• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2000년도 춘계총회,특별강연,심포지움,연구발표회
• /
• pp.124.1-124.1
• /
• 2000

• 한국진공학회지
• /
• 제12권S1호
• /
• pp.52-55
• /
• 2003

GaAs/AlGaAs quantum-wire (QWR) gain-coupled distributed-feedback (GC-DFB) lasers are fabricated and characterized Constant metalorganic chemical vapor deposition (MOCVD) growth is used to avoid grating overgrowth during the fabrication of DFB structures. Numerical calculation shows large gain anisotropy by optical feedback along the DFB directions near Bragg wavelength. DFB lasing via QWR active gratings is also experimentally achieved.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2003년도 제25회 학술발표회 초록집
• /
• pp.131-131
• /
• 2003

• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2002년도 학술대회 논문집
• /
• pp.91-94
• /
• 2002

Textured Ce$O_{2}$ buffers for YBCO coated conductors were deposited on biaxially textured Ni substrate by metalorganic chemical vapor deposition The texture of deposited Ce$O_{2}$ films was varied with deposition temperature(T) and oxygen partial pressure($Po_{2}$). ($\ell$ 00) textured Ce$O_{2}$ films were deposited at T= 500~$520^{\circ}C$, $Po_{2}$= 0.90~3.33 Torr. The growth rate of the Ce$O_{2}$ films was 150~200 nm/min at T= $520^{\circ}C$ and $Po_{2}$= 2.30 Torr, which was much faster than that prepated by other physical deposition method.

• 한국재료학회지
• /
• 제15권10호
• /
• pp.626-631
• /
• 2005

GaN-related compound semiconductors were grown on the corrugated interface substrate using a metalorganic chemical vapor deposition system to increase the optical power of white LEDs. The patterning of substrate for enhancing the extraction efficiency was processed using an inductively coupled plasma reactive ion etching system and the surface morphology of the etched sapphire wafer and that of the non-etched surface were investigated using an atomic force microscope. The structural and optical properties of GaN grown on the corrugated interface substrate were characterized by a high-resolution x-ray diffraction, transmission electron microscopy, atomic force microscope and photoluminescence. The roughness of the etched sapphire wafer was higher than that of the non-etched one. The surface of III-nitride films grown on the hemispherically patterned wafer showed the nano-sized pin-holes that were not grown partially. In this case, the leakage current of the LED chip at the reverse bias was abruptly increased. The reason is that the hemispherically patterned region doesn't have (0001) plane that is favor for GaN growth. The lateral growth of the GaN layer grown on (0001) plane located in between the patterns was enhanced by raising the growth temperature ana lowering the reactor pressure resulting in the smooth surface over the patterned region. The crystal quality of GaN on the patterned substrate was also similar with that of GaN on the conventional substrate and no defect was detected in the interface. The optical power of the LED on the patterned substrate was $14\%$ higher than that on the conventional substrate due to the increased extraction efficiency.

• 한국재료학회지
• /
• 제9권1호
• /
• pp.42-45
• /
• 1999

The room temperature optical transmission spectra of GaN /InGaN/GaN single quantum wells (SQW) and InGaN/GaN heterostructures grwon by low pressure metalorganic chemical vapor deposition have been measured. The dependence of the absorption edges of the GaN/InGaN/GaN SQW on the well width has been determined from the transmission spectra. The result shows that the absorption edge of GaN/InGaN/GaN SQW shifts towards lower energy as increasing the well width. The dependence of the absorption edges of the InGaN/GaN heterostructures on InN mole fraction has also been determined from the transmission spectra. The result is compared with calculated values obtained from Vegards's laws. Our result shows a good agreement with the calculated values.

• 한국진공학회지
• /
• 제5권3호
• /
• pp.206-212
• /
• 1996

저압MOCVD 방법을 이용하여 76 Torr에서 $In_{1-x}Ga_xAs$ 에피층을 성장하였다. 성장온도에 따른 성장속도의 변화는 크지 않았으며, 격자불일치와 성장온도, $AsH_3/(TMIn+TMGa)$ 비에 따라 표면형상이 변화하는 경향성을 관찰하였다. 깨끗한 byaus을 가지는 $In_{1-x}Ga_xAs$ 에피층의 5K PL 측정을 통하여 2.8meV 반가폭을 가지는 결정성이 좋은 에피가 성장되었음을 확인하였다. 성장온도에 따른 조성의 변화는 크지 않았으며, 고체상에서의 $In_{1-x}Ga_xAs$ 조성은 기체상에서의 원료가스의 확산단계에 의해 결정되었다. 격자불일치와 성장온도가 $In_{1-x}Ga_xAs$ 에피층의 전기적 특성을 결정하는 가장 중요한 변수로 확인되었고, 최적조건에서 성장한 에피층에 대해 상온에서 $8{\times}10^{14}/cm^3$의 전자농도와 11,000$\textrm{cm}^2$/V.sec 의 전자이동도를 얻었다.

• 한국재료학회지
• /
• 제11권8호
• /
• pp.655-660
• /
• 2001

Metalorganic chemical vapor deposition (MOCVD)으로 성장한 $In_{0.5}$ ($Gal_{1-x}$ $Al_{x}$ )0.5P/GaAS 이중 이종접합 구조의 특성을 표면 광전압 (surface Photovoltage ; SPV) 측정으로 연구하였다. $In_{0.5}$($Gal_{1-x}$ $Al_{x}$ )0.5P/GaAS 이중 이종접합 구조의 SPV 측정값을 Lorentzian 피팅한 띠 간격에너지 ($E_{0}$ ) 값과 조성비 (x)로 구한 이론 값이 잘 일치하였다. 그리고 변조 주파수 의존성을 측정한 결과 SPV 신호의 형태는 변하지 않고, 신호의 크기만이 변하는 것은 광 조사에 따른 전기적 상태의 과도 현상에 따른 것이고, GaAs와 InGaAlP의 특성시간의 차이는 광 캐리어의 수명의 차이로 분석된다. 그리고 온도 의존성 측정으로 $In_{0.5}$ /($Gal_{1-x}$ $Al_{x}$ )0.5P/GaAS 이중 이종 접합 시료의 균일한 변형분포와 계면상태가 양호함을 알 수 있었다.

• 한국진공학회지
• /
• 제7권4호
• /
• pp.328-333
• /
• 1998

저압 유기금속 화학증착법을 이용하여 (001) InP 기판 위에 격자 일치된 InAlAs 에 피층 성장 결과 620~$700^{\circ}C$범위에서 성장 온도가 증가할수록 산소 유입량의 감소 때문으로 생각되는 광학적 성질의 향상이 관찰되었으나 $750^{\circ}C$이상의 고온에서는 InP완충층의 열화에 의한 결정성의 감소가 발견되었다. 또한, AsH3의 유량이 증가됨에 따라 성장된 InAlAs층의 Al함유량이 증가하는 현상이 관찰되었고, 이는 Al-As와 In-As의 bond strength 차이로 설 명하였다. InGaAs/InAlAs 단일 양자우물구조에서 측정된 우물두께에 따른 photoluminescence peak energy는 계산 값과 잘 일치하였고, high resolution x-ray diffraction 측정을 통하여 뚜렷한 satellite peak와 fine thickness fringe들이 관찰되는 우수 한 계면특성을 가지는 다중 양자우물구조가 성장됨을 확인하였다.

• ETRI Journal
• /
• 제43권5호
• /
• pp.909-915
• /
• 2021

GaAs on Si grown via metalorganic chemical vapor deposition is demonstrated using various Si substrate thicknesses and three types of dislocation filter layers (DFLs). The bowing was used to measure wafer-scale characteristics. The surface morphology and electron channeling contrast imaging (ECCI) were used to analyze the material quality of GaAs films. Only 3-㎛ bowing was observed using the 725-㎛-thick Si substrate. The bowing shows similar levels among the samples with DFLs, indicating that the Si substrate thickness mostly determines the bowing. According to the surface morphology and ECCI results, the compressive strained indium gallium arsenide/GaAs DFLs show an atomically flat surface with a root mean square value of 1.288 nm and minimum threading dislocation density (TDD) value of 2.4×10⁷ cm^-2. For lattice-matched DFLs, the indium gallium phosphide/GaAs DFLs are more effective in reducing the TDD than aluminum gallium arsenide/GaAs DFLs. Finally, we found that the strained DFLs can block propagate TDD effectively. The strained DFLs on the 725-㎛-thick Si substrate can be used for the large-scale integration of GaAs on Si with less bowing and low TDD.