• 한국환경과학회지
• /
• 제31권6호
• /
• pp.479-490
• /
• 2022

This study was to evaluate the utilization of terrestrial light detection and ranging for forest inventory in coniferous forests. Heights and diameter of the stand trees were measured manually using the traditional measurement method and the method using terrestrial LiDAR. The results of two methods were compared and analyzed to evaluate accuracy and feasibility. The terrestrial LiDAR used fixed and handy types to compare the accuracy between different operational methods. Comparative analyses used a paired t-test and Bland-Altman plot analysis. In the case of tree heights, the average of difference between the traditional method and terrestrial LiDAR for each plot was 0.81 m, -0.07 m, and 0.13 m for fixed type; 2.88 m, 1.19 m, and 0.93 m for the handy type. In the case of tree diameter at breast height, the average value of the difference between traditional methods and terrestrial LiDAR for each plot was 0.13 cm, -0.66 cm, and -0.03 cm for fixed type; 2.36 cm, 2.13 cm, and 1.92 cm for the handy type. The values from the method using the fixed type was highly consistent with that using the traditional measurement methods; the average difference was closer to zero. The crown density influences the precision of the height measurement using terrestrial LiDAR in coniferous forests. Therefore, future studies should focus on verifying the accuracy of terrestrial LiDAR in forests and on expanding the utilization of terrestrial LiDARs according to their operational methods.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1999년도 춘계학술대회 논문집
• /
• pp.17-20
• /
• 1999

The retention and fatigue properties of ferroelectric LiNbO$_3$ thin films were studied. Metal-ferroelectric-semiconductor(MFS) devices by using rapid thermal annealed LiNbO$_3$/Si structures were successfully fabricated and demonstrated nonvolatile memory operations of the MFS devices. The I$_{D}$-V$_{G}$ characteristics of MFSFET\`s showed a hysteresis loop due to the ferroelectric nature of the LiNbO$_3$ thin film. The ferroelectric capacitors showed practically no polarization degradation up to about 10$^{10}$ switching cycles when subjected to symmetric bipolar voltage pulse (peak-to-peak 6V, 50% duty cycle) in the 500kHz. The retention properties of the LiNbO$_3$ thin films were quite good up to about 10$^{3}$ s . s .

• 신재생에너지
• /
• 제20권3호
• /
• pp.20-27
• /
• 2024

A Li-rich cathode material, Li_1.167Mn_0.548Ni_0.18Co_0.105O₂, with a spherical shape and high crystallinity, is prepared using flame spray pyrolysis. The post-heat treatment condition influences the properties of the prepared material, such as its structure, morphology, and chemical composition, and optimum performance is achieved at 900℃. Various excess Li contents (0-12 wt.%) are introduced in the precursor solution to compensate for volatilized Li during synthesis, bringing it close to the target composition. Compensation for volatilized Li enhances the electrochemical performance, i.e., the Li-compensated sample shows a good discharge capacity of 247 mAh g^-1 at a current density of 20 mA g^-1 in a potential window of 4.6-2.5 V. In addition, the prepared Li-rich cathode material supplemented with 9 wt.% of the Li source shows increased discharge capacity of 175 and 148 mAh g^-1 at 200 and 400 mA g^-1, respectively, compared with those of a bare sample (164 and 127 mAh g^-1, respectively).

• 해양환경안전학회:학술대회논문집
• /
• 해양환경안전학회 2018년도 공동국제학술발표회
• /
• pp.6-6
• /
• 2018

• 한국전기화학회:학술대회논문집
• /
• 한국전기화학회 2004년도 춘계총회 및 학술발표회
• /
• pp.54-54
• /
• 2004

• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2003년도 춘계총회 및 연구발표회 초록집
• /
• pp.115.2-115
• /
• 2003

• 한국GIS학회:학술대회논문집
• /
• 한국GIS학회 2008년도 공동추계학술대회
• /
• pp.318-323
• /
• 2008

국부적이지만 수 mm단위까지 스캔이 가능한 지상LiDAR 장비를 이용하여 사면을 스캐닝한 후에 사면의 6개 지점에 대하여 강제로 변화를 준 후 다시 스캐닝하여 분석한 결과 0.008m의 평균편차를 나타내었다. 이것을 볼 때 미세변화 탐지를 위한 기법으로 지상 LiDAR자료의 적용이 유효할 것으로 판단된다.

• 한국세라믹학회지
• /
• 제21권3호
• /
• pp.271-277
• /
• 1984

To study interface between crystals grown and molten state in the crusible. Pulling and rotating rate of the shaft were varied in LiF crystal growth by Czochralski method. Lower speed of the pulling and rotating rate increased the degree of convexity in solid-liquid interface and higher speed of the pulling and rotating rate decreased it. Optimum condition of LiF crystal growth obtained as pulling rate was 6.5cm/h when it rotated as 46rpm.

• 한국결정성장학회지
• /
• 제9권6호
• /
• pp.601-605
• /
• 1999

$LiCoO_2$와 고용체 화합물인 $LiCo_{1-x}Ni_XO_2$을 고상반응법을 이용하여 제조하여 XRD, SEM, 입도분석, $^7$Li NMR을 통하여 그 구조적 cation mixing 현상을 조사하였다. 고상반응법으로 합성한 $LiCoO_2$와 $LiCo_{1-x}$$Ni_x$$O_2$의 미세결정상은 hexagonal layered structure를 보여주었고 전반적인 입도는 니켈의 함량에 따라 증가되었다. 고용체에 있어서 Ni의 함량 분율(x)이 x=0.3, 0.5, 0.7로 Ni의 양이 증가함에 따라 cation mixing 효과가 증가되었다. $^7$Li NMR의 peak frequency는 Ni의 함량이 증가함에 따라 high frequency로 shift되었고 line width는 Ni의 함량에 따라 넓어지는 양상을 보여주었다.

• 전기화학회지
• /
• 제18권3호
• /
• pp.102-106
• /
• 2015

The performance of Li-B alloy as anode for molten salt electrolysis was firstly investigated. The crystalline phase of the prepared Li-B alloy was identified as $Li_7B_6$. The potential profile of Li-B alloy anode was monitored during the electrodeposition of $Nd^{3+}$ onto an LCC (liquid cadmium cathode) in molten LiCl-KCl salt at $500^{\circ}C$. The potential of Li-B alloy was increased from -2.0 V to -1.4 V vs. Ag/AgCl by increasing the applied current from 10 to $50mA{\cdot}cm^{-2}$. It was found that not only the anodic dissolution of Li to $Li^+$ but also the dissolution of the atomic lithium ($Li^0$) into the LiCl-KCl eutectic salt was observed, following the concomitant reduction of $Nd^{3+}$ by the $Li^0$ in Li-B alloy. It was expected that the direct reduction could be restrained by maintaining the anode potential higher that the deposition potential of neodymium.