• The Transactions of the Korean Institute of Electrical Engineers C
• /
• v.52 no.11
• /
• pp.512-515
• /
• 2003

This paper is to investigate how partial discharge pulse signal can flow in 6.6㎸ motor stator windings. Pulse propagation is experimentally analyzed in stator windings using a variety of frequency-domain techniques. The experiments were performed on two stator windings in the laboratory. Spectrum analyzer(9KHz to 3㎓) with tracking generator(100kHz to 3㎓) was used. Sweep time of the tracking generator was looms. The frequency spectrum of the response signal was detected by active FET probe(1㎓). The active FET probe has a flat amplitude response up to 1㎓ without high frequency attenuation. The stator winding acts as a low-pass filter below 600KHz, the high-frequency components being highly declined. The resonance peaks show about 1.1MHz and 2MHz in low frequency of No. 1 and No. 2 stator windings, respectively. This low-frequency range indicates that attenuation is low. The peaks of partial discharge magnitude show about 900MHz, 1.6MHz in No. 1 stator winding and about 800KHz, 1.4MHz in No. 2 stator winding.

• Composites Research
• /
• v.23 no.4
• /
• pp.1-6
• /
• 2010

The dynamicresponse of biomimetic composites mimicking nacre under low velocity impact is investigated. The composites have hierarchical structures with a staggered pattern consisting of a protein and a mineral. To analyze the impact response of the composites, the finite element method is used. The effects of the hierarchical structures of the compositeson the dynamic response are examined. It is shown that the maximum stress, displacement and contact force in the composite subjected to low velocity impact decrease as the level of structural hierarchy increases.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 1993.06a
• /
• pp.1054-1057
• /
• 1993

A direct method of fuzzy inference and a fuzzy algorithm with learning function are applied to the steam generator level control of nuclear power plant. The fuzzy controller by use of direct inference can control the steam generator in the entire range of power level. There is a little long response time of fuzzy direct inference controller at low power level. The rule base of fuzzy controller with learning function is divided into two parts. One part of the rule base is provided to level control of steam generator at low power level (0%∼30% of full power). Response time of steam generator level control at low power level with this rule base is shown generator level control at low power level with this rule base is shown to be shorter than that of fuzzy controller with direct inference.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.1
• /
• pp.7-11
• /
• 2002

A novel microstrip type law-pass filter using thin or thick film resistors is proposed to efficiently eliminate harmonic spurious response in stop-band. The proposed low-pass filter shows the spurious suppression enhancement of 20 dB over a conventional one. The designed low-pass filter could be used as a harmonic rejection filter of a local oscillator for Ku-band satellite payload system.

• Steel and Composite Structures
• /
• v.49 no.3
• /
• pp.281-291
• /
• 2023

Due to the fact that the nonlinear low-velocity impact response of graphene platelets reinforced metal foams (GPLRMF) doubly curved shells have not been investigated in the existing works, this paper aims to solve this issue. Using Reddy's high-order shear deformation theory (HSDT), the nonlinear governing equations of GPLRMF doubly curved shells are obtained by Euler-Lagrange method, discretized by Galerkin principle, and solved by the fourth-order Runge-Kutta method to obtain the impact force and central deflection. The nonlinear Hertz contact law is applied to determine the contact force. Finally, the impacts of graphene platelets (GPLs) distribution pattern, porosity distribution form, porosity coefficient, damping coefficient, impact parameters (radius and initial velocity), GPLs weight fraction, pre-stressing force and different shell types on the low-velocity impact curves are analyzed. It can be found that, among the four shell structures, the impact resistance of spherical shell is the best, while that of cylindrical shell is the worst.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.9 no.2
• /
• pp.221-228
• /
• 1997

A strong combustion-driven sound from a surface burner made of a perforated metal fiber plate for premixed gas was investigated to clarify the physical mechanism of its generation. A simple model was developed for the acoustic power generation in terms of the heat transfer response function and the acoustic impedance of the burner. The acoustic impedance of the perforated metal fiber placed on the open exit was measured and the heat release response of the burner to the oscillating flow associated with the acoustic disturbance was expressed in terms of a response function. It was found that the power is generated by the heat release in response to the downstream particle velocity, in contrast to the upstream velocity in the case of the Rijke oscillation driven by a heater placed in the lower half of a columm with upstream flow. The measured frequencies of the oscillation were in agreement with the estimated resonance frequencies and their excitation was varied with the combustion conditions. For the same fuel rate, the excited frequency increases with the air ratio if it is low but decreases with the ratio if not so low. Such frequency characteristics were explained by assuming a heat release response function with a time constant and it was shown that the excited frequency decreases as the time constant increases.

• Journal of Korean Institute of Industrial Engineers
• /
• v.38 no.1
• /
• pp.25-30
• /
• 2012

Desirability approaches have been proposed to find an optimum of multiple response problem. The existing desirability approaches use either of mean or min of individual desirability in aggregation of multiple responses. However, in order to find an optimum having high mean and low dispersion among individual desirability, the dispersion needs to be simultaneously considered with its mean. This study proposes bias and variance (BV) method which aggregates bias (ideal target-mean) and variance of individual desirability in multiple response optimization. The proposed BV method was applied to an example to evaluate its usefulness by comparing with existing methods. Evaluation results showed that the solution of BV method was a fairly good compared with DS (Derringer and Suich, 1980) and KL (Kim and Lin, 2000) methods. The BV method can be utilized to multiple response surface problems when decision makers want to find an optimum having high mean and low variance among responses.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.864-867
• /
• 2006

In order to satisfy with the clear visibility without any difficulties such as blurring and tailing, the high refreshing rate technology and fast response time of LC itself were applied to TFT-LCDs. In proportion to the decrease of holding time of 1 frame, the fast transition of LC behavior was necessary to both maintain the luminance and minimize the tailing appearance. The introduction of a new LC mixture for faster response times was realized by the good combination of newly introduced dielectrically neutral LC material so called 'Super Low Viscosity' (SLV) and highly polar $CF_2O-linkage$ LC material. This resulted in about a 20% reduction in the ${\gamma}_1$ of the new LC mixture compared to the references. In accordance with a new LC mixture with low ${\gamma}_1$, fast response time of 5ms has been made for S-IPS LCD TV application. Consequently, by applying the high frame frequency of 120Hz driving alongside the 5ms response time characteristics, the MPRT value was reduced by half.

• Wind and Structures
• /
• v.12 no.2
• /
• pp.103-120
• /
• 2009

Articulated tower platforms due to its compliant nature are more susceptible to the dynamic effects of wind than conventional fixed platforms. Dynamic response analysis of a double hinged articulated tower excited by low frequency wind forces with random waves is presented in this paper. The exposed super structure of the platform, housing the drilling and production facilities is subjected to mean and fluctuating wind loads, while the submerged portion is acted upon by wind driven waves. The fluctuating component of the wind velocity is modeled by Emil Simiu's spectrum, while the sea state is characterized by Pierson-Moskowitz spectrum. Nonlinearities in the system due to drag force, added mass, variable submergence and instantaneous tower orientation are considered in the analysis. To account for these nonlinearities, an implicit time integration scheme (Newmark's-${\beta}$) has been employed which solves the equation of motion in an iterative fashion and response time histories are obtained. The power spectra obtained from random response time histories show the significance of low frequency responses.

• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.12
• /
• pp.1690-1694
• /
• 2002

Genetic parameters were estimated for birth weight and weaning weight from three year (1991-1993) data totalling 1100 records of 25 rams to 205 ewes of Indigenous Sabi flock maintained at Grasslands Research Station in Zimbabwe. AIREML procedures were used fitting an Animal Model. The statistical model included the fixed effects of year of lambing, sex of lamb, birth type and the random effect of ewe. Weight of ewe when first joined with ram was included as a covariate. Direct heritability estimates of 0.27 and 0.38, and maternal heritability estimates of 0.24 and 0.09, were obtained for birth weight and weaning weight, respectively. The total heritability estimates were 0.69 and 0.77 for birth weight and weaning weight, respectively. Direct-aternal genetic correlations were high and positive. The corresponding genetic covariance estimates between direct and maternal effects were positive and low, 0.25 and 0.18 for birth weight and weaning weight, respectively. Responses to selection were 0.8 kg and 0.14 kg for birth weight and weaning weight, respectively. The estimated expected correlated response to selection for birth weight by directly selecting for weaning weight was 0.26. Direct heritabilities were moderate; as a result selection for any of these traits should be successful. Maternal heritabilities were low for weaning weight and should have less effect on selection response. Indirect selection can give lower response than direct selection.