• Resources Recycling
• /
• v.17 no.4
• /
• pp.3-9
• /
• 2008

The total amount of fluidized bed incinerator ash, i.e. incombustion materials generated from the municipal solid waste incineration(MSWI) in Korea was approximately 14,000 tons in 2006. Most of the ash after ferrous metal separation is finally discard to the landfill sites. In the present work, possibility for recycling of the ash is studied to utilize the ash as raw materials for ceramic products. Incombustion materials obtained from the two different incinerators were used to recover the raw materials by applying the magnetic separation and screening process to remove metallic particles. The raw materials show relatively low heavy metals content obtained from the KSLP leaching tests. The ceramic products were prepared by mixing the clay with the various amounts of the raw material. The physical properties, i.e. shrinkage rate, absorbancy and compressive strength of the ceramic products sintered at $1,000^{\circ}C$ and $1,050^{\circ}C$, respectively were improved by increasing the addition amounts of the incinerator ash. Based on the leaching tests the ceramic products also be satisfied with the standard limits on the leachability of heavy metals because most of the metallic materials are effectively removed from the incombustion materials by appling the separation processes.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.20 no.4
• /
• pp.97-105
• /
• 2012

This study examined for possibility of the food wastewater incineration treatment method as one of overland treatment method by incineration through liquefied spray of food wastewater when incinerating domestic wastes under operation and for the relationship, etc of air discharge material discharged in incineration, and the results of study are as follow: The food wastewater as one of overland treatment method was analysed 94-96% of moisture contents. Temperature of incinerator outduct during mixed incineration of food wastewater with MSW was average $897^{\circ}C$ and incineration of only MSW was $925^{\circ}C$. Temperature of the mixed incineration of food wastewater was dropped about $28^{\circ}C$ by incineration of only MSW. Concentration of nitrogen oxides(NOx) among air discharge gases was studied by 50ppm, 46ppm when inputting $200{\ell}/hr$, $300{\ell}/hr$ into the incinerator as the quantity of food wastewater. In the mixed incineration of food wastewater, generation speed of scales in the inside of a tubular exhaust gas boiler became rapid and the scale generation quantity became large but the exhaust gas boiler normally operated since scales were removed in cleaning of the tube with a compressive air cleaning facility and there was no opening clogging phenomena in a filter cloth of the filtering dust collector. The overland treatment method, not ocean dumping of food wastewater can be proposed as a technology since mixed incineration of food wastewater with MSW in the existing domestic waste incineration plant is possible, and operation costs of the incineration facility were reduced since use of chemicals such as ammonia and urinary hydrogen ion excretion, etc used in incineration facilities for removing nitrogen oxides(NOx).

• Journal of the Korea Organic Resources Recycling Association
• /
• v.20 no.1
• /
• pp.31-40
• /
• 2012

In order to making resources for the organic wastes, it is very important to understand for the life cycle of wastes before the physicochemical analysis and engineering technology. Therefore we try to fine the solution through the interdisciplinary consilience between natural science and social science for the management of refuge in summer resort. Summer visitors of beach answered that fly tipping of refuse was 65.56% and insufficient separation was 17.78% about the survey. But insufficient separation was 42.5% and fly tipping was 37.5% in valley. The survey for the effective methods at reducing refuse was represented that campaign and teaching was 47.78%, fine was 23.33% and using the standard bags was 18.89% in beach. Campaign and teaching was 37.5%, using the standard bags was 37.5% and fine was 15% in valley. Bulk density of refuse in gyeongpo beach was measured in $74kg/m^{3}$. This value was three times as much low than municipal solid wastes. Moreover, the composition of refuses in beach showed that combustible materials was 81.1% and incombustible materials was 18.9%. Moisture, ash and combustibles were analyzed 19.0%, 9.2% and 91.8% respectively.

• Journal of the Korean Society of Groundwater Environment
• /
• v.3 no.1
• /
• pp.37-49
• /
• 1996

The objectives of this study are to investigate the groundwater and surface water contamination, to interpret the attenuation mechanism of contaminant transport, and to find the appropriate contamination indicator. at the two big landfill sites : Nanjido Landfill and Hwasung Landfill. Leachate from the Nanjido, th, Hwasung and the Kimpo waste disposal sites is characterized by high temperature (31.7-40.1$^{\circ}C$), high electric conductivity (14,650-32,800 ${\mu}$S/cm), somewhat higher pH(7.58-8.45) and low Eh (-119.4-20.4 mV), and is enriched in both major (Na$^{＋}$, K$^{＋}$, Ca$^{2＋}$, Mg$^{2＋}$, HC $O_3$$^{－}$, Cl$^{－}$) and minor (Mn, Sr$^{2＋}$, Ba$^{2＋}$, Li$^{＋}$, F$^{－}$, Br$^{－}$) ions. Municipal solid waste leachate and industrial waste leachate are effectively discriminated by the content of S $O_4$$^{2－}$, Fe, and heavy metals. The attenuation mechanism of each component was assessed using the chemical analysis. Cl-normalizing process, WATEQ4F simulation, and preceding flownet analysis. Based on the calculation of Contamination Factor, K, Na, Ca, Mg, B, Zn, HC $O_3$, Cl, F, Br and TOC are effective contamination indicators in the Nanjido landfill site, and K, Na, Ca, Mg, B, S $O_4$, HC $O_3$, Cl, F, Br and TOC in the Habsburg landfill site Particularly, TOC is the best contamination indicator in landfill sites influenced by sea water.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.2
• /
• pp.114-118
• /
• 2009

With the advance of industrialization and urbanization, a lot of waste has been discharged and treated by incineration. But fly and bottom ashes are generated in this process. In addition, the treatment method to recycle sewage sludge and melting slag is required to manage these wastes. The objective of this research was to prepare of multi-functional brick which were made from MSWI (Municipal solid wastes incinerator) fly ash, sewage sludge and slag. The bricks were made by mixing raw materials and then drying for 24 hours. Next, they were dried for 24 hours at $160^{\circ}C$ and fired for 2 hours. Calcination temperature was changed to discuss the effect of temperature from $1,080^{\circ}C$ to $1,130^{\circ}C$. Compressive strength of a brick was creased with the increase of temperature. To increase mixing ratio of fly ash and slag reduce the compressive strength the optimal condition was the mixing ratio of fly ash : melting slag : sewage sludge : clay as 10 : 20 : 5 : 65 and $1,150^{\circ}C$ of calcination temperature. Compressive strength was obtained as about 41 MPa at this condition.

• Resources Recycling
• /
• v.22 no.5
• /
• pp.20-28
• /
• 2013

This study was carried out to evaluate the possibility of resource recovery for municipal solid waste(MSW) that sorted by a MBT system. First, physical property of MSW was similar to wastes carried into Sudokown landfill site. However, moisture of MSW was little higher than that. As a result of BMP test using organic fraction of MSW(OFMSWs), approximately 60 ~ 80 mL $CH_4/g$-VS of methane was occurred. Compared to the other studies, the value of methane is lower. It seems to be caused that high ratio of vinyl/plastic in OFMSWs. The other BMP test using sample of MBT system located in Sudokwon landfill was conducted each physical properties. According to the result of experiment, food waste makes 193 mL $CH_4/g$-VS, and paper is 102 mL $CH_4/g$-VS. However, there was not methane production in vinyl and rubber. Additionally, others that can't sort no more show 30 m $CH_4L/g$-VS of methane production. From the result of experimental data OFMSWs has high fraction of vinyl, rubber and other substance that difficult for biodegradation. Therefore it is need to sort of them.

• Resources Recycling
• /
• v.26 no.2
• /
• pp.11-17
• /
• 2017

Many problems are occurred by using industrial by-product and municipal solid waste in the cement manufacturing process. The main components of chlorine by-pass dust generated by the use of the wastes are $K^+$, $Cl^-$, and a slight amount of heavy metals is also contained. In terms of waste recycling, it is necessary to eliminate the heavy metals. Therefore, in this study, the experiments for the removal of heavy metals from KCl which was produced by chlorine by-pass dust were conducted. In order to find optimum conditions for the removal of heavy metals, we have controlled the amount of water and precipitator. The type and concentration of heavy metals in KCl were analyzed. The concentration of heavy metals decreased as amount of precipitator increased. The heavy metals such as Pb, Cd, and As were not detected in dust A and B, when the mixing ratios between dust A(B) and water were controlled to be 1:2 (1:2, 1:3.5) with the addition of 3% precipitator (NaOCl).

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.3
• /
• pp.232-239
• /
• 2009

This research investigated the characteristics of antibiotic resistance of bacteria in microbial communities from municipal wastewater treatment plants (MWTPs), and monitored seasonal changes of antibiotic resistant bacteria (ARB) from MWTPs and Han river. When antibiotics were amended to either R2A agar (R2A) for general heterotrophs or MacConeky sorbitol agar (MSA) for coliform bacteria, all the MWTP samples exhibited multiple antibiotic resistance on the antibiotic-amended solid media. The antibiotic resistance appearing frequencies of ampicillin and sulfathiazole, respectively, were higher than reported data for other countries. The antibiotic resistance appearances differed depending upon the concentrations of primary substrate and nutrients and the types of cultivation media. The following 16S rRNA gene phylogenetic analysis showed that the identified multiple-antibiotic resistant microbes on R2A plates were more likely to be known human-pathogenic bacteria than the background heterotrophic bacteria were, suggesting a high risk of antibiotic resistance appearance to public health. In addition, according to our investigation of seasonal changes of ARB from urban MWTP and river samples, the frequency of ARB appearances was shown to correlate positively with temperature. This indicates a possibility that global warming result in increase in microbial risk to public health.

• Applied Chemistry for Engineering
• /
• v.25 no.1
• /
• pp.103-106
• /
• 2014

Recycling of bottom ash from municipal solid waste (MSW) incinerator has been strictly limited due to its composition of high level chlorine and other unfavorable substances. The composition of MSW has been, however, changed after the introduction of garbage-bag sales system, extended producer responsibility (EPR) policy and the prohibition of direct landfill of food waste. Recent waste shows reduced moisture and chlorine content, increased calorific value due to the separation of food waste, incombustible materials and PVC. The main purpose of this study is to investigate the trend of composition changes of MSW incinerator bottom ash and to compare the analytical results with those before the separation system was introduced. CaO content of bottom ash, one of the major component of cement clinker, increased from 26.7% in 2001 to 34.0% in 2006. The chlorine content showed a dramatic decrease from 1.84% in 2001 to 0.00655% in 2006, which is closely compatible with that of the fly ash of coal-utilizing thermal power plants, which is mainly due to the changes of MSW composition. It is eventually considered that there is a possibility of utilizing the incinerator bottom ash as a raw material of cement clinker feed substances.

• Journal of Climate Change Research
• /
• v.3 no.3
• /
• pp.195-209
• /
• 2012

There are four differentiated levels to quantify the amount of greenhouse gas emissions from a facility, which are Tier 1 to 4 based on the IPCC guidelines. In this study, the emission estimates from all tier levels were calculated to compare their total $CO_2$ emission results among themselves for seven facilities, including three sectors of electricity generation, municipal solid waste incineration, and cement manufacturing for three months between February and May 2011. Generally the measured $CO_2$ emissions by Tier 4 were higher than the calculated $CO_2$ emissions by Tier 3, which had been also observed for the power plants in the USA. It was found out that to obtain more reliable estimation for Tier 3, accurate analysis of the composition of the fuel used should be carried out. It was suggested that further refinement on the administrative guidelines be made to make it more robust.