• Journal of Conservation Science
• /
• v.36 no.6
• /
• pp.533-540
• /
• 2020

Mt. Neoseongsan (NSS) is the only natural Neorok source in Korea. The geological, historical, and cultural values of NSS were recognized in 2013, and NSS has since been designated and maintained as a natural monument (No. 547), which has restricted the research and utilization of NSS Neorok. The limited NSS Neorok supply has hindered the restoration research of traditional pigments. Recently, a large amount of Neorok has been mined from Mt. Gwangeongsan (GJS) and is expected to be the main supply source of Neorok for restoring traditional pigments. Therefore, this study analyzed the characteristics of NSS- and GJS-Neorok-based pigments to evaluate the feasibility of substituting GJS Neorok for NSS Neorok in pigments. The NSS Neorok was mostly comprised of celadonite, whereas the GJS Neorok included minerals containing glassy phases such as celadonite, cristobalite, tridymite, etc. Because both Neorok samples were vitrified under identical conditions, the GJS Neorok grains were larger than the NSS Neorok ones. The GJS Neorok pigment showed that the chromaticity, grain size, oil absorption, and stability varied depending on the mineral types and contents. In particular, GJS-2 and NSS Neorok showed similar mineral compositions, physical properties, and stabilities, suggesting that GJS-2 can be substituted for NSS Neorok, which has been difficult to source and utilize ever since NSS was designated as a natural monument.

• Journal of Conservation Science
• /
• v.36 no.6
• /
• pp.541-548
• /
• 2020

There is a growing demand for natural materials to replace adhesives based on volatile organic compounds (VOCs). However, the exclusion of VOCs from the manufacturing process leads to difficulties in manufacturing, and reduction in productivity and preservability. In this paper, we report the manufacture of natural bioadhesives using the carrageenan component of seaweed. λ-carrageenan, isolated from the extracted total carrageenan, was used to prepare a highly stable adhesive for paper. The resulting composition was 52.0 ± 1.0% λ-carrageenan, 30.5 ± 0.5% Polyvinylpyrrolidone, 1.0 ± 0.05% ethylhexylglycerin, 1.5 ± 0.05% glycerin, 13.5 ± 0.5% dextrine, and 0.6 ± 0.05% food-grade antifoam emulsion. The viscosity was found to be 1.13 ± 0.07 × 105 cP (25℃), UV degradation occurred at pH6.22, drying rate was 15min, △b^* was -10.79, and △E^* ab was 8.18. The bioadhesive showed an excellent adhesion strength of 44.63 kgf/cm². Thus this adhesive showed excellent fungal resistance and good adhesive persistence, without the presence of total volatile organic compounds (TVOC), formaldehyde (HCHO), and heavy metals.

• Journal of Conservation Science
• /
• v.37 no.2
• /
• pp.77-89
• /
• 2021

In this study, materials and color formation techniques were assessed for black potteries excavated from the Janghyeon-dong, Jungsan-dong and Gyodong-ri sites during the Proto-Three Kingdoms period in Ulsan, Korea. Although the black potteries were black superficially, the inner cores were either black or reddish yellow. Microscopy analysis identified that body clay was used for reddish iron oxide rich soils with quartz, alkali feldspar and mica, along with grains of myrmechite texture. Additionally, as marginal differences exist in the contents of SiO₂, Fe₂O₃ and CaO, the composition of the host rock and clay distributed around the sites was affected. Thus, we can deduce that pottery was made by soiling at a short distance. Raman spectroscopy results revealed that the black layer of the black pottery was used as amorphous combustion carbon. In addition, as a transparent layer of brown lacquer was observed on the substrate that was in contact with the surface layer, the black layer of the pottery induced black color development by a combination of combustion carbon and lacquer. Based on the mineral composition and microtexture of the body clay, the firing temperature of the potteries seemed to range from 750 to 850℃, whereas the lacquer layer was pyrolyzed at 468℃ by thermal analysis. Therefore, a combined layer of combustion carbon and lacquer, which formed the black color, was painted after the body clay was fired.

• Journal of Conservation Science
• /
• v.37 no.3
• /
• pp.270-281
• /
• 2021

The Yongjam of Oejae, Yi Dan-ha's wife, is an ornamental hairpin with a dragon-shaped engraving; designated as National Folklore Cultural Heritage No. 4. It is also a component of the ceremonial costume, and an artifact of great value as it clearly identifies the position of the wearer and the period of this artifact. The Yongjam has been well preserved in general; however, various pollutants and corrosive products have affected the engraved patterns, requiring conservation treatment. Furthermore, a non-destructive analysis was conducted to identify the components of the materials and the manufacturing techniques used in the ornament. The Yongjam is hollow inside to reduce its weight when placed in the hair and has a color contrast of gold, red, and black. The decorative part and the body were made separately. That is, the body was made from an alloy of copper, silver, and zinc, and its joint was elaborately connected without any overlaps. In the decorative part, different alloy ratios were identified in the dragon's face, beard, horn, body, and fin. Further, for the dragon's face with its delicate patterns, an alloy of silver and copper was used, likely to make the face appear as realistic as possible.

• Journal of Conservation Science
• /
• v.36 no.6
• /
• pp.505-510
• /
• 2020

In this study, the anti-stain effect of the Traditional Myoung-oil, which has been reproduced through traditional method, the Clean Myoung-oil, which was developed in an eco-friendly method through scientific analysis of Traditional Myoung-oil, and the perilla oil, which is the raw material of Myoung-oil and is currently used as a finishing agent when repairing wooden cultural properties was evaluated. As a result of the evaluation, perilla oil showed almost no anti-stain effect, whereas both types of Myoung-oil showed high anti-stain effect. However, it was confirmed that the anti-stain effect was significantly reduced after 4 weeks of exposure to the strain when Myoung-oil was diluted with terpene oil, a natural solvent. Thus, it was considered that the amount of treatment in the wood affected the anti-stain effect of Myoung-oil. In other words, in constructing wooden buildings, Myoung-o il is more suitable as a finishing agent to suppress mold growth than perilla oil. And, in order to increase the applicability of Myoung-oil, it is suggested that additional research on the optimal treatment amount and treatment method that can inhibit mold growth inhibition in outdoor environments is necessary.

• Journal of Conservation Science
• /
• v.37 no.3
• /
• pp.209-219
• /
• 2021

In this study, the wind environment in an urban area near Sungneymun gate was numerically investigated in the cases of inflow directions. The wind fields for the target area were simulated using Geographic Information System data and Computational Fluid Dynamics model. Results, including vector fields, three-dimensional wind velocity components, and wind speeds, were analyzed to examine flow characteristics. Wind direction variability affected by buildings was shown in the target area. The complex flows around Sungneymun did not depend on the inflow direction as a boundary condition. The wind speed around Sungneymun was generally 3 times stronger at 14 m above ground level (AGL) compared to the surface wind at 2 m AGL and relatively high in the case of easterly inflow. The effect of wind was also analyzed to be relatively significant at the southeast side of Sungneymun. Thus, it was suggested that the assessment of wind environment affected by high-rise and high-density buildings should be necessary for the architectural heritage in urban areas.

• Journal of Conservation Science
• /
• v.36 no.6
• /
• pp.456-474
• /
• 2020

This study investigated the initial behavior (flowability and setting properties) and shrinkage characteristics of lime mortar, based on the mixing ratio of hydrated lime (lump, powder) and commercial lime, which is primarily used for repairing and restoring cultural assets. The flowability showed that the optimum mixing water contents of the masonry lime mortar were 8-10% for the lump hydrated lime, 10-18% for the powdered hydrated lime, and 17-40% for the commercial hydrated lime. The results of the setting and shrinkage analysis showed that the average final setting time ratio compared to the standard of cultural asset repair was in the increasing order of commercial hydrated lime(0.4) < powder hydrated lime(5.6) < lump hydrated lime(5.7). Moreover, the average shrinkage ratio was ordered as lump hydrated lime(1.1) < powder hydrated lime(1.2) < commercial hydrated lime(3.0). The analysis of the physical and chemical characteristics of hydrated lime showed that the optimum mixing water content was reduced as the particle size of the lime increased, thus delaying the setting time and decreasing the length change rate (shrinkage). These results are expected to contribute to the prediction of the initial behavior and shrinkage characteristics of mortars using handmade and commercial lime during repair and restoration work on cultural, heritage buildings.

• Journal of Conservation Science
• /
• v.37 no.2
• /
• pp.144-153
• /
• 2021

Gwanghwadang-Wonsam was designated as National Folklore Cultural Heritage No. 52 in 1979, it is in good condition. However, a problem is the attached a phoenix insignia badge that did not exist when it was designated recently. As it became known as the only purple Wonsam artifact with "phoenix insignia", raising the need for its conservation. In this regard, scientific analysis was required to correct misinformation about designated cultural assets and restore the original designated state by analyzing the history of the Gwanghwadang-Wonsam, other relics of the phoenix insignia and its making design patterns. An X-ray fluorescence analysis was used to confirm that the Phoenix insignia's metal threads were titanium-plated silver. Phoenix insignia using titanium-plated gold thread was not identified in Gwanghwadang-Wonsam photographs in 1986, and the TiN-type membrane plating method was used in various industries in the 1990s, which can be estimated to be attached in the early and mid-1990s. Especially, the scientific analysis results from the X-ray fluorescence analysis in this study provide key evidence for conservation processing. This study demonstrates the importance of investigating relics and similar artifacts in the conservation process of inherited relics and as a precedent for restoration that corrects misinformation about designated cultural properties.

• Journal of Chest Surgery
• /
• v.55 no.1
• /
• pp.10-19
• /
• 2022

Background: According to the eighth TNM (tumor-node-metastasis) staging system, the presence of separate tumor nodules in the same lobe is designated as a T3 descriptor. However, it remains unclear whether adjuvant chemotherapy confers survival advantages in this setting. Methods: We retrospectively identified 142 pathologic T3N0M0 patients with additional pulmonary nodules in the same lobe from a single-institutional database from 2004 to 2019. The main outcomes were overall survival and recurrence-free survival. Multivariable Cox regression was used to identify the benefit of adjuvant chemotherapy while adjusting for other variables. Results: Sixty-one patients received adjuvant chemotherapy (adjuvant group) and 81 patients did not receive adjuvant therapy after surgery (surgery-only group). There were no demonstrable differences between the 2 groups regarding hospital mortality and postoperative complications, indicating that treatment selection had not significantly occurred. However, the use of adjuvant chemotherapy was associated with improved 5-year overall survival (70% vs. 59%, p=0.006) and disease-free survival (60% vs. 46%, p=0.040). A multivariable Cox model demonstrated that adjuvant chemotherapy was associated with a survival advantage (adjusted hazard ratio, 0.54; p<0.001). In exploratory analyses of subgroups, the effect of adjuvant chemotherapy seemed to be insufficient in those with small main tumors (<4 cm). Conclusion: Adjuvant chemotherapy was associated with better survival in T3 cancers with an additional tumor nodule in the same lobe. However, the role of adjuvant chemotherapy in patient subgroups with small tumors or those without risk factors should be determined via large studies.

• Journal of Chest Surgery
• /
• v.55 no.1
• /
• pp.49-54
• /
• 2022

Background: We compared the safety and effectiveness of robotic anatomical resection and video-assisted thoracoscopic surgery (VATS). Methods: A retrospective analysis was conducted of the records of 4,283 patients, in whom an attempt was made to perform minimally invasive anatomical resection for lung cancer at Seoul National University Hospital from January 2011 to July 2020. Of these patients, 138 underwent robotic surgery and 4,145 underwent VATS. Perioperative outcomes were compared after propensity score matching including age, sex, height, weight, pulmonary function, smoking status, performance status, comorbidities, type of resection, combined bronchoplasty/angioplasty, tumor size, clinical T/N category, histology, and neoadjuvant treatment. Results: In total, 137 well-balanced pairs were obtained. There were no cases of 30-day mortality in the entire cohort. Conversion to thoracotomy was required more frequently in the VATS group (VATS 6.6% vs. robotic 0.7%, p=0.008). The complete resection rate (VATS 97.8% vs. robotic 98.5%, p=1.000) and postoperative complication rate (VATS 17.5% vs. robotic 19.0%, p=0.874) were not significantly different between the 2 groups. The robotic group showed a slightly shorter hospital stay (VATS 5.8±3.9 days vs. robotic 5.0±3.6 days, p=0.052). N2 nodal upstaging (cN0/pN2) was more common in the robotic group than the VATS group, but without statistical significance (VATS 4% vs. robotic 12%, p=0.077). Conclusion: Robotic anatomical resection in lung cancer showed comparable early outcomes when compared to VATS. In particular, robotic resection presented a lower conversion-to-thoracotomy rate. Furthermore, a robotic approach might improve lymph node harvesting in the N2 station.