• Journal of Industrial and Engineering Chemistry
• /
• v.68
• /
• pp.161-167
• /
• 2018

In this study, transition metal coated carbon nanofibers (CNFs) were synthesized and applied as anode materials of Li secondary batteries. CNFs/Ni foam was immersed into 0.01 M transition metal solutions after growing CNFs on Ni foam via chemical vapor deposition (CVD) method. Transition metal coated CNFs/Ni foam was dried in an oven at $80^{\circ}C$. Morphologies, compositions, and crystal quality of CNFs-transition metal composites were characterized by scanning electron microscopy (SEM), Raman spectroscopy (Raman), and X-ray photoelectron spectroscopy (XPS), respectively. Electrochemical characteristics of CNFs-transition metal composites as anodes of Li secondary batteries were investigated using a three-electrode cell. Transition metal/CNFs/Ni foam was directly employed as a working electrode without any binder. Lithium foil was used as both counter and reference electrodes while 1 M $LiClO_4$ was employed as the electrolyte after it was dissolved in a mixture of propylene carbonate:ethylene carbonate (PC:EC) at 1:1 volume ratio. Galvanostatic charge/discharge cycling and cyclic voltammetry measurements were taken at room temperature using a battery tester. In particular, the capacity of the synthesized CNFs-Fe was improved compared to that of CNFs. After 30 cycles, the capacity of CNFs-Fe was increased by 78%. Among four transition metals of Fe, Cu, Co and Ni coated on carbon nanofibers, the retention rate of CNFs-Fe was the highest at 41%. The initial capacity of CNFs-Fe with 670 mAh/g was reduced to 275 mAh/g after 30 cycles.

• Journal of the Korean Electrochemical Society
• /
• v.1 no.1
• /
• pp.33-39
• /
• 1998

To AC impedance study was performed in this study on the interfacial reaction between organic electrolyte and amorphous tungsten oxides thin film, cathodically coloring oxide, prepared by e-beam evaporation method in the 1 M $LiClO_4/PC$ organic solution. The electrochemical reactions at the interface were analyzed by the transient method and the complex impedance spectroscopy. The impedance spectrums showed that the electro-chemical intercalation of lithium cations was consisted of the following three steps; the first step, the charge transfer reaction of lithium cation at the interface between amorphous tungsten oxides thin film and the organic electrolyte, the second step, the adsorption of lithium atom on the surface of amorphous tungsten oxides thin film, and then the third step, the absorption and the diffusion of lithium atom into amorphous tungsten oxides thin layer. The bleaching and the coloring characteristics of amorphous tungsten oxides thin film were explained in terms of thermodynamic and kinetic variables, the simulated $R_{ct},\;C_{dl},\;D$ and $\sigma_{Li}$ by CNLS fitting method. Especially it was found that the limiting values of electrochromic reaction were the molar ratio of lithium, y=0.167 and the electrode potential, E=2.245 V (vs. Li).

• Analytical Science and Technology
• /
• v.23 no.1
• /
• pp.45-53
• /
• 2010

For the determination of chlorine in uranium compound, analytical methods by using a steam distillation and a pyrohydrolysis have been developed. The steam distillation apparatus was composed of steam generator, distilling flask and condenser etc. The samples were prepared with an aliquot of LiCl standard solution and a simulated spent nuclear fuel. A sample aliquot was mixed with a solution containing 0.2 M ferrous ammonium sulfate-0.5 M sulfamic acid 3 mL, phosphoric acid 6 mL and sulfuric acid 15 mL. The chloride was then distilled by steam at the temperature of $140^{\circ}C$ until a volume of $90{\pm}5\;mL$ is collected. The pyrohydrolysis equipment was composed of air introduction system, water supply, quartz reaction tube, combustion tube furnace, combustion boat and absorption vessel. The chloride was separated from powdered sample which is added with $U_3O_8$ accelerator, by pyrohydrolysis at the temperature of $950^{\circ}C$ for 1 hour in a quartz tube with a stream of air of 1 mL/min supplied from the water reservoir at $80^{\circ}C$. The chlorides collected in each absorption solution by two methods was diluted to 100 mL and measured with ion chromatography to determine the recovery yield. For the ion chromatographic determination of chlorine in molten salt retained in a metal ingot, the chlorine was separated by means of pyrohydrolysis after air and dry oxidation, and grinding for the sample.

• Polymer(Korea)
• /
• v.29 no.4
• /
• pp.403-407
• /
• 2005

In this work, the solid polymer electrolyte (SPE) composites, which are composed of poly(ethylene oxide) (PEO), mesoporous mobil crystalline material-41 (MCM-41), and lithium salt, are prepared in order to investigate the influence of MCM-41 contents on the ionic conductivity of the composites. The crystallinity of the SPE composites was evaluated using differential scanning calorimeter (DSC) and X-ray diffraction (XRD). The ionic conductivity of the SPE composites was measured by the frequency response analyzer (FRA). As a result, the addition of MCM-41 into the polymeric mixture prohibited the growth of PEO crystalline domain due to the mesoporous structures of the MCM-41. The $P(EO)_{16}LiClO_4$/MCM-41 electrolytes show an increased ion conductivity as a function of MCM-41 content up to 8 $wt\%$ and a slightly decreased conductivity over 8 $wt\%$. These ion conductivity characteristics are dependent on a change of polymer crystallinity in the presence of MCM-41 system.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.35 no.2
• /
• pp.231-237
• /
• 2006

The extracellular enzyme alginase produced by Bacillus licheniformis AL-577 was purified by ion chromatography on CM-Cellulose column, DEAE-Sepharose column, and followed by gel filtration on Sephadx G-100 column. The optimum pH and temperature for the activity of the purified enzyme were 6.0 and $35^{\circ}C$, respectively. The enzyme was stable at the pH range of $6.0\~9.0$ and at $20^{\circ}C$. The molecular weight of the enzyme was estimated to be about 25,500 daltons by SDS-polyacrylamide gel electrophoresis. NaCl was required for high activity of the enzyme. The enzyme was inhibited by $Ba^{2+},\;Co^{2+},\;Cu^{2+},\;Fe^{2+},\;Mg^{2+},\;Zn^{2+},\;NH_4^+$, EDTA, L-cysteine, and 2-mercaptoethanol, while stimulated by DTT, O-phenanthroline, $K^+$ and $Li^+$. This enzyme was proposed to be an alginase specifically degrading alginic acid.

• Membrane and Water Treatment
• /
• v.8 no.3
• /
• pp.225-244
• /
• 2017

A novel thin-film nanocomposite (TFN) reverse osmosis (RO)/non-woven fabric (NWF) membrane was prepared by adding zinc oxide (ZnO) nanospheres ($30{\pm}10nm$) during the interfacial polymerization process of m-phenylenediamine (MPD) and trimesoyl chloride (TMC) on self-made polysulfone (PSF) membrane/polyester (PET) non-woven fabric support. The improved performance of TFN RO membrane was verified in terms of water contact angle (WCA), water flux, salt rejection, antifouling properties and chlorine resistance. The results showed that the WCA value of TFN RO surface had a continuous decrease with the increasing of ZnO content in MPD aqueous solution. The water flux of composite TFN RO membranes acquired a remarkable increase with a stable high solute rejection (94.5 %) in $1g{\cdot}L^{-1}$ NaCl aqueous solution under the optimized addition amount of ZnO (1 wt%). The continuous testing of membrane separation performance after the immersion in sodium hypochlorite solution indicated that the introduction of ZnO nanospheres also dramatically enhanced the antifouling properties and the chlorine resistance of composite RO membranes.

• Journal of the Korean Chemical Society
• /
• v.22 no.1
• /
• pp.45-51
• /
• 1978

The luminescence of N-methyllutidone is studied in ethanol matrix at $77^{\circ}C$K. No fluorescence is observed but a strong phosphorescence with the quantum yield of 0.1 and the lifetime of 0.2 sec is recorded. An unusually high triplet energy of 85.1 kcal/mole is determined for the compound from the O-O band of phosphorescence. The cis ${\leftrightarrow}$ trans photoisomerization of high triplet energy olefins such as 2-hexene and trans-1,4-dichlorobutene-2 is efficiently sensitized by N-methyllutidone substantiating the high triplet energy of the compound. The negative polarization of O-O band reveals the emitting triplet state to be $({\pi},{\pi}^*)^3$ state. Alkaline metal salts such as lithium chloride enhances the phosphorescence intensity through cation-N-methyllutidone coordination widening the gap between $({\pi},{\pi}^*)^3$and $(n,{\pi}^*)^3$ states.

• Journal of the Korean Wood Science and Technology
• /
• v.49 no.3
• /
• pp.267-273
• /
• 2021

Camellia nut shell was collected, dried at room temperature and ground to get fine powder. The powder was extracted three times with 95% EtOH, combined, evaporated, and then freeze dried. The crude powder was dissolved in H₂O and then sequentially fractionated with n-hexane, CH₂Cl₂, EtOAc and n-BuOH. A part of EtOAc fraction was chromatographed on a silica gel and on a Sephadex LH-20 columns using MeOH, aqueous MeOH, EtOAc-n-hexane and EtOH-n-hexane to isolate gallotannins. Three gallotannins, 1,2-di-O-galloyl-β-D-glucopyranoside (2), 1,2,6-tri-O-galloyl-β-D-glucopyranoside (3) and 1,2,3,6-tetra-O-galloyl-β-D-glucopyranoside (4), including gallic acid (1), were isolated and elucidated by NMR and Mass spectroscopies. Although nothing new, these gallotannins were first reported from the nut shell extractives of camellia tree (Camellia oleifera C. Abel). This study was to investigate the chemical constituents, especially hydrolysable tannins, of nut shell extractives of Camellia oleifera and to provide basic information for the future chemical utilization of this species.

• Journal of Plant Biotechnology
• /
• v.30 no.4
• /
• pp.405-410
• /
• 2003

Environmental stress is the major limiting factor in plant productivity. In order to evaluate the stress tolerance of potato plants, leaf discs of two potato cultivars, Atlantic and Superior, were subjected to various stress conditions of high temperature, methyl viologen, H2O2, or $H_2O$$_2$. When potato leaf discs were exposed to high temperature at 37$^{\circ}C$ for 84 hr, Atlantic plants, a cultivar with high sensitivity to heat stress, showed about 20％ higher membrane damage than Superior plants. When exposed to 2$\mu$M methyl violgen (MV), a superoxide generating non-selective herbicide, for 36 hr, Atlantic plants also showed about 38％ higher membrane damage than Superior plants, and were more susceptible up to 10$\mu$M MV concentration tested. On treatment with 0.75M NaCl, Atlantic plants also had about 45％ less chlorophyll contents in leaf discs than Superior plants. There was, however, no difference in chlorophyll content of two cultivars at higher NaCl concentrations. The effect of $H_2O$$_2$ on the two cultivars was mixed. At low $H_2O$$_2$ concentration (25 mM) , Superior plants were more susceptible to $H_2O$$_2$stress after 36 hr. However, at high $H_2O$$_2$ concentration (100 mM), Atlantic plants exhibited higher susceptibility after 36 hr. The results indicate that in vitro leaf discs reflecting the whole plants in this study will be useful for selection and characterization of elite transgenic potato plants with enhanced tolerance to environmental stress.

• Journal of the Mineralogical Society of Korea
• /
• v.20 no.1 s.51
• /
• pp.1-6
• /
• 2007

Hectorite was synthesized by a two-step hydrothermal process from $Mg(OH)_{2}$, water glass (${\sim}30\;wt%\;SiO_{2}$) and Li-compound at $90{\pm}5^{\circ}C$. The product shows excellent dispersion and swelling properties. The mixture of the starting materials was heated in a glass vessel for the first reaction with continuous stirring and the pH of the solution was adjusted to $6{\sim}8$, resulting in the formation of a precursor of hectorite. The excess salt components were washed out from the resulting slurry and then was matured in the glass vessel for the 2nd reaction. Li compound was added during the reaction. After a 10 h retention, the gel of hectorite was formed. The XRD pattern of the synthesized one was coincided with that of natural hectorite and SEM study revealed uniform grains 50 m in diameter. The d001 basal spacing of the product moved from 12 to $17.4\;{\AA}$ after glycolation treatment. The measured value of CEC and the swelling capacity was 90 cmol/kg and $60{\sim}70\;mL/2\;g$, respectively.