• Electrical & Electronic Materials
• /
• v.10 no.7
• /
• pp.674-681
• /
• 1997

Ternary compound ceramics, (1-y-x) BaTiO$_3$-y SrTiO$_3$-x MgTiO$_3$(0.00 x 0.20), were fabricated by the conventional ceramic process. The structural and dielectric properties of specimens were investigated while varying the composition and sintering temperature(1,200~1,45$0^{\circ}C$) in order to obtain the optimum condition of capacitor. As is well known, Curie temperature(T$_{c}$) of high dielectric-based ceramic(BaTiO$_3$) was shifted and temperature of capacitance was decreased in according to increase of solid solution with (Sr, Mg)TiO$_3$. As a result, a suitable condition of compound rate for capacitor was obtained such as the BSM-11(0.8BaTiO$_3$-0.1SrTiO$_3$-0.1MgTiO$_3$), and sintering temperature was sintered at 1,25$0^{\circ}C$ for two hours. In this case, dielectric constant<1,300, dielectric loss(tan$\delta$)<0.03, and the variation rate of capacitance had less than 3% in the range -10~7$0^{\circ}C$.>.

• Journal of the Korean Chemical Society
• /
• v.54 no.1
• /
• pp.115-119
• /
• 2010

Neutral red5 (BR 5) adsorption from aqueous solution was investigated. New solid adsorbent was prepared from paper sludge incinerated at $250^{\circ}C$ during 2 hours. Experiments were carried out, in batch system, to remove RB5 dye from the synthetic waste water. Maximum adsorption of 374.98 mg/g at pH 5, at room temperature and contact time of 80 min was obtained. The Langmuir and Freundlich adsorption models were applied to interpret the equilibrium isotherm. The Freundlich isotherm fits quite well with the experimental data (with highly regression coefficient $R^2$). The incinerated sludge solid samples untreated and treated with BR5 dye were characterized by FT-IR spectrophotometer.

• Korean Journal of Poultry Science
• /
• v.17 no.2
• /
• pp.109-114
• /
• 1990

Enzymatic activity of isolated Lysozyme from egg white by cation ion-exchange chromatography was detected with various methods and stability of lysozyme in solution was studied by heat and pH treatments. Lysozyme activity refered to mg pure lysozyme/mg sample was more accurate although it needed standard lysozyme. But lysozyme activity refered to units/mg sample could be detected easily and reducted total detection time. Enzymatic activity of isolated lysozyme which dissolved in 0.066M phosphate buffer(pH 6.3) and then incubated at $37^{\circ}C$ for 2hr was increased remarkably on the lysis of Micrococcus lysodeikticus. The activity of isolated lysozyme by CM Sephadex C-25 was higher in eluting solution of above O. D. 1.0 at 640nm and attained 36, 000 units/mg solid. The stability of isolated lysozyme was decreased by various heat treatment. Activity began to decrease above 6$0^{\circ}C$ and dropped rapidly at $100^{\circ}C$. Especially, 35% loss of activity occured in 0.066M phosphate buffer at $100^{\circ}C$. for 15min. The stability of lysozyme was also affected by pH. lysozyme was very stable in acidic solution but in alkaline solution. Enzymatic activity showed maximum value at pH 3.0 solution while decreased rapidly above pH 6.0 solution.

• Journal of Korean Society of Water and Wastewater
• /
• v.10 no.3
• /
• pp.92-99
• /
• 1996

The effects of membrane fouling on the water permeability were examined using the hollow fiber microfiltration (HMF)membrane. A membrane module with a pore size of 0.1 micron was submerged in the permeation tank and water bath. The applied pressure was 12.4 kPa for direct solid-liquid separation of activated sludge. As the concentration of MLSS(880~2180mg/l) of the feed solution increased, the decreasing rates of the water flux increased and the membrane was clogged more rapidly. The water flux through the membrane did not increase effectively even with the increase in the applied pressure(40.0~93.3kPa). When the membrane was cleaned with water, the recovery rate of water flux were larger for lower applied pressure. The results indicated that the process of direct solid-liquid separation using HMF membrane was effective at lower pressure.

• Journal of Advanced Marine Engineering and Technology
• /
• v.18 no.2
• /
• pp.33-40
• /
• 1994

알루미늄 코팅막은 부식환경으로부터 강판을 보호하는 데에 자주 사용된다. 그러나 이 코팅막은 때때로 사용조건에 따라 제한을 받는다. 아무리 강판상에 치밀한 양질막을 코팅시켰다 할지라도, 사용중 이 피막이 손상을 받아서 강판이 노출되는 경우는 강판과의 갈바닉(Galvanic)작용으로 급격한 부식을 일으킨다. 본 연구는 내식성 개선을 목적으로 해서, 고밀착성의 코팅막을 제공하는 비평형프라즈마 프로세스인 이온프레이팅법에 의해 냉간압연강판상에 Al-Mg합금 코팅막을 제작했다. 제작된 막들은 우선, EMPA측정에 의해 원소조성분석을 한 후, 상구조분석 및 표.단면의 몰포로지(Molphology)를 X선 회절 및 주사형 전자현미경(SEM)에 의해 관찰했다. 또한, 이들막은 탈기시킨 3%NaCl용액중 양극분극 측정을 통해서 내식특성에 대한 평가를 행했다. 이들의 결과에 의하면, 알루미늄과 마그네슘의 조성비에 따라 주상, 미결정 및 아몰포스(Amorphous)조직을 보이는 금속간화합물이나 고용체의 Al-Mg박막이 나타났다. 이들 Al-Mg합금 코팅막은 강판과의 갈바닉 부식작용에 대한 방지 및 부동태 피막의 형성을 촉진하는 등의 좋은 내식성을 나타냈다.

• Korean Journal of Materials Research
• /
• v.18 no.8
• /
• pp.444-449
• /
• 2008

Samples of GaMnAs, GaMnAs codoped with Be, and GaMnAs simultaneously codoped with Be and Mg were grown via low-temperature molecular beam epitaxy (LT-MBE). Be codoping is shown to take the Ga sites into the lattice efficiently and to increase the conductivity of GaMnAs. Additionally, it shifts the semiconducting behavior of GaMnAs to metallic while the Mn concentration in the GaMnAs solid solution is reduced. However, with simultaneous codoping of GaMnAs with Be and Mg, the Mn concentration increases dramatically several times over that in a GaMnAs sample alone. Mg and Be are shown to eject Mn from the Ga sites to form MnAs and MnGa precipitates.

• Journal of the Korean Ceramic Society
• /
• v.39 no.5
• /
• pp.438-445
• /
• 2002

In this study, the glass frit of $PbO-TiO-2-SiO_2-BaO-ZnO-Al_2O-3-CaO-B_2O_3-Bi_2O_3-MgO$ system was manufactured. The glass was melted at $1,400{\circ}C$, quenched and attrition-milled. The glass frit powder was pressed and fired for 2h at the range of $750~1,000{\circ}C$. The crystallization of glass frit began at about $750{\circ}$ and at low temperature, the main crystal phases were hexagonal celsian($BaAl_2Si_2O_8$) and alumina. As the firing temperature increased, the crystal phases of monoclinic celsian, zinc aluminate, zinc silicate, calcium titanium silicate and titania appeared. And the increase of firing temperature led to transformation of hexagonal celsian to monoclinic. The only glass frit containing 15wt% PbO had the crystal phase of solid solution of $PbTiO_3-CaTiO_3$. At the frequency of 1 MHz, the dielectric constant of glass frit crystallized was in the range of 11~16 and the dielectric loss less than 0.020. But the glass frit containing 15wt% PbO had the dielectric constant of 17~26 and loss of 0.010~0.015 because of crystal phase of solid solution of $PbTiO_3-CaTiO_3$.

• Journal of Microbiology and Biotechnology
• /
• v.18 no.3
• /
• pp.483-489
• /
• 2008

Nine newly isolated mushroom strains were tested to assess both their zinc tolerance and potential for zinc removal from an aqueous solution. Four strains of ectomycorrhizal fungi, namely Clavariadelphus truncatus (T 192), Rhizopogon roseolus (T 21), Lepista nuda (T 373), and Tricholoma equestre (T 174), along with five strains of white rot fungi, Lenzites betulina (S 2), Trametes hirsuta (T 587), Ganoderma spp. (T 99), Polyporus arcularius (T 438), and Ganoderma carnosum (M 88), were investigated using zinc-amended solid and liquid media. Their biosorption properties were also determined. The colony diameter and dry weight were used as tolerance indices for fungal growth. C. truncatus and T. equestre were not strongly inhibited at the highest concentrations of (225 mg/l) zinc in solid media. The most tolerant four strains with solid media, C. truncatus, G carnosum, T. hirsuta, and T. equestre, were then chosen for tolerance tests in liquid media. An ectomycorrhizal strain, C. truncatus, was also detected as the most tolerant strain in liquid media. However, the metal-tolerant strains demonstrated weak activity in the biosorption studies. In contrast, the highest biosorption activity was presented by a more sensitive strain, G. carnosum. In addition, seven different biosorbent types from G. carnosum (M 88) were compared for their Zn (II) biosorption in batch experiments.

• Korean Journal of Plant Tissue Culture
• /
• v.22 no.1
• /
• pp.1-5
• /
• 1995

Dry-type artificial seeds were produced by dehydrating alginate-encapsulated somatic embryos of lire. When placed on half- strength MS solid medium 20% of the artificial seeds dehydrated to the level of 80% water loss were capable of germination. Addition of 0.1 mg/L ABA to alginate solution before encapsulation enhanced the germination percentage of those dehydrated to the level of nil to 90% water loss by up to 1.7-folds. The results suggest that ABA may enable somatic embryos to overcome physical and/or physiological restraint by encapsulation and dehydration.

• Analytical Science and Technology
• /
• v.8 no.4
• /
• pp.469-475
• /
• 1995

Di-2-pyridylmethanon 2-thiophenecarboxylie hydrazone(DPMTCH) was synthesized and used as a chromogenic reagent in the spectrophotometric determination of nickel in steel. The proton disc spectrophotometrically, were $pK_{a1}= 2.66$ and $pK_{a2}= 10.98$ ${\mu}=0.5(NaCl)$. Nickel(II) reacts with DPMTCH to form a 1:2 metal-2-ligand ratio complex, the xylene solution of which has an absorption maximum at 417 nm. Beer's law is obeyed over the range $0-1.17\;mg\;ml^{-1}$ of nickel(II). The molar absorptivity of the nickel(II) complex is $4.17{\times}10^4l\;mol^{-1}\;cm^{-1}$. The precision of the method was estimated for 4.7 mg of nickel(II), the coefficient of variation for 15 replicate determinations being 0.34%.