• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.6B
• /
• pp.1142-1148
• /
• 1999

In this paper, the characteristics of frequency dependent dispersion are analyzed for the phase shifters in Ku-band phased array antenna system using full-wave method, SDA(Spectral Domain Approach).The design technique of asymmetric coupled-line phase shifter with dielectric overlay is proposed. The compared results of phase responses are shown with conventional symmetric coupled-line Schiffman phase shifter. The experimental results verify the improvement of broadband characteristics by the increasing bandwidths and the decreasing phase deviations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.8
• /
• pp.937-942
• /
• 2007

A new, systematic, simplified design procedure for quasi-Yagi antennas is presented. The design is based on the simple impedance matching among antenna components: i.e., transition, feed, and antenna. This new antenna design is possible due to the newly developed ultra-wideband transition. As design examples, wideband quasi-Yagi antennas are successfully designed and implemented in Ku- and Ka-bands with frequency bandwidths of 53.2% and 29.1%, and antenna gains of $4{\sim}5 dBi$ and $ 5{\sim}5.6 dBi$, respectively. The design method can be applied to other balanced antennas and their arrays.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.941-944
• /
• 2015

In this paper study for VSAT(very small aperture terminal) LNB(low noise block). ship LNB was demanded high stability and low noise figure. We designed FEM(Front-End Module) that was operated multi-band. FEM designed was constructed in a multi-band low noise receiver amplifier, a frequency converter, IF amplifier, Voltage Control Oscillator signal generating circuit four circuit using. To convert the multi-band 2.05GHz band, it generates four local oscillator signals, the four(band1, band2, band3, band4) designed to output an IF signal developed conversion apparatus, the conversion gain 64dB, noise figure 1dB or less, output P1dB 15dBm or more, phase noise showed -73dBc@100Hz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.2
• /
• pp.206-211
• /
• 2004

A new techique is proposed for suppressing sidelobes due to the wave reflected from the waveguide end in the traveling-wave slot array. In this approach we use multiple sections of reduced-height waveguide with the final section terminated with a short circuit instead of the conventional matched load. To show the validity of the proposed method, a Ku-band slotted waveguide is fabricated and tested. Measurements confirm the excellent sidelobe suppressing capability of the proposed method.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.24 no.5
• /
• pp.519-526
• /
• 2021

In this paper, an array antenna for LOS datalink for mounting UAV(Unmanned Aerial Vehicle) of low-probability of intercept is presented. For low RCS, radome was designed by conformal form, and other components were inserted into the UAV. The antenna of the transmitter and receiver are each composed of 12×12 array antennas, and include a beam steering function by controlling the phase of the unit element for the Uni-directional pattern and the Bi-directional pattern. As a result of the measurement of the manufactured antenna, it was confirmed that all the required specifications were met, and the installing possibility of the UAV platform on low-probability of intercept in the future was confirmed.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.5
• /
• pp.325-335
• /
• 2018

We herein present a study on the active phased array antenna for receiving satellite broadcasting that can electrically align its polarization to that of target transmitters in its moving condition or in the Skew angle arrangement of the broadcasting satellite receiver. Hence, we have developed an active phased array structure composed of the self-developed Vivaldi antenna and multifunction core (MFC) chip, receiving RF front end module, and control units. In particular, the new Vivaldi antenna designed in the Ku-band of 10.7 - 14.5 GHz to receive one desired polarization mode such as the horizontal or vertical by means of an MFC chip and other control units that can control the amplitude and phase of each antenna element. The test results verified that cross-polarization property is 20 dB or higher and the primary beam can be scanned clearly at approximately ${\pm}60^{\circ}$.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.5
• /
• pp.748-754
• /
• 2000

A novel single feed wide band CP stacked microstrip antenna using crossed slots has been designed, fabricated and measured. For the single rediating element the designed 10dB return loss bandwidth is 34.5%99.45~13.54 GHz), 3dB axial ratio bandwidth is 18.7%(11.17~13.39GHz), and 6 dB gain bandwidth is 29%(10.21~13.64GHz). For the 2$\times$2 array designed using a sequential rotation method, the 10dB return loss bandwidth is 35.9%(9.69~13.94GHz), 3dB axial ratio bandwidth is 34.6GHz (9.93~14.03GHz), and 6dB gain bandwidth is 27.4%(10.35~13.6GHz). For the fabricated 8$\times$8 array antenna, the 10dB return loss bandwidth is 27.3%(10.17~13.41GHz), 3dB axial ratio bandwidth is 27.9GHz(10.1~13.4GHz), and the radiation pattern is good agreement with theory. This antenna can be used for broadband applications for communications or broadcasting in Ku band.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.8
• /
• pp.1110-1116
• /
• 2021

In this paper, we propose a conformal Ku-band data link antenna to ensure low RCS of stealth UAV. As a phased array antenna with electrical beam steering function, a transmitter and a receiver were designed and manufactured for FDD communication, respectively. Each antenna is designed as a 12*12 planar array antenna and has a function to form a uni-directional pattern and a bi-directional pattern through phase control of unit elements. The beam steering range is designed to be able to steer up to 60 degrees in theta direction and 360 degrees in the phi direction. As a result of manufacturing and measurement, the conformal type radome has low transmission loss and meets the required specifications including system performance. The feasibility of mounting the stealth UAV has been confirmed, and future research directions such as interworking of baseband devices and conversion to digital beam steering function are suggested.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.12
• /
• pp.85-91
• /
• 2004

The land mobile antenna for two-way communication using geostationary satellite consists of a transmitting and receiving systems. The transmitting system plays the role of sending the signal to the satellite while the receiving system does the role of receiving signal from the satellite and tacking the target satellite. Especially, the land mobile antenna for satellite communication must be met with the international regulation such as antenna pattern, transmitting power and tracking error to protect the damage of the neighbor satellites. On the other hand, this paper thoroughly examined a receiving system to satisfy a stable satellite tracking performance and antenna pattern specified by the international regulation for Ku-band geostationary satellite.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2014.10a
• /
• pp.159-160
• /
• 2014

In this paper, a design method for a broadband planar dipole antenna for the terrestrial digital television (DTV) reception is studied. The proposed antenna is an asymmetrical planar dipole consists of a rectangular patch with an embedded t-shaped slit, and the antenna shape is printed on a side of an FR4 substrate. The effects of geometrical parameters on the antenna performance are examined, and the parameters are adjusted to operate in the DTV frequency band of 470-806 MHz. The prototype antenna is fabricated on an FR4 substrate with a size of $260mm{\times}30mm$. The performance of the antenna is tested experimentally to verify the results of this study.