• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.11
• /
• pp.45-52
• /
• 2005

In this paper, we propose the PLL system of the local oscillator system for the millimeter wave band's radio astronomy receiving system. The development of the proposed local oscillator system based on the YIG oscillator VCO with $26.5\~40GHz$ specification. This system consists of the oscillator part including the YIG VCO, the harmonic mixer, and the isolator, the RF processing part including the triplexer, limiter, and RF discrimination processor, and the PLL system including YIG modulator and controller. Based on this configuration, we verify the frequency and power stability of the developed local oscillator system according to some temperature variation. From this test results we confirm the stable output frequency and power characteristic peformance of the developed LO system at constant temperature.

• Journal of the Korean Solar Energy Society
• /
• v.34 no.5
• /
• pp.109-115
• /
• 2014

The supply rate of renewable energy has been increasing under the influence of an energy scarcity. Government has supported the use of renewable energy by government subsidies. The operation of renewable may not been operating appropriately, although increasing the use of renewable energy. We found out some problems of the operation of renewable energy and offered some improvements. This research proposes the efficient operation method for the solar thermal system, and proposed operation method was compared and evaluated with existing operation strategy after selecting one building installed solar thermal system. Recently, the interest to renewable energy has increased because of the environmental issues and energy crisis. However the utilization of the renewable energy system is low because of the use of renewable energy system and existing renewable energy system independently, although supply rate of renewable system is increasing. Especially, in the case of solar thermal system heating load is not responsible for the load of hot water supply in many cases. Therefore, suggesting efficient operation plans and evaluations of the energy consumption and efficiency of a solar thermal system is needed.

• Journal of the Korean Chemical Society
• /
• v.40 no.5
• /
• pp.379-383
• /
• 1996

• Textile Coloration and Finishing
• /
• v.26 no.3
• /
• pp.209-217
• /
• 2014

Detergency and soil redeposition of wool fabric in drycleaning solvents, i.e. petroleum solvent, perchloroethylene (PCE), decamethylcyclopentasiloxane($D_5$), with commercial detergents were studied. The detergency of wool soiled cloth in drycleaning solvents without detergents were the order of PCE > petroleum solvent > $D_5$. When commercial detergents were added to the system, the detergency were greatly improved. When 1.0% water was added to solvents/commercial detergents system, the detergency of petroleum solvent and PCE improved whereas that of $D_5$ decreased. The soil redeposition prevention effects of solvents were the same order of detergency, i.e. PCE > petroleum solvent > $D_5$. When commercial detergents were added to the system, the soil redeposition changed depending on solvents and detergents. The soil redeposition in $D_5$ became higher with a commercial detergent, therefore it is important to develop appropriate detergents for $D_5$. Three silicone surfactants were tested for detergency and soil redeposition in $D_5$ to find candidate surfactants for drycleaning detergent formulations. Silicone surfactant PEG/PPG-19/19 Dimethicone was found to be the best surfactant for $D_5$ drycleaning detergents.

• Nuclear Engineering and Technology
• /
• v.26 no.2
• /
• pp.225-236
• /
• 1994

The sudden discharge of the loop seal water, which is present upstream of the SEBIM POSRV, creates large momentum and inertia forces on the downstream of the discharge piping system. This study provides the procedures and results of analysis of the thermal-hydraulic transient in the SEBIM POSRV discharge piping during the valve opening. The analysis is peformed by RELAP5/MOD3. The appropriate modeling of the discharge piping system, SEBIM POSRV opening characteristics, and loop seal water discharge for the RELAP5/MOD3 analysis is suggested. Also performed is the sensitivity study for the selection of proper options for the junction and volume control. flags. The analysis results demonstrate the adequacy of the RELAP5/HOD3 for the thermal-hydraulic transient analysis of the loop seal water discharge of the SEBIM POSRV discharge piping system. From the sensitivity analysis results, it is shown that the smooth area change option with reasonable geometric pressure drop distribution, non-equilibrium option, and proper time step should be selected for loop seal water discharge analysis.

• Communications of the Korean Mathematical Society
• /
• v.11 no.2
• /
• pp.385-390
• /
• 1996

Let X be a smooth projective threefold whose anticanonical division $-K_X$ is ample, i.e., Fano threefold. In this paper, we studied the linear system $$\mid$-nK_X$\mid$$ for a positive integer n. In Theorem 4, we studied the cases that $\-nK_X$\mid$$ has no base-points and the cases that $$\mid$-nK_X$\mid$$ generate the birational map. In Proposition 5, we studied the possible exceptional cases given in Theorem 4. Some results in this paper are already known, but we have gave brief proofs for those results.

• Proceedings of the KIEE Conference
• /
• 1995.07c
• /
• pp.1365-1367
• /
• 1995

The PLS 2-GeV linac employs 11 units of high-power pulsed klystrons(80MW) as the main RF sources. The matching modulators of 200 MW(400kV, 500 A) can provide a flat-top pulse width of 4.4 ${\mu}s$ with a maximum pulse repetition rate of 120 Hz at the full power level. For a good stability of electron beams, the pulse-to-pulse flat-top voltage variation of a modulator requires less than 0.5%. In order to achieve this goal, we stabilized high voltage charging power supplies within 1% by a phase controlled SCR voltage regulator. In addition, we employed ac/dc feedback together with a resistive De-Q'ing system to achieve far less than 0.5% variation of the PFN charging voltage. This paper presents the main feature of the klystron-modulator system and the characteristics of the pulsed high-power RF system performance during the beam injection operation for the Pohang Light Source commissioning.

• Journal of Digital Convergence
• /
• v.11 no.5
• /
• pp.135-144
• /
• 2013

The purpose of this study is case analysis on adopting process of K-IFRS and financial effects of SBS Media Holdings Co., Ltd. Adoption process is divided into two stages, To analyze the effect due to changes in accounting standards and to run this, system change and build a range-determining step in the IT sector. Showed that had the most significant impact on the financial effects due to changes in the target's of consolidated F/S and inventories and intangible assets(broadcasting content assets).

• 한국지구물리탐사학회:학술대회논문집
• /
• 2003.11a
• /
• pp.352-361
• /
• 2003

We have evaluated the extent of saltwater intrusion from electrical resistivity distribution in a coastal aquifer system in the southeastern part of Busan, Korea. This aquifer system is divided into four layers according to the hydrogeologic characteristics and the horizontal extent of intruded saltwater is determined at each layer through the geostatistical interpretation of electrical resistivity data. In order to define the statistical structure of electrical resistivity data, variogram analysis is carried out to obtain best generalized covariance models. IRF-k (intrinsic random function of order k) kriging is performed with covariance models to produce the plane of spatial mean resistivities. The kriged estimates are evaluated by cross validation to show a good agreement with the true values and the statistics of cross validation represented low errors for the estimates. In the resistivity contour maps more than 5 m below the surface, we can see a dominant direction of saltwater intrusion beginning from the east side. The area of saltwater intrusion increases with depth. The northeast side has low resistivities less than 5 ohm-m due to the presence of saline water in the depth range of 20 m through 70 m. These results show that the application of geostatistical technique to electrical resistivity data is useful for assessing saltwater intrusion in a coastal aquifer system.

• Journal of Sensor Science and Technology
• /
• v.17 no.5
• /
• pp.338-345
• /
• 2008

Steel bearing balls are important component in machines having moving parts. In this paper we describe a vision-based automatic inspection system designed for sensing defects on the surface of steel bearing balls. The system has a camera looking down over a rail on which balls roll. Two mirrors are installed at both sides of the rail so that the side parts of a ball can be well inspected. The entire ball surface can be sufficiently seen by taking three images at $120^{\circ}$ rotation interval. Defects are detected by thresholding the difference image between an image captured and the reference image of a good ball.