• Journal of the Korean Society of Combustion
• /
• v.9 no.3
• /
• pp.1-9
• /
• 2004

This study is aimed to characterize the combustion behavior of solid fuel in the various types of the combustors: stoker, rotary kiln and fluidized bed type combustors. Three different types of reduced-scale combustors are introduced, and temperatures and flue gas compositions are measured for various fuel sizes, water contents, initial temperature, and air flow rates. In case of the rotary kiln combustor, effects of rotating speed of the combustor are also investigated. Mean carbon conversion time (MCCT) and flame propagation rate (FPR) are used for the quantitative analysis. It is revealed that the reaction rates of the fuel are significantly influenced by the fuel characteristics, type of the combustors and air flow rate. Major design parameters for each type of the combustors are summarized through the reduced-scaled model analysis.

• Journal of the Korean Wood Science and Technology
• /
• v.25 no.4
• /
• pp.22-28
• /
• 1997

This research was carried out to obtain the fundamental data for the development of the technology and practical use of far-infrared radiation(IR) drying of quarter-sliced decorative veneers of walnut and red oak. The average drying rates of IR drying were about one and half to four times those of kiln drying and this tendency was prominent in thin veneer. The end wavinesses of the IR-dried veneers were smaller than those of kiln-dried veneers. These were largely recovered by the cold treatments after drying. The consumed electric power for IR drying was about one-fifth to two-fifthes compared to that for kiln drying.

• Korean Journal of Soil Science and Fertilizer
• /
• v.8 no.2
• /
• pp.89-96
• /
• 1975

The experiment was carried out to investigate the chemical properties of cement kiln dusts, abundantly produced from cement industry as a byproduct, and their effectiveness on rice yield. The field experiment was conducted on the acid paddy soil developed on basalt at Dongsong-Myon, Chulwon-Kun, Gangwon-Do. Two kinds of cement kiln dusts were used ; By Pass (BP) collected from the suspension preheater and Electric Precipitate (EP) from the cottrell electric precipitator. The levels of cement kiln dust applied were 100kg/10a, 200kg/10a and 300kg/10a, and the recommended variety "Nong Back" was adopted for this experiment. The results obtained are summarized as follows ; 1. The component of cement kiln dusts seems to be quite suitable for liming material. BP has 55% alkalinity, 41.7% of soluble calcium, 9.8% of soluble magnesium and 4.5% of water soluble silicate, while EP has 53.5% alkalinity, 41.7% soluble calcium, 8.3% soluble magnesium and 1% water soluble silicate. 2. The relative effectiveness of cement kiln dust in the soil will be superior due to very fine particle size. EP pass through completely 270 mesh screen, and 95% of BP pass through 150 mesh screen, 68% passing 270 mesh. 3. BP application at the rate of 100kg/10a increased 21% of rice yield as compared with control and EP 15%. It was observed that the affected yield components were increased panicle number per hill, grain number per panicle and 1,000 grains weight. 4. The application of optimum amount (100kg/10a) of cement kiln dusts accelerated the uptake of nutrients by rice plant and increased rice yield. However, the excess amounts (200kg/10a, 300kg/10a) of cement kiln dusts retarded the uptake of nutrients from soil.

• Korean Journal of Heritage: History & Science
• /
• v.47 no.3
• /
• pp.24-41
• /
• 2014

Since the celadons excavated from the Son-gok 2-ri 4th kiln site are located in the Beopcheon temple site and at close range, the similarity to the celadons excavated from the Beopcheon temple site is being raised. Thus, this study examined the correlation using a natural-scientific method. In this study, historical ceramic properties of total 19 celadons were examined and they were scientifically analyzed. First of all, according to the scientific analysis, chemical compositions of celadon clay showed a dispersed distribution at RO2 3.79-7.77mole and RO+R2O 0.33-0.49mole. When the microstructure was analyzed, most celadons excavated from the Beopcheon temple site, Wonju, which are estimated to be used in real life, had a favorable state, and some celadons from the Son-gok 2-ri 4th kiln site were found not to be glazed and sintered properly. When analyzing body crystalline phases of the celadons using the XRD method, quartz and mullite were extracted from all of the samples. And corundum was extracted from sg4 sample. Though firing temperature of each sample was different, they were mostly fired to temperatures between 1150 and $1200^{\circ}C$ and some of them experienced a low temperature of $1100^{\circ}C$ or a high temperature above $1200^{\circ}C$. Various chemical compositions and producing techniques were observed in the celadons from the Beopcheon temple site and Son-gok 2-ri 4th kiln site and it is hard to assure that the Son-gok 2-ri 4th kiln site was the production kiln site of the celadons used in the Beopcheon temple site. But according to the analysis of rare earth elements, some of the celadons from the Beopcheon temple site and Son-gok 2-ri 4th kiln site displayed a distribution pattern with certain regularity and this implies there is a possibility that the raw materials used in producing the ceramics might have come from the same origin. From the perspective of ceramic history, the celadons excavated from the Beopcheon temple site and Son-gok 2-ri 4th kiln site were produced using the same molding and sintering technique. Also, it is estimated that they were produced in the 12th or 13th century, judging from the overall shapes and patterns of the celadons.

• Cement
• /
• s.30
• /
• pp.74-79
• /
• 1969

• Cement
• /
• s.75
• /
• pp.29-44
• /
• 1979

• Cement Symposium
• /
• no.5
• /
• pp.37-49
• /
• 1977

• Cement
• /
• s.44
• /
• pp.27-38
• /
• 1971

• Cement
• /
• s.13
• /
• pp.48-60
• /
• 1965

• Cement
• /
• s.29
• /
• pp.45-52
• /
• 1969