• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.38 no.10
• /
• pp.754-764
• /
• 2001

Class A bipolar second-generation current conveyor (CCII) with low current-input impedance and its offset-compensated CCII for high-accuracy current-mode signal processing are proposed. The CCIIs consist of a regulated current-cell for current input, a emitter follower for voltage input, and a cascode current mirror lot current output. In these architecture, the two input stages are coupled by current mirror to reduce the current input impedance. Experiments show that the CCII has impedance of 8.4 Ω and offset voltage of 40 mV at current input terminal. To reduce this offset, the offset-compensated CCII adopts diode-connected npn and pnp transistor in the proposed CCII. Experiments show that the offset-compensated CCII has current input impedance of 2.1 Ω and offset voltage of 0.05 mV. The 3-dB cutoff frequency of the CCIIs when used as a voltage follower extends beyond 30 MHz. The power dissipation is 7.0 mW

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.47 no.4
• /
• pp.273-278
• /
• 2002

An efficient low-input system (LIS) for fertiliser use in rice cultivation is necessary to reduce fossil energy use and pollution. Japanese people like Japonica rice, especially cv. Koshihikari. However, it has very low lodging resistance in Japanese weather condition. Our objective was to develop a LIS with the minimum sacrifice of grain yield in rice. Koshihikari was grown using conventional fertilization as a control (CON) with 4 g N $m^{-2}$., 8g $P_2$ $O_{5}$ $m^{-2}$ and 8 g $K_2$O $m^{-2}$ as a basal fertilizer dressing. It was compared with a low fertilizer treatment (LF) with only 4 g $P_2$ $O_{5}$ $m^{-2}$ as a basal dressing in the first year and no basal phosphorus fertilizer in the second year. Chopped rice straw was incorporated into the soil before the cropping season in both years. Fertilizer of 4 g N $m^{-2}$ was top-dressed at 15 days before heading in CON plots and 30 days before heading in LF plots in both years. Lodging was significantly less in LF than in CON plots, however, no rice straw effect was found in low fertilized condition. Grain yields in LF plots were reduced by 15-16% below those of CON plots. Lower yields in LF plots were associated with a reduced number of spikelets per unit area. However, big spikelet size was acquired in LF by 10 days earlier N top dressing than CON plots. A close relationship was found between spikelet numbers and N content of the plant at heading, and between grain yield or shoot dry weight and N content of the plant at maturity. Regardless of the fertilizer application methods, N use efficiency for the number of spikelets, final total dry matter and grain yield was essentially identical among fertilizer treatments. The reduced growth and yield in the LF plots resulted from low absorption of nitrogen. Conclusively, LIS can drastically reduce chemical fertilizer use and facilitate harvest operations by reducing lodging with some yield reduction..

• Korean Chemical Engineering Research
• /
• v.50 no.3
• /
• pp.588-593
• /
• 2012

Compatibility of unsaturated polyester (UP) and low profile agent (LPA) of polystyrene (PS) have been investigated under various mixing conditions such as the ratio of UP and LPA, mixing time, mixing temperature, and input amount of 2nd UP. It was possible to obtain mixture with small particle size and low phase separation in condition of 35 g of LPA, 25 g of 1st UP input, 5 min of mixing time, 1700 rpm of mixing speed, and 45 g of 2nd UP input. It was found that compatibility of UP and LPA was very sensitive to mixing conditions. In addition, molded sample using sheet molding compound prepared by stable mixing condition appeared good properties such as low water adsorption, low shrinkage, and high gloss.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.26 no.6
• /
• pp.868-874
• /
• 2002

A high-impulse, low-power, digital microthruster has been developed using low-boiling-temperature liquid propellant with high-viscosity fluid plug. The viscous fiction force of the fluid plug increases the blast pressure and the low-boiling-temperature liquid propellant is intended to reduce input power consumption. The three-layer microthruster has been fabricated by surface micromachining as well as bulk micromachining in the size of 7$\times$13$\times$1.5㎣. A digital output impulse bit of 6.4$\times$10$^{-8}$ Nsec has been obtained from the fabricated microthruster using perfluoro normal hexane (FC72) propellant and oil plug, resulting in about ten times increase of the impulse bit using one hundredth electrical input energy compared to the conventional multiple-shot microthruster.

• Proceedings of the KSME Conference
• /
• 2001.06c
• /
• pp.59-63
• /
• 2001

A high-impulse, low-power, continuous-shot microthruster has been developed using low boiling temperature liquid-propellant with high viscous fluid-plug. The viscous friction force of the fluid-plug increases the blast pressure and the low boiling temperature liquid-propellant is intended to reduce input power consumption. The three-layer microthruster has been fabricated by surface micromachining as well as bulk micromachining in the size of $7{\times}13{\times}1.5mm^{3}$. A continuous output impulse bit of $6.4{\times}10^{-8}N{\cdot}sec$ has been obtained from the fabricated microthruster using perfluoro normal hexane (FC72) propellant and oil plug, resulting in about ten times increase of the impulse bit using one hundredth electrical input energy compared to the conventional continuous microthruster.

• Journal of Power Electronics
• /
• v.7 no.4
• /
• pp.328-335
• /
• 2007

A conventional Single-Stage Power-Factor-Correction (PFC) AC/DC converter has a link capacitor voltage problem under high line input and low load conditions. In this paper, this problem is analyzed by using the voltage conversion ratio of the DC/DC conversion cell. By applying this analysis, a new Single-Stage PFC AC/DC converter with a boost PFC cell integrated with a Voltage-Doubler Rectified Asymmetrical Half-Bridge (VDRAHB) is proposed. The proposed converter features good power factor correction, low current harmonic distortions, tight output regulations and low voltage of the link capacitor. An 85W prototype was implemented to show that it meets harmonic requirements and standards satisfactorily with near unity power factor and high efficiency over universal input.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2002.11a
• /
• pp.16-20
• /
• 2002

This paper describes the resistive FET mixer with low IF for the 4-Ch DBF(Digital Beam Forming) receiver with LNA(Low Noise Amplifier). This DBF receiver based on the direct conversion method is generally suitable for high-speed wireless mobile communications. A radio frequency(RF), a local oscillator(LO) and an intermediate frequency(IF) considered in this research are 2.09 ㎓, 2.08 ㎓ and 10㎒, respectively. The RF input power, LO input power and Vgs are used -10㏈m, 6㏈m and -0.4 V, respectively. In the 4-Ch resistive FET mixer with LNA, the measured IF and harmonic components of 10㎒, 20㎒, 2.09㎓ and 4.17㎓ are about -12.5 ㏈m, -57㏈m, -40㏈m and -54㏈m, respectively. The IF output power observed at each channel of 10㎒ is about -12.5㏈m and it is higher 27.5 ㏈m than the maximum harmonic component of 2.09㎓. Each IF output spectrum of the 4-Ch is observed almost same value and it shows a good agreement with the prediction.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2008.10a
• /
• pp.890-893
• /
• 2008

In this paper, we present a low complexity modified multi-level sphere decoder (SD) for multiple-input multiple-output (MIMO) systems employing quadrature amplitude modulation (QAM) signals. The proposed decoder, exploiting the multi-level structure of the QAM signal scheme, first decomposes the high-level constellation into low-level 4-QAM constellations, so-called sub-constellations. Then, it deploys SD in the sub-constellations in parallel. In addition, in the searching stage, it uses the optimal low-complexity sort method. Computer simulation results show that the proposed decoder can provide near optimal maximum-likelihood (ML) performance while it significantly reduces the computational load.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.9
• /
• pp.41-45
• /
• 2014

In this paper, a high-efficiency power amplifier is implemented by using a drain bias control circuit operated at low input power for WPT(Wireless Power Transfer). Adaptive bias control circuit was added to high-efficiency class-E amplifier. It was possible to obtain the overall improvement in efficiency by adjusting the drain bias at low input power. The proposed adaptive class-E amplifier is implemented by using the input and output matching network and serial resonant circuit for improvement in efficiency. Drain bias control circuit consists of a directional coupler, power detector, and operational amplifier for adjusting the drain bias according to the input power. The measured results show that output powers of 41.83 dBm were obtained at 13.56 MHz. At this frequency, we have obtained the power added efficiency(PAE) of 85.67 %. It was confirmed increase of PAE of an average of 8 % than the fixed bias from the low input power level of 0 dBm ~ 6 dBm.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.40 no.3
• /
• pp.19-32
• /
• 2003

In the conventional photorefractive joint transform correlator(PRJTC), the intensity ration of input signal-to-pump beam should be large enough to saturate two-beam coupling transfer function to obtain a desired correlation result. As a result, the signal-to-noise ratio(SNR) of correlation result is decreased in a noisy input image. In this paper, we propose the improved method for increasing the SNR of the PRJTC by using the characteristics of BaTiO$_3$. We stop the energy transfer saturating by low intensity ratio of input beam and realize a short length of effective interaction in BaTiO$_3$ by making large incident angle of the signal beam. So the gain in high frequency area is decreased and the gain in low frequency area comes up to the saturation gain of the beam coupling transfer function. Therefore the SNR is improved in noisy input image and the PRJTC can be easily realized by low intensity ratio of input beam.