• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.2
• /
• pp.663-666
• /
• 2004

In this paper, we have investigated the structure and dielectric properties of the $(Ba_{0.6}Sr_{0.4})TiO_3$ (BST) thin films film fabricatedon MgO(100)/Si substrate by an alkoxide-based sol-gel method. Both the structure and morphology of films were analyzed by x-ray diffraction (XRD) and atomic force microscope (AFM). For the MgO(100)/Si substrates, the BST thin films exhibited highly (100) orientation. The highly (100)-oriented BST thin films showed high dielectric constant, tunability, and figure of merit (FOM). The dielectric constants, dielectric loss and tunability of the BST thin films annealed at 700 C deposited on the MgO(100)/Si substrates measured at 10 kHz were 515.9, 0.0082, and 54.3 %, respectively.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 추계학술대회 논문집
• /
• pp.358-361
• /
• 1999

This paper describes on the fabrication and characteristics of hot-film type micro-flowsensors integrated with Pt-RTD\`s and micro-heater on the Si substrate, in which MgO thin-films were used as medium layer in order to improve adhesion of Pt thin-films to SiO$_2$ layer The MgO layer improved adhesion of Pt thin-films to SiO$_2$` layer without any chemical reactions to Pt thin-films under high as gas flow rate and its conductivity increased due to increase of heat-loss from sensor to external. Output voltage was 82 mV at N2 flow rate of 2000 sccm/min, heating power of 1.2W. The respons time was about 100 msec when input flow was step-input

• 한국전기전자재료학회논문지
• /
• 제27권7호
• /
• pp.472-476
• /
• 2014

We report the characteristics of thin-film transistor (TFT) to make the bi-channel structure with stacked $Mg_{0.1}Zn_{0.9}O$ (Mg= 10 at.%) and ZnO. The ZnO and $Mg_{0.1}ZnO_{0.9}O$ thin films were deposited by radio frequency (RF) co-sputter system onto the thermally oxidized silicon substrate. A total thickness of active layer was 50 nm. Firstly, the ZnO thin films were deposited to control the thickness from 5 nm to 30 nm. Sequentially, the $Mg_{0.1}ZnO_{0.9}O$ thin films were deposited to change from 45 nm to 20 nm. The bi-layer TFT shows more improved properties than the single layer TFT. The field effect mobility and subthreshold slope for $Mg_{0.1}ZnO_{0.9}O$/ZnO-TFT are $7.40cm^2V^{-1}s^{-1}$ and 0.24 V/decade at the ZnO thickness of 10 nm, respectively.

• 한국결정성장학회지
• /
• 제28권2호
• /
• pp.57-62
• /
• 2018

본 연구에서는 Mg acetate 수용액을 사용한 간편한 도핑방법으로 불순물을 주입하여 성장한 $Ga_2O_3$ 박막의 불순물 주입 효과에 대해 연구하였다. MOCVD 방법을 이용해 Si 기판 위에 undoped $Ga_2O_3$ 박막과 Mg-doped $Ga_2O_3$ 박막을 각각 $600^{\circ}C$와 $900^{\circ}C$의 성장온도에서 30분간 성장하였다. 표면 형상 분석 결과 Mg 불순물 주입에 따른 큰 차이는 확인되지 않았으며 $900^{\circ}C$에서 성장한 박막의 표면이 $600^{\circ}C$에서 성장한 박막의 표면보다 큰 거칠기를 가지고 다결정화 되는 것을 확인하였다. 광학적 특성 분석 결과, 도핑된 샘플의 경우 전체적인 발광 피크가 red shift 되었고 UV 방출 세기가 커지는 특성을 보였다. I-V 측정 결과로부터 Mg 불순물에 의해 $600^{\circ}C$ 성장 박막의 누설전류가 감소하고, $900^{\circ}C$ 성장 박막의 광전류는 증가하는 효과를 확인하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.263-266
• /
• 2001

In this paper, we investigated dielectric properies for BST thin films that was deposited on MgO/Si substrates using RF magnetron sputtering. In here, MgO film was used to perform that a diffusion b arrier between the BST film and Si substrate and a buffer layer to assist the BST film growth. A d eposition condition for MgO films was RF Power of 50W, substrate temperature of room temperature and the working gas ratio of Ar:O$_2$ were varied from 90:10 to 60:47. Finally we manufactured the cap acitor of Al/BST/MgO/Si/Al structure to know electrical properties of this capacitor through I-V, C-V measurement. In the results, C-V aha racteristic curves was shown a ferroelectric property so we measured P-E. A remanent poliazation and coerceive electric field was present 2$\mu$C/cm$^2$ and -27kV/cm respectively at Ar:O$_2$=90:10. And a va clue of dielectric constant was 86 at Ar:02=90:10.

• 한국진공학회지
• /
• 제6권S1호
• /
• pp.141-153
• /
• 1997

The paraelectric cubic-to-ferroelectric tetragonal phase transition of the thin Pb(Zr, Ti)$O_3$ (PZT) films grown on MgO(001) substrate was investigated in a series of synchrotron x-ray scattering experiments. As the thickness of the film decreases the transition temperature and the amount of the tetragonal distortion were decreased continuously Different from only the c-domains were existent in the thinnest 25nm thick film. Based on this we propose a model for the domain structure of the tetragonal PZT/MgO(100) film that is very different from the ones suggested in literature. We attribute the suppression of the transition to the substrate field that prefers the c-type domains near the interface and suppresses the tetragonal distortion to minimize the film-substrate lattice mismatch.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 추계학술대회 논문집 전기물성,응용부문
• /
• pp.202-203
• /
• 2006

In the AC PDP, the MgO film is used as electrode protective film. This film must provide excellent ion bombardment protection, high secondary electron emission, and should be high transparent to visible radiation. In this study, we investigated the relations between the crystal orientation and e-beam evaporation process parameters. The crystal orientation of the MgO layer depends on the conditions of deposition. The parameters are the thickness of the MgO film $1000{\AA}-6500{\AA}$, the deposition rate $200{\AA}/min{\sim}440{\AA}/min$, the temperature $150^{\circ}C{\sim}250^{\circ}C$, and the distance between crucible and substrate 11cm ${\sim}$ 14cm. The temperature of substrate and evaporation rate of source material, or deposition rate of the film, are definitely related to the crystal orientation of the MgO thin film. The crystal orientation can be changed by the distance between the target(MgO tablet) and the substrate. However, the crystal orientation is not much affected by the thickness of MgO thin film.

• 한국초전도ㆍ저온공학회논문지
• /
• 제16권3호
• /
• pp.7-9
• /
• 2014

Single-crystal like $MgB_2$ thin film was grown on (000l) $Al_2O_3$ substrate by using hybrid physical-chemical vapor deposition (HPCVD) system. Single crystal properties were studied by X-ray diffraction (XRD) and the full width at half maximum (FWHM) of the (0001) $MgB_2$ peak is $15^{\circ}$, which is very close to that has been reported for $MgB_2$ single-crystal. It indicates that the crystalline quality of thin film is good. Temperature dependence on resistivity was investigated by physical property measurement system (PPMS) in various applied fields from 0 to 9 T. The upper critical field ($H_{c2}$) and irreversibility field ($H_{irr}$) were determined from PPMS data, and the estimated values are comparable with that of $MgB_2$ single-crystals. The thin film shows a high critical temperature ($T_c$) of 40.4 K with a sharp superconducting transition width of 0.2 K, and a high residual resistivity ratio (RRR=21), it reflects that $MgB_2$ thin film has a pure phase structure.

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 2000년도 International Symposium on Magnetics The 2000 Fall Conference
• /
• pp.377-378
• /
• 2000

• 센서학회지
• /
• 제9권3호
• /
• pp.171-176
• /
• 2000

반응성 스퍼터링과 고주파 마그네트론 스퍼터링으로 각각 증착된 MgO 박막과 그 위에 증착된 백금박막의 열처리 온도 및 시간에 따른 물리적, 전기적 특성을 4침 탐침기, 주사전자현미경 및 X선 회절법을 이용하여 분석하였다. $1000^{\circ}C$, 2시간의 열처리 조건하에서 MgO 박막은 백금박막과 화학적 반응없이 백금박막의 열산화막에 대한 부착특성을 개선시켰으며, 그 위에 증착된 백금박막의 면저항 및 비저항은 각각 $0.1288\;{\Omega}/{\square}$, $12.88\;{\mu}{\Omega}{\cdot}cm$이었다. Lift-off 방법을 이용하여 $SiO_2$/Si기판상에 백금 저항체를 만들었으며, 백금 와이어, 백금 페이스트 그리고 SOG를 이용하여 마이크로 열 센서용 박막형 Pt-RTD를 제작하였다. $25{\sim}400^{\circ}C$의 온도범위에서 $1.0{\mu}m$의 두께를 갖는 제작된 Pt-RTD의 저항온도계수는 벌크 백금에 가까운 $3927ppm/^{\circ}C$로 측정되었다. 측정온도범위내에서 저항값은 선형적인 변화를 보였다.