• The korean journal of orthodontics
• /
• v.23 no.4 s.43
• /
• pp.529-541
• /
• 1993

The purpose of this study was to investigate not only the variability in the timing and amount of the maximum pubertal spurt in cranial base and mandible, but also its interrelationship with the timing of peak height velocity. This study was carried out by analysing biannual serial lateral cephalometric radiographs of twenty-six males and twenty-one females who were taken from 8.5years to 16.5years old of mean age, according to the established land-marks and linear measurements. The results of this study were summarized as follows. 1. Prevalance of the maximum growth spurt more than 80 percentage was occurred in all measurements of cranial base and mandible, except posterior cranial base length in the female. 2. In all measurements of cranial base and mandible, the maximum spurt was occurred earlier in the female than the male while it was greater in male in all measurements except ramal height. 3. In body height measurement, the peak height velocity was occurred 2 years earlier for the female(11.0 years old) than the male(13.0 years old). 4. The timing of maximum spurt in anterior cranial base length and total mandibular length in both sexes and ramal height in the female were coincided with PHV. The maximum spurt was occurred in both sexes in all measurements 2 years before or after PHV, except mandibular body length and posterior cranial base length the in female. 5. In all ages, there was significant correlation between the total mandibular length and ramal height, and was also correlation between total cranial base length and anterior cranial base length(P<0.05). However, there was no significant correlation between the ramal height and mandibular body length. In addition, there was also no any correlation between the anterior cranial base length and posterior cranial base length in all ages(P>0.05).

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.48 no.2
• /
• pp.86-90
• /
• 2011

The effects of cations are very important in field-effect transistors (FETs) type DNA sensors detecting the intrinsic negative charge between single-stranded DNA and double-stranded DNA without labeling, because the intrinsic negative charge of DNA is neutralized by cations in electrolyte solution. We consider the Debye length, which depends on the concentration of cations in solution, to detect DNA hybridization based on the intrinsic negative charge of DNA. The Debye length is longer in buffer solution with a lower concentration of NaCl and the intrinsic negative charge of DNA is more effective on the channel surface in longer Debye length solution. The shifts in the gate voltage by DNA hybridization with complementary target DNA are 21 mV in 1 mM NaCl buffer solution, 7.2 mV in 10 mM NaCl buffer solution, and 5.1 mV in 100 mM NaCl buffer solution. The sensitivity of FETs to detect DNA hybridization based on charge detection without labeling depends on the Debye length.

• Journal of Educational Research in Mathematics
• /
• v.19 no.2
• /
• pp.321-340
• /
• 2009

The purpose of this study was to analyze how lower graders in elementary school might respond to 4 different problem types in the context of measuring length: unit-length comparison, units and unit counting, unit-length expectation, and length comparison. A total of 375 students(185 second graders and 190 third graders) were surveyed and analyzed. The results showed that students were good at 'unit-length comparison' and 'units and unit counting', whereas they were not as to 'length comparison', This paper includes detailed analysis of students' responses as to both correct answer and incorrect one in conjunction with their typical answers and reasoning behind the answers. This paper suggests that teachers be sensitive to the certain level of reasoning tied to each type of problems and attend to students' difficulties in comparing length.

• Journal of the Korean Home Economics Association
• /
• v.31 no.3
• /
• pp.175-186
• /
• 1993

The present study was designed to find out the construction conditions of tight skirt for sale in relation to its brand, target age and length. The 15 tight skirts each from 3 brand groups(designer character, national and minor brand) of 2 target age groups(youth and middle age) and the 15 tight skirts each from 3 skirt length groups(mini, natural line and maxi) of only the minor brand-a total of the 120 tight skirts on the market-were measured. The data were analyzed with use of SAS package. The statistics were based on frequency, percentage, average, standard deviation, one-way ANOVA, two-way ANOVA, Pearson's correlation and linear regression analysis. The main results were as follows. 1. There were significant differences in the construction conditions of tight skirt according to its brand and target age. There was a significant difference particurarly in the difference between hip girth and hem girth according to brand target age. The difference between hip girth and hem girth of designer's character brand skirt was larger than that of national brand & minor brand skirt, and that of skirt targeting the youth was larger than that of skirt targeting the middle aged. 2. There were significant difference particurarly in the differences in the construction conditions of tight skirt according to its length. There was a significant difference particurarly in the difference between hip girth and he girth according to skirt length, and that of maxi skirt was larger than that of mini & natural line skirt. There was a good correlation between skirt length and slit length and between skirt length and skirt length above the slit. The longer the skirt length was, the longer the slit length and the skirt length above the slit were.

• Clinical and Experimental Pediatrics
• /
• v.63 no.9
• /
• pp.361-367
• /
• 2020

Background: Length of stay is a significant indicator of care effectiveness and hospital performance. Owing to the limited number of healthcare centers and facilities, it is important to optimize length of stay and associated factors. Purpose: The present study aimed to investigate factors associated with neonatal length of stay in the neonatal intensive care unit (NICU) using parametric and semiparametric models and compare model fitness according to Akaike information criterion (AIC) between 2016 and 2018. Methods: This retrospective cohort study reviewed 600 medical records of infants admitted to the NICU of Bandar Abbas Hospital. Samples were identified using census sampling. Factors associated with NICU length of stay were investigated based on semiparametric Cox model and 4 parametric models including Weibull, exponential, log-logistic, and log-normal to determine the best fitted model. The data analysis was conducted using R software. The significance level was set at 0.05. Results: The study findings suggest that breastfeeding, phototherapy, acute renal failure, presence of mechanical ventilation, and availability of central venous catheter were commonly identified as factors associated with NICU length of stay in all 5 models (P<0.05). Parametric models showed better fitness than the Cox model in this study. Conclusion: Breastfeeding and availability of central venous catheter had protective effects against length of stay, whereas phototherapy, acute renal failure, and mechanical ventilation increased length of stay in NICU. Therefore, the identification of factors associated with NICU length of stay can help establish effective interventions aimed at decreasing the length of stay among infants.

• Fashion & Textile Research Journal
• /
• v.22 no.2
• /
• pp.222-232
• /
• 2020

This study analyzes changes in the knees, hips, and hip joint length according to the different angles of bending knees by 45°, 90°, and 135° respectively for knees, hips, and the hip joint that have high fracture rates when falling down. The research subjects were 10 elderly women in their 60s (or older) that obtain data collected through direct measurement. For analysis, the study drew a diagram of elongation and shrinkage based on changes and change rate from a straight posture (0°) and conducted a statistical analysis on differences of body surface length by zone according to movements. The more the knees were bent, the vertical surface length in front of the knees, the horizontal surface length above the knee line, the horizontal body surface length below the knee lines on the back, and the vertical surface lengths between front side lines and the side lines increased; however, the vertical surface length on the back decreased. For the hip joint, the difference in the vertical surface length was more distinctive when compared to the horizontal. Finally, the horizontal surface length increased below the hips and the vertical surface length increased in most areas except the sidelines and the front. The result of the change in body surface length according to the movements of this study can be utilized in the development of the motion-variable protector.

• Journal of Life Science
• /
• v.14 no.2
• /
• pp.339-344
• /
• 2004

Identification of individual quantitative trait loci (QTL) is a prerequisite to application of marker-assisted selection for stern length. Two simple sequence repeat (SSR)-based linkage maps were constructed from recombination inbred line populations between cross of Keunolkong and Shinpaldalkong. Two parents used differed greatly in stem length, which were 30.57 cm and 49.75 cm in Keunolkong and Shinpaldalkong, respectively. Using the constructed maps, regression analysis and interval mapping were performed to identify QTLs conferring stem length. Four QTLs for stem length on linkage groups (LG) F, J, N and O were identified in the Keunolkong ${\times}$ Shinpaldalkong population and they totally explained 37.83% of variation for stem length. In the population, two major QTLs on LG J and O conditioning 14.25% and 10.68% of the phenotypic variation in stem length were determined and two QTLs with minor effect were detected on LG F and N. Identification of QTLs for stem length and mapping individual locus should facilitate to describe genetic mechanisms for stem length in different population. SSR markers tightly linked to QTLs for stem length allow to accelerate the elimination of deleterious genes and selection for desirable recombinants at early stage in crop breeding programs.

• Journal of Korean Society on Water Environment
• /
• v.24 no.5
• /
• pp.569-580
• /
• 2008

In this study, area-weighted slope and slope length module, considering measured field slope and slope length of the agricultural fields within the subwatershed, was developed using the ArcView Avenue programming to reflect the field topography of the Soil and Water Assessment Tool (SWAT) HRU in simulating the hydrology and water quality. Flow and sediment yield estimated values of the SWAT were compared with and without applying area-weighted slope and slope length module, developed in this study. There was 103% increases in estimated sediment with area-weighted slope and slope length module for the study watershed. The soil erosion and sediment yield from only agricultural field in Hae-an watershed was also assessed. There are 111% increase in estimated soil erosion and 112% increase in estimated sediment by applying area-weighted slope and slope length module. This study shows that the area-weighted slope and slope length module needs to be utilized in estimating the HRU field slope and slope length for accurate estimation of soil erosion and nonponit source pollutant modeling with the SWAT although it is not feasible to measure topographic information for every agricultural fields within the watershed. The area-weighted slope and slope length module can be used in identifying soil erosion hot spot areas for developing cost effective and efficient soil erosion management practices.

• Journal of Life Science
• /
• v.10 no.2
• /
• pp.177-181
• /
• 2000

This study was conducted to estimate the genetic parameters such as combining ability, heritabilities and correlation coefficients forsome agronomic characters by 6$\times$6 dialled crosses of barley. The results obtained were summarized as follows. Mean squares of general combining ability(GCA) and specific combining ability(SCA) were significant for all characters observed. Mean squares of general combining ability for all characters were expressed as higher values than those of specific combining ability. Jecheon #5 showed the high general combining ability effects for culm length, and Waegwanpimack #1 showed the highest general combining ability effects for tiller number. Cygne also showed the high general combining ability effects for spike length and 1,000 grains weight. Furthermore, Plumage was expressed with the highest general combining ability effects for spike length and 1,000 grains weight. Furthermore, Plumage was expressed with the highest general combining ability effects for number of grains per spike. In specific combining ability effects, Samdugjeonbug # 45$\times$Plumage showed the high value for culm length, and Suwon #6 $\times$Waegwanpimack #1$\times$ was expressed with the highest specific combining ability effects for tiller number. Jecheon #5$\times$Plumage also showed the high specific combining ability effects for spike length and number of grains per spike. Suwon #6$\times$Cygne showed the high specific combining ability effects for 1,000 grains weight. The heritabilities of spike length an number of grains per spike were over 90%. In correlation coefficients among characters, relationships between culm length and tiller number, culm length and spike length, culm length and 1,000 grains weight, and spike length and 1,000 grains weight showed highly positively correlation.

• Restorative Dentistry and Endodontics
• /
• v.29 no.6
• /
• pp.541-547
• /
• 2004

The aim of this study was to compare the initial apical file (IAF) length between the mesio-buccanl and mesio-lingual canals of the mandibular molar before and after early coronal flaring. Fifty mandibular molars with complete apical formation and patent foramens were selected. After establishing the initial working length of the buccal and lingual canal of the mesial root using the Root-ZX, radiographs were taken for the working length with a 0.5 mm short of #15 K-file tip just visible at the foramen under a surgical microscope (OPMI 1-FC, Carl Zeiss Co. Germany) at 25X. After early coronal flaring using the $K^3$ file, additional radiographs were taken using the same procedure. The root canal morphology and the difference in working length between the buccal and lingual canals were evaluated. These results show that the difference in the length between the mesio-buccal and mesio-lingual canals of the mandibular molar was $\leq$ 0.5 mm. If one canal has a correct working length for the mesial root of the mandibular molar, it can be used effectively for measuring the working length of another canal when the files are superimposed or loosening. In addition, the measured the working length after early coronal flaring is much more reasonable because the difference in the length between the mesio-buccal and mesio-lingual canals can be reduced.