• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1159-1165
• /
• 2008

In this paper, a single-feed equilateral-triangular microstrip antenna with truncated corners is used for achieving diverse radiation polarization. The proposed antenna is excited by a microstrip line, which is place parallel to an oblique side of the equilateral-triangular patch. Depending on whether the three identically-sized comers of the triangular patch are cut or not, the equilateral-triangular microstrip antenna shows linear polarization(LP) or left-hand circular polarization(LHCP) or Tight-hand circular polarization(RHCP). Based on the equilateral-triangular microstrip antenna with truncated corners, a novel reconfigurable microstrip antenna with switchable polarization sense is also proposed. The proposed reconfigurable antenna has a simple structure, consisting of a corner-truncated triangular patch, a small triangular conductor, and a microstrip line. Using a biased PIN diode between the patch and the small triangular conductor, it can produce LP or RHCP according to bias voltages. From the measured results, low cross polarization level when operated in the linear state and good axial ratio in the circular state are observed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.1
• /
• pp.46-53
• /
• 2008

In general, the cassegrain dual offset reflector is used for the satellite communication antenna, but is analyzed as the reflector system for the CPTR(Compact Payload Test Range) facility in here. The near-field at the test zone of the CPTR is obtained by using the physical optics approximation. The CPTR has to provide a uniform plane wave with the minimum amplitude and phase ripple and the low cross polarization. Therefore, in this paper, the near-field pattern are calculated, and the ripple and taper of the field and the cross polarization are investigated with the variation of the reflector geometry and the position of the test region. Especially, the cross polarization of the antenna axis direction which is not found in the satellite reflector antennas is investigated.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.4
• /
• pp.27-37
• /
• 2001

The design, fabrication, and an experimental implementation of the strip patch antenna coupled with a H-shaped aperture arc presented in this paper. The proposed antenna has the wide bandwidth, high gain, and low cross-polarization levels. We measured the VSWR, smith chart impedance characteristic, co/cross polarization pattern, gain, and so on. The measured bandwidth of this antenna is 47.1 %. To reduce the back lobe and increase the gain, when the reflector is used, cross polarization level is below -18.2dB at E-plane and below 25.7 dB at H -plane. The maximum gain at 2.05 GHz is also 10.4 dBi and the 3 dB gain bandwidth with center frequency at 2.17 GHz is 24 %, which is the wide bandwidth. This antenna can find applications in mobile communication, wireless LAN, RF communication system, and so on.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.1
• /
• pp.125-135
• /
• 2001

A 8$\times$4 microstrip antenna array is designed at 5.3 GHz and its characteristics are investigated with respect to the application in dual polarized synthetic aperture radars. The design is focused on the achievement of a wide bandwidth, a high polarization purity, a low loss, a good isolation and some mechanical requirements suitable for the application. The antenna is fed by a -3 dB tapered feed network, and is composed of dual polarized SSFIP (Strip-Slot-Foam-Inverted Patch) elements with honeycomb and shielding plane. Simulation results for the antenna array are presented and compared with measurements. It is observed that the antenna shows a bandwidth of 80 MHz, a polarization isolation better than 20 dB, an isolation of 40 dB, and good mechanical characteristics.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.5
• /
• pp.237-244
• /
• 2010

In this paper, the dual parabolic cylindrical reflector systems are analyzed as the reflector system for the CATR(Compact Antenna Test Range) facility. The near-field at the test zone of the CATR is calculated by using the PO(Physical Optics) approximation. The CATR has to provide an uniform plane wave with the minimum amplitude and phase ripple and the low cross polarization. Therefore, in this paper, the near-field pattern are calculated, and the ripple and taper of the field and the cross polarization are investigated with the position of the subreflector and the test region. It is confirmed that the analysis results can be used for the design of the CATR with the dual parabolic cylindrical reflector.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2016.05a
• /
• pp.79-80
• /
• 2016

In this paper, we considered a design method for a microstrip patch antenna fed through two radiating edges by two feeding microstrip lines. Two feedlines are made to have a phase difference of 180 degree with each other in order to reduce cross-polarization level radiated from the antenna. The operation principle and design procedure for the considered antenna are explained using equivalent circuits. In order to check the validity of this study, the results for reflection coefficients of the antenna obtained by the proposed equivalent circuit method and the simulation using commercial antenna design tool are compared with each other.

• Journal of Biomedical Engineering Research
• /
• v.42 no.1
• /
• pp.25-30
• /
• 2021

Objective: The aim of this study is to consider the effect of skin tissue necrosis by improving blood flow in animal skin models for low frequency pulsed electromagnetic fields (LF_PEMF) stimulation. Methods: Twenty rats (Wistar EPM-1 male, 280-320 g) were randomly divided into control groups (n=10) and the PEMF groups (n=10). To induce necrosis of the skin tissue, skin flap was treated in the back of the rat, followed by isolation film and skin flap suturing. Subsequently, the degree of necrosis of the skin tissue was observed for 7 days. The control group did not perform any stimulation after the procedure. For the PEMF group, LF_PEMF (1 Hz, 10 mT) was stimulated in the skin flap area, for 30 minutes a day and 7 days. Cross-polarization images were acquired at the site and skin tissue necrosis patterns were analyzed. Results: In the control group, skin tissue necrosis progressed rapidly over time. In the PEMF group, skin tissue necrosis was slower than the control group. In particular, no further skin tissue necrosis progress on the day 6. Over time, a statistically significant difference from the continuous necrosis progression pattern in the control group was identified (p<0.05). Conclusions: It was confirmed that low frequency pulsed electromagnetic fields (LF_PEMF) stimulation can induce relaxation of skin tissue necrosis.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.4
• /
• pp.390-395
• /
• 2009

Design and optimization of a broadband meander-line twist reflector was performed for X-band application. Based on the equivalent transmission line model, the polarization twist performance was evaluated. Genetic analysis, particles swarm, and hybrid swarm optimizations were employed to obtain the optimized geometrical parameters. The optimized design exhibits low cross-polarization level below - 25 dB between 8.45 and 11.38 GHz. The polarization twist loss was below 0.2 dB. Comparison between computed and simulated results was also discussed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.7
• /
• pp.712-720
• /
• 2003

In this paper, a multi-layered metallic disk array structure(MDAS) excited by cross-dipole elements was proposed for efficiently shaping of flat-topped element patterns(FTEP) with circular polarization. The MDAS excited by cross-dipole elements has advantages to decrease in volume and weight of an overall array antenna and so, it is appropriate for the FTEP applications of a ralativlely low frequency band. In order to verify the effectness of this structure, the MDAS breadboard operated at X-band(7.9 ∼ 8.4 GHz) was fabricated, and its design parameters were experimentally optimized on the basis of the previous design experience. The experimental results were shown that the MDAS could shape good FTEPs of ${\pm}$20$^{\circ}$beam width at least within a 6.1 % frequency band.

• Transactions on Electrical and Electronic Materials
• /
• v.14 no.6
• /
• pp.329-333
• /
• 2013

SiOC films were prepared by capacitively coupled plasma chemical vapor deposition, and the correlation between the binding energy by X-ray photoelectron spectroscopy and Arrhenius equation for ionization energy was studied. The ionization energy decreased with increase of the potential barrier, and then the dielectric constant also decreased. The binding energy decreased with increase of the potential barrier. The dielectric constant and electrical characteristic of SiOC film was obtained by Arrhenius equation. The dielectric constant of SiOC film was decreased by lowering the polarization, which was made from the recombination between opposite polar sites, and the dissociation energy during the deposition. The SiOC film with the lowest dielectric constant had a flat surface, which depended on how carbocations recombined with other broken bonds of precursor molecules, and it became a fine cross-linked structure with low ionization energy, which contributed to decreasing the binding energy by Si 2p, C 1s electron orbital spectra and O 1s electron orbital spectra. The dielectric constant after annealing decreased, owing to the extraction of the $H_2O$ group, and lowering of the polarity.