• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.3B
• /
• pp.221-232
• /
• 2011

Applicability of three soil erosion models for burnt hillslopes was evaluated. The models were estimated with the data from plots established after tremendous wildfire occurred in the east coastal region. Soil erosion and surface runoff were simulated by the Water Erosion Prediction Project (WEPP) and the Revised Universal Soil Loss Equation (RUSLE) of application mode for disturbed forest areas and the Soil Erosion Model for Mountain Areas (SEMMA) developed for burnt hillslopes. Simulated sediment yield and surface runoff were compared with the measured those. In maximum value of sediment yield, three models was under-predicted and RUSLE and WEPP had difference of over two times. SEMMA showed the best model response coefficient, determination coefficient and the model efficiency. In application of models to the soil erosion according to the elapsed year after wildfire, all models were underestimated in initial stage disturbed by wildfire. Evaluation of models in this burnt hillslopes was shown the tends to under-predict soil erosion for larger measured values. Although a lot of sediment can be generated in small rainfall event as fine-grained soil of the high water repellency was exposed excessively right after wildfire, this under-prediction was shown that those models have a limit to estimate the weighted factors by wildfire.

• Journal of the Korean Chemical Society
• /
• v.54 no.6
• /
• pp.687-695
• /
• 2010

Complexes of thiocyanato(L)cobaloximes where L is urea, acetamide, semicrabazide and formamide were synthesized and characterized. The reaction of thiocyanato (L) cobaloximes (SCNCo$(DH)_2$(L)) with benzyl (aquo) cobaloxime $PhCH_2Co(DH)_2(OH_2)$ was found to produce a series of thiocyanato bridged dicobaloximes of a general formula of $PhCH_2Co(DH)_2SCNCo(DH_2)(L)$. Evidence for formulation as dicobaloximes containing thiocyanato ligand bridges was obtained from infrared data which show $20-45cm^{-1}$ increase in vCN upon formation of the dicobaloxime from the corresponding terminal thiocyanocobaloxime (SCNCo$(DH)_2$(L)). Further characterization of these two series was done on the basis of ($^1H$,$^{13}C$)NMR, LCMS and elemental analysis. Anti-microbial activity of thiocyanato(L)cobaloximes and thiocyanato bridged dicobaloximes were screened against E. Coli. The DNA-binding behaviors of both monomers and dimers were investigated by spectroscopic methods and viscosity measurements. The results indicated that the dimer complexes bind with calf-thymus DNA in an intercalative mode via the terminal benzyl ring into the base pairs of DNA. It was observed that the monomer complexes did not interact with DNA. Fluorescence spectra for the interaction between thiocyanato bridged dicobaloximes and DNA were also studied.

• Korean Journal of Crystallography
• /
• v.12 no.4
• /
• pp.197-206
• /
• 2001

A stoichiometric mixture of evaporating materials for AgInS₂ single crystal thin films was prepared from horizontal electric furnace. To obtain the single crystal thin films. AgInS₂ mixed crystal was deposited on thoroughly etched semi-insulating GaAs(100) substrate by the Hot Wall Epitaxy(HWE)system. The source and substrate temperatures were 680℃ and 410℃, respectively. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction(DCXD). The carrier density and mobility of AgInS₂ single crystal thin film mea-sured from Hall effect by van der Pauw method are 9.35×10/sup 16/㎤ and 294㎠/V·s at 293K respectively. The temperature dependence of the energy band gap of the AgInS₂ obtained from the absorption spectra was well described by the Varshni's relation , E/sub g/(T)=2.1365eV-(9.89×10/sup-3/eV/K/)T²(T+2930K). The crystal field and the spin-orbit splitting energies for the valence band of the AgInS₂ have been estimated to be 0.1541eV and 0.0129 eV, respectively, by means of the photocur-rent spectra and the Hopfield quasicubic model. These results indicate that the splitting of the Δso definitely exists in the Γ/sub 5/ states of the valence band of the AgInS₂ /GaAs epilayer. The three photo-current peaks ovserved at 10K are ascribed to the A₁-, B-₁and C₁-exction peaks for n=1.

• Korean Journal of Optics and Photonics
• /
• v.15 no.4
• /
• pp.375-384
• /
• 2004

Switching phenomenon of a three-waveguide optical coupler was analyzed by using the coupled mode theory, and the coupling-length of the device was calculated by means of the FDM. CPW traveling-wave electrodes were designed by the CMM and SOR simulation techniques so as to satisfy the conditions of phase-velocity and impedance matching. Traveling-wave modulators were fabricated on a z-cut LiNbO$_3$ substrate. Ti was in-diffused in LiNbO$_3$ to make waveguides and Au electrodes were built on the waveguides by the electroplating technique. Insertion loss and switching voltage of the optical modulator were about 4 ㏈ and 15.6V. Network analyzer was used to obtain S parameters and corresponding RF response. From the measurement, parameters of the traveling-wave electrodes were extracted as such Z$_{c}$=39.2 $\Omega$, Neff=2.48, and a0=0.0665/cm((GHz) (1/2)). The measured optical response R(w) was compared with the theoretically estimated and both responses were shown to agree well. The measurement results revealed that the ㏈ bandwidth turned out to be about 13 GHz.

• Korean Journal of Optics and Photonics
• /
• v.10 no.6
• /
• pp.500-506
• /
• 1999

We designed and fabricated a bidirectional optical transceiver module for low cost access network. An integrated chip forming a pin-PD on an 1.3 urn FP-LD was assembled by flip-chip bonding on a Si optical bench, a single mode fiber with an angled end facet was aligned passively with the integrated chip on V-groove of Si-optical bench. Gaussian beam theory was applied to evaluate the coupling coefficients as a function of some parameters such as alignment distance, angle of fiber end facet, vertical alignment error. The theory is also used to search the bottle-neck between transmittance and receiving coupling efficiency in the bi-directional optical system. Tn this paper, we confirmed that reduction of coupling efficiency by the vertical alignment error between laser beam and fiber core axis can be compensated by controlling the fiber facet angle. In the fabrication of sub-module, a'||'&'||' we made such that the fiber facet have a corn shape with an angled facet only core part, the reflection of transmitted laser beam from the fiber facet could be minimized below -35 dE in alignment distance of 2: 30 /J.m. In the same condition, transmitted output power of -12.1 dEm and responsivity of 0.2. AIW were obtained.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.35 no.2
• /
• pp.112-119
• /
• 2015

Photoacoustic microscopy is capable of providing high-resolution molecular images, and its spatial resolution is typically determined by ultrasonic transducers used to receive the photoacoustic signals. Therefore, ultrasonic transducers for photoacoustic microscopy (PAM) should have a high operating frequency, broad bandwidth, and high signal-reception efficiency. Polyvinylidene fluoride (PVDF) is a suitable material. To take full advantage of this material, the selection of the backing material is crucial, as it influences the center frequency and bandwidth of the transducer. Therefore, we experimentally determined the most suitable backing material among EPO-TEK 301, E-Solder 3022, and RTV. For this, three PVDF high-frequency single-element transducers were fabricated with each backing material. The center frequency and -6 dB bandwidth of each transducer were ascertained by a pulse-echo test. The spatial resolution of each transducer was examined using wire-target images. The experimental results indicated that EPO-TEK 301 is the most suitable backing material for a PAM transducer. This material provides the highest signal magnitude and a reasonable bandwidth because a large portion of the energy propagates toward the front medium, and the PVDF resonates in the half-wave mode.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.17 no.5
• /
• pp.179-186
• /
• 2007

Single crystal $CdGa_2Se_4$ layers were grown on a thoroughly etched semi-insulating GaAs(100) substrate at $420^{\circ}C$ with the hot wall epitaxy(HWE) system by evaporating the polycrystal source of $CdGa_2Se_4$ at $630^{\circ}C$. The crystalline structure of the single crystal thin films was investigated by the photoluminescence and double crystal X-ray diffraction(DCXD). The carrier density and mobility of single crystal $CdGa_2Se_4$ thin films measured with Hall effect by van der Pauw method are $8.27{\times}10^{17}cm^{-3},\;345cm^2/V{\cdot}s$ at 293 K, respectively. The photocurrent and the absorption spectra of $CdGa_2Se_4/SI$(Semi-Insulated) GaAs(100) are measured ranging from 293 K to 10 K. The temperature dependence of the energy band gap of the $CdGa_2Se_4$ obtained from the absorption spectra was well described by the Varshni's relation $E_g(T)=2.6400eV-(7.721{\times}10^{-4}eV/K)T^2/(T+399K)$. Using the photocurrent spectra and the Hopfield quasicubic model, the crystal field energy(${\Delta}cr$) and the spin-orbit splitting energy(${\Delta}so$) far the valence band of the $CdGa_2Se_4$ have been estimated to be 106.5 meV and 418.9 meV at 10 K, respectively. The three photocurrent peaks observed at 10 K are ascribed to the $A_{1^-},\;B_{1^-},\;and\;C_{11}-exciton$ peaks.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.5B
• /
• pp.431-438
• /
• 2011

This study investigated the problem of mean-field bias correction under the assumption that the radar and rain gauge rainfall data follow the log-normal distribution. Regression curves for the average, median and mode of the radar and rain gauge rainfall were derived and evaluated for their usefulness. Additionally, these regression curves were compared with those derived under the assumption that the radar and rain gauge data follow the normal distribution. This study investigated the regression results for the Typhoon Meami occurred in 2003 as an example. As results, three regression lines with the radar rainfall as the independent variable were found to underestimate the rainfall, while those with the rain gauge rainfall as the independent variable to overestimate. Among three types of regression curves considered, the result for the average was most appropriate. However this case was found to be inferior to the regression line passing the origin under the assumption of the normal distribution with the rain gauge rainfall as its independent variable. So it was hard to conclude that the consideration of the log-normality on the correction of radar rainfall is beneficial.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.20 no.5
• /
• pp.787-807
• /
• 2018

When conducting the underground safety impact assessment under the special law in Korea, it is essential to investigate the occurrence of underground cavities. When underground cavities were discovered, the underground safety was assessed through numerical analysis. The previous study has suggested the stability evaluation based on the factor of safety by changing the 2D shape of the small underground cavity. In this study, the effects of small underground cavities considering 3D shapes were examined using a continuum analysis program and compared with the 2D results presented in previous study. If the 3-Dimensional shape of the underground cavity is found close to the sphere type, it would be reasonable to evaluate the factor of safety by the shear strength reduction method regardless of the size and position of the cavity. If a high-aspect ratio underground cavity with a depth of 2 m or more from the ground surface and an aspect ratio (a/b) of 2.0 or more is in the vertical direction, not only the factor of safety but the failure mode shape should be cautions in the stability evaluation using the shear strength reduction method. The results of this study are expected to be basic data on underground safety impact assessment.

• BMB Reports
• /
• v.41 no.5
• /
• pp.408-413
• /
• 2008

Pyridoxal-5'-phosphate phosphatase (PLPP) catalyzes the dephosphorylation of pyridoxal-5'-phosphate (PLP). A human brain PLPP gene was fused with a PEP-1 peptide and produced a genetic in-frame PEP-1-PLPP fusion protein. The purified PEP-1-PLPP fusion protein was efficiently transduced into PC12 cells in a time- and dose-dependent manner when added exogenously to culture media. Once inside the cells, the transduced PEP-1-PLPP fusion protein was stable for 36 h. The concentration of PLP was markedly decreased by the addition of exogenous PEP-1-PLPP to media pretreated with the vitamin $B_6$ precursors; pyridoxine, pyridoxal kinase and pyridoxine-5'-phosphate oxidase into cells. The results suggest that the transduction of the PEP-1-PLPP fusion protein can be one mode of PLP level regulation, and to replenish this enzyme in the various neurological disorders related to vitamin $B_6$.