• 조명전기설비학회논문지
• /
• 제29권8호
• /
• pp.7-17
• /
• 2015

Changes in melatonin concentration levels by differences in CCT of white LED light focused on Spectral Power Distribution (SPD) differences compared to the same CCT of conventional fluorescent light were analyzed. For this, melatonin concentration levels in saliva samples were taken over four different experiments at seven-day intervals. In 71.4% of participants, it was confirmed that melatonin concentration is suppressed by exposure to light, and a slight difference was observed by different CCTs. In addition, Experiment II with a high CCT was relatively high in terms of the melatonin suppression rate compared to Experiment III. A key finding was the possibility that different SPDs under a particular CCT of white LED light compared to the same CCT of conventional fluorescent light could have the same effect on the melatonin suppression.

• 한국조명전기설비학회지:조명전기설비
• /
• 제6권5호
• /
• pp.19-26
• /
• 1992

A computer program to calculate the illumination distributions of a room interior was made. The room has a light source with arbitrary intensity distribution. The program follows the paths of the particles from the light sources, and the illumination distribution is calculated by repeating this following to many particles. Monte Carlo method is applied to the decision of the direction of the particle from light source, and the new direction of the reflected particles. Making simulation program on this basis, illumination distributions were measured for various light sources and wall surfaces tocertify the calculated results. As a results, it is known that the calculated distribution would be correct if the size of the light source is sufficiently smaller than the size of the room.

• 설비공학논문집
• /
• 제27권8호
• /
• pp.395-401
• /
• 2015

Recently, many research studies have been carried out on the efficiency of light-shelf daylighting systems, especially comparing performance improvements and the limitations of reflective surfaces and their lighting performance. In this study, a crystal face reflective surface is proposed. The objective of the study is to evaluate the lighting performance of a crystal face light-shelf through a performance study. The performance study was carried out in a full scale test-bed in order to calculate the light distribution and energy consumption utilizing the standard indoor illumination as an index. The conclusions of the performance study are as follows. 1) The optimal angle of incidence for daylighting for both the operable flat type light-shelf and the crystal face light-shelf are taken in the natural environment on the dates of the winter and summer solstices, as well as the autumn and spring equinoxes. 2) The application and installation of the crystal face light-shelf can produce a 29.9%~34.3% increase of light distribution within the indoor space. However, the increase of light distribution can also lead to a decrease in the uniformity ratio, a design challenge that should be considered when applying a crystal face light-shelf. 3) It is possible to achieve a 7.98%~13.3% greater reduction in energy consumption when applying a crystal face light-shelf than when applying a flat type light-shelf. The increase in the number of crystal faces should concur with the analysis of the energy reduction. A limitation of the study is that only one predetermined pattern was performance tested for a crystal face light-shelf. In order to carry out further research on crystal face light-shelves, additional performance studies are needed based on alternative patterns and designs.

• 한국광학회지
• /
• 제29권6호
• /
• pp.253-261
• /
• 2018

본 논문은 비대칭 배광을 가지는 LED 광원용 반사경 설계 방법에 대한 연구를 진행하였다. 스포츠 경기에서 광원을 중심으로 대칭 배광을 갖는 조명은 선수와 관중이 광원을 직접적으로 바라보게 되어 눈부심을 발생시키는 문제점이 있다. 이러한 문제점을 해결하기 위해 최적 기울기 각도를 도출하여 비대칭 배광을 갖는 반사경 설계를 진행하였다. 이후 테니스장 조명 규격에 맞게 배치하여 성능 분석을 진행하였고 유럽 표준 조명 등급의 Class 1을 만족하는 것을 확인하였다.

• Tribology and Lubricants
• /
• 제17권6호
• /
• pp.482-489
• /
• 2001

Changes in light transmission characteristics caused by various types of oil contaminations were experimentally measured with a built-in type wear monitoring device. Three kinds of iron powders of different size distribution, carbon duct, two kinds of solutions and grease were used for the test contaminants in this work. Light intensity of the transmitted light was measured with the contamination level. Results showed that the transmitted light intensity decreased linearly with the contamination concentration in the oil and the slope was affected by the size distribution. Light attenuation was also caused greatly by carbon dust, water contamination and poly-meric fibers in terms of the light absorption. As a result, it was proved that the optical measurement device could be applicable effectively for detecting any significant change in lubricating oils.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 2001년도 제33회 춘계학술대회 개최
• /
• pp.287-298
• /
• 2001

Change in light transmission characteristics caused by various types of oil contaminations was experimentally measured with a built-in type wear monitoring device. Three kinds of iron powders of different size distribution, carbon dust, two kinds of solutions and grease were used for the lest contaminants in this work. Light intensity of the transmitted light was treasured with the contamination level. Results showed that the transmitted light intensity decreased linearly with the contamination concentration in the oil and the slope was affected by the size distribution. Light attenuation was also caused greatly by carbon dust, water contamination and polymeric fibers mainly due to the light absorption. As a result, it was proved that the optical measurement device could be applicable effectively for detecting any significant change iii lubricating oils.

• 천문학회보
• /
• 제44권2호
• /
• pp.48.2-48.2
• /
• 2019

Light from universe is absorbed, scattered, and re-released by interstellar dust before it reaches us. Therefore, accurate correction of the observed light requires not only spatial distribution of interstellar dust, but also information on absorption and scattering for each wavelength. Far-ultraviolet (FUV) light is mainly produced by bright, young O-type and some B-type stars, but it is also observed in interstellar space without these stars. Called FUV Galactic light (DGL), these lights are mostly known as starlight scattered by interstellar dust. With the recent release of GAIA DR2, not only accurate distance information of stars in our Galaxy, but also accurate three-dimensional distribution maps of interstellar dust of our Galaxy were produced. Based on this, we performed 3-dimensional Monte Carlo dust scattering radiative transfer simulations for FUV light to obtain dust scattered FUV images and compared them with the observed FUV image obtained by FIMS and GALEX. From this, we find the scattering properties of interstellar dust in our Galaxy and suggest the intensity of extragalactic background light. These results are expected to aid in the study of chemical composition, size distribution, shape, and alignment of interstellar dust in our Galaxy.

• 산업기술연구
• /
• 제21권B호
• /
• pp.149-153
• /
• 2001

A study on the particle growth in $TEOS/O_2$ plasma was performed, and particle size and its distribution was measured by the electrical aerosol analyzer (EAA), light scattering particle size analyzer and the particle size was also determined by SEM. The effects of process variables such as total gas flow rate, reactor pressure, supplied power and initial reactant concentration on the particle growth were investigated. From the EAA results, the particle size distribution is divided into three groups of the cluster size and the small and large size particles. The particle size distribution measured by the light scattering particle size analyzer becomes bimodal, because the cluster size particles smaller than 20 nm in diameter cannot be detected by the light scattering particle size analyzer. The size of particles measured by the light scattering particle size analyzer is in good agreements with those by the SEM. Also we could understand that the particle formation is very sensitive to the changes of reactor pressure and reactant concentration. As the total gas flow rate increases, the particle size decreases because of the shorter residence time. As the reactor pressure, or the reactant concentration increases, the particle concentration increases and the particles grow more quickly by the faster coagulation between particles.

• 대한기계학회논문집B
• /
• 제41권5호
• /
• pp.303-309
• /
• 2017

본 연구에서는 비정상조직(파라핀)을 가진 생체조직에 광을 조사하고 그에 따른 조직의 표면온도와 비정상조직 주위에서의 온도분포를 실험과 해석적 방법을 통해 분석하였다. 파라핀을 이용하여 비정상 조직을 모사한 후 조사하는 광의 파장과 시간을 변화시키면서 조직 주위에서의 온도를 K형 열전대를 사용하여 측정하였다. 또한 전산열전달 기법을 이용하여 해석적으로 조직에 대한 온도분포를 예측하였다. 정상조직과 비정상조직의 주위에서의 온도는 차이가 있었으며, 비정상조직이 있는 경우 표면과 조직 주위의 온도가 높게 나타났다.

• 한국조명전기설비학회지:조명전기설비
• /
• 제10권4호
• /
• pp.53-61
• /
• 1996

광원에 대하여 서로 다른 여러 각도방향에서 광원을 바라볼 때 관측되는 광도 분포 및 재귀반사성능을 측정하기 위해 광도 분포 측정장치(배광측정기)를 제작하였다. 이 장치는 광원을 좌우로 360도, 상하로 $\pm$30도 회전 시킬수 있는 광원회전장치, 광검출기로 광전자증배관(PM Tube)을 쓰는 수광부 및 재귀반사성능 측정용 투광기와 제어 및 표시부로 구성되어 있다. 광도측정범위는 0.01~199900cd, 관측각범위는 0.2~1.5도 이고 광도의 측정오차는 $\pm$3%이다. 제작된 장치의 구조와 성능평가결과가 제기되었다.