• The Korean Journal of Physiology
• /
• v.6 no.1
• /
• pp.33-37
• /
• 1972

It was thought desirable to elucidate the influence of the mammillary bodies upon sexual behavior. Twenty male rats were used, of which 9 rats had their mammillary bodies damaged electrolytically through implanted electrodes (mammillary body group) and 11 rats received the same surgery short of electrolytic damage to the mammillary bodies (operated control group). Their sexual behavior was observed 3 weeks after surgery. Observation was discontinued when an ejaculation was followed by a successive intromission. 1. Mounting without intromission occurred significantly less often in the mammillary body group than in the operated control group. 2. No significant group difference existed with regard to the occurrence of mounting with intromission. However, the value tended to rise in the mammillary body group compared with the value of the operated control group. 3. Mountings with and without intromission tended to occure more often in the mammillary body group than in the operated control group, but the difference was nonsignificant. 4. The ejaculatory latency (time interval between the first intromission and the first ejaculation) and the postejaculatory interval (time interval between an ejaculatory act and the next intromission) tended to decrease in the mammillary body group compared with the values of the operated control group. However, again the difference did not reach significancy. 5. There existed no significant group differences with regard to the mounting latency (time interval between the first encounter with female and the first mounting with or without intromission), the intromission latency (time interval between the first encounter and the first intromission), and the interintromission period (mean time interval between two successive intromissions). From the above results, it may be inferred that the mammillary bodies tend to exert slight and nonsignificant inhibitory influence upon sexual behavior of male rats. However, further study is indicated before reaching final conclusion.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.33 no.4
• /
• pp.17-26
• /
• 2005

Numerical investigation has been made on the aerodynamic characteristics of supersonic air-launching rocket, as a new concept launching mechanism. Parametric study on the variations of launching velocity, incident angle and mounting location of the rocket has been performed using three dimensional Euler equations. Influential factors at separating stage of the rocket were extracted through comprehensive analyses, and, the response surface models were constructed for those factors. From the study, the aerodynamic behavior of the air-launching rocket at supersonic speed and useful guidelines for the optimal mounting location of the rocket have been obtained.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.22 no.6
• /
• pp.495-501
• /
• 2012

In this study, the natural frequencies and mode shape of an external mounting pod were verified using the modal analysis and modal testing technique for a pod mounted on an aircraft. The procedure associated with the FE model building of an external mounted pod to predict the dynamic behavior of aircraft structures is described. The simplified FE model reflecting the results of the modal testing of a pod is built through the optimization and will be applied to the structural dynamic model of an aircraft which is used to verified the stability of vibration and flutter of an aircraft.

• Korean journal of applied entomology
• /
• v.47 no.4
• /
• pp.487-490
• /
• 2008

Field collected larvae inside the pumpkin fruit in Jinan, Chonbuk Province were kept in the laboratory at $24{\pm}2^{\circ}C$, RH $65{\pm}5%$, and 14L:10D until they pupated and eclosed. Adults were fed with dry-milk based diet. Mating behavior was observed when they were 40 days old in a field cage at dusk in July and October, 2008. Wing vibration in male took place under the light intensity of 200 lux-20 lux, however, most commonly under 30 lux. Mounting between male and female was observed under 150 lux-30 lux after the act of wing vibration, also most frequently under 30 lux. Copulation occurred under 150 lux-20 lux. Females approached face to face to males which had been engaged in wing vibration and the copulation was successful for up to 64%. Copulation never occurred when a female positioned in front or at side of the male that was not engaged in wing vibration.

• Tribology and Lubricants
• /
• v.23 no.6
• /
• pp.272-277
• /
• 2007

Various type of rotary unions are widely used to provide fluids between rotating parts. To prevent fluid leakage, most of the rotary unions adopt mechanical seals which is highly reliable but too expensive and complicate. In this paper, a simple lip seal system made of PTFE is adopted in designing of a compact rotary union. Using MARC, the behavior characteristics of lip seal are investigated for seal mounting process, and obtained variations of contact pressure distribution and contact width with interferences and fluid pressures. The results showed that contact width are increased with interference and pressure. The maximum contact pressure are also increased up to a certain interference and pressure, however, then decreased. The numerical methods and results can be applied in designing and performance improvement of lip seal adopted rotary union, and further extensive studies are required.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.7 no.9
• /
• pp.195-202
• /
• 1999

The kinematic and complicance characteristics of torsion beam axle is structurally related to the location and section profile of torsion beam and the span from body mounting point to wheel center. This paper presents the effect of section properties in torsion beam on the structural characteristics and roll behavior of suspension. The structural characteristics is on the maximum stress on the welding area of torsion beam and the roll behavior is on roll steer and roll-camber of suspension which are important for controllability and stability in cornering. Four factors are used for the section design of torsion beam, which are thickness , midline length, are inner radius, and sector half angle . Through the structural and quasi-static analysis made for six torsion beam axle models, it can be noticed that roll steer and the structural durability of suspension are closely related to warping constant and shear center in section properties of torsion beam.

• Development and Reproduction
• /
• v.1 no.2
• /
• pp.181-187
• /
• 1997

This study has been conducted to investigate the mating behavior, time sequence of mating and time limit with which female can fulfill spawning and brooding after pre-spawning molting in the giant fresh-water prawn, macrobrachium rosenbergii reared in the laboratory. the results obtained were summarized as follows. Mating happened spontaneously as the following sequences: courting gesture, seizure of female by male, mounting, turning of female, copulation. The entire mating lated approximately seven minutes. The endopodite of 2nd pleopod of male bore the appendix masculins whcih are male's secondary sex characteristic. cinciulli was formed at the distal portion of appendix interna which are on the upper portion of appendix masculins and helped stabilizing the connection of each side of 2nd pleopod during mating. After the connection of each side of 2nd plepod was fixed on the posterior portion of the thoracic sternum in female, a gelatinous spermatophore that emitted at the basipodite of 5th pereiopod during courting gesture was deposited on the ventral groove of 2nd, 3rd, 4th and 5th pereiopod. time limit which female can fulfill copulation and brooding was from 3 hours to 15 hours after pre-spawning molting.

• Proceedings of the KSME Conference
• /
• 2001.06c
• /
• pp.345-350
• /
• 2001

Dynamic behavior of high speed train is very important because the high speed train should be safe and satisfied with the ride comfort. An eddy current brake system is mounted on trailer bogie and wheelset. The eddy current braking force longitudinally exerts on the articulated trailer bogie and the attraction force vertically exerts on the wheelset. Because a frame of eddy current brake system is flexible, these forces generate the vertical vibration at middle point of the frame. Also, the vibration change the vertical clearance between an electromagnet and top of rail which affect the magnitude of braking and attracting forces. Therefore, the dynamic behavior of the eddy current braking system must be predicted for design the dynamic characteristic of its mounting system when normally operate on rail which have irregularity. Vampire program is used for prediction of the dynamic behavior of an eddy current braking system. Five design variables and five performance index are considered for optimization through D-optimal experimental design in this paper. Also model center is used to search the optimal point for sum of performance index with variational matric method.

• Smart Media Journal
• /
• v.12 no.7
• /
• pp.18-26
• /
• 2023

In this study, we propose a cow behavior recognition system based on YOLOX and OC-SORT. YOLO X detects targets in real-time and provides information on cow location and behavior. The OC-SORT module tracks cows in the video and assigns unique IDs. The quantitative analysis module analyzes the behavior and location information of cows. Experimental results show that our system demonstrates high accuracy and precision in target detection and tracking. The average precision (AP) of YOLOX was 82.2%, the average recall (AR) was 85.5%, the number of parameters was 54.15M, and the computation was 194.16GFLOPs. OC-SORT was able to maintain high-precision real-time target tracking in complex environments and occlusion situations. By analyzing changes in cow movement and frequency of mounting behavior, our system can help more accurately discern the estrus behavior of cows.

• Journal of Embryo Transfer
• /
• v.22 no.3
• /
• pp.185-190
• /
• 2007

The objective of this study was to investigate the characteristics of various estrous behavior and ovulation time in dairy cows and heifers. In total, 73 ovulations and 61 estrous detection were observed in 89 Holstein cows. Various estrous behavior were observed during 72 hours from two days after $PGF_2{\alpha}$ injection and their relation with the time of ovulation(ultrasound examinations at 4-h intervals) was investigated. In estrous periods, the rate of sniffing, chin resting, mounting and standing heat was 81%, 78%, 78% and 56%, respectively in cows. In heifers, the rate of sniffing, chin resting, mounting and standing heat was 61%, 68%, 82% and 76%, respectively. Ovulation in cows and heifers occurred $25.58{\pm}7.94\;and\;25.55{\pm}5.72h$ after onset of estrus, and $13.42{\pm}7.14\;and\;7.48{\pm}7.41h$ after end of estrus, respectively. Interval between onset of estrus and ovulation time was significantly (p<0.05) shorter for standing heat ($17.33{\pm}5.83\;h$) than for mounting, sniffing and chin resting ($23.58{\pm}5.12\;h,\;24.25{\pm}6.09\;h,\;23.42{\pm}6.04\;h$) in cows but not significantly different in heifers. Interval between end of standing heat and ovulation time was significantly (p<0.05) shorter for heifer($6.38{\pm}4.80$) than for cows($13.05{\pm}4.53$). Our results show that characteristics of estrous behavior and ovulation in dairy heifers are different to that of cows.