• Progress in Superconductivity and Cryogenics
• /
• v.16 no.3
• /
• pp.7-9
• /
• 2014

Single-crystal like $MgB_2$ thin film was grown on (000l) $Al_2O_3$ substrate by using hybrid physical-chemical vapor deposition (HPCVD) system. Single crystal properties were studied by X-ray diffraction (XRD) and the full width at half maximum (FWHM) of the (0001) $MgB_2$ peak is $15^{\circ}$, which is very close to that has been reported for $MgB_2$ single-crystal. It indicates that the crystalline quality of thin film is good. Temperature dependence on resistivity was investigated by physical property measurement system (PPMS) in various applied fields from 0 to 9 T. The upper critical field ($H_{c2}$) and irreversibility field ($H_{irr}$) were determined from PPMS data, and the estimated values are comparable with that of $MgB_2$ single-crystals. The thin film shows a high critical temperature ($T_c$) of 40.4 K with a sharp superconducting transition width of 0.2 K, and a high residual resistivity ratio (RRR=21), it reflects that $MgB_2$ thin film has a pure phase structure.

• Progress in Superconductivity
• /
• v.4 no.2
• /
• pp.153-156
• /
• 2003

We have studied fabrication of $MgB_2$ thin film on $SrTiO_3$ (001) and r-cut $A1_2$$O_3$ substrates by rf magnetron sputtering method using and $ MgB_2$ single target and two targets of Mg and B, respectively. Based on P -T phase diagram of $MgB_2$ and vapor pressure curves of Mg and B, a three-step process was employed. B layer was deposited at the bottom to enhance the film adhesion to the substrate. Secondly, co-sputtering of Mg and B was done. Finally, Mg was sputtered on top to compensate fur the loss of Mg during annealing. Subsequently, $MgB_2$ films were in-situ annealed in various conditions. The sample fabricated using the three-step process showed $T_{c}$ of 24 K and formation of superconducting $MgB_2$ phase was confirmed by XRD spectra. In case of co-sputtering deposition, $T_{c}$ depended on annealing time and argon pressure. However, those made by single-target sputtering showed non-superconducting behavior or low transition temperature, at best.est.

• Progress in Superconductivity and Cryogenics
• /
• v.24 no.4
• /
• pp.1-5
• /
• 2022

We investigate the effect of surface disorder on the lower critical field (H_c1) of MgB₂ thin films with a thickness of 850 nm, where the disorder on the surface region is produced by the irradiation of 140 keV Co ions with the dose of 1 × 10¹⁴ ions/cm². The thickness of the damaged region by the irradiation is around 143 nm, corresponding to ~17% of the whole thickness of the film, thereby forming the disordered MgB₂ overlayer on the pure MgB₂ layer. The magnetic field dependence of magnetization, M(H), for the pristine MgB₂ thin film and the film with overlayer is measured at various temperatures, and H_c1 is determined from the difference (△M) between the Meissner line and magnetization signal with the criterion of △M = 10^-3 emu. Intriguingly, the film with the disordered overlayer shows a remarkably large H_c1(0) = 108 Oe compared to the H_c1(0) = 84 Oe of pristine film, indicating that the disordered MgB₂ overlayer on the pure MgB₂ layer serves to prevent the penetration of vortices into the sample. These results provide new ideas for improving the superheating field to design high-performance superconducting radio-frequency cavities.

• 한국초전도학회:학술대회논문집
• /
• v.12
• /
• pp.6-6
• /
• 2002

• 한국초전도학회:학술대회논문집
• /
• v.16
• /
• pp.42-42
• /
• 2006

• Progress in Superconductivity and Cryogenics
• /
• v.15 no.2
• /
• pp.12-15
• /
• 2013

The pure and carbon (C)-doped $MgB_2$ thin films were fabricated on $Al_2O_3$ (0001) substrates at a temperature of $650^{\circ}C$ by using hot-filament-assisted hybrid physical-chemical vapor deposition technique. The $T_c$ value for pure $MgB_2$ film is 38.5 K, while it is between 30 and 35 K for carbon-doped $MgB_2$ films. Expansion in c-axis lattice parameter was observed with increase in carbon doping concentration which is in contrast to carbon-doped $MgB_2$ single crystals. Significant enhancement in the critical current density was obtained for C-doped $MgB_2$ films as compared to the undoped $MgB_2$ film. This enhancement is most probably due to the incorporation of C into $MgB_2$ and the high density of grain boundaries, both help in the pinning of vortices and result in improved superconducting performance.

• Progress in Superconductivity
• /
• v.3 no.1
• /
• pp.23-27
• /
• 2001

We have investigated the mixed-state magnetoresistance of high quality c-axis-oriented MgB2 thin film for magnetic field from 0.5 T to 5.0 T, applied normal to ab-plane. The temperature dependence of magnetoresistance was well described by vortex glass and fluctuation theories for different temperature regimes. We observed glassy exponent of v(z-1)~3 and upper critical field of $H_{c2}$(0)~35 T, which is consistent with previous data obtained from direct $H_{c2}$(0) measurements. Interestingly, the thermally activated flux flow region was observed to be very narrow, suggesting that the pinning strength of this compound is very strong. This finding is closely related to the recent reports that the bulk pinning is dominant in $MgB_2$and the critical current density of $MgB_2$ thin film is very high, comparable to that of cuprate superconductor. The present results further suggest that $MgB_2$is beneficial to technical applications.ons.

• 한국초전도학회:학술대회논문집
• /
• 2007.07a
• /
• pp.55-55
• /
• 2007

• 한국초전도학회:학술대회논문집
• /
• v.12
• /
• pp.26-26
• /
• 2002

• Progress in Superconductivity and Cryogenics
• /
• v.8 no.3
• /
• pp.18-22
• /
• 2006

We obtained in-situ $MgB_2$ thin films in an one-step process using ESSD (Evaporation Sputtering Simultaneous Deposition) method. In our approach. the Ma evaporator is designed specially Mg and B are simultaneously evaporated and sputtered, respectively, in the specially designed ESSD chamber. The background pressure was less than $1{\times}10^{-6}$ Torr. The substrate temperature was kept at 623 K. The film properties were investigated by both electrical resistivity and PPMS. As a result, typical $T_c$ of films was 11 K.