• Journal of the Optical Society of Korea
• /
• v.16 no.3
• /
• pp.203-209
• /
• 2012

Visible light communications (VLC) use modern solid-state light-emitting diodes (LEDs) to broadcast information. Emerging white-light LEDs allow the combination of lighting and optical wireless communication in one optical source. In this paper, a new LED lighting design using one-chip-type white LEDs is proposed for efficient illumination and optical wireless communications under the existence of several obstacles. Lighting and communication performance are analyzed to show the effectiveness of the proposed LED lighting. Specifically, the signal-to-noise ratio considering intersymbol interference and the bit-error rate of variable pulse position modulation (VPPM) with dimming control are considered.

• Journal of information and communication convergence engineering
• /
• v.19 no.4
• /
• pp.269-275
• /
• 2021

Light-emitting diodes (LEDs) are modulated using a square wave pulse sequence for flicker prevention and dimming control in visible light communication (VLC). In a VLC transmitter, the high and low bits of the non-return-to-zero (NRZ) data are converted to two square waves of different frequencies, which continue for a finite time defined by the fill ratio in an NRZ bit time. As the average optical power was kept constant and independent of data transmission, the LED was flicker-free. Dimming control is carried out by changing the fill ratio of the square wave in the NRZ bit time. In the experiments, the illumination of the LED light was controlled in the range of approximately 19.2% to 96.2% of the continuous square wave modulated LED light. In the VLC receiver, a high-pass filter combined with a latch circuit was used to recover the transmitted signal while preventing noise interference from adjacent lighting lamps.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2021.10a
• /
• pp.65-67
• /
• 2021

This thesis is to proposer a new algorithm for a position measurement system using a trilateration method through visible light communication(VLC), by light emitting diode(LED). The length from each LED to the sensor is derived, and location information is found using trilateration method based on the derived length. Unlike th existing positioning system using visible light communication, the proposed positioning system is simpler and more cost effective because it does not require communication between the transmitter and the receiver.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.6A
• /
• pp.587-591
• /
• 2011

In a visible light communication (VLC) system using LEDs, its nonlinearity degrades the performance. If it is compensated by using predistortion and LED's linear range is extended, then a large signal can be used as an LED input and the performance of VLC will be improved. In this paper, a predistortion curve is made by periodic measurement of LED nonlinearity, and the experimental results of predistorted OFDM is provided.

• Journal of Sensor Science and Technology
• /
• v.21 no.6
• /
• pp.429-433
• /
• 2012

In this paper, we reduced the optical noise interference in a visible light communication system using two color LEDs. In the transmitter, the original and the inverted signals of the transmitted data modulated a red LED and a blue LED, respectively. In the receiver, a differential detector which is composed of two photodetectors and an optical red filter detected the mixed signal radiated from the two LEDs. In an environment that the optical noise from a fluorescent lamp exists, the signal-to-noise ratio in this system was improved by about 20dB compared to that in the conventional system which uses a single LED and a single photodetector.

• Journal of Sensor Science and Technology
• /
• v.27 no.3
• /
• pp.143-149
• /
• 2018

In this paper, we introduce an edge-spike modulation method for visible light communication (VLC). This method is effective in preventing LED flicker and 120 Hz noise interference in base-band VLC. In the VLC transmitter, edge-spikes are generated by passing the digital data through a simple RC-high pass filter (HPF). The LED modulation of the edge-spikes does not change the average power of the LED light; thus it prevents LED flicker. In the VLC receiver, the 120 Hz noise from other lighting lamps is easily eliminated by RC-HPF, while the edge-spike signal is detected normally. In our experiment, the message of an air-quality sensor was successfully transmitted using edge-spike modulation. This structure is useful in constructing, e.g., wireless gas monitoring sensor systems to warn and prevent harmful gas leakage accidents in buildings using LED light.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.1
• /
• pp.63-67
• /
• 2015

White light-emitting diode (WLED) is growing interest in using both illumination and communications. This paper reports visible light communication (VLC) composed of a super bright white light-emitting diode, low cost commercial photo-diode and a Fresnel lens. LED driver is consisted of the power MOSFET and MOSFET driver that switches the LED on and off. The modulation bandwidth of the LED used was determined to be 8 MHz. However, it was possible to communicate up to 1 Mbps under illumination of 500 lx because of the weak signal power and a low spectral sensitivity of the SHF213 as a PIN photodiode. In order to enhance the system bandwidth, the LED light was focused on the PIN photodiode by use of the Fresnel lens. As a result of that, visible light link was operated up to modulation bandwidth of the LED. The signal to noise ratio can be improved by 40 dB using an optical concentration at the receiver.

• Journal of Navigation and Port Research
• /
• v.34 no.10
• /
• pp.763-768
• /
• 2010

Today the light of mankind since the dawn of mankind and that they were living "lives" on the huge influence across space is a dynamic energy. Because of this, when all human beings with the light and you can feel more comfortable with a stable mind to the beauty and the pursuit of happiness is to have instincts. In this paper, a fuzzy control system using a combination of external environmental factors, respectively, the conversion of quantitative uncertainty information into the LED lighting is designed to express algorithms, available in indoor circadian control circuit was designed and fabricated LED. Factor in the external environment temperature, humidity, and light intensity values to the controller through the sensor to accept these values and the optimal values for lighting the fuzzy control algorithm is converted into human emotion to feel comfortable to express through the dimming control LED lighting.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.2
• /
• pp.401-407
• /
• 2014

There are increasing interests in COB (Chip On Board) that densely arranged many LED chips on one board in order to solve the heat issue. There are many problems being on the rise: the lifespan decreases as the temperature of LED devices increases; Red Shift phenomenon, in which wave length of spectral line moves from original wave length to long wave length, occurs; and optical power decreases as $T_j$ increases. In order to resolve such problems, this study selected the optimum thickness and length of Fin, planned the second Heat sink that is optimum for COB LED with 15W, and analyzed thermal mode by Solid Works Flow Simulation through 15W COB packaging with the planned Heat sink. 15W COB down-light Heat sink that is produced based on this analysis was utilized to analyze thermal mode through contact thermometer and electrical properties through Kelthley 2430.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.6
• /
• pp.180-187
• /
• 2013

In this paper, we propose a LED communication based multi-hop audio data transmission network system. The main contribution and features of the proposed system are as follows. First, the contribution of this research is to develope the LED communication based multi-hop transmission network system which can transmit audio data signal with long distance via multi-hops. Second, the developed system has the following features: In transmitter, audio data is transmitted after encoding with S/PDIF format via a general LED. The relay receives digital audio signal by using photo diode and then transmits the signal to receiver after error checking and amplifying. The receiver receives the encoded audio data via photo diode and then converts to analog audio signal by using decoding and amplifying. The performance evaluation of the proposed system is conducted in the laboratory with fluorescent light source. The results of the performance evaluation confirm that the system can provide high quality audio transmission from transmiter to receiver via multi-hop relays in a long distance while we can see there are differences in the transmitted audio quality according to the used LED colors.