• International Journal of Naval Architecture and Ocean Engineering
• /
• 제9권1호
• /
• pp.55-65
• /
• 2017

Underwater torpedo has control fin with very low aspect ratio due to launching from limited size of cylindrical torpedo tube. If the aspect ratio of control fin of underwater vehicle is very low three-dimensional flow around control fin largely reduces control forces. In this study, the end plate was applied to reduce the three-dimensional flow effects of partially movable control fin of underwater vehicle. Through numerical simulations the flow field around control fin was examined with and without end plate for different flap angles. The pressure, vorticity, lift and torque on the control fin were analyzed and compared to experiments. The comparison have shown a reasonable agreement between numerical and experimental results and the effect of end plate on a low aspect ratio control fin. When the end plate was attached to the movable control fin, the lift increased and the actuator shaft torque did not significantly change. As this means less consumption of the actuator shaft torque compared to the control fin that has the same control force, the inner actuator capacity can be reduced and energy consumption can be saved. Considering this, it is expected to be effectively applied to the control fin design of underwater vehicles such as torpedoes.

• 대한기계학회논문집B
• /
• 제30권2호
• /
• pp.117-125
• /
• 2006

In the present study the unsteady forces acting on the pitching foils such as a flat plate, NACA0010, NACA0020, NACA65-0910 and BTE have been measured by using a six-axis sensor in a circulating water tunnel at a low Reynolds number region. The unsteady characteristics of the dynamic drag and lift have been compared to the quasi-steady ones which are measured under the stationary condition. The pitching motion is available for keeping the lift higher after the separation occurs. Especially, the characteristics of the dynamic lift are quite different from the quasi-steady one at high pitching frequency regions. As the pitching frequency deceases, the amplitude of the dynamic lift becomes closer to the quasi-steady one. However, the phase remains different between the steady and unsteady conditions even at low pitching frequencies. On the other hand, the dynamic drag is governed strongly by the angle of attack.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2011년 춘계학술대회논문집
• /
• pp.331-336
• /
• 2011

The flow fields over multi-element airfoils with lift-enhancing flat-plate tabs were numerically investigated. Common choice of the height of the lift-enhancing tabs usually ranges from 0.25% to 1.25% of the reference airfoil chord, and in this study the effect of the position of the tab with l%-chord height was studied by varying the distance of the tab from the trailing edge ranging from 0.5% to 2% of the reference chord. In this paper, the effects of lift-enhancing tabs with various position were studied at a constant Reynolds number on a two-element airfoil with a slotted flap. Computed streamlines show that the additional turning caused by the tab reduces the amount of separated flow on the flap.

• 한국기계가공학회지
• /
• 제20권4호
• /
• pp.24-30
• /
• 2021

In this paper, a structural stability analysis of the swash plate hydraulic piston pump installed on hydraulic supply systems in marine vessels is presented. In order to verify the integrity of the pump design, a standard structural analysis technique based on the finite element method has been applied for various operating and boundary conditions. For the maximum operational torque (223 N·m) at 5°, 10°, and 15° of the swash plate angle, the maximum deformation, equivalent stress and safety factor are evaluated. The analytical results show that under current operating conditions, the structural reliability of the design has been confirmed.

• 비파괴검사학회지
• /
• 제36권4호
• /
• pp.288-294
• /
• 2016

Flexible ECT (eddy current array) probe를 사용하여 판재 및 용접부에 존재하는 notch 결함을 MS-5800E와 OmniScan MX 장비로 검출능력을 비교하고, 주파수와 lift-off를 변수로 신호의 특성을 비교하고자 하였다. 실험 결과, 500, 1000, 1500 kHz를 사용하였을 때 notch 깊이가 증가할수록 신호의 진폭이 증가하는 것으로 나타났고, lift-off 변화에 따른 신호의 진폭은 선형적으로 감소하였다. 또한 용접부 결함은 probe와 시험체의 접촉면에 밀접한 관계가 있다. Probe와 시험체의 접촉면이 양호한 경우 검출감도가 우수하고 그렇지 않은 경우에는 검출감도가 떨어지는 것을 알 수 있었다.

• 수산해양기술연구
• /
• 제22권2호
• /
• pp.36-39
• /
• 1986

The steady potential flow about a TP 620 hydrofoil, flying in air above a dynamic water surface. is calculated by the one dimensional theory as the clearance-to-length ratio tends to very small. The characteristics on water surfare effects of air supported TP 620 hydrofoil over water are compared NACA 4412, NACA 66 and plate. respectively. It is found that using the TP 620 hydrofoil is superior lift coefficients. Moreover for trailing edge shape of the hydrofoil, high lift coefficients at 1 Fmn can be obtained.

• 한국항공운항학회지
• /
• 제6권1호
• /
• pp.7-20
• /
• 1998

A reduction of induced drag is an important problem in order to save fuels. In this study, the aerodynamic characteristics of wing tip devices to reduce induced drag, such as end plate, plain ring, helical ring wing tip device, was experimentally investigated in a low speed wind tunnel. The experimental results showed that the wing model with a helical ring wing tip device reduced a induced drag and increased lift-drag ratio.

• Journal of Advanced Marine Engineering and Technology
• /
• 제36권6호
• /
• pp.808-813
• /
• 2012

본 연구는 정방형주의 후류측으로 분리된 분할판(Detached splitter plate)을 설치한 경우 정방형주의 항력저감특성을 분할판의 폭과 정방형주 후면에서부터 분할판까지의 간격을 변수로 하여 양 항력측정 실험으로 파악한 것이다. 그 결과를 요약하면 다음과 같다. 양 항력의 시간변화를 측정해 본 결과 정방형주의 후류측에 분리된 분할판을 설치한 경우가 본래의 정방형주에 비해 양력의 진폭이 대폭 감소했다. 분할판의 폭비를 고정시킨 경우 정방형주의 항력감소율은 간격비가 증가할수록 증가하다 감소하는 특성을 보였다. 같은 간격비에서는 분할판의 폭비가 클수록 정방형주의 항력감소율이 컸으며, 폭비 H/B=1.5, 간격비 G/B=0.5에서 최대 24.2%의 항력감소율을 보였다.

• 한국항해항만학회:학술대회논문집
• /
• 한국항해항만학회 2002년도 추계공동학술대회논문집
• /
• pp.95-100
• /
• 2002

표면효과익선이란 동체의 날개가 해수면 가까이 비행할 때 수면과 날개 사이에서 양력이 증가되는 표면효과를 이용하는 에너지 절약형 선박이다. 표면효과익선은 낮은 고도로 공기 중에서 비행하여야 되므로 박판으로 이루어져야 한다. 그러므로, 표면효과익선 구조에서 외판의 두께는 얇고 가벼우며 Stringer와 Frame등의 보강재는 외판에 비하여 단면적이 훨씬 크다. 이와 같은 구조에 있어서는 외판이 면내방향의 하중을 받으면 박판인 외판은 순전단장에 가깝게 된다. 이와같이 외판과 큰 단면적을 갖는 String를 서로 조합하여 이루어진 구조는 표면효과익선 구조물의 구조응답해석이 가능하다. 본 연구에서는 기본설계 단계에서 간단하게 기체 구조강도해석을 할 수 있는 기존의 해석적인 방법으로 동체와 표면익의 구조강도를 계산할 수 있는 해석적인 방법을 제시하였다.

• Wind and Structures
• /
• 제35권2호
• /
• pp.109-120
• /
• 2022

The force coefficients of rotating plates in the acceleration stage will vary with rotation rate from 0 to stable rotation rate w₀, which are important for quasi-steady theory of plate-like windborne debris to simulate the trajectory. In this paper, a wind tunnel experiment is carried out to study the effects of geometry and the Reynolds number on the variations of mean force coefficients of rotating plates. The rotational lift coefficients are sensitive to both geometry effect and Reynolds number effect, while the rotational drag and moment coefficients are only sensitive to geometry effect. In addition, new empirical formulas for the rotational lift coefficient and moment coefficients are proposed. Its accuracy is verified by comparing the predicted results with existing test data. Based on the experimental data of rotating plates, a new rotational force model for quasi-steady theory, which can be applied to a wider scope, is proposed to calculate the trajectory of plate-like windborne debris. The results show that the new model provides a better match with the tested trajectories than previous quasi-steady theories.