• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.10 no.1
• /
• pp.177-185
• /
• 2009

In this study, we developed the program to calculate the corrosion evaluation index for examining the corrosivity of raw water. When it was applied to the Han river and Nakdong river system, sulfuric acid ion, which accelerated corrosion, was higher in Nakdong river system than Han river system while calcium and hardness, which restrained corrosion, was the same way. Summarization of the LI and CCPP calculation result by the developed corrosion evaluation model showed that water quality of Han river system had strong tendency to corrode (is strongly corrosive). Moreover, this study evaluated the corrosivity of calcium carbonate saturation index by adding the chemicals to tap water. Saturation status was maintained in the order of $Ca(OH)_2$ > NaOH > ${Na_2}{CO_3}$ > $CaCO_3$ in the case of LI and RI.

• Journal of Electrochemical Science and Technology
• /
• v.2 no.1
• /
• pp.14-19
• /
• 2011

Quasi-equilibrium profiles are analyzed through galvanostatic intermittent titration technique (GITT) and potentiostatic intermittent titration technique (PITT) to study the charge/discharge mechanism in multicomponent olivine structure ($LiMn_{1/3}Fe_{1/3}Co_{1/3}PO_4$). From GITT data, the degree of polarization is evaluated for the three regions corresponding to the redox couples of $Mn^{2+}/Mn^{3+}$, $Fe^{2+}/Fe^{3+}$ and $Co^{2+}/Co^{3+}$. From PITT data, the current vs. time responses are examined in each titration step to find out the mode of lithium de-intercalation/intercalation process. Furthermore, lithium diffusivities at specific compositions (x in $Li_xMn_{1/3}Fe_{1/3}Co_{1/3}PO_4$) are also calculated. Finally, total capacity ($Q^{total}$) and diffusional capacity ($Q^{diff}$) are obtained for some selected voltage steps. The entire study consistently confirms that the charge/discharge mechanism of multicomponent olivine cathode is associated with a one-phase reaction rather than a biphasic reaction.

• Resources Recycling
• /
• v.23 no.5
• /
• pp.21-27
• /
• 2014

A study on the solvent extraction for the recovery of Li from lithium-containing waste solution was investigated using $D_2EHPA$ as an extractant. The experimental parameters, such as the pH of the aqueous solution, concentration of extractant and phase ratio were observed. Experimental results showed that the extraction percentage of Li was increased with increasing the equilibrium pH. More than 50% of Li was extracted in eq. pH 6.0 by 20% $D_2EHPA$. From the analysis of McCabe-Thiele diagram, 95% of Li was extracted by four extraction stage at phase ratio(O/A) of 3.0. Stripping of Li from the loaded organic phases can be accomplished by sulfuric acid as a stripping reagent and 90 ~ 120 g/L of $H_2SO_4$ was effective for the stripping of Li. Finially, Li was concentrated about 11.85 g/L by continuous stripping process, and then lithium carbonate was prepared by precipitation method.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.21 no.3
• /
• pp.227-231
• /
• 2008

In this study, in order to improve the electrical properties of low temperature sintering piezoelectric ceramics, $[0.05Pb(Zn_{1/2}W_{1/2})-0.07Pb(Mn_{1/3}Nb_{2/3})-0.088Pb(Zr_{0.48}Ti_{0.52})]O_3$(abbreviated as PZW-PMN-PZT) ceramic systems were fabricated using $Bi_2O_3$, CuO and $Li_2CO_3$ as sintering aids and then their piezoelectric and dielectric properties were investigated according to the amount of $Li_2CO_3$ and post-annealing process. Post-annealing process enhanced all physical properties except for mechanical quality factor (Qm). 0.2 wt% $Li_2CO_3$ added and post-annealed specimen showed the excellent values suitable for low loss piezoelectric actuator application as follow: the density = 7.86 $g/cm^3$ electromechanical coupling factor (kp) = 0.575, piezoelectric constant $d_{33}$ = 370 pC/N, dielectric constant ($\varepsilon_r$) = 1546, and mechanical quality factor (Qm) = 1161, respectively.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.10 no.6
• /
• pp.400-406
• /
• 2000

The fired Precursor (Y,Gd,Eu)(OH)$CO_3$.$H_2O$$900^{\circ}C$ was used to synthesize the red phosphor $(Y,Gd)_2O_3$: Eu for plasma display panel. Rounded and ~l $\mu\textrm{m}$ diameter phosphor $(Y,Gd)_2O_3$: Eu can be obtained by the reaction of aformentioned powder with a small amount addition of flux at $1350^{\circ}C$ for 2 hours. Emission spectra of these phosphors were measured under excitation wavelength at 254 nm and 147 nm and the optimum concentrations of activator ion were determined at around 15 mo1e % and 10 mole % under these conditions, respectively. $BaCO_3$flux had the best property in emission intensity among the prepared $BaCO_3AlF_3$and $Li_3PO_4$phosphors. The properties of optimized sample were improved in terms of relative luminance and color coordinate comparing with commercial phosphor such as $Y_2O_3$: Eu.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.713-716
• /
• 2001

In many papers, the electrochemical analysis of LiMn$_2$O$_4$shows the transition results of Mn$^{3+}$ ion. Charge ordering is accompanied by simultaneous orbital ordering due to the Jahn-Teller effect in Mnl$^{3+}$ ions. To analyze the cycle performance of LiMn$_{2-x}$Cu$_{x}$ O$_4$as the cathode of 4 V class lithium secondary batteries, XRD, TGA analysis were conducted. Although the cycle performance of the LiMn$_{2-x}$Cu$_{x}$ O$_4$was improved from pure LiMn$_2$O$_4$, the discharge capacity was significantly lower than LiCoO$_2$. In this paper, We study the Electrochemical characterization and enhanced stability of Cu-doped spinels in the LiMn$_{2-x}$Cu$_{x}$ O$_4$upon initial cycling.l cycling.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.248-248
• /
• 2010

리튬이온 2차전지의 대체 양극 후보 물질인 $LiFePO_4$를 합성하기 위하여 출발원료로 $Li_2CO_3$, $Fe_2O_3$, $NH_4H_2PO_4$를 사용하여 볼밀 방법으로 혼합 분쇄한 후 열처리를 실시하였다. 합성 시에 3가 Fe를 2가로 환원시키기 위하여 $C_{12}H_{22}O_{11}$(흑설탕)을 출발원료와 함께 5 ~ 12 wt%로 나눠서 첨가하였다. 합성 후 XRD로 결정구조의 양질성을 확인하였고. FE-SEM으로 나노미터 크기의 구형 입자를 관찰하였다. XRF를 이용하여 3 ~ 10 wt%의 탄소 잔량을 확인하였다. 전기화학적 특성을 충 방전시험기로 평가한 결과, 8wt%의 탄소원을 첨가한 $LiFePO_4$에서 가장 좋은 수명 특성을 얻었고, 최대 145 mAh/g의 방전용량을 얻었다.

• Proceedings of the Optical Society of Korea Conference
• /
• 2002.07a
• /
• pp.96-97
• /
• 2002

불순물을 이용한 비휘발성 홀로그램저장[1,2]은 기존의 열정착을 광정착으로 대치하는 방법으로서 여러 가지 희토류 혹은 전이금속이온을 첨가한 LiMbO$_3$ (LNO) 단결정 재료에서 시도되고 있다. 대표적인 재료로서 Mn,Fe：LNO 가 있으나 Mn,Ce：LNO, Cu,Co：LNO, Tb,Fe：LNO 등도 연구되고 있고 Stoichiometric LNO 경우엔 Pr：LNO, Er：LNO, Tb：LNO 등이 연구되고 있다. 그 외에 Mn：YAlO$_3$도 약하긴 하지만 비휘발성이 최근 보고되었다. (중략)

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.18 no.3
• /
• pp.415-420
• /
• 2020

Strontium is known as a salt-soluble element during the electrolytic oxide reduction (EOR) process. The chemical behavior of SrO during EOR was investigated via thermodynamic calculations to provide quantitative data on the chemical status of Sr. To achieve this, thermodynamic calculations were conducted using HSC chemistry software for various EOR conditions. It was revealed that SrO reacts with LiCl salt to produce SrCl₂, even in the presence of Li₂O, and that the ratio of SrCl₂ depends on the initial concentration of Li₂O dissolved in LiCl. It was found that SrO reacts with Li to produce Sr during EOR and that the reduced Sr reacts with LiCl salt to produce SrCl₂. As a result, the proportions of metallic forms were lower in Sr than in La and Nd under various EOR conditions. The thermodynamic calculations indicated that the three chemical forms of SrO, SrCl₂, and Sr co-exist in the EOR system under an equilibrium with Li, Li₂O, and LiCl.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1997.06a
• /
• pp.139-143
• /
• 1997

The doping effects of Mg and/or Fe ions on congruent LiNbO$_3$ single crystal growth were studied in order to clarify the roles of MgO in Fe doped LiNbO$_3$ single crystals. The effective distribution coefficienct of Fe was found decreased drastically from 0.85 to 0.5 by the addition of MgO into the LiNbO$_3$ melt. M ssbauer spectra revealed that the addition of MgO reduces the occurrence of Fe2+ ions during growth in air. Therefore, it is likely that there would be two important roles of MgO in Fe doped LiNbO$_3$. One is to suppress the incorporation of all Fe ions, and the other is to reduce the concentration of Fe2+ ions among the total Fe ions.