• 한국산학기술학회논문지
• /
• 제6권6호
• /
• pp.497-501
• /
• 2005

Dry film 공정에 의해 PDP(Plasma Display Panel)용 무연 투명유전체를 제조하였다. 여러 슬러리 조성으로부터 고밀도 green sheet를 제조하는데 최적의 조성을 선정하였다. 한편, 슬러리는 양질의 green sheet를 제작하는데 적합한 shear thinning 특성을 나타냈다. 제조한 투명유전체의 열팽창계수는 유리기판인 PD-200과 유사한 $97{\times}10^{-7}/^{\circ}C$로 측정되었다. PD-200에 접합된 투명유전체의 단면 주사현미경 관찰로부터 두 층은 갭이 없이 매우 견실히 접합되어 있음을 확인할 수 있었다.

• 한국전기전자재료학회논문지
• /
• 제17권10호
• /
• pp.1107-1113
• /
• 2004

Dry film method for large size of PDP(Plasma Display Panel) module has been actively investigated. This method for lead-free transparent dielectric formation depends on green sheet technology. By adjusting the composition of transparent dielectric powders and organics, uniformly dispersed slurry was fabricated, Viscosity of the slurry exhibited pseudoplastic behavior for tape casting, Cast green sheets were tested under tensile condition at room temperature. It was found that the increase in transparent dielectric powder and binder ratio leads to decrease in strain to failure of green sheets from 120 % to 34 % and from 255 % to 4 %, respectively. Tensile strength of green sheets decreased abruptly with increase of transparent dielectric powder ratio, with minimum at 0.13 MPa. On the other hand, tensile strength increased continuously from 0.1 MPa to 2.4 MPa with increase of binder ratio. The green sheets were attached on the glass substrate and heated by following firing schedule. As a result, the best result was obtained when fired at 580 $^{\circ}C$ for 15 min and had transmittance of 78 % in visible range 550 nm.

• Transactions on Electrical and Electronic Materials
• /
• 제12권5호
• /
• pp.222-225
• /
• 2011

Lead zirconate titanate (PZT) films were fabricated on Pt/Ti/$SiO_2$/Si substrate by the sol-gel method using a sol containing poly(N-vinylpyrrolidone) (PVP). PVP in alkoxide solutions can suppress the condensation reaction in gel films during heat treatment, and increase the viscosity of alkoxide solutions. Single-phase PZT films as thick as 1 ${\mu}m$ were deposited by repetitive coating with successive third-step heat treatments at 150$^{\circ}C$, 350$^{\circ}C$ and 650$^{\circ}C$. After heat treatment, the films were crack free, and optically transparent. As a result, we demonstrated a PZT film with a PVP molar ratio of 0.5, which has a permittivity of 734, a dielectric loss of 0.042, a $P_r$ of 40.5 ${\mu}C/cm^2$ and an $E_c$ of 156 kV/cm.