of chamber wall and also a Helmholtz type axial electromagnets was located outside the chamber. Gas combinations of $Cl_2,{\;}BCl_3$, and HBr were used with pressures between 5mTorr and 30mTorr, rf-bias voltages from -50Vto -200V, and inductive powers from 400W to 800W. In the case of $Cl_2/BCl_3$ plasma chemistry, the etch rate of AI-Nd films and etch selectivity over photoresist increased with $BCl_3$ rich etch chemistries for both with and without the magnets. The highest etch rate of $1,000{\AA}/min$, however, could be obtained with the magnets(both the multi-dipole magnets and the electromagnets). Under an optimized electromagnetic strength, etch uniformity of less than 5% also could be obtained under the above conditions.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.18 no.3
• /
• pp.337-346
• /
• 2020

Two commonly used ceramics in molten salt research are alumina and mullite. The two ceramics were exposed to a combination of rare earth chlorides (YCl₃, SmCl₃, NdCl₃, PrCl₃, and CeCl₃; each rare earth chloride of 1.8 weight percent) in LiCl-KCl at 773 K for approximately 13 days. Scanning electron microscopy with wave dispersion spectra was utilized to investigate a formation layer or deposition of rare earths onto the ceramic. Only the major constituents of the ceramics (Al, Si, and O₂) were observed during the wave dispersion spectra. X-ray fluorescence was used as well to determine concentration changes in the molten salt as a function of ceramic exposure time. This study shows no evidence of ionic exchange or layer formation between the ceramics and molten chloride salt mixture. There are signs of surface tension effects of molten salt moving out of the tantalum crucible into secondary containment.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.18 no.3
• /
• pp.415-420
• /
• 2020

Strontium is known as a salt-soluble element during the electrolytic oxide reduction (EOR) process. The chemical behavior of SrO during EOR was investigated via thermodynamic calculations to provide quantitative data on the chemical status of Sr. To achieve this, thermodynamic calculations were conducted using HSC chemistry software for various EOR conditions. It was revealed that SrO reacts with LiCl salt to produce SrCl₂, even in the presence of Li₂O, and that the ratio of SrCl₂ depends on the initial concentration of Li₂O dissolved in LiCl. It was found that SrO reacts with Li to produce Sr during EOR and that the reduced Sr reacts with LiCl salt to produce SrCl₂. As a result, the proportions of metallic forms were lower in Sr than in La and Nd under various EOR conditions. The thermodynamic calculations indicated that the three chemical forms of SrO, SrCl₂, and Sr co-exist in the EOR system under an equilibrium with Li, Li₂O, and LiCl.

• Korean Journal of Environmental Agriculture
• /
• v.19 no.2
• /
• pp.166-170
• /
• 2000

This study was conducted in to elucidate the changes of growth characteristics and photosynthesis in three soybean (Glycine max L. cv. Danwonkong, Hwangkeumkong and Kwangankong) 30 day old seedlings to 100mM NaCl concentration containing 1/2 Hoagland's nutrient solution in sand culture. The main stem height and number of main stem node were decreased. thus, leaf area and dry matter were decreased with 100mM NaCl. Growth reduction was less little in Hwangkeumkong than other cultivars. The stem growth rate was affected less than other parts as root or leaf, by NaCl treatment. The specific leaf area (SLA), shoot : root ratio and leaf : root ratio decreased with NaCl solution except for those of Hwangkeumkong. There is no general tendency in leaf thickness by leaf position of three cultivars. The chlorophyll content (SPAD) of the primary and 2nd leaf slightly decreased under NaCl solution but rapidly increased in non-NaCl solution at 15 days after treatments. The photosynthesis, stomatal conductance and transpiration of 2nd leaf positions reduced by NaCl and there were a sigificant correlation between photosynthesis and stomatal conductance or transpiration.

• Bulletin of the Korean Chemical Society
• /
• v.28 no.11
• /
• pp.2003-2008
• /
• 2007

The aminolysis of diphenyl thiophosphinic chloride (2) with substituted anilines in acetonitrile at 55.0 oC is investigated kinetically. Kinetic results yield large Hammett ρX (ρnuc = ?3.97) and Bronsted βX (βnuc = 1.40) values. A concerted mechanism involving a partial frontside nucleophilic attack through a hydrogen-bonded, four-center type transition state is proposed on the basis of the primary normal kinetic isotope effects (kH/kD = 1.0-1.1) with deuterated aniline (XC6H4ND2) nucleophiles. The natural bond order charges on P and the degrees of distortion of 42 compounds: chlorophosphates [(R1O)(R2O)P(=O)Cl], chlorothiophosphates [(R1O)(R2O)P(=S)Cl], phosphonochloridates [(R1O)R2P(=O)Cl], phosphonochlorothioates [(R1O)R2P(=S)Cl], chlorophosphinates [R1R2P(=O)Cl], and chlorothiophosphinates [R1R2P(=S)Cl] are calculated at the B3LYP/ 6-311+G(d,p) level in the gas phase.