• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.10
• /
• pp.929-934
• /
• 2016

In this paper, we studied the design and fabrication of array antenna at around 1.8 GHz band. To improve of frequency properties of antenna, single feed microstrip patch antenna was simulated by HFSS(High Frequency Structure Simulator). A $1{\times}2$ array antenna of 1.8 GHz for LTE band was designed and fabricated by photolithography on an FR4 substrate (dielectric constant of 4.4 and thickness of 0.8 mm). The fabricated antenna was analyzed by network analyzer. The measured results agree well with the simulations, which confirmed the validity of this study. The fabricated $1{\times}2$ array antenna showed a center frequency, the minimum return loss and impedance were 1.82GHz, -30.5dB, and $49.6{\Omega}$ respectively.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.11 no.11
• /
• pp.1047-1052
• /
• 2016

In this paper, we propose the CSLR(: Complementary Single Loop Resonators)-loaded inset fed patch antenna with a conducting reflector to improve the radiation patterns. Reflector of the proposed antenna is located below about ${\lambda}_0/4$ from the ground plane of the patch, the size is about two times of the patch. The proposed antenna is designed and fabricated on the substrate which has a dielectric constant and thickness with 2.5 and 0.787 mm, respectively. Simulation results are obtained by using the HFSS, 3D EM Solver based Finite Element Method(: FEM). The resonant frequency and matching characteristics of the antenna with reflector are substantially the same as when there is no change in the antenna without reflector, it is confirmed that radiation patterns are significantly improved by the reflector.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.10
• /
• pp.1116-1120
• /
• 2010

Low cost patch array antenna for high sensitivity electromagnetic(EM) sensor is presented. The operating frequency band of the antenna is 24.05~24.25 GHz. Array structure is the symmetrical pattern by Chebyshev polynomial and the feed point is located in the middle of the array. Also, the gain of the array antenna can be increased by the side wings which are connected with the ground plane. It is proved through simulation and the measurement results that the operating frequency and the side-lobe level(SLL) are rarely changed when the inclined angle of the side wings is varied.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.3
• /
• pp.573-581
• /
• 1994

A microstrip antenna having a dual polarization and a smaller size than feed horn polarizer of F.R.R.S(Faraday Rotation Rotary Switch) is designed, in which GaAs MESFET switches are inserted for selective reception of RHCP or LHCP. For an accurate analysis of the resonance frequency, input impedance and radiation pattern of the circularly polarized microstrip antenna, finite difference time domain (FDTD) method is used. When the GaAs MESFET switch in the feeder is ON-stats, the truncated patch antenna has a gain of about 16.6dB including amplifier gain, while the switch is OFF-state, this has a isolation level of -24dB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.145-151
• /
• 2008

In this paper, a dual band microstrip antenna with similar radiation pattern for the satellite internet service is proposed. The proposed antenna has two Y-shaped slots on the microstrip patch that is fabricated on RO4003 substrate with a dielectric constant of 3.38 and a thickness of 0.508 mm, and operates in the 2 GHz and 5 GHz bands. The size of the antenna is $50\times47.5\times6.5\;mm^3$, and fed by coaxial cable. The measured bandwidths of the antenna are 2.398$\sim$2.507 GHz and 5.458$\sim$5.972 GHz for VSWR<2. The measured gains are 8.92 dBi and 7.74 dBi, respectively, for the lower and upper bands.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.5
• /
• pp.853-859
• /
• 2007

This paper presents a microstrip patch array antenna having transmission feed and reception feed for satellite communication in the Ku band. In this paper, the element of the patch array antenna is a three-stacked structure consisting of one radiation patch and two parasitic patches for high gain and wide bandwidth characteristics. To obtain higher gain, the unit elements are expanded into a $1{\times}8$ may using a mixture of series and parallel feeds. The proposed antenna has horizontal polarization for the Rx band and vertical polarization for the Tx band. To verify the practicality of this antenna, we fabricated a three-stacked patch array antenna and measured its performance. The gain of the array antenna in the Rx and Tx bands exceeds 17 and 18 dBi, respectively. The impedance bandwidth is over 10 % in both bands. The cross-polarization level is below -25 dB, and the sidelobe level is below -9.4 dB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.1
• /
• pp.1-9
• /
• 2014

In this paper, a reconfigurable polarization patch antenna that uses a Y-shaped feed is proposed. The proposed antenna consists of a square patch, a Y-shaped feeding structure, a PIN diode, and a bias circuit for diode operation. The structural symmetry/asymmetry of the feeding structure is determined by the on/off operation of the PIN diode that inserted into the side of one of the lines of the Y-shaped feeding structure. For the proposed reconfigurable antenna, the two microstrip lines of the feeding structure have the same length when the PIN diode operates in the on state, and the antenna exhibits linear polarization(LP). On the other hand, when the PIN diode operates in the off state, the length of one side line of the feeding structure is relatively shorter than that of the other line. Therefore, the antenna exhibits circular polarization(CP). From the measurement results, it is found that the proposed antenna exhibits good impedance matching and axial ratio. In addition, polarization switching can be easily achieved in the same operating band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.17 no.3 s.106
• /
• pp.295-306
• /
• 2006

In this paper, we proposed and implemented a novel antenna cover mounted over a microstrip path antenna for ultrafast aircraft. A protective antenna cover prevents alteration in the electrical characteristics of the antenna due to environmental conditions. The permittivity of the cover materials should be practically invariable at all operating frequencies. We evaluated the characteristics of the antenna with both simulation and experiment. The experimental results show that the proposed antenna cover can be useful for ultrafast aircraft.

• Proceedings of the KIEE Conference
• /
• 1995.11a
• /
• pp.46-48
• /
• 1995

An efficient technique for the analysis of a general class of microstrip structures with a substrate is applied in this paper using newly-derived closed-form spatial domain Green's functions employed in conjunction with the Method of Moments(MoM). The computed current distributions on the microstrip structures are used to determine the scattering parameters of microstrip discontinuties and the input impedances of microstrip patch antennas. It is shown that the use of the closed-form Green's functions in the context of the MoM provides a computational advantage in terms of the CPU time by almost two orders of magnitude over the conventional spectral domain approach employing the transformed version of the Green's functions.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.49 no.2
• /
• pp.56-66
• /
• 2012

The inductive loaded patch antenna with suppressed radiation along the horizontal plane and enhanced broadside gain is investigated by adjusting the width and the via radius of a unit cell at a fixed length of a unit cell. The effects of the via radius and the width of the unit cell on the dispersion characteristics of the inductive loaded transmission line are investigated. The systematic study to determine the via radius and the width of the unit cell for the effective dielectric constant of the inductive loaded patch antenna close to 1 in order to suppress the radiation along the horizontal plane is presented. Inductive loaded patch antennas composed of five unit cells with resonant frequency of 5 GHz are designed and their radiation characteristics are presented. The horizontal radiation along the E-plane is greatly suppressed to less than -15 dBi when the effective dielectric constant of the inductive loaded patch antenna is slightly less than 1.