• 전기학회논문지
• /
• 제65권8호
• /
• pp.1334-1339
• /
• 2016

In a power grid that has a high wind power penetration, the fast voltage support of a wind power plant (WPP) during the grid fault is required to stabilize the grid voltage. This paper proposes a voltage control scheme of a doubly-fed induction generator (DFIG)-based WPP that can promptly support the voltage of the point of common coupling (PCC) of a WPP during the grid fault. In the proposed scheme, the WPP and DFIG controllers operate in a voltage control mode. The DFIG controller employs two control loops: a maximum voltage dip-dependent reactive current injection loop and a reactive power to voltage loop. The former injects the reactive power in proportion to the maximum voltage dip; the latter injects the reactive power in proportion to the available reactive power capability of a DFIG. The former improves the performance of the conventional voltage control scheme, which uses the latter only, by increasing the reactive power as a function of the maximum voltage dip. The performance of the proposed scheme was investigated for a 100-MW WPP consisting of 20 units of a 5-MW DFIG under various grid fault scenarios using an EMTP-RV simulator. The simulation results indicate that the proposed scheme promptly supports the PCC voltage during the fault under various fault conditions by increasing the reactive current with the maximum voltage dip.

• 한국전기전자재료학회논문지
• /
• 제11권5호
• /
• pp.365-370
• /
• 1998

We studied a electrical properties in GaAs/AlGaAs/InGaAs pseudomorphic high electron mobility transistors(PHEMT s) recessed by electron cyclotron resonance(ECR) plasma and wet etching. Using the $NH_4OH$ solution, a nonvolatile AlF$_3$layer formed on AlGaAs surface after selective gate recess is effectively eliminated. Also, we controlled threshold voltage($V_th$) using $H_3PO_4$ etchant. We have fabricated a device with 540 mS/mm maximum transconductance and -0.2 V threshold voltage by using $NH_4OH$ and $H_3PO_4$dip after ECR gate recessing. In a 2-finger GaAs PHEMT with a gate length of 0.2$\mu m$ and width of 100 $\mu m$, a current gain of 15 dB at 10 GHz and a maximum cutoff frequency of 58.9 GHz have been obtained from the measurement of current gain as a function of frequency at 12mA $I_{dss}$ and 2 V souce-drain voltage.

• 한국재료학회지
• /
• 제34권4호
• /
• pp.215-222
• /
• 2024

Because collagen is inherently piezoelectric, research is being actively conducted to utilize it to harvest energy. In this study, a collagen solution was prepared using edible low-molecular-weight peptide collagen powder, and collagen films were fabricated using a dip coating method. The collagen films prepared by dip coating showed a smooth surface without defects such as pinholes or cracks. Dehydrothermal treatment of the collagen films was performed to induce a stable molecular structure through cross-linking. The collagen film subjected to dehydrothermal treatment at 110 ℃ for 24 h showed a thickness reduction rate of 19 %. Analysis of the collagen films showed that the crystallinity of the collagen film improved by about 7.9 % after dehydrothermal treatment. A collagen film-based piezoelectric nanogenerator showed output characteristics of approximately 13.7 V and 1.4 ㎂ in a pressure test of 120 N. The generator showed a maximum power density of about 2.91 mW/m² and an output voltage of about 8~19 V during various human body movements such as finger tapping. The collagen film-based piezoelectric generator showed improved output performance with improved crystallinity and piezoelectricity after dehydrothermal treatment.