• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.27 no.2
• /
• pp.159-167
• /
• 2009

To obtain the gravity data with consistent quality and good distribution over Korea, to overcome the difficulties in constructing precision geoid from biased distribution of ground data, to resolve the discrepancy between the ground and ocean gravity data, an airborne gravity survey was conducted from Dec. 2008 to Jan. 2009. The data was measured at the average flying height of 3,000m and the data with cross-over error of 2.21mGal is obtained. The geoid constructed using this airborne gravity data shows the range of 9.34 $\sim$ 33.88m. Comparing the geoid with respect to the GPS/levelling data, a precision of 0.145m is obtained. After fitting, the degree of fit to GPS/levelling data was calculated about 5cm. It was found that there exists large biases in the area of south-western and northern part of the peninsular which is considered to be the effect of distorted vertical datum in Korea. Thus, more investigation on vertical datum would be needed in near future.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.13 no.2
• /
• pp.285-289
• /
• 1995

This paper describes the determination of geoid using height data measured by GPS and Spirit Levelling. The GPS data of the 88 stations were used to determine the geoid undulation (N) which can be easily obtained by subtracting the orthometric height(H) from the ellipsoidal height(h). From the geoid undulation (N) calculated at each station mentioned above, geoid plots with a contour interval of 0.25 m were drawn using two interpolation methods. The following interpolation methods were applied and compared with each other: Minimum Curvature Method and Least Squares Fitted Plane. Comparison between geometric geoid and gravimetric geoid undulation by FFT technique was carried out.

• Proceedings of the KIPE Conference
• /
• 2000.07a
• /
• pp.651-656
• /
• 2000

This paper describes the optimal sizing of each component using computer simulation and presents the efficient operating scheme of series HEV using hardware simulator the equivalent system. As the sizing method of components have been experimental and empirical it is needed to spend much time and development cost. however the results of computer simulation will set the optimal sizing of components in short time. There are two type of driving control power-tracking mode and load-levelling mode in series HEV. This paper presents that series HEV be operated in the load-levelling mode which is more efficient that power-tracking mode.

• Journal of Sericultural and Entomological Science
• /
• v.33 no.1
• /
• pp.9-12
• /
• 1991

A study on dyeing-rate for single and mixture dyeing of silk with acid dyes was carried out. Single and mixture dyeings were performed with levelling and milling dyes at 7$0^{\circ}C$ and at pH 3, pH 4 and pH 5, respectively. The results of this study were summerized as follows : 1. C. I. Acid Orange 7. A) At pH 3, dyeing-rate was more fast in the single dyeing than in mixture dyeing at the beginning of dyeing process. B) At pH 4 and 5, dyeing-rates tend to get very similar in single and mixture dyeing. 2. C. I. Acid Blue 138 A) At all pH value, dyeing-rates were more fast in the mixture dyeing than single dyeing at the beginning of dyeing. B) As the time increased, the difference of dyeing-rate and adsorption amounts between single and mixture dyeing was not shown.

• The Journal of the Korea Contents Association
• /
• v.8 no.9
• /
• pp.274-280
• /
• 2008

The new high order Earth's gravity Model(EGM2008) are expected to improve the application about the Earth's global gravity field. The objectives of this research are to present characteristics on the geoid heights of provinces in South KOREA which calculated from the height anomalies by Earth Gravity Models. For this, seven EGMs (EGM2008<2,190>, EGM2008<360>, EGM96, EIGEN-GL04C, EIGEN-CG03C, EIGEN-GL04S1, and ITG-Grace02S) selected. Geoid heights of fifty BM check points by GPS/levelling are compared with those by NORI-05 model and seven EGMs. And also, geoid heights of 30"$\times$30" grid points in land(sixes blocks ; $1^{\circ}\times1^{\circ}$ sampled) and sea (four blocks ; $1^{\circ}\times1^{\circ}$ sampled) areas of South KOREA by EGM2008 are compared with those by NORI-05 and six EGMs. The results show that geoid heights obtained from EGM2008(2,190) of NGA displayed the nearest results to those by GPS/levelling.

• Textile Coloration and Finishing
• /
• v.16 no.4
• /
• pp.1-9
• /
• 2004

In recent, development of nano fiber has been one of the most active subjects in the world. Nano fiber is defined as a ultra fine yarn with a diameter unit of $10-100\times10^{-9}meter$, which is possible to be produced by an electro-spinning technology. In this study, physical characteristics and dyeing properties of nylon 66 nano fiber were investigated. Nylon 66 nano fiber was dyed with levelling type acid dyes. X-ray diffraction method and DSC analysis were used for the measurement of the degree of crystallization. Analysis of amino end groups was also performed in order to examine a relationship between number of amino groups and its dyeing property as well as water absorption behavior. The maximum exhaustion % of dyes and dyeing rate under various dyeing conditions, such as dyeing temperature and pH in dye bath, along with build-up properties for 2 acid dyes were evaluated. It was found that the degree of crystallization of nano fiber was smaller than that of regular fiber, and amino end groups of nano fiber were less than regular fiber. Half dyeing time of nano fiber was shorter than regular fiber because of the bigger specific surface area. Effect of pH on exhaustion % was small in case of nano fiber. Exhaustion of nano fiber increased with higher concentration of dye.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.23 no.4
• /
• pp.353-358
• /
• 2005

The purpose of this paper is to evaluate a new geopotential model, EIGEN-CG01C which had been developed from CHAMP and GRACE mission observations and surface gravity data. The accuracy analysis was conducted by comparing the geoidal heights computed from two types of geopotential models (i.e., EIGEN-CG01C and EGM96) with spirit leveled GPS bench mark. To this end, three hundred twenty GPS leveled bench marks are used as bases for the numerical investigation. From the analysis, it was possible to conclude that EIGEN-CG01C was more suitable to upgrade the KGEOID 98 since the results that the EGM96 was slightly biased.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.14 no.1
• /
• pp.49-58
• /
• 1996

This paper deals with the gravimetric solution of geoid by Fast Fourier Transform(FFT) technique in and around Korean Peninsula. The used reference surface is OSU91A geopotential model up to degree and order 180 refered to GRS80. The remove and restore technique was applied to obtain the geoidal height in this paper. And the FFT with 20% window was applied to compute the medium wavelength effect from terrestrial gravity anomalies. For the comparison of computed results, the geometric geoidal height was derived from GPS/Levelling data. According to the comparison, the mean value and RMSE of the differences are 0.3819m and 0.4695m respectively.

• Journal of the Korea Computer Industry Society
• /
• v.3 no.9
• /
• pp.1315-1328
• /
• 2002

Recently there has been increasing demand on developing methodologies and tools for measuring the information security level of organizations for the efficient security management, as the growth of security incidents. However, most methodologies from foreign countries are not realistic in constructing the checklists, moreover their tools provide neither the ease of use nor the inexpensiveness, and most domestic works are not properly considering the characteristics of the organizations. In this study, based on the recently developed standard for information security management, an information security levelling tool is designed and implemented which can be used before building an information security management system while considering the characteristics of organizations more efficiently. The efficiency comes from applying multiple variable weights for security levelling according to the characteristics of organizations.

• Convergence Security Journal
• /
• v.2 no.2
• /
• pp.123-135
• /
• 2002

As the development of information technology and thus the growth of security incidents, there has been increasing demand on developing methodologies and tools for measuring the information security level of organizations for the efficient security management. However, most works from foreign countries are not realistic in constructing the checklists, moreover their tools provide neither the ease of use nor the inexpensiveness, and most domestic works are not properly considering the characteristics of the organizations when measuring the information security level. In this study, an efficient information security levelling tool is suggested, which applies the multiple variable weights for security levelling according to the characteristics of organizations and the fuzzy technique to reduce the user's subjectivity.