• The Bulletin of The Korean Astronomical Society
• /
• v.43 no.2
• /
• pp.39.2-39.2
• /
• 2018

RR Tel is an interacting binary system in which a hot white dwarf (WD) accretes matter from a Mira variable via gravitational capture of the stellar wind. We present a high-resolution optical spectrum of RR Tel obtained with MIKE at Magellan-Clay telescope, Chile. We find broad emission features at 6825, 7082, 7023, and $7053{\AA}$, which are formed through Raman scattering of far-UV O VI ${\lambda}{\lambda}$ 1032 and $1038{\AA}$, C II ${\lambda}{\lambda}$ 1036 and $1037{\AA}$ with atomic hydrogen. Raman O VI 6825 and 7082 features are characterized by double-peaked profiles indicative of an accretion flow with a characteristic speed ~ 30km/s, whereas the Raman C II features exhibit a single Gaussian profile with FWHM ${\sim}10{\AA}$. Monte Carlo simulations for Raman O VI and C II are performed by assuming that the emission nebula around the WD consists of the inner O VI disk with a representative scale of 1 AU and the outer part with C II sphere. The best fit for Raman profiles is obtained with an asymmetric matter distribution of the O VI disk, the mass loss rate of the cool companion ${\dot{M}}{\sim}2{\times}10^{-6}M_{{\odot}/yr}$ and the wind terminal velocity v~10 km/s. We also find O VI doublet at 3811 and $3834{\AA}$, which are blended with other emission lines. Our profile decomposition shows that the O VI ${\lambda}{\lambda}$ 3811, 3834 doublet have a single Gaussian profile with a width ~ 25 km/s. A comparison of the restored fluxes of C II ${\lambda}{\lambda}$ 1036 and 1037 from Raman C II features with the observed C II ${\lambda}1335$ leads to an estimate of a lower bound of N(CII) > $9.87{\times}10^{13}cm^{-2}$ toward RR Tel, which appears consistent with the presumed distance D ~ 2.6 kpc.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.21 no.4
• /
• pp.135-141
• /
• 2021

Interest is growing in the design and development of square wave driven BLDC permanent magnet motors suitable for industrial automation, and the development of position detection circuits and drivers. However, this motor is somewhat limited in its application despite the price and functional advantages due to the decrease in efficiency due to switching loss and vibration and noise. In the process of designing and assembling a BLDC motor, the magnetic pole angle is not uniform or the magnetic flux distribution is distorted due to problems in magnetic circuit design or product non-uniformity in the assembly process. Therefore, these things cause position detection deviation and deteriorate the motor characteristics. In addition, the sine wave driven BLDC system can operate stably only when the signal generated from the position sensor is accurately fed back to the driver. However, since the generated signal cannot perform stable position detection due to the occurrence of DC offset component due to magnetic flux density deviation or magnetization technology, which is an external influence, this study intends to study the proposed circuit that can remove the DC offset component.

• International Area Studies Review
• /
• v.20 no.4
• /
• pp.37-56
• /
• 2016

The purpose of this research is to present the implication for Korean firms' entry into the power market in Myanmar. This study investigated the characteristics of the Myanmar power market and analyzed SWOT, focusing on energy policy, power supply and demand, energy relations with neighboring countries and climate change issue. Opportunity factors are changes in energy strategies, the launch of an energy integration organization, changes in the power energy portfolio, rapid economic and power demand growth, and a clean development mechanism. The threats are high nonfulfillment of a contract, high power loss rates and low electricity distribution rates, increased energy exports to neighboring countries, and vulnerability to climate change. We suggest the use of CHP (Combined Heat and Power), Clean Development Mechanism (CDM), and Multilateral Development Bank (MDB).

• Journal of The Korean Society of Clinical Toxicology
• /
• v.18 no.2
• /
• pp.51-56
• /
• 2020

Purpose: Acute nicotine poisoning by liquid nicotine in electronic cigarettes is becoming an increasing problem worldwide. The current systematic review aimed to determine the harm of acute nicotine poisoning by reviewing published case reports. Methods: An online literature search with PubMed, Embase, Cochrane Library, and KoreaMed database was performed to identify relevant studies addressing acute nicotine poisoning with electronic cigarettes. Two investigators searched the case reports written in English or Korean. Results: Twenty-six cases were included in this study. The routes of intoxication included ingestion in 18 cases, intravenous injection in three cases, subcutaneous injection in two cases, and ocular exposure in two cases. Ten cases had a cardiac arrest, and seven of them died. Seven out of 12 cases with intentional poisoning had a cardiac arrest. Nine children under 18 years were reported, and three of them had a cardiac arrest. Sixteen cases without a cardiac arrest recovered well, except for one case with sudden sensorineural hearing loss. Conclusion: The authors reviewed the risks of electronic cigarette liquid in terms of acute poisoning through a systematic review. The nicotine solution of an e-cigarette can be life-threatening in cases of acute poisoning. Therefore, active emergency treatment with early recognition is necessary. In addition, various management methods and regulations for preventing acute nicotine poisoning, such as restriction of distribution and nicotine concentration, should be considered.

• Computers and Concrete
• /
• v.27 no.5
• /
• pp.417-435
• /
• 2021

The optimal distribution of steel fibers over different layers of concrete can be considered as an appropriate method in improving the structural performance and reducing the cost of fiber-reinforced concrete members. In addition, the use of waste tire rubber in concrete mixes, as one of the practical ways to address environmental problems, is highly significant. Thus, this study aimed to evaluate the flexural behavior of functionally graded steel fiber-reinforced concrete containing recycled tire crumb rubber, as a volume replacement of sand, after exposure to elevated temperatures. Little information is available in the literature regarding this subject. To achieve this goal, a set of 54 one-, two-, and three-layer concrete beam specimens with different fiber volume fractions (0, 0.25, 0.5, 1, and 1.25%), but the same overall fiber content, and different volume percentages of the waste tire rubber (0, 5, and 10%) were exposed to different temperatures (23, 300, and 600℃). Afterward, the parameters affecting the post-heating flexural performance of concrete, including flexural strength and stiffness, toughness, fracture energy, and load-deflection diagrams, along with the compressive strength and weight loss of concrete specimens, were evaluated. The results indicated that the flexural strength and stiffness of the three-layer concrete beams respectively increased by 10 and 7%, compared to the one-layer beam specimens with the same fiber content. However, the flexural performance of the two-layer beams was reduced relative to those with one layer and equal fiber content. Besides, the flexural strength, toughness, fracture energy, and stiffness were reduced by approximately 10% when a 10% of natural sand was replaced with tire rubber in the three-layer specimens compared to the corresponding beams without crumb rubber. Although the flexural properties of concrete specimens increased with increasing the temperature up to 300℃, these properties degraded significantly with elevating the temperature up to 600℃, leading to a sharp increase in the deflection at peak load.

• Journal of Forest and Environmental Science
• /
• v.37 no.2
• /
• pp.116-127
• /
• 2021

Predicting carbon distribution of soil aggregates is difficult due to complexity in organo-mineral formation. This limits global warming mitigation through soil carbon sequestration. Therefore, knowledge of land use effect on carbon stabilization requires quantification of soil mineral cations. The study was conducted to quantify carbon and base cations on soil mineral fractions in Natural Forest, Plantation Forest and Farm Land. Five 0.09 ha were demarcated alternately along 500 m long transect with an interval of 50 m in Natural Forest (NF), Plantation Forest (PF) and Farm Land (FL). Soil samples were collected with soil cores at 0-15, 15-30 and 30-45 cm depths in each plot. Soil core samples were oven-dried at 105℃ and soil bulk densities were computed. Sample (100 g) of each soil core was separated into >2.0, 2.0-1.0, 1.0-0.5, 0.5-0.05 and <0.05 mm aggregates using dry sieve procedure and proportion determined. Carbon concentration of soil aggregates was determined using Loss-on-ignition method. Mineral fractions of soil depths were obtained using dispersion, sequential extraction and sedimentation methods of composite soil samples and sieved into <0.05 and >0.05 mm fractions. Cation exchange capacity of two mineral fractions was measured using spectrophotometry method. Data collected were analysed using descriptive and ANOVA at α_0.05. Silt and sand particle size decreased while clay increased with increase in soil depth in NF and PF. Subsoil depth contained highest carbon stock in the PF. Carbon concentration increased with decrease in aggregate size in soil depths of NF and FL. Micro- (1-0.5, 0.5-0.05 and <0.05 mm) and macro-aggregates (>2.0 and 2-1.0 mm) were saturated with soil carbon in NF and FL, respectively. Cation exchange capacity of <0.05 mm was higher than >0.05 mm in soil depths of PF and FL. Fine silt (<0.05 mm) determine the cation exchange capacity in soil depths. Land use and mineral size influence the carbon and cation exchange capacity of Gambari Forest Reserve.

• Journal of Animal Science and Technology
• /
• v.63 no.1
• /
• pp.1-15
• /
• 2021

As a result of intensive breeding, litter size has considerably increased in pig production over the last three decades. This has resulted in an increase in farrowing complications. Prolonged farrowing will shorten the window for suckling colostrum and reduce the chances for high-quality colostrum intake. Studies also agree that increasing litter sizes concomitantly resulted in decreased piglet birth weight and increased within-litter birth weight variations. Birth weight, however, is one of the critical factors affecting the prognosis of colostrum intake, and piglet growth, welfare, and survival. Litters of uneven birth weight distribution will suffer and lead to increased piglet mortality before weaning. The proper management is key to handle the situation. Feeding strategies before farrowing, management routines during parturition (e.g., drying and moving piglets to the udder and cross-fostering) and feeding an energy source to piglets after birth may be beneficial management tools with large litters. Insulin-like growth factor 1 (IGF-1)-driven recovery from energy losses during lactation appears critical for supporting follicle development, the viability of oocytes and embryos, and, eventually, litter uniformity. This paper explores certain management routines for neonatal piglets that can lead to the optimization of their colostrum intake and thereby their survival in large litters. In addition, this paper reviews the evidence concerning nutritional factors, particularly lactation feeding that may reduce the loss of sow body reserves, affecting the growth of the next oocyte generation. In conclusion, decreasing birth weight and compromised immunity are subjects warranting investigation in the search for novel management tools. Furthermore, to increase litter uniformity, more focus should be placed on nutritional factors that affect IGF-1-driven follicle development before ovulation.

• Molecules and Cells
• /
• v.44 no.3
• /
• pp.168-178
• /
• 2021

The retinal pigment epithelium (RPE) forms a monolayer sheet separating the retina and choroid in vertebrate eyes. The polarized nature of RPE is maintained by distributing membrane proteins differentially along apico-basal axis. We found the distributions of these proteins differ in embryonic, post-natal, and mature mouse RPE, suggesting developmental regulation of protein trafficking. Thus, we deleted tumor susceptibility gene 101 (Tsg101), a key component of endosomal sorting complexes required for transport (ESCRT), in embryonic and mature RPE to determine whether ESCRT-mediated endocytic protein trafficking correlated with the establishment and maintenance of RPE polarity. Loss of Tsg101 severely disturbed the polarity of RPE, which forms irregular aggregates exhibiting non-polarized distribution of cell adhesion proteins and activation of epidermal growth factor receptor signaling. These findings suggest that ESCRT-mediated protein trafficking is essential for the development and maintenance of RPE cell polarity.

• Nuclear Engineering and Technology
• /
• v.54 no.2
• /
• pp.666-673
• /
• 2022

The optimization of a transmission type bremsstrahlung conversion target was carried out with Monte Carlo code FLUKA for intense pulsed electron beams with electron energy of several hundred keV for maximum photon fluence. The photon emission intensity from electrons with energy ranging from 300 keV to 1 MeV on tungsten, tantalum and molybdenum targets was calculated with varied target thicknesses. The research revealed that higher target material element number and electron energy leads to increased photon fluence. For a certain target material, the target thickness with maximum photon emission fluence exhibits a linear relationship with the electron energy. With certain electron energy and target material, the thickness of the target plays a dominant role in increasing the transmission photon intensity, with small target thickness the photon flux is largely restricted by low energy loss of electrons for photon generation while thick targets may impose extra absorption for the generated photons. The spatial distribution of bremsstrahlung photon density was analyzed and the optimal target thicknesses for maximum bremsstrahlung photon fluence were derived versus electron energy on three target materials for a quick determination of optimal target design.

• Journal of Environmental Science International
• /
• v.31 no.7
• /
• pp.543-553
• /
• 2022

The latest aerospace technology is important for the stable flight of a launch vehicle, but weather conditions on the day of launch are also one of the essential factors for successful launch campaign. If a launch vehicle is directly struck while preparing to take off from the launch pad on the day of launch or the electronic device are damaged by induced current during flight of the launch vehicle, this means launch failure and can lead to enormous national loss. Therefore, for a successful launch campaign, it is necessary to analyze the lightning detection characteristics of the Naro Space Center. In this study, the seasonal factors of the lightning that occurred over the Naro Space Center from 2003 to 2017, the influence of the polarity, and the correlation with the lightning intensity was confirmed. As a result, there was a high probability of intensive occurrence of multiple lightning strikes in summer, and a high proportion of positive (+) lightning strikes in winter. Lastly, in the distribution of the number of lightning strikes, an average of 2.0 to 2.5 negative (-) lightning strikes occurs in the coastal regions of the South and West Seas when one flash happens.