• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.50 no.5
• /
• pp.325-331
• /
• 2005

Seedlings of two rice genotyopes, cvs. Ilpumbyeo and Gancheokbyeo, were exposed to 0, 50 and 100 mM NaCl in nutrient solution for nine days. Plants were collected at the interval of 3 days and organic and inorganic solutes in leaves and roots and antioxidative enzyme activity in leaves were determined. Under salinity, the accumulation of soluble sugars occurred considerably in the older leaves of stressed seedlings compared to younger leaves and roots. The endogenous Na+ contents markedly increased at higher NaCl concentration in leaves and roots of seedlings, though it was higher accumulated in roots. Salinity resulted in an excessive proline accumulation in the stressed plants. A more pronounced increase was observed in Gancheokbyeo leaves. SOD activity in Impumbyeo cannot found any remarkable change, whereas, in Gancheokbyeo, its activity was rapidly decreased. CAT and POD activities increased with an increase in NaCl concentration in both genotypes. In sum­mary, the high capacity of rice seedlings to overcome an unfavorable growth condition such salt stress appears to be related to an adequate partition of organic solutes between shoots and roots and to changes in absorption, transport and re-translocation of salts.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.17 no.6
• /
• pp.1404-1411
• /
• 1993

This study was undertaken to investigate the corrosive wear charateristics upon various transformation condition of austempered low-alloy ductile cast iron in corrosive environments against mating specimen made of the hardened SM45C. The corrosive wear test was carried out by rubbing the annular surface of two test pieces in distilled water and aqueous solution at constant sliding speed of 0.5m/s. In severe wear region, the corrosive wear rate Wc increased hastily with NaCl concentration owing to intermetallic adhesion but Wc went down slowly in mild wear region due to lubricating effect of the corrosion product. The critical sliding distance decreased with increasing NaCl concentration due to increased generation rate of the corrosion product and the specific corrosive wear rate has maximum in 1% NaCl aqueous solution at mild wear region. With the variation of matrix, the corrosive wear resistance of the fine acicular bainite was higher than that of coarse upper bainite because of reducing the local cell reaction by carbides. A growth in volume fraction of retained austenite in matrix increased the Wc due to soften surface, but has a declining tendency of Wc in mild wear region.

• KSBB Journal
• /
• v.13 no.6
• /
• pp.693-699
• /
• 1998

The relationship between bioluminescence of immobilized Photobacterium phosphoreum and toxic substances was investigated to monitor toxic substances in aqueous solution. The sodium alginate was used as an immobilization matrix. A bioluminescence intensity was maximum when OD660 for cell concentration were between 1.0 and 1.2 and the biolumescence was stable at the pH range of between 6.0 and 8.0. The optimum concentration of alginate for immobilization was found to be 5.0%(w/v) in which dilution was carried out with 2.5%(w/v) NaCl solution that is an optimum environmental condition for the growth of P. phosphoreum. The bioluminescence intensity responded against the toxic substances was proportional to the concentration and a regression curve were established with linearity by using specific bioluminescence reduction rate and Gamma values. It was also found that the response was very rapid and sensitive. The response with such rapidity and sensitivity is a very important factor for the real time monitoring. The immobilized cells showed higher sensitive response to the toxic substances than free cells.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.35 no.1
• /
• pp.109-114
• /
• 2006

For the purpose of oligosaccharide production from alginate, the main component in cell walls of brown algae, the alginate degrading bacteria have been screened from the seaweeds and soil. Among the isolated 69 strains, one strain showing the highest degrading activity was selected and identified as Bacillus licheniformis strain. The adequate sodium alginate concentration for growing the Bacillus licheniformis was $2.0\%$. The effective nitrogen source is nutrient broth $(0.1\%)$, and optimum initial pH, NaCl concentration, temperature and incubation time to produce the alginate degrading enzyme were 7.5, $2\%,\;30{\pm}2^{\circ}C$, and 144 hrs, respectively.

• Membrane and Water Treatment
• /
• v.13 no.4
• /
• pp.191-199
• /
• 2022

In industrial production, the development of traditional polyamide nanofiltration (NF) membrane was limited due to its poor oxidation resistance, complex preparation process and high cost. In this study, a composite NF membrane with high flux, high separation performance, high oxidation resistance and simple process preparation was prepared by the method of dilute solution dip coating. And the sulfonated polysulfone was used for dip coating. The results indicated that the concentration of glycerin, the pore size of the based membrane, the composition of the coating solution, and the post-treatment process had important effects on the structure and performance of the composite NF membrane. The composite NF membrane prepared without glycerol protecting based membrane had a low flux, when the concentration of glycerin increased from 5% to 15%, the pure water flux of the composite NF membrane increased from 46.4 LMH to 108.2 LMH, and the salt rejection rate did not change much. By optimizing the coating system, the rejection rate of Na₂SO₄ and PEG1000 was higher than 90%, the pure water flux was higher than 40 LMH (60psi), and it can withstand 20,000 ppm.h NaClO solution cleaning. When the post treatment processes was adjusted, the salt rejection rate of NaCl solution (250 ppm) reached 45.5%, and the flux reached 62.2 LMH.

• The Journal of the Korean Society for Microbiology
• /
• v.22 no.2
• /
• pp.109-116
• /
• 1987

As a process to establish an effective preventive measure of V. vulnificus septicemia, bactericidal effect of distilled water against V. vulnificus was studied. When about $2.0{\times}10^7\;CFU/ml$ of V. vulnificus was inoculated in distilled water, a dramatic decrease in the number of viable bacteria by 5 to $6LOG_{10}$ was observed in 5 minutes. Bactericidal kinetic curves could be divided into the first rapid killing phase until 1 minute and the later slow killing phase after then, showing the heterogeneity of the bacterial population inoculated. When V. vulnificus was inoculated in saline solutions having various salinities, significant decrease in the number of viable bacteria was noted only at salinities under 0.2%. The higher was the concentration of NaCl, the greater was the degree of protection against osmotic shock. When glucose, NaCl, $MgCl_2$, and $CaCl_2$ were diluted with deionized water to give same osmolarities and V. vulnificus was inoculated in each of them to compare the bactericidal curves plotted during the first 5 minutes after inoculation, the protection efficiencies were in the order of $MgCl_2>CaCl_2{\gg}NaCl{\gg}glucose$. Above results indicate that treatment(or thorough washing) of contaminated sea animals or other products with distilled water can be used as a preventive measure of V. vulnificus septicemia, and divalent cations can protect V. vulnifcus to osmotic shock with high efficiency.

• Journal of environmental and Sanitary engineering
• /
• v.6 no.1
• /
• pp.47-62
• /
• 1991

Yellow Sand Phenomena was observed from April 8 th to 10 th in 1990. During this period particle was collected to investigate the chacteristics of chemical composition of particulate by High Volume Air Sampler and Andersen Air Sa~npler in Seoul. During this period the particle concentration was 350 yg/$m^3$ and the anions, cations, and metal concentrations were increased and the orders of these were $S0_4\;^{-2}>N0_3\;^->Cl^->F^-, Na^+>Ca^{+2}>NH_4\;^+>Mg^{2+}>K^+$, and Fe>Al>Si>Zn>Pb respectively. The principal source of Yellow Sand were identified soil and sea salt. Mn used by the trace element of soil, the persentage of contribution from soil was calculated to be about 81.3% for the particle increased by Yellow Sand Phenomena. Also the principal chemical compounds of particle were estimate metals(Fe, Al, Si, Zn) oxides, $CaSO_4, NaSO_4, MgSO_4, NaC1, MgCl_2$ and $(NH_4)_2SO_4$.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1323-1326
• /
• 2005

The photoluminescence, electroluminescence and surface properties of ZnS:Cu,Cl phosphor coated by sol-gel process were studies. Na-silicate was used as precursor coating material. pH of solution and the concentration of Na-silicate are the important conditions to obtain the uniform coating on the phosphors. Also, the electroluminescent devices were made with Na-silicate coated phosphor. The spectroscopic characterization is performed by photospectrometer.

• Journal of Korean Society of Water and Wastewater
• /
• v.30 no.3
• /
• pp.263-270
• /
• 2016

Recent Engineered nanoparticles were increasingly exposed to environmental system with the wide application and production of nanomaterials, concerns are increasing about their environmental risk to soil and groundwater system. In order to assess the transport behavior of silver nanoparticles (AgNPs), a saturated packed column experiments were examined. Inductively coupled plasma-mass spectrometry and a DLS detector was used for concentration and size measurement of AgNPs. The column experiment results showed that solution chemistry had a considerable temporal deposition of AgNPs on the porous media of solid glass beads. In column experiment, comparable mobility improvement of AgNPs were observed by changing solution chemistry conditions from salts (in both NaCl and $CaCl_2$ solutions) to DI conditions, but in much lower ionic strength (IS) with $CaCl_2$. Additionally, the fitted parameters with two-site kinetic attachment model form the experimental breakthrough curves (BTCs) were associated that the retention rates of the AgNPs aggregates were enhanced with increasing IS under both NaCl and $CaCl_2$ solutions.

• Analytical Science and Technology
• /
• v.10 no.2
• /
• pp.126-130
• /
• 1997

Electrochemical behavior of 1.0mM bis(2,2'-bipyridyl)copper( II )(${Cu(bpy)_2}^{2+}$) in 100mM NaCl+27mM $MgCl_2$ solution with and without sodium dodecyl sulfate(SDS) is investigated. In the presence of SDS, $E_{pa}$ and $E_{1/2}$ of ${Cu(bpy)_2}^{2+/1+}$ shifts to the positive direction compared to the SDS free. Teh intersection of two lines on ${\Delta}E_p$ vs. -log[SDS] plot for 1.0mM $Cu(bpy)_2(NO_3)_2$ in 100mM NaCl+27mM $MgCl_2$ solution is a critical micelle concentration(CMC). Reduced form ${Cu(bpy)_2}^{1+}$ in the presence of $MgCl_2$ is more easily associated to dodecyl sulfate anion($DS^-$) than oxidized ${Cu(bpy)_2}^{2+}$. As the ionic strength is increased by the addition of multiply charged cations($MgCl_2$), the double layer becomes more compact and micelle formation is more difficult.