• Proceedings of the KIEE Conference
• /
• 1993.11a
• /
• pp.103-105
• /
• 1993

This paper proposed a new direct vector control scheme using high frequency current injection. This scheme has some attractive features such as using no flux sensor or speed sensor, robustness of parameter variation, capability of accurate vector control at very low speed. Compared to other direct vector control scheme, this scheme doesn't depends on phase delay and difference of magnitude of estimated flux, rotor resistance and all inductances except stator resistance. These features are proved by computer simulation and experimental results.

• Journal of computational fluids engineering
• /
• v.15 no.4
• /
• pp.76-84
• /
• 2010

In order to analyze the periodic unsteady flow problem efficiently the partially implicit harmonic balance (PIHB) method was developed. Contrary to the existing harmonic balance method, this method handles the harmonic source term explicitly and deals with flux terms implicitly. This method has a good convergence in comparison with the full explicit harmonic method and it is easy to apply this method because there is no need to calculate the complicated flux Jacobian term by comparing with the full implicit harmonic method. With the multigrid method about the each harmonic it turns out that this method has a good convergence regardless of the number of harmonics. The oscillating flows over NACA0012 airfoil is considered to verify this method then the result correponsed to both the result of dual time stepping and explicit Runge-Kutta method.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.24 no.4
• /
• pp.519-525
• /
• 2000

The effect of nozzle diameter on the local Nusselt number distributions has been investigated for an axisymmetric turbulent jet impinging on the flat plate surface. The flow at the nozzle exit has a fully developed velocity profile. A uniform heat flux boundary condition at the plate surface was created using gold film Intrex. Liquid Crystal was used to measure the plate surface temperature. The experiments were made for the jet Reynolds number (Re) 23,000, the dimensionless nozzle to surface distance (L/d) from 2 to 14, and the nozzle diameter (d) from 1.36 to 3.40 cm. The results show that the Nusselt number at and near the stagnation point increase with an increasing value of the nozzle diameter.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05b
• /
• pp.586-591
• /
• 1996

Through the analysis of many experimental post-dryout data, it is shown that the most probable flow regime near dryout or quench front is not annular flow but churn-turbulent flow when the mass flux is low. A correlation describing the initial droplet size just after the CHF position at low mass flux is suggested through regression analysis. In the post-dryout region at low pressure and low flow, it is found that the suggested one-dimensional mechanistic model is not applicable when the vapor superficial velocity is very low, i.e., when the flow is bubbly or slug flow regime. This is explained by the change of main entrainment mechanism with the change of flow regime. Therefore, the suggested correlation is valid only in the churn-turbulent flow regime ( $j_{g}$ $^{*}$＝0.5~4.5).).

• Proceedings of the KIPE Conference
• /
• 1998.10a
• /
• pp.304-309
• /
• 1998

In this paper, authors introduce an application of a nonlinear rotor flux observer, known under the name of ELO(extended Luenberger Observer), for direct rotor field oriented control(DRFOC) of induction motor. ELO requires no solution of nonlinear partial differential equation for its coordinate transformation and linearization used for the nonlinear observer design. Its simulation results concerned to different level of unknown variables of load torque and rotor resistance show high accuracy on rotor flux estimation in steady state.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.2 s.179
• /
• pp.172-180
• /
• 2006

Although there existed many types of manual/power hybrid wheelchairs, their use was not widespread because of their inconvenience in converting drive system and in folding frames. To carry a wheelchair in the car or to convert driving methods, some hard work of disassembling or exchanging wheels was required for most of currently available hybrid wheelchairs. In this study, the standard foldable manual wheelchair was reformed to a power wheelchair by installing the newly developed Axial Flux Permanent Magnet(AFPM) type of brush less direct current(BLDC) motor on each rear hub of wheelchair. This wheelchair could be driven by manual or electric power without exchanging. wheels, thus no additional work was needed for carriage or for power conversion. The developed wheelchair was evaluated for durability, stability, maneuverability, cost, and reliability in accordance with the Korean standards. The results indicated that the developed hybrid wheelchair was good enough for commercialization comparing to other imported wheelchairs.

• Electrical & Electronic Materials
• /
• v.10 no.8
• /
• pp.807-811
• /
• 1997

In this paper we have investigated the removal characteristics of NOx by pulsed corona discharge with a multi-pointplane electrode where a magnetic field is applied in the discharge region. The efficiency of NOx removal was measured and analyzed as a function of pulse frequency gas flow rate NOx initial concentration magnetic flux density. In this result the highest removal efficiency of NOx was obtained at the following operating conditions; the frequency =400[Hz] gas flow =1[$\ell$/min] initial concentration= 400[ppm] and magnetic flux density=0.36[T].

• Bulletin of the Korean Space Science Society
• /
• 2004.10b
• /
• pp.380-383
• /
• 2004

We study the two storm events of 1997: one in May that was accompanied by a relativistic electron event (REE) and the other in September, with a more profound Dst decrease, but with no significant flux increase of relativistic electrons. We find that a larger amount of seed electrons was present in the May event compared to that of the September storm, whereas the ULF (ultra low frequency) power was more enhanced and the particle spectrum was harder in the September event. Hence, we demonstrate that a larger storm does not necessarily produce more seed electrons and that the amount of seed electrons is an important factor in an actual increase in REE flux levels, while ULF can harden the particle spectra without causing an apparent REE.

• Proceedings of the KIEE Conference
• /
• 2005.04a
• /
• pp.120-122
• /
• 2005

Magnetic field analysis of claw-pole type generator using equivalent circuit is presented in this paper. On the basis of 3D geometry and flux paths, equivalent magnetic circuit is designed and field analysis is performed by solving the circuit. Non-linear characteristic of material is considered for precise analysis results. 3D FEA is performed to verify analysis results, and flux densities in rotor and stator regions are compared. Calculated no-load back emf for field input voltage and speed are verified by experiment. Comparing to 3D FEA, presented method provides precise results with instant calculation time.

• 전기의세계
• /
• v.14 no.1
• /
• pp.35-39
• /
• 1965

Field problems are solved by a variety of methods. In the relatively small number of cases that are simiple enough, the mathematical attack may be the method of choice. But many field problems with irregular boundary condition must be handled by the use of the electrolitic tank analog, conducting paper or the fluid mapper analog for the purpose of effectiveness and convenience. The method of choice depends on the actual of the problems. There is no one best way to solve all problems. The following points have been described in this apepr, 1. Theoretical studies are made of the vector which is produced by leading the fluid flow vector by a right angle. 2. Curvilinear square method is described., 3. Determination on magnetic flux distribution and variation according to the magnitude of exciting currents.