• Bulletin of the Korean Chemical Society
• /
• v.28 no.12
• /
• pp.2293-2298
• /
• 2007

In this study, a dithizone extraction technique involving purge & trap GC-MS was developed for the determination of methylmercury in biological samples, especially blood and fish. After alkaline digestion, methylmercury in biological samples was extracted into dithizone and back-extracted into aqueous sulfide solution. The extracted methylmercury was converted to the volatile ethyl derivative, purged and trapped onto a solid-phase collection medium, and then introduced into the GC-MS system. The determined MDLs of the established method were 0.9 ng·g?1 for biological samples and its accuracy and precision were found to be 93% and 3.8%, respectively. The method was validated by analysis of CRMs such as SRM 966, BCR 463 and IAEA 407 and all analytical results were within certified ranges with average RSDs of less than 6%. The analytical results of field-sampled fish also showed that the method can be successfully used as an alternative for commonly used distillation method followed by GC-CVAFS detection.

• Journal of environmental and Sanitary engineering
• /
• v.19 no.1
• /
• pp.8-16
• /
• 2004

Ground water samples were collected from residential, green" industrial, landfill and mining area and analyzed for 23 inorganics from March to October in 2002. The results are as follows; 1. The detection frequencies of inorganic materials such as As, Ba, B, Mo, Ca, Mg, Al, Cu, Fe, Mn, Zn, Na, K were 7.2∼77.1% which showed that these inorganics were detected in many ground waters. 2. The detection frequencies of 7 inorganics(Cd, Cr, Ph, Se, Sb, Be, Tl) were commonly low at ranging from 0.42 to 2.5%. These inorganics were contained in ground water partially. 3. Three inorganics such as Hg, Ni, Ag were not detected in any ground-water samples. 4. Compared to the other areas, ground water samples from landfill area contained greater concentration in many inorgainics and then showed higher levels in industral, residential, mining and green area in order. 5. Compared to noted concentrations of bottled water, inorganic minerals including Ca, Mg, Na, K related to taste were fluent in target samples. The results showed that the average concentrations of Mg, Na, K were 4.0 mg/l, 14.7 mg/l, 1.5 mg/l respectively. 6. The concentrations of inorganics such as Sb, Ba, Mo, Be, Tl, K in some ground water samples exceeded the water quality standards of WHO, the US and UK. Especially, Ba, Mo, K also showed relatively high detection frequencies so these inorganics need to be considered as analytes in Korea Drinking Water Regulation in further study.

• Journal of environmental and Sanitary engineering
• /
• v.20 no.1 s.55
• /
• pp.55-63
• /
• 2005

Ground water samples of 275 were collected from Gapyeong county which it contained six-eup and myeon and analyzed for 12 mineral inorganics extending from March to October in 2004. Among the inorganics, Calcium, Magnesium, Sodium, Potassium, Copper and Zinc had more than $70\%$ of detection frequencies, which coincided with essential inorganics required by the human body. The average values of inorganic contents by sampling sites were insignificant. Fluorine contents of 8 samples, $2.9\%$ of 275 samples, exceeded KDWR, and it was considered to be affected by a base rock being made up granite and gneiss because there were not polluting sources around. It is necessary to find out relation between geological characteristics and mineral inorganics in ground water through the further investigation. Compared to noted concentrations of bottled water, inorganic minerals including Calcium, magnesium, Sodium and Potassium related to taste were fluent double in target samples and those average concentrations were 14.80, 3.80, 7.60, and $2.31\cal{mg/L}$ respectively.

• Membrane Journal
• /
• v.25 no.5
• /
• pp.456-463
• /
• 2015

In this study, we synthesize novel silane based inorganics for preparation of the polymer electrolyte membrane with high proton conductivity under high temperature condition and developed membranes are characterized. SPAES, hydrocarbon based polymer are synthesized and used as main polymeric material. We used sol-gel method to prepare inorganic material with high performance using silica, phosphate and zirconium. Three types of inorganics were prepared by control of the mole ration of each component. As a result of EDX analysis, the inorganic materials are well dispersed in the polymer membrane. The water uptake of the composite membrane is increased by introduction of the hydrophilic inorganic material in the membrane. When the content of the zirconium in the membrane is increased, the proton conductivity of the composite membrane shows the higher value than pure SPAES membrane at the high temperature. And the silica based inorganics effect to increase the proton conductivity under low temperature condition.

• Journal of Digital Convergence
• /
• v.15 no.1
• /
• pp.509-517
• /
• 2017

As the effectiveness of ionic water that mainly used for the purpose of treatment has been widely known with the recent "well-being" trend, people's interest in it is also gradually increasing. Especially, the alkaline ionic water for drinking purpose could conveniently provide different types/amount of inorganics required for different dietary life depending on nature and race, could effectively provide alkaline inorganics that could be insufficient to modern Korean people, and also could provide alkaline inorganics that prevent/cure/relieve pregnant women's morning sickness. Applying the suggested performance/manufacturing method of alkaline ionic water through the performance assessment of alkaline electrolytic ionic water of the developed product, it would be necessary to have additional researches on the improvement of product or parallel development that could be applied to diverse areas.

• Proceedings of the Korean Nuclear Society Conference
• /
• 2001.05a
• /
• pp.470.2-470
• /
• 2001

• Analytical Science and Technology
• /
• v.32 no.6
• /
• pp.225-232
• /
• 2019

Traceability establishment in chemical measurements is a like a linkage established through an unbroken chain from the measured results to the international system (SI) of units. The primary process for traceability establishment is the purity assignment of a target material to be measured. In this study, we studied the purity assignment of 17α-hydroxyprogesterone (17-OHP). The presence of 17-OHP is indicative of congenital adrenal hyperplasia (CAH) and it builds up due to the deficiency of 21-hydroxylase and 11β-hydroxylase enzyme in the human blood. The purity assignment of 17-OHP was performed by the mass balance method, in which the impurities are categorized into four classes: total related structural impurities, water, residual organic solvents, and nonvolatiles/inorganics. The total related structural impurities were characterized by HPLC-UV; water content was determined by Karl-Fisher coulometer; and the total residual solvents and nonvolatiles/inorganics were determined by TGA. The purity of 17-OHP from a commercial manufacturer was calculated as 993.30 mg/g, and the expanded uncertainty was 0.58 mg/g. The proposed method was validated by uncertainty evaluation and comparing with the actual value of purity.

• Proceedings of the Korean Society of Agricultural Engineers Conference
• /
• 1998.10a
• /
• pp.490-499
• /
• 1998

This study was initiated to investigate the applicability of sludge from water or waste water treatment on the crop cultivation. Sludge is generated in the process of water and wastewater treatment process in large quantity. The sludge can cause many environmental problems. we have a many available treatment methods of sludge However, these methods still shortcomings and are not. The composition of typical municipal sludge contains organics and inorganics. The organics components are normally burnt in high temperature and mainly inorganics components are left after thermal treatment process. For the production of artificial media, chabazite was used as additive, and the mixed material was thermally treated in the firing kiln at 800~1,10$0^{\circ}C$ for about 10 minutes. The physical and chemical characteristics of artificial media were analyzed and it showed that the artificial media could be used as a media for plants and soil conditioner for farmland. The concentrations of the toxic heavy metals in the media were lower then those in the soil quality standard for farmland. This study illustrated that the artificial media production process, and introduced how to produce it's possible application as a media for Plant growth.

• Journal of Korean Society of Water and Wastewater
• /
• v.25 no.4
• /
• pp.479-488
• /
• 2011

Nanofiltration was performed with polyaluminium chloride solutions at different pH conditions to understand effects of inorganic compounds on aluminum hydrolysis products, i.e., three distinctive groups of aluminum species: polymeric Al at low pH; $Al(OH)_3$ at neutral pH; and ${Al(OH)_4}^-$ at high pH. The PACl solution was prepared to be approximately 4.0mM and adjusted to the designated pH. The influence of inorganic compounds on Al species fouling was investigated with 4.9mM $CaCl_2$ and 3.5mM $MgSO_4$ because $Ca^{2+}$, $Mg^{2+}$, $Cl^-$, ${SO_4}^{2-}$ are the most common inorganics in the drinking water. NF membrane fouling was measured by flux decline rate. The impact of $CaCl_2$ was not significant on the individual Al hydrolysis products fouling. However, the flux decline rate was drastically changed in the presence of $MgSO_4$. The concentration of particulate matters was considerably increased possibly due to interaction between Al species and ${SO_4}^{2-}$ where $MgSO_4$ was introduced. The particulates were accumulated on the membrane and enhanced the hydraulic resistance of the cake layer. In addition, conductivity removal of the membrane was decreased when Al-hydroxide was dominant due to reduction of membrane surface charge. The rejection of $Ca^{2+}$and $Mg^{2+}$ were considerably different, which implys that composition of inorganics paly a role on conductivity removal.

• Analytical Science and Technology
• /
• v.30 no.5
• /
• pp.226-233
• /
• 2017

In general, quantitative chemical analysis in various areas including food, the environment, in vitro diagnostics, etc., requires traceability in order to increase the reliability of the measurements. Measurement traceability is a property of an unbroken chain of comparisons relating an instrument's measurements to SI units. Purity analysis is the first process for establishing traceability to SI units in chemical measurements. The purpose of this study is to develop and validate a method of purity assignment for establishing the traceability of $17{\beta}$-estradiol measurements in an in vitro diagnostics field. The establishment of this method is very important as it can be applied to the development of CRM and to the analysis of the purity of other hormones. The method of assignment of the purity of $17{\beta}$-estradiol was developed using the mass balance method and was validated through participation in an International comparison. In the mass balance method, impurities are categorized into four classes as follows: total related structure impurities, water, residual organic solvents, and nonvolatiles/inorganics. In this study, total related structure impurities were characterized by a gas chromatography-flame ionization detector (GC-FID) and a high-performance liquid chromatography-ultraviolet (HPLC-UV) detector, water content was determined by a Karl-Fisher coulometer, and total residual solvents and nonvolatiles/inorganics were checked simultaneously by thermogravimetric analysis (TGA). The purity of the $17{\beta}$-estradiol was 985.6 mg/g and the expanded uncertainty was 2.1 mg/g at 95% confidence. The developed method can be applied to the development of certified reference materials, which play a critical role in traceability.