• 에너지공학
• /
• 제23권2호
• /
• pp.170-174
• /
• 2014

This paper presents the influences of ethanol addition to gasoline on bench test a spark ignition engine performances and emissions characteristics. The use of ethanol gasoline blended fuels decrease the brake power and brake torque, and increases the brake specific fuel consumption (BSFC). Ethanol gasoline blended fuels show lower brake torque and brake power and higher BSFC than gasoline. When ethanol containing oxygen is blended with gasoline, the combustion of the engine becomes better and therefore CO emission is reduced. HC emissions decrease to some extent as ethanol added to gasoline increase, as the percentage of ethanol in the blends increased, NOx emission was decreased under various engine speeds.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2013년도 제46회 KOSCO SYMPOSIUM 초록집
• /
• pp.37-40
• /
• 2013

Hydrogen-dimethy ether (DME) and hydrogen-diesel compression ignition engine combustion were investigated and compared each other in a single cylinder compression ignition engine. Hydrogen and DME were used as low carbon alternative fuels to reduce green house gases and pollutant. Hydrogen was injected at the intake manifold with an injection pressure of 0.5 MPa at fixed injection timing, $-210^{\circ}CA$ aTDC. DME and diesel were injected directly into the cylinder through the common-rail injection system at injection pressure of 30 MPa. DME and diesel inejction timing was varied to find the optimum CI combustion to reduce CO, HC and NOx emissions. When DME was injected early, CO and HC emissions were high while NOx emission was low. Fuel consumption, heat release rate, and exhaust emissions were measured to analyze each combustion characteristics of each ignition promoter. Fuel consumption was decreased when diesel was used as an ignition promoter. This is due to the lower volatility of diesel which created more stratified charge than DME.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 1999년도 제19회 KOSCO SYMPOSIUM 논문집
• /
• pp.149-154
• /
• 1999

The influences of air staging on NOx emission and burnout of coal flames were investigated using 1MWth combustion test facility. The experiments showed that variation of overall excess air ratio led to a relatively higher NOx emission level for ${\lambda}=1.2.$ When air staging was applied to the combustion air, it was confirmed that a fuel rich primary combustion zone was established and unburned char was burened completely by mixing with the staged air supplied radially around the flame. The NOx emissions were redued by increasing the staged air flow rate, and staging air was suggested to be more than 40% of the total combustion air for the substantial NOx reduction.

• 한국에너지공학회:학술대회논문집
• /
• 한국에너지공학회 1999년도 춘계 학술발표회 논문집
• /
• pp.89-93
• /
• 1999

Experimental studies are conducted to investigate the flame stability and the thermal/fuel NOx formation characteristics of the low calorific value(LCV) gas fuel. Synthetic LCV fuel gas is produced through mixing carbon monoxide, hydrogen, nitrogen and ammonia on the basis that the thermal input of the syngas fuel into a burner is identical to that of natural gas, and then the syngas mixture is fed to and burnt with air on flat flame burner. Flame behaviors are observed to identify flame instability due to blow-off or flash-back when burning the LCV fuel gas at various equivalence ratio conditions. Measurements of NOx in combustion gas are made for comparing thermal and fuel NOx emissions from the LCV syngas combustion with those of the natural gas one, and for analyzing ammonia to NOx conversion mechanism. In addition, the nitrogen dilution of the LCV syngas is preliminarily attempted as a NOx reduction technique.

• 한국대기환경학회지
• /
• 제21권4호
• /
• pp.401-411
• /
• 2005

This study was conducted to develop a method to be able to estimate the vehicular emissions according to spatial scales-Seoul province, 25 counties and hundreds of grids $(1km{\times}1km)$. First, the emissions at each spatial scale was calculated by using the road network and the travel volume and speed of each link modeled by travel demand model (TDM). Second, the emission at each spatial scale was calculated on the basis of average speeds estimated by using three kinds of averaging method. These are called the provincial, volume-delay function (VDF) and zonal method, respectively. Third, three kinds of emissions and those by TDM are compared each other at three spatial scales. In Seoul (provincial scale), three kinds of emissions are less than those by TDM, but the differences of TDM from three speed averaging methods (SAMs) are small. The relative ratios of three SAMs to TDM are $88\~90\%\;in\;CO,\;99\~100\%\;in\;NOx,\;84\~85\%$ in VOCs. At county scale, NOx among three pollutants showed the highest correlation between TDM and three SAMs and the zonal method among three SAMs was proven to be the highest correlation with TDM. NOx showed the coefficients $(R^2)$ greater than 0.9 in all three SAMs but CO and VOC showed the coefficients $(R^2)$ greater than 0.9 in only zonal method. Slopes of co..elations of all pollutants showed the values close to '1' in zonal method. In the other two SAMs, slopes of NOx showed the values close to '1', but those of CO and VOC showed the values less than 0.85. At grid scale, correlations between TDM and three SAMs were not high. CO showed $0.68\~0.77\;in\;R^2s\;and\;58\~0.68$ in slopes. NOx showed $0.90\~0.94\;in\;R^2s\;and\;0.86\~0.94$ in slopes. VOC showed $0.56\~0.70\;in\;R^2s\;and\;0.48\~0.57$ in slopes. There are not high correlations between TDM and three SAMs in grid scale. This study showed that there is the most suitable method for calculating the average travel speed at each spatial scale and it is thought that the zonal method is more suitable than the VDF or provincial method.

• 대한기계학회논문집B
• /
• 제36권2호
• /
• pp.225-232
• /
• 2012

희박 예혼합 가스터빈 연소기에서 배출되는 NOx, CO 와 같은 오염물질을 예측하기 위해서 화학반응기 네트워크 모델을 개발했다. 본 연구에서는 CHEMKIN 코드와 4 가지 NO 생성 메커니즘을 포함한 GRI 3.0 메탄-공기 연소 메커니즘을 이용해서 가스터빈의 부하조건을 변화시키며 NOx 및 CO 배출의 예측을 수행하였다. 모델의 검증을 위해서 계산된 결과를 모사연소기의 실험 데이터와 비교하였다. 여러부하조건에 따른 4 가지 NO 경로의 기여도를 조사하였다. 또한 인젝터의 질량유동 및 당량비의 불균일성이 NOx 배출이 끼치는 영향을 고찰하고 10ppm 이하의 저 NOx 연소기 개발을 위한 저감 방법을 제안했다.

• 한국가스학회지
• /
• 제24권4호
• /
• pp.25-31
• /
• 2020

산업용 혹은 발전용 가스터빈에 사용되는 이중 콘형 예혼합 연소기의 연소 특성을 이해하기 위하여 실험적 연구를 수행하였다. 노즐의 여러 연료 분사 방식에 대하여 NOx와 CO의 배출 특성, 화염 안정성 및 연소실 온도 분포에 대한 연소특성을 비교하였다. 주 연구 결과로는 연료홀 개수가 동일하고 연료 홀 직경이 감소하는 경우와 연료 홀면적이 동일하고 연료 홀 수가 감소되는 경우 연료의 연소용 공기층 침투가 커지기 때문에 NOx의 배출은 감소하지만 화염 안정성은 감소하게 된다. 그리고 동일 연료 홀 면적을 이용하는 분사방식에 있어서 연료 홀을 교차 변경하는 경우 연료의 평균 침투거리 증가로 NOx의 배출이 감소되며 연료 침투거리가 적은 연료가 화염을 안정화시키는 역할을 한다.

• Journal of Korean Society for Atmospheric Environment
• /
• 제11권E호
• /
• pp.31-43
• /
• 1995

Natural emissions of NOx from soils were measured at an agricultural corn field during 3 weeks of growing season in summer (from May to June) 1995. This experiment was conducted in an effort to characterize the role of soil NOx on tropospheric ozone formation in rural atmosphere, and understand the natural NOx emission mechanism with respect to soil parameters. NO fluxes were ranged from 3.1 ng Nm$^{-2}s^{-1}$ to 259.0 ng Nm$^{-2}s^{-1}$, and average NO flux during experimental period was found to be 47.6 $\pm$ 50.6 ng Nm$^{-2}s^{-1}$ with 732 number of data. Diurnal variation of NO flux was shown clearly with daytime maximum and nighttime minimum. NO fluxes were correlated with soil temperature. Exponential soil temperature dependency of NO fluxes was found with 0.0160$^{circ}C^{-1} of k and r^2=0.508$, which agrees well to the value estimated at corn fields in eastern United States. The significant increases of NO fluxes from agricultural soil were detected after applying N fertilizers to soil. THe mechanisms attributed to this are enhanced biological nitrification and denitrification. In the view of rural ozone formation, the roles of natural NO emissions are very essential, especially in NOx - limited region such as southern United States.

• 대한기계학회논문집
• /
• 제16권1호
• /
• pp.180-188
• /
• 1992

본 연구에서는 와류실식 디젤 기관에 경유-물의 유화연료 사용시 시관의 회전 속도(1500rpm)가 일정인 경우 물의 첨가량(체적비, 0~20%)과 기관의 부하(BMEP,2.1~ 7.5kg/$\textrm{cm}^2$)변화에 따른 연소실내 압력, 압력상승률 및 열발생률, 착화지연 기간, 연료 소비율 등의 연소특성과 CO, HC, NOx 및 매연의 배출능도 등 유해 배출 가스에 미치는 영향에 관하여 실험적으로 구한 것이다.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2002년도 제24회 KOSCO SYMPOSIUM 논문집
• /
• pp.185-191
• /
• 2002

The influence of N2 addition on soot formation, flame temperature and NOx emissions is investigated experimentally with methane fuel co-flow diffusion flames. The motivation of the present investigation is the differences in NOx reduction reported between fuel-side and oxidizer-side introduction of N2. To determine the influence of dilution alone, fuel was diluted with nitrogen while keeping the adiabatic flame temperature fixed by changing the temperature of the reactants. And to see the thermal effect only, air was supplied at different temperature without N2 addition. N2 addition into fuel side suppressed the soot formation than the case of oxidizer-side, while flame temperature enhanced the soot formation almost linearly. These results reveals the relative influences of the thermal, concentration effects of N2 additives on soot formation In accordance with experimental study, numerical simulation using CHEMKIN code was carried out to compare the temperature results with those acquired by CARS measurement, and we could find that there is good agreement between those results. Emission test revealed that NOx emissions were affected by not only flame temperature but also N2 addition.