• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.2
• /
• pp.239-247
• /
• 2018

Adaptive Beamforming (ABF) algorithm, which is a typical jammer suppression algorithm, guarantees the performance on the assumption that the jamming characteristics of the TDS (Training Data Sample) are stationary, which are obtained immediately before and after transmitting the pulse signal. Therefore, effective jammer suppression can not be expected when the jamming characteristics are non-stationary. In this paper, we propose a new jammer suppression algorithm, of which power spectrum fluctuates fast. In this case, we assume that the location of the jammer station is fixed during the processing time. By applying the MPM (Matrix Pencil Method) to the jamming signal in TDS, we can estimate jammer parameters such as power and incident angle, of which the power will vary fast in time or range bins after TDS. Though we assume that the jammer station is fixed, the estimated jammer's incident angle has an error due to the noise, which degrades the performance of the jammer suppression as the jammer power increases fast. Therefore, the jammer's incident angle should be re-estimated at each range bin after TDS. By using the re-estimated jammer's incident angle, we can construct new covariance matrix under the non-stationary jamming environment. Then, the optimum weight for the jammer suppression is obtained by inversing matrix estimation method based on the matrix projection with the estimated jammer parameters as variables. To verify the performance of the proposed algorithm, the SINR (signal-to-interference plus noise ratio) loss of the proposed algorithm is compared with that of the conventional ABF algorithm.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.6
• /
• pp.906-911
• /
• 2001

In this paper, LPI(low probability of intercept) and AJ(anti jamming) performance of the chirped BPSK system are analyzed. In the chirp method the cyclostationary of the signal is eliminated, since the instantaneous frequency is varied randomly within the whole spread bandwidth. Therefore, chirp method is considered for good LPI system against DAM(delay-and-multiplier) or SC (squaring circuit) interceptor which detects the chip rate or carrier frequency. Longer chirp duration makes the LPI performance better. From the simulation results, the chirp method has better AJ performance than DS(direct sequence) system in the PBNJ(partial band noise jammer) channel. At the same JSR(jammer to signal power ratio) level, chirped BPSK system has more robust AJ performance against MTJ(multi-tone jammer) than PBNJ.

• Journal of Positioning, Navigation, and Timing
• /
• v.3 no.2
• /
• pp.45-51
• /
• 2014

GNSS has the disadvantage of being vulnerable to jamming, and thus, the necessity of jamming countermeasure techniques has gradually increased. Jamming countermeasure techniques can be divided into an anti-jamming technique and a jammer localization technique. Depending on the type of a jammer, applicable techniques and performance vary significantly. Using an appropriate jamming countermeasure technique, the effect of jamming on a GNSS receiver can be attenuated, and prompt action is enabled when estimating the location of a jammer. However, if an inappropriate jamming countermeasure technique is used, a GNSS receiver may not operate in the worst case. Therefore, jammer identification is a technique that is essential for proper action. In this study, a technique that identifies a jammer based on template matching was proposed. For template matching, analysis of a received jamming signal is required; and the signal analysis was performed using a spectral correlation function. Based on a simulation, it was shown that the proposed identification of jamming signals was possible at various JNR.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.1
• /
• pp.69-73
• /
• 2011

In the defence wireless communications, conventional Anti-Jamming techniques(Frequency Hopping/Spread Spectrum or Direct Sequence/Spread Spectrum) are used to overcome a intentional interfering signals which are single/multitone or partial band jammer etc. DS/SS techniques is very strong on tone jamming signal but not to be on a partial band jammer. So FH/SS AJ performances are expected method of an substitution of DS/SS, however FH/SS could not have good performance on some BMTJ(Band Multi-tone Jammer). So this paper proposes FH-CSS (Frequency Hopped - Chirp Spread Spectrum) to get more robustness against jammers(BMTJ, PBNJ) and analyze the AJ performances.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.15 no.9
• /
• pp.3444-3457
• /
• 2021

In the field of anti-jamming based on dynamic spectrum, most methods try to improve the ability to avoid jamming and seldom consider whether the jammer would perceive the user's signal. Although these existing methods work in some anti-jamming scenarios, their long-term performance may be depressed when intelligent jammers can learn user's waveform or decision information from user's historical activities. Hence, we proposed a hidden anti-jamming method to address this problem by reducing the jammer's sense probability. In the proposed method, the action correlation between the user and the jammer is used to evaluate the hiding effect of the user's actions. And a deep reinforcement learning framework, including specific action correlation calculation and iteration learning algorithm, is designed to maximize the hiding and communication performance of the user synchronously. The simulation result shows that the algorithm proposed reduces the jammer's sense probability significantly and improves the user's anti-jamming performance slightly compared to the existing algorithms based on jamming avoidance.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.18 no.3
• /
• pp.71-75
• /
• 2018

In this paper, we study the secrecy outage probability when using jammer in a relay system based on decode-and-forward. The jammer may be selected among the relays not selected to increase the security capacity in the physical layer so as to generate intentional noise. Jammer noise can equally interfere with the receiver and eavesdropper but can enhance the physical layer security by selecting an optimal jammer that makes the channel quality between the sender-eavesdropper links worse than the channel of the sender-receiver link. In this paper, we compute the theoretical formula of the secrecy outage probability with and without jammers, and compare the theoretical value with the simulation value to prove that the equation is valid.

• Journal of Aerospace System Engineering
• /
• v.8 no.2
• /
• pp.40-48
• /
• 2014

In this paper, a prototype of GPS jammer localization system for precise landing is developed. The jammer localization system consists of the four jamming signal receivers for collecting RF signal, one central tracking station for estimating jammer position, and one monitoring station for displaying estimated position on the map. In order to estimate jammer location TDOA and AOA algorithm are introduced, and the function and design parameters of the developed prototype are proposed. CW, DSSS, Swept CW jamming signals were generated and used. From the results, it can be confirmed that developed system meets the performance goal.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.4
• /
• pp.88-94
• /
• 2007

This paper deals with the performance analysis of 3-dimensional array antenna by DOA estimation and beamforming in GPS receiver for performance improvement by interference elimination. The array antenna in GPS receiver can improve the system performance by estimating DOA of arriving signal direction, making the main beam for desired direction and elimate the jammer signal by nulling while keeping the GPS signal direction by spatial filtering. In this paper, we propose five types of 3-dimensional array antenna and analyze the estimation error via MUSIC algorithm which is used for the estimation of DOA of arrived signal and beamforming performance. In analyzing DOA performance, we measure DOA estimation error, while in analyzing beamformig performance, we measure BER. In beamforming performance analyzing, we use various jammer power and the existence of GPS signal and angle spread. By performing through the computer simulation, Curved (B) 7-element antenna in proposed 3-dimensional array antenna exhibits the superior performance in the DOA estimation, estimation error, BER characteristic and angle spread compared to the rest four array antenna types.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.7
• /
• pp.1707-1717
• /
• 1998

Polyphase filtering techniques is used to suppress the narrowband jammer signal such as USDC TDMA overlaying the band occupied by DS-CDMA system. In the proposed jammer suppression, the received signal is separated into 64 subchannels in two stages by polyphase filtering and the location of the narrowband jammer signal is determined by measuring each subchannel power and the contaminated subchannels are simply blocked. The $E_{b}/N_{0}$ 0/ improvement of the CDMA system from jammer suppession was outstanding. The $E_{b}/N_{0}$ degradation in comparison with a performance of no jammer is around 0.8dB in the worst case. The results are also compared with those of linear prediction jammer suppression. The implementation of the ployphase jammer suppression requires great amount of data processing and computation compared to linear predication filter. Thus it is more appropriate to implement with a ASIC rather than WITH several DSPs for user terminals of forward link.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.5
• /
• pp.424-433
• /
• 1991

In the noncoherent FH/FSK system presence of the multitione jamming and noise, in the case random and 송 structures jamming model, the performance analyzed that random and struetured jamming derived error proability. It is found that error probability and performance when error corecting code used Hamming. BCH, Convolutional code under the worst case partial band jamming interference.