• Journal of the Korean GEO-environmental Society
• /
• v.14 no.12
• /
• pp.31-41
• /
• 2013

The damage caused by lateral movement occurs frequently on site where abutment or retaining wall was built on soft ground along with embankment behind and the study on stability of abutment against lateral movement has been mostly focused on soft ground. However lateral movement occurs not only on soft ground but also on embankment slope which causes the impact on structure. The bridges built in Korea are mostly on mountainous area than soft ground. This study is intended to analyze the ground behavior resulting from lateral movement using finite element analysis method to the section as well as propose the basic data for abutment design on embankment slope through the analysis of the outcome of reinforcement method. As a result, when it comes to the reinforcement with soil surcharge and stabilized pile in slope, lateral movement was reduced by 4~30% and displacement on bearing shoe on abutment was reduced by 2~13%. On the contrary, when reinforced with EPS, lateral float was reduced by 97% and maximum horizontal displacement of bearing shoe on abutment was reduced by 95%. Thus, it's necessary to identify the design technique which is applicable to domestic condition through additional tests and more reliable study using numerical analysis and comparing the measured values shall follow.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.10
• /
• pp.535-542
• /
• 2016

As one of the most cost-effective methods for surface emission measurements, flux chamber method has been used worldwide. It can be classified into two types: SFC (with slope method) and DFC (with steady-state method). SFC (static flux chamber) type needs only simple equipment and is easy to handle. However, the value of flux might vary with SFC method, because it assumes that the change of concentration in chamber is linear with time. Although more specific equipments are required for DFC (dynamic flux chamber) method, it can lead to a constant result without any ambiguity. We made a self-designed DFC using a small and compact kit, which recorded good sample homogeneity (RSD < 5%) and recovery ( > 90%). Relative expanded measurement uncertainty of this improved DFC method was 7.37%, which mainly came from uncontrolled sweep air. The study shows that the improved DFC method can be used to collect highly reliable emission data from large landfill area.

• Journal of the Korean GEO-environmental Society
• /
• v.19 no.4
• /
• pp.17-26
• /
• 2018

This study systematically examines the changes in the compressive and tensile strength of soil cement reinforced by natural hair fiber, which is regularly produced from human. Extensive experimental tests of various test specimens have been carried out in a laboratory. Several factors are considered, including the soil type, amount of cement, amount of fiber, fiber length, loading type, and curing age. The test results indicate that both the compressive and tensile strengths are significantly affected by the fiber, either increasing or decreasing depending on the conditions. The increase in tensile strength is significant in the sand-based soil cement due to the tensile resistance of the fiber which is interlocked with the surrounding soil or cement particles. The natural fiber provides a larger strain to failure due to its extensibility, which allows greater deformation. Based on the test results, natural hair fibers can be an effective and environmentally friendly way to improve soil ground subjected to tensile loading, such as an embankment slope, road subgrade, or landfill, thus reducing the cost for cement and waste treatment. The study results provide a useful information of better understanding the mechanical behavior of natural hair fiber in soil cement and the practical use of waste materials in civil engineering. The findings can be practically applied for improving earth structures under tensile loading.

• Journal of the Korean Geotechnical Society
• /
• v.19 no.1
• /
• pp.173-180
• /
• 2003

In spite of its potential importance in the assessment of geosynthetic-related dynamic problems, no serious attempt has yet been made to investigate a probable dependence of dynamic friction resistance of the geosynthetic interface on shear displacement rate. Hence, an experimental study of geosynthetics was carried out on a shaking table, and the relationship between dynamic friction resistance and shear displacement rate of geosynthetic interfaces was investigated. A cyclic, displacement rate-controlled experimental setup was used. The subsequent multiple rate tests showed that interfaces that involve geotextiles have such unique shearing characteristics that shear strengths tend to increase with displacement rate. In contrast, once submerged with water, the shear strength appears to be no longer dependent on the displacement rate, partly due to lubrication effect of water trapped inside the interface. The results of the experimental study can be used in the seismic safety assessment of a landfill cover and slope where the geosynthetic materials are exposed to a relatively low normal stress.

• Journal of the Korean Regional Science Association
• /
• v.14 no.1
• /
• pp.91-107
• /
• 1998

Waste disposal problem is one of the most important social welfare indicators in urban area, because the volume of waste generated from urban area is remarkable. So far most waste of Seoul has been disposed at landfills. However, this landifill disposal method is confronted with several difficulties in recent. As public concern on environmental problem increases and autonomy system is settled down, local community people of the landfills refuse to receive the waste produced other places any more. It brought reginal confliction problem between waste sending and receiving by refusing to accept waste from certain region. Furthermore, it is difficult to find another place to fill up the waste, while the existing landfiis is reached at the limit in the near future. In terms of environmental aspects landfill method is not the best way to dispose waste. It contaminates the soil and ground/underground water by leaking water containing many serious pollutants as well as offensive oder. In terms of equity, this waste disposal method is not fair. Environmental pollution causes damage to residence near to the landfills, while the waste produced other places. In order to satisfy the equity aspect, the waste generated a region should be disposed within the region. Incineration of Waste has been provided as the alternative. Government plans to construct waste incinerator in every anatomy, so the waste produced by local community is disposed within their local autonomous area. However, the location decision is not easy, since waste incinerator is one of the facilities to the community people. We can not apply the existing location models for this problem, because they show strong NIMBY phenomenon for the location. The location of waste incinerator should be determined very carefully with consideration of various location factors and criteria. This study proposes a methodology for determining the location of the waste incinerators by utilizing GIS, which is a power research tool for location decision where various geographical factors related. We drive the location factors which should be considered in the determination of waste incinerators. They involve environmental, socio-economic, and institutional factors. In first, we eliminate the area which is located within the environmental location criteria such as slope, fault line, distance to river, and then eliminate ares which is conflict with the social and institutional criteria.

• Journal of the Korean Institute of Landscape Architecture International Edition
• /
• no.2
• /
• pp.178-184
• /
• 2004

The Yatomi - Aioiyama line is a city-planning road that was notified in 1957 and subsequently prepared by land readjustments. Currently, approximately 900m of road pass in the inside of the Aioiyama green area has not been constructed. The surveying briefing session for inhabitants was held in July 1992, the project was authorized by the Ministry of Land, Infrastructure and Transport in September 1993, and the project briefing session for inhabitants was held in September 1993. The site purchase has been completed. At the May 2000 briefing session, inhabitants of the area began voicing dissenting demanding the conservation of the natural environment of this green area. The inspector system serves as the third party, independent of both the administration and the inhabitants. Before finalizing the geometric line form of the road to be constructed, some surveys of animals and plants found along the walking trails carried out intensively in the northern area, which is approximately 50 ha, of the Aioiyama green area. The natural environment inspector submitted a plan for changing the geometric line form of the road decided upon by city planning, and it was approved by the city planning council. If the shelter structure or the retaining wall structure is adopted at the location where large slope faces are produced by excavation or landfill, and if the bridge structure is adopted at the place where stream-lines and walking trails intersect, it leads to a reduction of approximately $40\%$ in the areas for which change is planned. Furthermore, approximately $20\%$ of the area to be changed is restored by returning soil to the roof of the shelter.

• Journal of the Korean Geotechnical Society
• /
• v.37 no.12
• /
• pp.117-125
• /
• 2021

The occurrence of ground subsidence and sinkhole in downtown areas, which threatens the safety of citizens, has been frequently reported. Among the various mechanisms of a sinkhole, soil erosion through the damaged part of the sewer pipe was found to be the main cause in Seoul. In this study, a random forest model for predicting the occurrence of sinkholes caused by damaged sewer pipes based on sewage pipe information was trained using the information on the sewage pipe and the locations of the sinkhole occurrence case in Seoul. The random forest model showed excellent performance in the prediction of sinkhole occurrence after the optimization of its hyperparameters. In addition, it was confirmed that the sewage pipe length, elevation above sea level, slope, depth of landfill, and the risk of ground subsidence were affected in the order of sewage pipe information used as input variables. The results of this study are expected to be used as basic data for the preparation of a sinkhole susceptibility map and the establishment of an underground cavity exploration plan and a sewage pipe maintenance plan.

• Journal of Soil and Groundwater Environment
• /
• v.6 no.4
• /
• pp.61-72
• /
• 2001

A barrier liner system is placed at the bottom and side slope in landfill to protect a leaking of leachate that the hydraulic conductivity of this system should be less than It 107cm/sec. In this study, the soil-bentonite mixture for the bottom liner system was evaluated in two point of views : changing characteristics of the hydraulic conductivity according to the different mixing ratio of soil-bentonite with the effect of bentonite swelling and the difference method (A & D type) of compaction on the hydraulic conductivity. As the results, maximum dry density (${\gamma}$$_{dmax}$) of SC group mixture was higher than of CL group mixture. However, the result of optimum moisture contents(OMC) of both groups were the contrary. In case of ${\gamma}$$_{dmax}$ by different compaction method, D type was higher than A. But the OMC were the contrary. The difference of ${\gamma}$$_{dmax}$ according to the Compaction energy, “SC” group mixture W3S higher than the “CL” group. In case of OMC of “CL” group was higher than “SC” group. The effecting of swelling was a little bit different on the two factors. According to the result of compaction test, the use of site soil only could not meet the criteria on hydraulic conductivity, but could find a solution for the mixing ratio of bentonite mixture were satisfied to the standard of barriation. The increased in bentonite mixing ratio and degree of swelling, the values of hydraulic conductivity were decreased. Especially the “CL” group with “D” type compaction measured the lowest value with the same conditions. Also, the bentonite mixing ratio has more influenced on the hydraulic conductivity compare with swelling effect. The “SC” group mixture with “A” typo compaction got a big difference from others. The evaluation of economic for the construction cost on the two cases, the lower bentonite mixing ratio of soil-bentonite mixed soil is more economically because of bentonite cost.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.40 no.4
• /
• pp.409-415
• /
• 2020

Low-flow mortar injection method grouting technology was selected and the traffic area was preserved as much as possible in order to secure safety for road traffic when the outflow and subsidence of landfill occurred due to ground-water, and etc. In particular, the current existing method was newly improved since there are risks of damage such as hydraulic fracturing at the lower part of the road, spilling of soil particles on steep slopes, and bumps on the road due to excessive injection pressure during construction. This study was carried out at the site of reinforcement work on the road as a maintenance work for the danger zone for collapse of the steep slope of the 00 hill, which was ordered from the 00 city 00 province. The improved low-flow mortar type grouting method adopted a new automated grouting management system and especially, it composites the method for grouting conditions decision by high-pressure pre-grouting test and injection technology by AGS-controlled and studied about grouting effect analysis by using new technology. By applying the improved low-flow mortar type grouting method, it was possible to lay the groundwork for road maintenance work such as the prevention of subsidence of old roads, uneven subsidence of buildings and civil engineering structures, and of soil leakage of ground-water spills. Furthermore, the possibility of application on future grouting work not only for just construction that prevents subsidence of old roads but also for various buildings and civil engineering structures such as railroads, subways, bridges, underground structures, and boulder stone and limestone areas was confirmed.

• Korean Journal of Plant Resources
• /
• v.23 no.2
• /
• pp.187-196
• /
• 2010

A total of 10 islands (Kumodo and Komundo in Yeosu City; Oinarodo in Goheung County; Chongsando, Soando, and Pogildo in Wando County; Chodo in Jindo County; Uido, Huksando, and Hongdo in Shinan County) were surveyed to confirm distribution of naturalized plants from June 2006 to December 2008. A total of 100 naturalized plants taxa from 25 families were recorded. The highest number of naturalized plant species (82 taxa) was recorded on Oinarodo, while the lowest number was recorded on Hongdo (42 taxa) and on Uido (34 taxa). A total of 26 naturalized species taxa (such as Dactylis glomerata, Lolium perenne, Bromus unioloides, Rumex obtusifolius, Chenopodium album, Phytolacca americana, Barbarea vulgaris, Lepidium apetalum, Robinia pseudo-acacia, Trifolium repens, Erigeron annuus, Erigeron canadensis, Senecio vulgaris, Xanthium strumarium) was recorded in all study areas. Distribution of naturalized plants were categorized into 7 habitat types based on ecological traits: afforested land, beach, port, and vacant land, road boundary, road cut and slope area, waste arable land, landfill area, and wetland. Systematic management is required to conserve unique landscape, species diversity, vegetation and ecosystem of Dadohae National Park. In order to manage the naturalized plants in Dadohae National Park, basic surveys are most needed to understand distribution and dispersal of naturalized plants communities based on ecological features of each habitat type.