• Aerospace Engineering and Technology
• /
• v.5 no.2
• /
• pp.27-36
• /
• 2006

This paper describes the performance test procedures and results of NRSB-1M and NRSB-2M Not only aerodynamic performance test but also sound measurement test were performed for the small-scaled blades in the ground Total thrusts and torques of the rotor were measured using rotating balance for aerodynamic performance test. Sound pressure levels were measured using microphone in 1.64D distance for sound measurement test. Non-dimensionalized test data are compared and analyzed. Consequently, It was confirmed that NRSB-2 was better than NRSB-1.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.11a
• /
• pp.431-434
• /
• 2009

Conceptual study of an open-circuit type low-speed wind tunnel for test of wind turbine blade is conducted. The tunnel is constituted of a settling chamber, a contraction, closed and open test sections, a diffuser, two corners, a cross leg and a fan and motor. For the performance test, the closed test section width of 1.8 m, height of 1.8 m and length of 5.25 m is selected. The open test section with dimension width of 1.8 m, height of 1.8 m and length of 4.14 m is adopted for aeroacoustic test. The contraction ratio is 9 to 1 and maximum speed in the closed test section is 67 m/sec. Input power in the tunnel is about 238 kW and its energy ratio is 3.6. The wind tunnel designed in present study will be an effective tool in research and development of wind turbine.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2002.10a
• /
• pp.693-696
• /
• 2002

This study examined the effects of the testing temperature on the mechanical properties of the carbon tool steel (SK4M) for flat spring. Hardness test and fatigue test were performed at room temperature ($20^{\circ}C$). Tensile test and creep test were performed at temperature range $20^{\circ}C$ ~$160^{\circ}C$. The micro-vickers hardness values of SK4M was Hv=584. The Elastic modulus, tensile strength and yield strength of SK4M at 160t test temperature were decreased 0.92 time, 0.97 time and 0.82 time those of SK4M at 2$0^{\circ}C$ test temperature, respectively. The maximum creep strain for 100hr at creep temperature ($80^{\circ}C$ ~$160^{\circ}C$) and creep stress ($37.4Kgf/\textrm{mm}^2$ ~$93.6Kgf/\textrm{mm}^2$) was 0.572%. The fatigue limit of SK4M was $94Kgf/\textrm{mm}^2$.

• The Journal of Korean Academy of Prosthodontics
• /
• v.49 no.1
• /
• pp.1-7
• /
• 2011

Purpose: The purpose of this study was to investigate the cutting efficiency of coarse grit diamond burs with air-turbine handpiece on natural tooth. Materials and methods: Four groups of coarse grit diamond bur were selected: Komet (A), Shofu (B), Premier (C), and Mani (D). The extracted maxillary central incisors were used, and ten cuts were made on each specimen, using the rotary diamond burs. The surface of each bur was measured at the upper, middle, and bottom of the bur with confocal laser scanning microscope and imaged with SEM. The data were analyzed with one-way ANOVA and t-test at the significance level of 0.05. Results: The surface roughness was measured. At the A diamond bur, the Sa values were $52.93\;{\mu}m$, $48.32\;{\mu}m$, $46.79\;{\mu}m$, $45.06\;{\mu}m$, and $43.43\;{\mu}m$ for control, test 1, 2, 3, and 4 respectively. The Sa values were $50.68\;{\mu}m$, $45.62\;{\mu}m$, $44.41\;{\mu}m$, $44.10\;{\mu}m$, and $42.46\;{\mu}m$ for B diamond bur, $58.02\;{\mu}m$, $55.53\;{\mu}m$, $52.22\;{\mu}m$, $48.26\;{\mu}m$, and $45.36\;{\mu}m$ for C diamond bur, and $50.11\;{\mu}m$, $46.73\;{\mu}m$, $45.46\;{\mu}m$, $42.58\;{\mu}m$, and $41.80\;{\mu}m$ for D diamond bur. Surface roughness after each bur use showed significant changes, but no significant difference was found in surface roughness change between bur systems. Conclusions: Surface roughness in the same bur system showed significant differences after each tooth preparation. However no statistically significant differences were found in surface roughness between bur systems. The SEM images between control and test 4 showed the abraded particles.

• Tunnel and Underground Space
• /
• v.33 no.6
• /
• pp.472-482
• /
• 2023

The grid-type or room-and-pillar method is applied for the purpose of mining horizontally buried minerals. In this study, design and pilot test were performed to apply the room-and-pillar method which uses natural rock as a rock pillar to the construction of underground space. The area where the pilot test was conducted was in stone mine and had good rock conditions with an appropriate depth (about 30 m) to apply the pilot test. The pilot test site was selected by reviewing accessibility and ground conditions and then site construction was performed through detailed ground investigation and design. The pilot test was designed with a column shape of 8×8 m and a cross-section of 8×12 m. The blasting pattern was determined through test blasting at the site, and blasting of 3 m excavation with 89 holes was performed. Through field observations, the average width of 12.5 m and the average height of 8.3 m were measured. Therefore, it is possible to proceed similar to the cross-sectional shape considered in the design.

• Toxicological Research
• /
• v.13 no.3
• /
• pp.203-208
• /
• 1997

The antigenic potential of M3S tumor necrosis factor-$\alpha$(M3S TNF), which is a mutated form of TNF(TNF mutein) designed to reduce adverse effects of wild type human TNF, was investigated in the present study. The antigenicity of M3S TNF was examined by conducting active systemic anaphylaxis (ASA) test in guinea pigs, heterologous(mouse-rat) passive cutaneous anaphylaxis(PCA) test and passive hemagglutination(PHA) test. The experimental animals were divided into low, medium, high and the highest dose groups and the groups with or without immunoadjuvant, sensitized according to the appropriate schedule and challenged. In ASA test, when challenged with 120 $\mu\textrm{g}$ /animal, moderate to severe positive anaphylactic responses were observed in groups sensitized with 12 $\mu\textrm{g}$ /animal, 120 $\mu\textrm{g}$ /animal and 120 $\mu\textrm{g}$ /animal+Freund's complete adjuvant. In PCA test, positive responses were observed in the group sensitized with the highest dose emulsified with an alum(12 $\mu\textrm{g}$ /animal+alum). In PHA test, positive responses were observed in the group sensitized with 3 $\mu\textrm{g}$ /animal emulsified with an alum. All the other groups in each experiment showed negative responses. Based on these results, M3S TNF is considered to have some antigenic potential.

• Korean Journal of Digital Imaging in Medicine
• /
• v.13 no.4
• /
• pp.157-164
• /
• 2011

This test is for checking investigation about quality control of general X-ray system in clinic and hospital. We compared general X-ray system of clinic and hospital which are selected freely in the metropolitan area using PMX-III and carried out quality control. Carried out Kilovoltage test, mR/mAs output test, Light filed/Beam alignment test, Half value layer test. Most of test result are appeared that failure rates of clinic is higher than hospital one. Therefore, we should lower failure rates through regular quality control and make environment which can get high quality image.

• Ocean Science Journal
• /
• v.40 no.1
• /
• pp.17-24
• /
• 2005

A series of experiments were conducted to develop standard test organisms and test protocols for measuring sediment toxicity using candidate amphipods such as Mandibulophoxus mai, Monocorophium acherusicum, Haustorioides indivisus, and Haustorioides koreanus, which are indigenous to Korea. The relevant association of test species with sediment substrates was one of the important factors in sediment bioassay. The indigenous amphipods M mai and M. acherusicum were well associated with test sediments when they were exposed to various sediment substrates from sand to mud. The tolerant limits to various physico-chemical factors affecting bioassay results such as temperature, salinity and ammonia, as well as sensitivities to reference toxicant and contaminated sediments, were investigated using M. mai and M. acherusicum in the present study. These amphipods were tolerant to relatively wide ranges of salinity $(10{\sim}30\;psu)$ and ammonia (<50 ppm), and displayed relevant sensitivity to temperature as well. They are more sensitive to Cd, the reference toxicant, when compared to the standard test species used in other countries. Field-sediment toxicity tests revealed that M. mai would be more sensitive to sediment-associated pollutants than M. acherusicum, while the sensitivity of M. acherusicum was comparable to that of Leptocheirus plumulosus, which has been used as a standard test species in the United States of America. Overall results of this first attempt to develop an amphipod sediment toxicity test protocol in Korea indicated that M. mai and M. acherusicum would be applicable in the toxicity assessment of contaminated sediments, following the further evaluation encompassing various ecological and toxicological studies in addition to test method standardization.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.13 no.4
• /
• pp.239-250
• /
• 1993

The dynamic resilient modulus tests to determine the $M_R$ of the soils require expensive equipments and well trained personnels to obtain reliable test results. These problems inherent in the dynamic resilient modulus testing have been realized as major negative factors to hinder the $M_R$ test from being practically implemented as a routine test. In this regard. it is highly desirable to develop a simpler alternative testing method incorporating inexpensive equipments and easy-to-perform testing procedures. Developed in this study is an alternative $M_R$ test method based on statically repeated loading scheme utilizing the standard static triaxial test equipments. Applicability and limitations of the developed static $M_R$ testing method are investigated for typical subgrade soils in Korea.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.15
• /
• pp.6095-6098
• /
• 2014

Background:Cervical cancer is potentially the most preventable and treatable cancer. Despite the known efficacy of cervical screening, a significant number of women do not avail themselves of the procedure due to lack of awareness. Objectives: This study was conducted to elicit information on the knowledge, attitude and practice (KAP) regarding screening (Pap test) and vaccination for carcinoma cervix among female doctors and nurses in a tertiary care hospital in Bangalore and to assess barriers to acceptance of the Pap test. Materials and Methods: A cross-sectional, descriptive study was conducted with semi-structured, self-administered questionnaire among female health professionals. The study subjects were interviewed for KAP regarding risk factors for cancer cervix, Pap test and HPV vaccination for protection against carcinoma cervix. Results: Higher proportion of doctors 45 (78.9%) had very good knowledge as compared to only 13 (13.3%) of the nurses, about risk factors for cancer cervix and Pap test (p=0.001). As many as 138(89.6%) of the study subjects had favorable attitude towards Pap test and vaccination, but 114 (73.6%) of the study subjects never had a Pap test and the most common reason 35 (31%) for not practicing was absence of disease symptoms. Conclusions: In spite of good knowledge and attitudes towards cancer cervix and Pap test being good, practice remained low among the study subjects and most common reasons for not undergoing Pap test was absence of disease symptoms. The independent predictors of ever having a Pap test done was found to be the occupation and duration of married life above 9yrs. Hence there is a strong need to improve uptake of Pap test by health professionals by demystifying the barriers.