• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.12
• /
• pp.1455-1461
• /
• 2008

We implemented a subminiature internal antenna that is around 1 cc volume for the mobile phone. The fundamental type of studied antenna is IFA(Inverted F Antenna), and this antenna is designed to be improved efficiency and gain due to minimum current cancellation by the avoidance of multiple bending pattern. For the implementation of multiple band, helix is applied to compensate for short antenna length for low frequency band, and a 3 dimensional pattern is used for high frequency band. We made two kinds of 3D structure antenna. One is a 1 cc volume antenna for GSM/DCS band on the bare board set, and the other is a 1.5 cc volume for the GSM/USPCS mobile phone set. Measurements showed good gain performance that average gain of two antenna on each band are $-3.46{\sim}-0.45\;dBi$ and $-4.80{\sim}-3.29\;dBi$ respectively.

• ETRI Journal
• /
• v.35 no.1
• /
• pp.51-57
• /
• 2013

In this paper, a small internal antenna for a mobile handset is presented using multiband, wideband, and high-isolation multiple-input multiple-output techniques. The proposed antenna consists of three planar inverted-F antennas (PIFAs) that operate in the global system for mobile communication (GSM900), the digital communication system (DCS), the personal communication system (PCS), the universal mobile telecommunication system (UMTS), and wireless local area network (WLAN) bands with a physical size of $40mm{\times}10mm{\times}10mm$. A resonator attached to the folded PIFA creates dual resonances, achieving a wide bandwidth of approximately 460 MHz, covering the DCS, PCS, and UMTS bands; a meander shorting line is used to improve impedance matching. Additionally, a modified neutralization link is embedded between diversity antennas to enhance isolation, which results in a 6-dB improvement in the isolation and less than 0.1 in the envelope correlation coefficient evaluated from the far-field radiation patterns. Simulation and measurements demonstrate very similar results for S-parameters and radiation patterns. Peak gains show 3.73 dBi, 3.77 dBi, 3.28 dBi, 2.15 dBi, and 5.86 dBi, and antenna efficiencies show 56.15%, 72.15%, 68.59%, 52.92%, and 82.93% for GSM900, DCS, PCS, UMTS, and WLAN bands, respectively.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.13 no.1
• /
• pp.61-66
• /
• 2014

This paper describes the design, fabrication, and measurement of a compact hexa-band coupling antenna for 4G mobile handset using a small element with two slots. In order to obtain sufficient bandwidth (LTE700, GSM850, GSM900, GSM1800, GSM1900, UMTS) with a Voltage Standing Wave Ratio $(VSWR){\leq}3:1$, two slots are inserted in the small element, and coupling patch is used. The measured result of the fabricated antenna provides 410MHz bandwidth form 0.688 to 1.098GHz and 643 MHz bandwidth form 1.607 to 2.250GHz (${\leq}VSWR 3:1$) with the gain ranging from -0.52 to 4.68 dBi. Also, a good radiation pattern is achieved within the hexa-band (0.698-0.960GHz and 1.710-2.170GHz) range.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.3 s.118
• /
• pp.288-297
• /
• 2007

The novel internal monopole chip antenna of penta-band operation for GSM850/GSM900/DCS/USPCS/WCDMA bands for mobile phones is proposed. This antenna occupies a small volume $8\times3.2\times20mm^3$ and is suitable to be embedded in a mobile phone as an internal antenna. The minimization of the proposed antenna was realized by using spiral line structure and meander line structure on FR-4 of dielectric$(\varepsilon_r=4.4)$. The designed antenna has the wide-band operation in the upper band by overlapping high order resonances. The measured bandwidth of this antenna (VSWR>3) is 150MHz$(1,030\sim1,180\;MHz)$ in the lower band operation and 650 MHz$(1,760\sim2,410\;MHz)$ in higher band operation. The measured radiation efficiency within bandwidth(VSWR 3:1) is over 50 %. The antenna has been designed by a commercial software HFSS.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.3
• /
• pp.48-55
• /
• 2008

This paper presents a design of a multi-band infernal antenna for mobile handsets which can cover the major mobile services such as WiBro/WiMAX mobile internet services and Media-FLO/S-DMB services. Using wideband monopole antenna structure, the proposed antenna obtains the wide bandwidth characteristic at high Sequency band to be applicable for new mobile services. Stacking meandered radiator on the wideband monopole radiator and obtaining the different current path and lenga on these stacked radiators, overall antenna volume is effectively reduced. The measured bandwidths (VSWR<3) of the proposed antenna is 270 MHz and 2032 MHz at low and high band, respectively. This antenna can effectively covers major wireless communication bands including Media-FLO, CDMA, GSM, GPS, DCS, PCS, UMTS, WiBro, WiMAX, and S-DMB.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2009.10a
• /
• pp.762-765
• /
• 2009

In general, small antenna is located with several devices in the mobile handsets. But these devices are a bad influence to characteristics of antenna. This paper deals with the loss characteristics of small loop antenna near the several devices in the small handset. Especially, we analyzed effect of ground plane and condensers that use matching circuit. Result of analysis, condenser near feed point of antenna to have much effect on radiation efficiency.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.7
• /
• pp.778-784
• /
• 2008

In this paper, a chip antenna using multi-layer configuration for multi-band operation, such as GSM, DCS, pcs, WCDMA, and Mobile WiMAX for 2.3 GHz is proposed. This proposed antenna is a PIFA structure with multi-layer configuration fabricated on R04003 substrate(${\varepsilon}_r=3.4$) and its size is $22{\times}5.5{\times}4.0\;mm^3$. Multi-layer structure can effectively reduce the size of an antenna from a reuse of air-space and can achieve broad bandwidth due to decrement of parallel capacitances from the insertion air-gap to the middle layer. The proposed antenna has a broadband operation by the high order resonance modes and the resonance at the top layer. The measured bandwidths with over 45 % radiation efficiency are 80 MHz($880{\sim}960\;MHz$) at the lower band and 690 MHz($1,710{\sim}2,400\;MHz$) at the higher band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.315-320
• /
• 2010

In this paper, an internal TDMB(Terrestrial Digital Multimedia Broadcasting) antenna for mobile phone is proposed. The overall dimension of designed antenna with substrate is 30 mm$\times$5 mm$\times$0.6 mm. The proposed antenna consists of a meander type radiator which is connected front- and back-plane of Kapton substrate by via hole and parasitic element for tuning the resonant frequency. And to compensate the electric length of desired frequency, passive inductor is used for matching element. Measured gain of the implemented antenna -17.6 dBi at 174 MHz, -13.01 dBi at 195 MHz, and -14.9 dBi at 216 MHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.12
• /
• pp.1445-1454
• /
• 2008

In this paper, small UWB antenna with band-stop function for mobile handsets is proposed. A gap between radiator and under and side ground is adjusted for small size and broadband. A radiator is folded to the back side of PCB for miniaturization and tapered feeding structure is used to enhance matching characteristic. A antenna clearance has a size of $14{\times}14\;mm^2$ and a size of radiator is $10{\times}7\;mm^2$. It covers all UWB band from 3.15 GHz to 4.75 GHz and from 7.2 GHz to 10.2 GHz for VSWR<2 and has band stop characteristic at 5.8 GHz. A maximum gain is measured as 5.85 GHz. In case conventional handset case is considered, it also covers all UWB and a maximum gain is measured from -2 dBi to -2 dBi.

• Journal of Satellite, Information and Communications
• /
• v.9 no.1
• /
• pp.102-106
• /
• 2014

In this paper, we investigate the realistic environment influence on the Hearing-Aid Compatibility(HAC) of the body-held device mock-up with a dual-band antenna. In detail, first, a dual-band internal antenna is designed considering the neighboring objects essential to a real attachable mobile device. This comes to reality by making its mock-up version. Second, the HAC of this device is simulated and measured for 'stand alone', and 'hand-held' cases. Particularly, the electromagnetic simulation of the designed antenna in the real device is verified by the standard measurement. Finally, the evaluated HAC is analyzed in terms of the relations with the bands, the mock-up environment and the hand effect.