• Macromolecular Research
• /
• v.11 no.3
• /
• pp.189-193
• /
• 2003

pH- and temperature-sensitive bifunctional hydrogels composed of N-isopropylacrylamide (NiPAAm) and a sulfadimethoxine monomer (SDM) derived from sulfadimethoxine were prepared. These hydrogels exhibit simultaneous pH- and temperature-induced volume-phase transitions. The pH-induced volume-phase transition behavior is produced by the ionization/deionization of SDM and is very sharp. In the high pH region, the ionization of SDM induces swelling of the hydrogels. In the low pH region, the deionization of SDM induces deswelling of the hydrogels. The temperature-induced volume-phase transition behavior of the bifunctional hydrogels exhibits negative thermosensitivity because of the NiPAAm component. The hydrogels swell even at low pH as the temperature decreases. The hydrogels swell at low temperature and high pH, and deswell at high temperature and low pH. The volume of the hydrogels dependl on the balance of the swelling and deswelling produced by the two competing stimuli, pH and temperature.

• Proceedings of the KIEE Conference
• /
• 2000.07d
• /
• pp.2365-2367
• /
• 2000

The deterministic errors of semiconductor gyros and accelerometers must be estimated and compensated to develop the low-cost IMU using them. Generally, the dominant errors of the low-cost IMU are bias and misalignment errors. Bias is sensitive to temperature. Therefore, in this paper, the effect on temperature of bias is analyzed and temperature compensation are carryed out. It is shown by experiment that the compensation is efficient.

• Journal of Korean Society of Forest Science
• /
• v.28 no.1
• /
• pp.31-35
• /
• 1975

The present study explored the rapid effect of low temperature on the freezing resistance of dehardening twigs of three apple cultivars and sweet cherry. The effect of low temperature was depending upon the thawing treatment following to the low temperature treatment. When the freezing temperature to $-9^{\circ}C$ for three hours followed by thawing treatment ($5^{\circ}C$) was given repeatedly twice, the low temperature increased apparently the cold hardiness of apple and cherry by 3 to $9^{\circ}C$. On the other hand, when the freezing temperature ($-9^{\circ}C$) for ten hours was pretreated without thawing, the low temperature appeared not affecting the cold resistance of the twigs. The role of freezing-thawing temperature cycle in nature was discussed as a signal of environmental stimulus to which dehardening plant may be responding to increase their cold hardiness so as to adapt against the damage of late frost in early spring.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2015.11a
• /
• pp.179-180
• /
• 2015

In this study, the experimental study on Insulation performance of insulated forms utilizing NT frame heat insulation at low Temperature. For this study, placing insulated TEGO film plywood based form between two constant temperature and humidity chamber that maintaining 10℃, decrease temperature of one chamber to -10℃ and -20℃. Each of steps, maintaining period of temperature was 1 hour. After placing the insulated form, measure temperature of outside if insulated form. As a result of experiment, temperature difference of Fumed Silica Vacuum insulation was lowest.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.15 no.4
• /
• pp.254-260
• /
• 2003

The boiling characteristics for R134a are studied to clarify the hysteresis at low temperature on enhanced tubes of a flooded evaporator. Initial boiling conditions, refrigerant temperature, and inlet temperature of the chilled water are considered as the key parameters of the experiments. Unlike previous studies of the boiling heat transfer with uniform heat flux and uniform wall temperature, the wall temperature was varied along the tube. In, this study, it was found that the hysteresis of the temperature overshoot (705) at the onset of nucleate boiling initially at the inlet section of the tube. It is also concluded that the abnormal operation can be avoided during the low temperature boiling if the refrigeration system is started with LMTD larger than $3.4^{\circ}C$ at initial stage and larger than $1.0^{\circ}C$ at normal stage.

• Electrical & Electronic Materials
• /
• v.10 no.9
• /
• pp.869-875
• /
• 1997

Bi based superconducting thin films were fabricated by 4-target RF magnetron sputtering using the method of controlling the on-off time. These thin films showed better crystal structures. The ratio of Cu/Bi decreased but the critical temperature increased with increasing the temperature of the substrate. High temperature phase low temperature of the substrate. High temperature phase low temperature phase and semiconducting phase can be formed by controlling the on-off time of the shutter respectively.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2015.05a
• /
• pp.57-58
• /
• 2015

In this study, the experimental study on Thermal Performance of Insulated Forms with Different Insulating Methods at Low Temperature. For this study, placing insulated plywood based form between two constant temperature chamber that maintaining 10℃, decrease temperature of one chamber to -10℃ and -20℃. Each of steps, maintaining period of temperature was 1 hour. After placing the form, measure temperature of opposite side of the insulated form. As a result of experiment, temperature difference of rigid urethane was lowest.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.15 no.3
• /
• pp.936-943
• /
• 1991

• Journal of Adhesion and Interface
• /
• v.5 no.2
• /
• pp.1-7
• /
• 2004

A novel carboxyl terminated butadiene-acrylonitrile (CTBN) modified, low temperature cure epoxy film adhesive was developed in this paper. It can be cured at as low as $75^{\circ}C$ for 4 hours with a pressure of 0.1MPa. After post cure at $120^{\circ}C$ for 2 hours, the bonding strengths of Phosphoric Acid Anodizing(PAA) surface treated aluminum adherend were similar to those of structural film adhesives curing at $120^{\circ}C$. It is suitable to bond both metal/composite laminate-to-laminate and laminate to honeycomb structure.

• Korean Journal of Environmental Biology
• /
• v.22 no.2
• /
• pp.279-286
• /
• 2004

This study observed the temperature and humidity within the green zone to understand the effect that land coverage and the structure of forests have on the relief of micro-climate control. Based on this set of data, this study interpreted, through the regression analysis, the relevance of land coverage of the green zone with temperature and distribution of humidity, as well as the amount of green with the relief of microclimate control. The results of the study demonstrated that high temperature regions were formed in barren areas, and low temperature regions in forests or near the water. In particular, low temperature was found in areas covered with tall and small trees, the water surrounded by forests and areas enclosing small rivers. Furthermore, mechanisms causing low temperature were, among others, the ratio of land coverage (forest, grassland, water). In fact, the temperature reduction effect varied in accordance with the types and ratios of the land coverage. Humidity also showed a close correlation with the distribution of temperature high temperature areas had low humidity and low temperature areas had high humidity. Such a phenomenon.