• Proceedings of the KIEE Conference
• /
• 2006.10c
• /
• pp.482-484
• /
• 2006

This paper describes fast-hopping frequency synthesizers for multi-band OFDM(MB-OFDM) ultra-wide band(UWB) systems. Three different structures in generating 3 center frequencies(3432MHz, 3960MHz, 4488MHz) are designed and compared. The first structure generates 3 center frequencies using only one PLL operating at 4224MHz. The second uses three PLLs operating at corresponding center frequencies. The third employes two PLLs operating at 3960MHz and 528MHz. Simulation results using a 0.18um RF CMOS process parameters show that the third structure exhibit the best characteristics. The band switching time of the proposed synthesizer is less than 1.3ns and the spur is less than -36dBc. The synthesizer consumes 22mA from a 1.8V supply.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.2
• /
• pp.431-434
• /
• 2011

In this paper, bandwidth enhanced design of dielectric resonator antenna fabricated in multi-layer substrate is introduced. The proposed dielectric resonator antenna is operating with fundamental TE101 mode and higher-order TM111 mode. Each resonance frequency is dependent on resonator dimensions. As increasing the height of radiating aperture, the higher-order TM111 mode resonance frequency approach the fundamental TE101 mode resonance frequency and the antenna bandwidth increase by double resonance. Three different aperture height size antennas that operated at 7GHz are fabricated in FR4 multi-layer substrate. Measured 10 dB matching bandwidth is 8 percent for single resonace antenna and 18 percent for double resonance antenna.

• Journal of the Microelectronics and Packaging Society
• /
• v.11 no.1
• /
• pp.13-19
• /
• 2004

This paper demonstrates the detailed study of a microstrip Yagi-Uda antenna with and without PBG structure at wireless LAN(5725∼5825 MHz) frequency band. The impedance bandwidth of the antenna with the PBG holes is greater than (about 30 MHz) that of its counter part without PBG holes. The measured gains of the antenna at the frequency band are 7 dB and 6 dB respectively for antenna with and without PBG. The improvement of gain of about 1 dB is likely due to the suppression of surface wave.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.4
• /
• pp.71-75
• /
• 2008

A folded monopole antenna is proposed for mobile communication applications. The proposed antenna covers CDMA and GSM at low frequency band, and it has a wide bandwidth (6.85 GHz) at high frequency band to cover GPS, DCS, USPCS, UHfS, WLAN (2.4, 5.2, 5.8 GHz), and the future application of IEEE 802.16e mobile WiMAX.

• Journal of Korean Institute of Industrial Engineers
• /
• v.29 no.4
• /
• pp.259-270
• /
• 2003

In order to properly design warning sounds that are affectively suitable to computer users, warning sounds used in Windows operating system were analyzed in terms of their sound properties; frequency band, spectral characteristics and physical intensity. A total of 36 warning sounds (3*4*3) were generated and tested with respect to three experimental variables. Among 178 collected affective adjectives that are related to hearing and sounds, seven representative affective adjectives were abstracted by statistical grouping techniques. In the experiment, subjective preference tests were performed for the 36 warning sounds according to the seven affective factors. From the result, the affective factors were again grouped into three major factors and the 60dB boost-type warning sounds at the low frequency band were, in general, the most preferred. followed by the 70dB cut-type sounds at the middle frequency band. These warning sounds have a characteristic of boost power spectrum below 1000Hz frequency band and received good scores on simplicity, clarity and accurateness.

• Journal of information and communication convergence engineering
• /
• v.8 no.6
• /
• pp.687-689
• /
• 2010

In this paper, the equalization for frequency slope of path loss in Multi-Band(MB) OFDM UWB is proposed. The path loss of a signal is proportionate to the square of the signal's frequency. So, the received signal amplitudes of OFDM subcarrier can be different up to 3dB when MB-OFDM occupies bandwidth over 1.5GHz. The differences of subcarrier-amplitudes make an effective of 0.3 bit reduction of soft decision bits of viterbi decoder, and when the effective of 0.3 bit reduction can cause 0.5dB SNR degradation. This paper proposes two modem architectures which compensate for the degraded subcarrier by multiplying the reciprocal of degraded values in analog or digital domain. It is shown that, for the proposed architecture applied to MB-OFDM UWB, the performance improvements up to 0.5dB can be obtained over the conventional uncompensated receiver architecture.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2009.01a
• /
• pp.254-257
• /
• 2009

In this paper, we propose a learning-based super-resolution algorithm. In the proposed algorithm, a multi-resolution wavelet approach is adopted to perform the synthesis of local high-frequency features. To obtain a high-resolution image, wavelet coefficients of two dominant LH- and HL-bands are estimated based on wavelet frames. In order to prepare more efficient training sets, the proposed algorithm utilizes the LH-band and transposed HL-band. The training sets are then used for the estimation of wavelet coefficients for both LH- and HL-bands. Using the estimated high frequency bands, a high resolution image is reconstructed via the wavelet transform. Experimental results demonstrate that the proposed scheme can synthesize high-quality images.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.7-12
• /
• 2008

In this paper, a highly efficiency power amplifier is presented for multi-band antenna system. The class F power amplifier operating in dual-band designed with one LDMOSFET. An operating frequency of power amplifier is 900 MHz and 2.14 GHz respectively Matching networks and harmonic control circuits of amplifier are designed by using the unit cell of composite right/left-handed(CRLH) transmission line(TL) realized with lumped elements. The CRLH TL can lead to metamaterial transmission line with the dual-band holing capability. The dual-band operation of the CRLH TL is achieved by the frequency offset and the nonlinear phase slope of the CRLH TL for the matching network of the power amplifier. Because the control of all harmonic components for high efficiency is very difficult, we have controled only the second- and third-harmonics to obtain the high efficiency with the CRLH TL. Also, the proposed power amplifier has been realized by using the harmonic control circuit for not only the output matching network, but also the input matching network for better efficiency.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.16 no.3
• /
• pp.97-102
• /
• 2016

The UFMC(Universal Filtered Multi-Carrier) is one of multi-carrier transmission technique as a candidate of transmission method for the recent 5G communication system. The UFMC can be considered as the system which has both the advantages of OFDM(Orthogonal Frequency Division Multiplex) and the simplicity of FBMC(Filter Bank Multi-Carrier). CFO(Carrier Frequency Offset) causes the problem to lower the BER performance due to a mismatch between the sub-carriers in multi-carrier transmission scheme. The effect of CFO on UFMC is not greater than the OFDM. But it still degrades the system performance caused by interference between the sub-band. In this paper, we analyze the SNR degradation due to changes in the value of EsNo and CFO on UFMC system.

• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.51 no.2
• /
• pp.85-91
• /
• 2002

A novel multi-section power divider configuration is Proposed to obtain wide-band frequency performance up to microwave frequency region. Design procedures for the proposed microwave broadband power divider are composed of a Planar multi-section three-Ports hybrid and a waveguide transformer design procedures. The multi∼section power divider is based on design theory of the optimum quarter- wave transformer Furthermore, in order to obtain the broadband isolation performance between the two adjacent output ports, the odd mode equivalent circuit should be matched by using the lossy element such as resistor. The derived design formula for calculating these odd mode∼matching elements is based on the singly terminated filter design theory. The waveguide transformer section is designed to suppress the propagation of the higher order modes such as waveguide modes due to employing the metallic electric wall. Simulation and experiment show excellent performance of multi section power divider.