• Clean Technology
• /
• v.8 no.1
• /
• pp.1-9
• /
• 2002

Mild pyrolysis of four different coals (two bituminous coals and two Korean antracite) was investigated. Desulfurization characteristics, weight loss and variation of heating values were studied. As operating variables of experiment, pyrolysis temperature($350{\sim}550^{\circ}C$), pyrolysis time(5~20 min.) and particle size(0~3.55mm) were examined. The maximum sulfur removal rate of bituminous coal and anthracite were 38% and 28%, respectively. The optimum mild pyrolysis conditions were 10~15 min for pyrolysis time and $450{\sim}550^{\circ}C$ for pyrolysis temperature. The mild pyrolysis was effective to reduce organic sulfur content. Heating values of char per mass after pyrolysis increased about 5% compared to raw coal. The effect of coal particle size on the desulfurization was not observed.

• Fisheries and Aquatic Sciences
• /
• v.15 no.3
• /
• pp.241-250
• /
• 2012

Polycyclic aromatic hydrocarbons (PAHs), butyltins (BTs), nonylphenol (NP), and fecal sterols concentrations in sediments were investigated from Gunsan coast of Korea to evaluate organic pollution from anthropogenic activities. Sediment toxicity was also examined by bacterial bioluminescence toxicity test (Vibrio fischeri). The concentrations of 16 PAHs in sediments ranged from 67.9 to 425 ng/g dry wt; BTs ranged from 2.79 to 14.1 ng Sn/g dry wt; NP ranged from 20.7 to 2171 ng/g dry wt; and coprostanol, a fecal sterol, ranged from 7.60 to 245 ng/g dry wt. Effective concentration 50% ($EC_{50}$) of sediments ranged from 0.38 to 23.8 mg/mL. Most of the chemicals were present at levels lower than or comparable to the previously reported values from Korea. However, NP levels in the present study were in the high range of levels reported from the Korean coast, and 40% of the measured samples exceeded screening and ecotoxicological values of NP suggested by the Netherlands and Canada. This suggests that an ongoing source of NP is a serious concern in the Gunsan coast. High levels of contaminants were found in the proximity of potential sources, such as the outfall of a wastewater treatment plant for NP, an anthracite-fired power plant for PAHs, and ports for BTs, fecal sterols, and sediment toxicity. This indicates that Gunsan coast has various potential sources of marine sediment contaminants.

• Journal of the Korean Chemical Society
• /
• v.20 no.5
• /
• pp.431-437
• /
• 1976

On the condition of adequate air supply, complete removal of carbon monoxide,occurred above $650^{\circ}C$. Using catalysts, the oxidation of carbon monoxide occurred at lower temperatures; on both $MnO_2 \;and\;30%\;MnO_2-70%\;CuO\;at\;250{\circ}C,\;on\;CuO\;at\;450{\circ}C,\;on\;50%\;MnO_2-50%\;CuO\;at\;200{\circ}C,\;and\;on\;70%\;MnO_2-30%\;CuO\;at\;180{\circ}C$. Manganese dioxide (p-type) showed higher activity than cupric oxide (n-type) and a catalyst consisting of 60% $MnO_2-40%$ CuO had the highest activity of all the $MnO_2$-CuO mixture. Over the range of transitional temperature, carbon monoxide removal efficiency decreased linearly with increasing inlet carbon monoxide concentration while temperature was fixed. Residence time of gases in the catalytic reactor, in the range of 0.9 to 1.8 seconds, gave no effect on carbon monoxide conversion.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.2
• /
• pp.189-198
• /
• 2009

Tastes and odor in water caused by geosmin and 2-MIB are the major customer complaints for water utilities. Therefore, control of geosmin and 2-MIB is a worldwide concern. In this study, the effects of biofilter media type (three different activated carbons and anthracite), empty bed contact time (EBCT) and temperature on the removal of geosmin and 2-MIB in BAC filters were investigated. Experiments were conducted at three different water temperatures (5, 15 and $25^{\circ}C$) and four different EBCTs (5, 10, 15, and 20 min). The experimental results indicated that the coal based BAC retained more bacterial biomass on the surface of the activated carbon than the other BACs, and increasing EBCT or increasing water temperature also increased the geosmin and 2-MIB removal in BAC filters. To achieve above 50% of removal efficiency for geosmin and 2-MIB in a BAC filter, above 10 min EBCT at $5^{\circ}C$ and 5 min EBCT at above $15^{\circ}C$ were required. The kinetic analysis for the biodegradation of geosmin and 2-MIB indicated a first-order reaction rate at various water temperatures. Data obtained from the BAC filters at various temperatures were also used to evaluate pseudo first-order rate constants for geosmin and 2-MIB. The half-lives evaluated at 5, 15, and $25^{\circ}C$ for geosmin and 2-MIB ranged from 2.39 to 10.31 min and 3.35 to 13.97 min, respectively, which can be used to assist water utilities in designing and operating BAC system.

• Journal of the Korean Society for Heat Treatment
• /
• v.36 no.1
• /
• pp.22-32
• /
• 2023

In general, when scrap is dissolved in an electric arc furnace, the amount of electric furnace steel dust (EAFD) generated is about 1.5% of the scrap charge amount, and the electric furnace steel dust collected by the bag filter is charged into the Rotary Kiln or Rotary Hearth Furnace (RHF), and the zinc component is recovered as crude zinc oxide, at which time a clinker of Fe-Base is generated. In this research, first, for the efficient resource conversion of electric furnace steel dust, a reduction and roasting experiment was conducted and the reaction kinetics was examined. As a result of the experiment, it was observed that the reduction and roasting reaction was actively conducted in the range of 1100~1150℃, and melting occurred in the range of 1250℃. In the past, this clinker was widely used as a roadbed material for road construction and an Fe-Source for cement production, but in recent years, it has been mainly reclaimed due to strengthening environmental standards. However, landfill treatment is by no means a desirable treatment method due to environmental pollution caused by leachate, expensive landfill costs, and waste of Fe resources. Therefore, in order to more actively recycle the Fe component in the clinker, first of all the clinker was pulverized into an optimal particle size, and anthracite and binder (starch) were added to the magnetic material obtained by specific gravity and magnetic separation for briquet. As a experimental results, it was possible to efficiently separate clinker as Fe component and other slag component by specific gravity and magnetic force. As a results of loading and dissolving the manufactured briquet clinker in an electric arc furnace, it was observed that the unit of power and production yield were clearly improved and the carbon addition effect in molten metal was also somewhat.

• Economic and Environmental Geology
• /
• v.57 no.3
• /
• pp.281-292
• /
• 2024

North Korea relies heavily on coal as the primary energy source, playing an important role in all energy demand sectors except for the transportation sector. Approximately half of the total electricity is generated through coal-fired power plants, and coal is used to produce heat and power for all industrial facilities. Furthermore, coal has been a significant contributor to earning foreign currency through long-term exports to China. Nevertheless, since the 1980s, indiscriminate mining activities have led to rapid depletion of coal production in most coal mines. Aging mine facilities, lack of investment in new equipment, shortages of fuel and electricity, difficulties in material supply, and frequent damage from flooding have collectively contributed to a noticeable decline in coal production since the late 1980s. North Korea's coal deposits are distributed in various geological formations from the Proterozoic to the Cenozoic, but the most critical coal-bearing formations are Ripsok and Sadong formations distributed in the Pyeongnam Basin of the Late Paleozoic from Carboniferous to Permian, which are called as Pyeongnam North and South Coal Fields. Over 90% of North Korea's coal is produced in these coal fields. The classification of coal in North Korea differs from the international classification based on coalification (peat, lignite, sub-bituminous coal, bituminous coal, and anthracite). North Korean classification based on industrial aspect is classified into bituminous coal, anthracite, and low-grade coal (Chomuyeontan). Based on the energy factor, it is classified into high-calorie coal, medium calorie coal, and low-calorie coal. In North Korea, the term "Chomuyeontan" refers to a type of coal that is not classified globally and is unique to North Korea. It is a low-grade coal exclusively used in North Korea and is not found or used in any other country worldwide. This article compares North Korea's coal classification and the international coal classification of coal and provides insights into the geological characteristics, reserves, utilization, and research trends of North Korean coal resources. This study could serve as a guide for preparing scientific and industrial agendas related to coal collaboration between North Korea and South Korea.

• Journal of Soil and Groundwater Environment
• /
• v.18 no.7
• /
• pp.54-62
• /
• 2013

Fine suspended solids and soluble heavy metals generated from mine drainage could destroy environment as the aesthetic landscapes, and depreciate water quality. Therefore, this research is focused on process development applied the actual field for controlling fine suspended solids and heavy metals, and so that bench-scale tests were performed for field application based on advanced researches. The field of mine drainage in this research was in H mine located Taebaek-si, Gangwon-do. The inclination plates were mounted 2 kinds of arrangement (octagon and radial types) in circle type settling basin. The inclination plates could be helped to settle of suspended solids; decreased 34% of suspended solids and 50% of turbidity in effluent. Radial type of inclination plates showed the results that is more efficient to settle of suspended solids (average to 3.45 mg/L) compared to octagon type. In the experiments to decrease retention time of mine drainage in settling basin from 6 hrs to 1.5 hrs, suspended solid concentration was exceeded to 30 mg/L as the standard for suspended solid at 10 days after the operation under tha retention time of 3hrs and 1.5hrs. In the tests for filtration, granular activated carbons were indicated the better effective to filtering and absorption of fine suspended solid and soluble heavy metals than anthracite.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.12 no.1
• /
• pp.177-186
• /
• 1992

In this study, the proper mixing ratio of fly ash to bottom ash is evaluated and bearing capacity of this mixed ash is examined for use of highway embankment and subgrade materials in large quantities. Independently of the mixing ratio of fly ash to bottom ash or the method of compaction test, maximum dry density ${\gamma}_{dmax}$ and CBR value of anthracite mixed coal ash is greater than that of bituminous mixed coal ash. The mixed ashes to contain more fly ash than that of which the ratio of fly ash to bottom ash is 8 : 2, are slaked readily when the water contents of compaction are greater than optimum moisture content O.M.C. The proper mixing ratios of fly ash to bottom ash are about 5 : 5 to 6 : 4. Coal ashes mixed with these ratios exhibit proper physical and geotechnical properties for use of highway embankment and subgrade materials, and enable coal ashes to be used in large quantities.

• Economic and Environmental Geology
• /
• v.30 no.5
• /
• pp.443-450
• /
• 1997

The main purpose of this study is to investigate mineralogical and chemical changes during natural weathering, and assess the mobility of major and trace elements. Yongwol power plant utilize anthracite coal which is mainly composed of illite, kaolinite, pyrophyllite and quartz in mineralogy. Coal and coal-derived fly ash samples were sampled by the electrostatic precipitator in Yongwol coal-fired power plant in Korea. Short term weathered fly ash were also collected in ash disposal mound, and two profile soil samples were taken from an ash near the power plant. Amorphous materials are the main component of the fly ash, and mullite, quartz, magnetite and heamatite are present in all coal-derived fly ash. In chemistry, Si and Al are the most abundant elements of the total content. The ash samples were fractionated into upper $90{\mu}m$ and under $45{\mu}m$ size. Finer particles show higher concentrations in metal contents including Co, Cr, Cu, Ni, V, Zn and Pb. Concentration of Zn and Pb are nearly 4 times higher concentration in the finer particles. For the profile samples, the concentrations of $SiO_2$, $Na_2O$, MgO and $K_2O$ generally show increasing trends with depth, whereas those of $Fe_2O_3$ and $TiO_2$ appear to decrease with depth. Content of MnO does not show any specific depth trend. For the trace elements, Co, Cu, Ni and V show increasing concentrations with depth.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.8 no.2
• /
• pp.59-66
• /
• 1988

At the present time, annually about 2 million tons of coal ashes are generated from thermal power plants in Korea, however, they are dumped into ash ponds mixed with sea water very expensively. In this thesis, engineering characteristics of bituminous and anthracite ashes are studied to utilize them as construction materials. The coal ash is non-plactic material and its grain size falls in the range of silt, but it has better soil engineering characteristics than general soils of same grain size. For example, the permeability, shearing strength, CBR, and consolidation properties match to that of sandy soils, moreover, strengthening by hydration can be expected with the lapse of year because of CaO presence in the components. So, utilizing those coal ashes in a productive way as reclamation or banking materials is expected.