• Korean Journal of Food Science and Technology
• /
• v.31 no.1
• /
• pp.122-127
• /
• 1999

Quality changes of Korean ginseng on microwave drying were determined in terms of water activity, crude protein, crude lipid, crude ash, dielectric properties, content of sugar, ginsenoside composion, microstructure. Korean fresh ginseng were subjected to four different processing : 3 min microwave drying and 2 min holding-24 hrs drying (MWI), 5 min microwave drying and 2.5 min holding-24 hrs drying (MW2), 3 min microwave drying and 2 min holding-12 hrs after hot air drying for 12 hrs drying at $45^{\circ}C$ (MWH1), 5 min microwave drying and 2.5 min holding-12 hrs drying after hot air drying for 12 hrs at $45^{\circ}C$ (MWH2), Water content was decreased 14.33% without shrinkage and water activity was 0.57 after microwave drying. Permittivity was increased as water content increased. As temperature increased, permittivity was increased until $40^{\circ}C$ and fast decreased over $40^{\circ}C$. Content of ginsenoside for MW1 and MW2 was higher than that of MWH1 and MWH2. Data of free sugar showed that there was no significant difference in each treatment. The MW2 dried ginseng showed a more compact structure than the MWH2 ginseng.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.18 no.1
• /
• pp.22-28
• /
• 2015

The design on a riser in 1MW OTEC system is performed. The minimum diameter of the riser is decided depending on intake quantity of deep-sea water to supply an OTEC cycle. An applicable pipe material is selected from analyzing the properties of commercial pipes. The selected HDPE pipe with the low density and strength is reinforced with a lumped block attached at the end of and wire ropes along the riser. A lumped block, connected to a floating structure by wire ropes, with 25% and 50% weight of a GFRP riser is designed to be attached the end of a riser. The structural safety of the HDPE riser with wire rope supporting axial loads induced by a lumped block is analyzed under the harsh ocean environmental condition near Hawaii ocean with the numerical method. The final dimension of the riser and accessories is determined considering the economic point of view. The designed riser will be applicable to the construction of the 1 MW OTEC pilot plant.

• Food Science and Preservation
• /
• v.16 no.3
• /
• pp.321-326
• /
• 2009

We assessed quality changes in and washing effects (time and method) on lettuce (Lactuca sativa L.) treated with micro-bubbles. Samples were treated with micro-bubbling for 1, 3, or 5 min, and the 5-min treatment yielded the best results in terms of reduced total microorganism counts, sensory aspects, and degree of washing. Total microorganism counts were 4.30 log colony-forming units (CFU)/g in unwashed lettuce(CT), 4.10 log CFU/g in hand-washed lettuce (HW), 3.98 log CFU/g in conventional, bubble-washed lettuce (BW) and 3.25 log CFU/g in micro-bubble-washed lettuce (MW). In comparison, total counts of samples examined after 10 days of storage were 7.00 log CFU/g for CT, 6.19 log CFU/g for HW, 6.02 log CFU/g for BW, and 5.89 log CFU/g for MW. The lowest counts were seen after micro-bubble treatment. BW and MW samples showed significantly higher counts than did CT and HW samples. In general, BW and MW samples did not vary significantly in count numbers. MW showed a 2.3-fold lower residual pesticide level compared with CT, and also had the lowest level of impurities. HW and BW samples were not well washed.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2016.05a
• /
• pp.574-574
• /
• 2016

유역으로 유입되는 오염물질의 발생원은 점오염원과 비점오염원으로 구분할 수 있으며 점오염원의 경우 생활하수, 산업폐수, 그리고 축산폐수에 대해 처리시설 확충 및 기술개발을 통해 관리하고 있다. 비점오염원에서의 오염물질 유출은 토지이용, 강우, 불특정적인 오염물질 투입상태 등에 따라 다르며, 지역적 특성에 영향을 받기 때문에 불확실성이 고려되어야 한다. 특히 농촌지역에서의 비점오염은 접근이 어렵고 관리주체가 모호하여 좀처럼 규명되지 않았으며, 전국적으로 그 영향이 정량화되지 않아 실질적인 관리 및 대책마련에 어려움이 있었다. 특히, 가축분뇨의 발생으로부터 처리, 자원화에 이르기까지 각 관리체계에 있어서 축산비점오염의 배출경로와 수계오염부하량, 수질환경 영향을 정밀하게 분석하여 향후 대책마련을 위한 기초자료를 확보할 필요가 있다. 또한 전국적으로 비점오염이 수계에 미치는 영향과, 그 중 축산비점오염의 영향을 면밀히 분석하여 향후 정책 및 제도개선을 위한 과학적 기초자료로서 활용할 필요가 있다. 따라서 본 연구에서는 축산 밀집 지역을 대상으로 오염원 조사를 통해 강우시 비점오염 모니터링 지점을 선정 하였으며, 년5회씩 강우 모니터링을 하여 기초데이터를 축적 하였다. 대상지역은 강원도 횡성군에 위치한 일리천 유역이며 농가 수는 총 90개의 농가가 위치하고 있는데 그 중 돼지 1,467마리, 한우 1,957마리, 젖소 581마리, 개 2,880마리, 닭 75,000마리, 사슴 4마리로 조사되었다. 대상유역을 대상으로 배출부하량을 조사한 결과 BOD 배출부하량은 총 509.3 kg/day, T-N 배출부하량은 총 331.5 kg/day, T-P 배출부하량은 총 28.3 kg/day로 조사되었다. 유출특성을 파악하기 위하여 유량가중평균농도(Event Mean Concentration, EMC)를 산정한 결과 BOD의 경우 MW-4에서 1.2 mg/L - 7.2 mg/L, MW-5에서 0.8 mg/L - 6.3 mg/L, MW-7에서 0.7 mg/L - 5.2 mg/L의 범위를 보였다. T-N의 경우 MW-4에서 1.426 mg/L - 5.321 mg/L, MW-5에서 1.205 mg/L - 4.27 mg/L, MW-7에서 0.989 mg/L - 3.859 mg/L의 범위를 보였다. T-P의 경우 MW-4에서 0.245 mg/L - 0.632 mg/L, MW-5에서 0.236 mg/L - 0.596 mg/L, MW-7에서 0.213 mg/L - 0.521 mg/L의 범위를 보였다. 본 연구에서 EMC를 산정한 방법은 평시 수질 및 유량을 정하는 기준에 따라 값이 많이 달라질 수 있다. 따라서 합리적으로 평시 부하량을 제외하고 강우시의 영향을 파악할 수 있는 EMC 산정방법에 대한 추가적인 고찰이 필요할 것으로 사료된다.

• Journal of Korean Society of Water and Wastewater
• /
• v.19 no.4
• /
• pp.480-486
• /
• 2005

The main goals of this work are to investigate the effect of molecular weight distribution(MWD) and activated carbon adsorption capacity after conventional coagulation and enhanced coagulation. The ozonation was very effective to decompose the NOM to smaller size and to remove molecular smaller than 1,000. The concentration of DOC was reduced 0.25mg/L and 0.56mg/L by the conventional coagulation and the enhanced coagulation, respectively The conventional coagulation was not effective to remove NOM. However, the enhanced coagulation was effective to remove MW bigger than 10,000. The higher MW was shifted to smaller weight by ozonation in the raw water and the after conventional coagulation. After enhanced coagulation the MW had not changed significantly by ozonation. Also, it was observed that the ozone dosage did not have significant impact on MW shifting to smaller size. The adsorption capacity simulated by IAST comparing K values showed that the adsorption capacity was not impacted by ozone doses. There was very strong correlation between MW smaller than 10,000 and the mid- and strongly adsorbable fractions.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.58 no.4
• /
• pp.388-392
• /
• 2013

The proteins from functional rice cultivars (Nogwonchalbyeo, Giant embryonic, Arhyangchalbyeo, and Goamibyeo) and general white rice were extracted and separated using two-dimensional (2D) gel electrophoresis. A wide variation in the molecular weight (MW) and pH range of the expressed proteins in rice samples were observed. The green-kerneled rice (Nogwonchalbyeo) exhibited proteins with MW of 9-57 kDa and appeared at a pH range of 4-7. The Giant embryonic contained proteins with MW of 31-63 kDa and a pH range of 5-6. The aromatic glutinous rice (Arhyangchalbyeo) showed proteins with MW of 24-28 and pH of 5.8-6.8. The high-amylose rice (Goamibyeo) exhibited proteins with MW of 3-63 and pH of 5.2-5.6. The identified proteins uniquely found and highly expressed in each cultivar may have a significant role on rice functionality. The results illustrate that the 2D gel electrophoresis is a valuable method in the determination of the protein expression profiles in functional rice grains and may be useful in the identification of specific marker proteins associated with the functional property of rice.

• Progress in Superconductivity and Cryogenics
• /
• v.6 no.3
• /
• pp.38-43
• /
• 2004

1MW class superconducting synchronous motor is designed considering several conditions such as superconducting wire length, machine efficiency and size. As the machine is larger and larger, the superconducting machine shows the advantages more and more over the conventional machines. Although the advantages at 1MW rating are not so great, the design approach to get an appropriate result would be very helpful for larger superconducting synchronous machine design. Major design concerns are focused on reducing expensive Bi-2223 HTS(High Temperature Superconducting) wire which is used for superconducting field coil carrying the rating current around 30K(-243$^{\circ}C$) while the machine efficiency is higher than conventional motors or generators with the same rating. Furthermore, some iron cored structure is considered to reduce the HTS wire requirement without bad effect on machine performances such as sinusoidal armature voltage waveform, synchronous reactance and so on.

• Journal of Advanced Marine Engineering and Technology
• /
• v.35 no.8
• /
• pp.1063-1069
• /
• 2011

This paper presents aerodynamic power outputs of wind turbine of 6 MW wind farm composed of 3 sets of 2 MW wind turbine according to the separation distance by using CFD. Layout design including offshore wind farm and onshore wind farm is key factor for the initial investment cost, annual energy production and maintenance cost. For each wind turbine rotor, not actuator disc model with momentum source but full 3-dimensional model is used for CFD and it has a great technical meaning. The results of this study can be applied to the offshore wind farm layout design effectively.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.18 no.1
• /
• pp.44-51
• /
• 2004

Fractal-space multiplexing using a moving window(MW) can multiplex holograms by moving a window left and right. and up and down. But, crosstalk occurs by two neighboring moving windows in the vertical direction of the holographic memory system and limits high-density information recording. Accordingly, we analyzed the crosstalk with the focal length of lens, the distance of MW, and the number of multiplexed hologram to record high-density infromation and presented the optical experimental results of fractal-space multiplexing using volumetric photorefractive crystal and disc type photopolymer.

• New & Renewable Energy
• /
• v.7 no.2
• /
• pp.59-69
• /
• 2011

5MW wind turbine is regarded as a promising system for offshore wind farms in the western sea of Korean. And the wind turbine is developed in many companies but not much information is known about it. In this study, aerodynamics and control characteristics depending on several control methods is reviewed on 5MW wind turbine, in which configuration data of the turbine are used from the previous study of NREL. For the calculations, GH_Bladed, which is certificated software by GL, is used and compared with data from FAST code of NREL. This study shows that how much power production, and aerodynamic performances and loads can be obtained with different controls in the operation of 5MW wind turbine, which is expected to be useful in the design of the wind turbine system.