• YAKHAK HOEJI
• /
• v.51 no.2
• /
• pp.133-139
• /
• 2007

A simple and sensitive HPLC-MS method for quantitation of 10${\alpha}$-methoxy-9,10-dihydrolysergol (MDL), the main metabolite of nicergoline, in human plasma was developed and the bioavailability parameters of MDL was assessed in Korean healthy male volunteers. Clomipramine was used as an internal standard. MDL and internal standard in plasma sample were extracted using ethyl acetate. A centrifuged upper layer was then evaporated and reconstituted with mobile phase of 10 mM ammonium acetate-acetonitrile (10 : 90, v/v). The reconstituted samples were injected into a Zorbax SB-C8 column (2.1${\times}$150 mm,5 ${\mu}$m) at a flow-rate of 0.3 ml/min. Using MS with selected ion monitoring (SIM) mode, MDL and clomipramine were detected without severe interference from human plasma matrix. MDL produced a protonated molecular ion ([M+H]$^+$) at m/z 287. Internal standard produced a protonated molecular ion ([M+H]$^+$) at m/z 315. A linear relationship for MDL was found in the range of 2.5${\sim}$100 ng/ml. The lower limit of quantitation (LLOQ) was 2.5 ng/ml with acceptable precision and accuracy. The intra- and inter-day validation for all coefficients of variation (R.S.D.%) were found less than 15%. Main pharmacokinetic parameters of 30 mg of nicergoline were revealed as follows: AUC$_t$ 321.1${\pm}$64.5 ng${\cdot}$hr/ml, C$_{max}$, 51.2${\pm}$25.3 ng/ml, T$_{max}$ 3.6${\pm}$1.5 hr, K$_{el}$ 0.12${\pm}$0.07 hr$^{-1}$ and t$_{1/2}$ 7.6${\pm}$3.4 hr. Inter subject variations and race differences were shown in comparison with the published data in the literature.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.24 no.6
• /
• pp.1159-1174
• /
• 2014

As the use of smartphones and tablet PCs has exploded in recent years, there are many occasions where such devices are used for treating sensitive data such as financial transactions. Naturally, many types of attacks have evolved that target these devices. An attacker can capture a password by direct observation without using any skills in cracking. This is referred to as shoulder surfing and is one of the most effective methods. There has been only a crude definition of shoulder surfing. For example, the Common Evaluation Methodology(CEM) attack potential of Common Criteria (CC), an international standard, does not quantitatively express the strength of an authentication method against shoulder surfing. In this paper, we introduce a shoulder surfing risk calculation method supplements CC. Risk is calculated first by checking vulnerability conditions one by one and the method of the CC attack potential is applied for quantitative expression. We present a case study for security-enhanced QWERTY keyboard and numeric keypad input methods, and the commercially used mobile banking applications are analyzed for shoulder surfing risks.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2011.10a
• /
• pp.462-465
• /
• 2011

A pulse oximeter is a device which provides non-invasive estimate of percentage oxygen saturation of haemoglobin (SpO2). Due to the limitations of resources of personal health devices (PHDs) including pulse oximeters, they generally transmit the estimated data to a remote monitoring server through a close manager (e.g. mobile device or PC). Therefore, communication protocols between PHDs and a manager is an important research topic in terms of interoperability. In this paper, we present design results of an SpO2 transmission agent based on the ISO/IEEE 11073 (X73) protocol. The protocol is an international standard for PHDs. The agent is an embedded program which generates X73 messages from the estimated pulse rates and SpO2, and transmits the messages to a close manager. The agent consists of a Session, Message and Memory Handler. The Session Handler manages a communication session with the manager, and the Message Handler generates and analyzes the exchanged messages according to the X73 protocol. The Memory Handler extracts pulse rates and SpO2s which are stored in a memory of the pulse oximeter. The SpO2 transmission agent allows pulse oximeters to communicate with managers based on x73 standard. Consequently, the interoperability between the pulse oximeters and the managers is guaranteed.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.3
• /
• pp.623-628
• /
• 2009

The emergence of compact and low-power wireless communication sensors and actuators in the technology supporting the ongoing miniaturization of processing and storage allows for entirely the new kinds of embedded systems. These systems are distributed and deployed in environments where they may have been designed into a particular control method, and are often very dynamic. Collection of devices can communicate to achieve a higher level of coordinated behavior. Wireless sensor nodes deposited in various places provide light, temperature, and activity measurements. Wireless sensor nodes attached to circuits or appliances sense the current or control the usage. Together they form a dynamic and multi-hop routing network connecting each node to more powerful networks and processing resources. Wireless sensor networks are a specific-application and therefore they have to involve both software and hardware. They also use protocols that relate to both applications and the wireless network. Wireless sensor networks are consumer devices supporting multimedia applications such as personal digital assistants, network computers, and mobile communication devices. Wireless sensor networks are becoming an important part of industrial and military applications. The characteristics of modem embedded systems are the capable of communicating adapting the different operating environments. In this paper, We designed and implemented sensor network system which shows through host PC sensing temperature and humidity data transmitted for wireless sensor nodes composed wireless temperature and humidity sensor and designs sensor nodes using embedded system with the intention of studying USN.

• The Transactions of the Korea Information Processing Society
• /
• v.7 no.10
• /
• pp.3210-3218
• /
• 2000

In a IS-95 cellular systm, blocking will occur when the reverse link user interference power reaches a predepermmed level which is set to maintam acceptable signal quality. In this paper, it is assumed that a mobile rdio channel is a shadowing channel and Erlang capacity is calculated for the reverse limk of an imperfect power controlled IS-95 cellular system. the blocking probability is derived using lognornal pproximation and the results according to guassian and lognormal approximation method are compared and analyzed respcctively. Assuming that blocking probability is 1% at the data rate of $R_b$=9.6kbps and $R_b$=14.4kbps, it is shown that Erlang capacity using Iognormal approximation is 13.68 Erlang and 7.08 Erlang and then the approximation erroris occurred about 24.4% and 40.4% inthe garssian approximation, respectively. It is also observed that if the power control becomes periect, the Erlang capacity is increased more 6.99 and 4.21 Erlang than that of the imperfect power control that the power contrl error is 2.5dB, and if voice activity is considered as 10%, the Erlang capacity is increased more 8.21 and 1.25 Erlang than that using non voice activity, respectively.

• The KIPS Transactions:PartC
• /
• v.13C no.7 s.110
• /
• pp.803-812
• /
• 2006

This paper analytically evaluates the FEC(Forward Error Correction) symbol size's effect on the performance and energy consumption of 802.11 protocol with the block FEC algorithm over WSN(Wireless Sensor Network). Since the basic recovery unit of block FEC algorithms is symbols not bits, the FEC symbol size affects the packet correction rate even with the same amount of FEC check bits over a given WSN channel. Precisely, when the same amount of FEC check bits are allocated, the small-size symbols are effective over channels with frequent short bursts of propagation errors while the large ones are good at remedying the long rare bursts. To estimate the effect of the FEC symbol site, the paper at first models the WSN channel with Gilbert model based on real packet traces collected over TIP50CM sensor nodes and measures the energy consumed for encoding and decoding the RS (Reed-Solomon) code with various symbol sizes. Based on the WSN channel model and each RS code's energy expenditure, it analytically calculates the transmission efficiency and power consumption of 802.11 equipped with RS code. The computational analysis combined with real experimental data shows that the RS symbol size makes a difference of up to 4.2% in the transmission efficiency and 35% in energy consumption even with the same amount of FEC check bits.

• Journal of Broadcast Engineering
• /
• v.15 no.1
• /
• pp.122-132
• /
• 2010

AT-DMB system has been developed to increase data rate up to double of conventional T-DMB in the same bandwidth while maintaining backward compatibility. The AT-DMB system adopted hierarchical modulation which adds BPSK or QPSK signal as enhancement layer to existing DQPSK signal. The enhancement layer signal should be small enough to maintain backward compatibility and to minimize the coverage loss of conventional T-DMB service coverage. But this causes the enhancement layer signal of AT-DMB susceptible to fading effect in transmission channel. A turbo code which has improved error correction capability than convolutional code, is applied to the enhancement layer signal of the AT-DMB system for compensating channel distortion. However there is a need for other solutions for better reception of AT-DMB signal in receiver side without increasing transmitting power. In this paper, we propose adaptive array antenna system with Eigen-space beamforming algorithm which benefits beamforming gain along with diversity gain. We analyzed the reception performances of AT-DMB system in indoor and mobile environments when this new smart antenna system and algorithm is introduced. The computer simulation results are presented along with analysis comments.

• Journal of Broadcast Engineering
• /
• v.17 no.1
• /
• pp.152-164
• /
• 2012

DMB provides various kinds of data services such as BWS and TPEG service in addition to audio and video services. But recently the necessity of new business models creating profit has been on the rise due to the saturation of DMB receiver market and break-down of market barrier between mobile IPTV and DMB services. This paper introduces DMB filecasting service technology, which can be expected a new profit-creative business model. The purpose of DMB filecasting service is to transmit non-real time multimedia contents based on DMB AF format to the users through DMB channels. It makes possible to consume DMB contents with any DMB-installed device anytime, anywhere and share them with others. Also DMB filecasting service makes consumption and request of DMB contents possible to be extented to a variety of networks as well as DMB channels. The paper explains the standardization status of DMB filecasting service and various DMB filecasting service scenarios. And also it proposes a signalling methode, a transmission and reception protocol and a receiver structure using DMB broadcasting program guide information.

• KIISE Transactions on Computing Practices
• /
• v.22 no.8
• /
• pp.375-380
• /
• 2016

The proliferation of online social networking services (OSNSs) and smartphones has enabled people to easily make friends with a large number of users in the online communities, and interact with each other. This leads to an increase in the usage rate of OSNSs. However, individuals who have immersed into their digital lives, prioritizing the virtual world against the real one, become more and more isolated in the physical world. Thus, their socialization processes that are undertaken only through lots of face-to-face interactions and trial-and-errors are apt to be neglected via 'Add Friend' kind of functions in OSNSs. In this paper, we present a friend recommendation system based on the on/off-line contextual information for the OSNS users to have more serendipitous offline interactions. In order to accomplish this, we modeled both offline information (i.e., place visit history) collected from a user's smartphone on a 3D tensor, and online social data (i.e., friend relationships) from Facebook on a matrix. We then recommended like-minded people and encouraged their offline interactions. We evaluated the users' satisfaction based on a real-world dataset collected from 43 users (12 on-campus users and 31 users randomly selected from Facebook friends of on-campus users).

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.7
• /
• pp.2719-2726
• /
• 2010

The purpose of this study was to investigate the scientific basic grounds for the assessment of health and environmental diseases resulting from air pollutants in Pohang. For this study, we investigated pollutants, weather characteristics and concentration distribution of fine particles ($PM_10$) yearly and each season, using data from Air Quality Monitoring Stations. The properties of concentration distribution and seasonal fluctuation of $PM_10$ were studied qualitatively and quantitatively using CALPUFF, air dispersion model. The average concentration of $PM_10$ for each season was spring($75.7{\mu}g/m^3$)>summer($56.8{\mu}g/m^3$)>winter($53.6{\mu}g/m^3$)>fall( $52.7{\mu}g/m^3$). In the case of spring, high concentrations appear due to the Asian dust frequently occurring. The contributions of $PM_10$ classified by the types of pollution source in Pohang were point source 62%>mobile source 33%>area source 5%. An important point is that 97% of emissions were produced from the iron manufacture in steel industry. Therefore, it is necessary to control the emission sources of pollutants and to construct an observation system at Pohang steel industrial complex from now on. It’s time to control the risk factors for health and environmental disease to protect the health of resident in Pohang and its neighboring areas.