• 한국에너지공학회:학술대회논문집
• /
• 한국에너지공학회 1999년도 춘계 학술발표회 논문집
• /
• pp.89-93
• /
• 1999

Experimental studies are conducted to investigate the flame stability and the thermal/fuel NOx formation characteristics of the low calorific value(LCV) gas fuel. Synthetic LCV fuel gas is produced through mixing carbon monoxide, hydrogen, nitrogen and ammonia on the basis that the thermal input of the syngas fuel into a burner is identical to that of natural gas, and then the syngas mixture is fed to and burnt with air on flat flame burner. Flame behaviors are observed to identify flame instability due to blow-off or flash-back when burning the LCV fuel gas at various equivalence ratio conditions. Measurements of NOx in combustion gas are made for comparing thermal and fuel NOx emissions from the LCV syngas combustion with those of the natural gas one, and for analyzing ammonia to NOx conversion mechanism. In addition, the nitrogen dilution of the LCV syngas is preliminarily attempted as a NOx reduction technique.

• Journal of Advanced Marine Engineering and Technology
• /
• 제31권1호
• /
• pp.44-50
• /
• 2007

Diesel engines have high thermal efficiency, and they have less CO & HC emissions than another engines. while NOx & Soot emissions are very much. compared with exhaust emission standards. However, the limit level is more and more strengthened yearly due to the importance of environmental protection. So, the optimal countermeasures for the reduction of NOx & Soot emissions below limit level are required. Therefore. the author has investigated the effects of emulsified fuel on the characteristics of exhaust emissions. using an four-cycle, four-cylinder and direct injection diesel engine because the using of emulsified fuel among various methods for reducing NOx & Soot emissions is simple in installation low in cost and high in efficiency. The results of investigation according to various operating conditions are as follows : 1) Specific fuel consumption increase maximum 19.8% at low load. but is not affected at full load. 2) In case of emulsion ratio 25%, NOx emission decrease 32% at 75% load. 30% at full load. 3) In case of emulsion ratio 25%, Soot emission decrease 84% at 75% load, 59% at full load.

• 에너지공학
• /
• 제25권1호
• /
• pp.100-107
• /
• 2016

본 연구에서는 예혼합 화염과 비예혼합 화염을 동시에 구현하는 하이브리드 연소시스템에 배기가스 재순환 방법(FI-EGR and FPI-EGR)을 적용하여 공해물질 저감 효과를 확인하였다. 그 결과, 배기가스 재순환을 적용한 경우 상당량의 NOx 배출지수가 감소하는 것을 확인 할 수 있었으며, 추가적으로 배기가스 재순환을 적용한 하이브리드 연소시스템의 배출성능이 동일한 배기가스 재순환율을 가지는 비예혼합 화염의 배출성능보다 우수함을 확인하였다. 특히, 비예혼합 화염과 예혼합 화염의 비율이 50: 50인 하이브리드 연소시스템의 연료 측에 25% 까지 배기가스를 재순환 시킬 경우(FI-EGR), 배기가스 재순환을 적용하지 않은 비예혼합 화염에 비해 NOx 배출지수가 59% 저감되는 것을 확인하였으며, 혼합비율이 70:30인 하이브리드 연소시스템의 예혼합기와 연료측에 15%까지 배기가스를 재순환 시킬 경우(FPI-EGR), 배기가스를 재순환하지 않은 하이브리드 화염에 비해 NOx 배출지수가 48% 저감되는 것을 확인하였다.

• International Journal of Automotive Technology
• /
• 제8권6호
• /
• pp.667-674
• /
• 2007

Various types of NOx storage catalysts for NGV's were designed, manufactured, and tested in this work on a model gas test bench. As in most of other studies on NOx storage catalyst, alkaline earth metal barium(Ba) was used as the NOx adsorbing substance. The barium-based experimental catalysts were designed to contain different amounts of Ba and precious metals at various ratios. Reaction tests were performed to investigate the NOx storage capacity and the NOx conversion efficiency of the experimental catalysts. From the results, it was found that when Ba loading of a catalyst was increased, the quantity of NOx stored in the catalyst increased in the high temperature range over 350. With more Ba deposition, the NOx conversion efficiency as well as its peak value increased in the high temperature range, but decreased in the low temperature range. The best of de-NOx catalyst tested in this study was catalyst B, which was loaded with 42.8 g/L of Ba in addition to Pt, Pd and Rh in the ratio of 7:7:1. In the low temperature range under $450^{\circ}C$, the NOx conversion efficiencies of the catalysts were lower when $CH_4$, instead of either $C_3H_6$ or $C_3H_8$, was used as the reductant.

• 한국분무공학회지
• /
• 제25권4호
• /
• pp.178-187
• /
• 2020

The current emission regulations, US Tier-4 and EU Stage-V, are only able to satisfy the regulations when all currently mass-produced emission reduction technologies such as EGR, DOC, DPF, and SCR are applied. Therefore, in this study, for the application of the Urea-SCR system to non-road diesel engines, the database was established by measuring the NO, NO2 concentration and calculating the NO2/NOx ratio based on the catalyst temperature and exhaust mass flow rate. Also, based on the measured NO2/NOx ratio data, a mathematical model was proposed to predict the NO2/NOx ratio at SCR catalyst, and the suitability of the model was verified through steady-state and transient mode. As a result of comparing the NO2/NOx ratio measured at the DOC outlet under the steady-state condition to two model values separately, the R2 was 0.9811 for the 3D map model and 0.9303 for the mathematical model. And in the case of the NO2/NOx ratio measured at the DPF outlet, the R2 was 0.9797 for the 3D map model and 0.935 for the mathematical model. It was confirmed that the R2 with the model value of the 3D Map of the mathematical model in the transient mode is 0.957, which shows high reliability.

• 청정기술
• /
• 제26권3호
• /
• pp.211-220
• /
• 2020

본 연구는 80 kW급 단일버너 연소로에서 석탄 연소시 초저 NOx 버너 설계인자를 평가하기 위한 실험적 연구이다. 버너 설계 인자인 선회강도, 총 과잉 공기비, 버너 영역 과잉공기비, 1차/2차 산화제 비율, OFA 비율을 변경하여 총 81개 조건을 대상으로 실험을 수행 하였다. 실험 결과, 선회류가 약하면 연소로 출구에서 CO가 증가하고 연소로 내부 온도가 감소하는 것으로 나타났다. 그러나, 선회류가 강하면 NOx가 증가하기 때문에 적절한 선회류 강도를 결정하는 것은 NOx를 줄이는 데 중요한 요소이다. 1차/2차 산화제의 비율 또한 중요한 요소이며, 생성 된 NOx의 양은 산화제의 비율에 따라 달라진다. 2차 산화제의 비율이 증가하면 연소 초기에 NOx 방출량이 증가하고, 측정 된 배출구 NOx가 증가하게 된다. 그러나, 2차 산화제 비율이 감소하면 화염이 길어지고 CO가 증가한다. 본 연구에 사용 된 연소 시스템은 적절한 조건이 만족 될 때 O₂ 6%를 기준으로 최소 NOx가 82 ppm 생성되는 것으로 확인 되었다. 본 실험에서 대상으로 한 버너는 연소용 공기를 석탄을 이송하는 1차공기 외에 2차공기로 하나의 산화제 유동만 사용하는 방식으로서 추후 3차 및 4차공기로 분할하여 화염형태 및 반응을 세밀하게 제어할 경우 추가적인 NOx 감소가 가능할 것으로 예상된다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제23권1호
• /
• pp.25-32
• /
• 1999

This study was carried out to reduce NOx emissions from diesel engine and to investigate the variation of engine performance using the water injection. In this study the water was extracted from the exhaust gas and injected directly into the intake port with the inlet charge. The water condensing system operated as a closed system without any supplementary water supply. The experimental parameters such as the revolution the torque and the water injection rate are varied and the result from this experiment found the significant NOx reduction whereas the smoke emission increases as water/air ratio increases as the cases like the EGR. In spite of increasing the quantity of the water injection the engine output was slightly decreased and the specific fuel consumption was increased as was anticipated. Especially the system was founded to be effective on the reduction of the NOx emissions at the high load region relatively.

• 한국자동차공학회논문집
• /
• 제10권4호
• /
• pp.43-50
• /
• 2002

In the present study, reduction of harmful exhaust gas in a diesel engine using stratified injection system of dual fuel (diesel fuel and methanol) was tried. The nozzle and fuel injection pump of conventional injection system were remodeled to inject dual fuel in order from the same injector. The quantity of each fuel was controlled by micrometers, which were mounted at rack of injection pumps. The injection ratio of dual fuel was certificated by volumetric ratio in injection quantity test. Cylinder pressure and exhaust gas were measured and analyzed under various supply condition of duel fuel. We confirmed that combustion of dual fuel was performed successful1y by using modified injection system in a D.I. diesel. Soot and NOx are simultaneously reduced by stratified injection without large deterioration of thermal efficiency, but THC and CO are relatively increased.

• 한국해양공학회지
• /
• 제13권3B호
• /
• pp.22-28
• /
• 1999

The purpose of this study is to investigate the NOx emission of turbulent diffusion flame formed in the after burner, which is located on the waste gas coming out from the test furnace. Three types of flame was tested and each of which was changed by adequate equivalence ratio. It is necessary to study more about NOx reduction effect in the after burner system.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2010년 춘계학술대회논문집
• /
• pp.368-375
• /
• 2010

To alleviate NOx emission, a variety of approaches has been applied. In marine diesels, the application of SCR systems has been considered an effective exhaust aftertreatment method for NOx emission control. Most current SCR systems use a various catalyst for the reaction of ammonia with NOx to form nitrogen and water. In theory, it is possible to achieve 100% NOx if the NH3-to-NOx ratio is 1:1. However, the reaction has a limited non-uniformity of the exhaust gas flow and ammonia concentration distribution. Therefore it is necessary to investigate the optimum flow conditions. In order to achieve uniform flow at monolith front face, we are equipped with a various mixed device. In this paper, it is presented that the mixed devices play an important role improvement of flow patterns and particle distributions of NH3 by numerical simulation.