• Journal of Korean Society on Water Environment
• /
• v.18 no.3
• /
• pp.253-260
• /
• 2002

The purpose of this research was to describe the mechanisms and prevention of initial degradation in turbidity of the sand filter effluent. The method used was by adding a coagulant (PAC) to the sand filter after backwashing as a means of reducing turbidity. It was found that adding 80 mg/L of PAC solution to the sand filter was very effective in improving the initial effluent turbidity. A turbidity removal efficiency of 99 % was observed in the initial term period as compared to a 70% efficiency without PAC addition. The PAC solution added to the sand filter resulted in high aluminum concentration at the upper layer as compared with the bottom layer of the sand filter column. A change in the zeta potential to a strong positive-ions at upper layer was observed at this time but only a small change was obtained at the bottom. This result showed that the zeta potential of the sand was changed to positive with PAC coating. The effect of pH on zeta potential with PAC addition was also investigated. Zeta potential was greatly changed to positive-ion at pH 4~6. A series of experiments was then conducted in this study to optimize the pH of the PAC solution to be added to the sand filter after backwashing. The removal efficiency of turbidity was found to be highest at pH 5. This result suggested that hydrolyzed aluminium species attached to the surface of the sand enhanced the removal of turbidity of the effluent.

• Journal of the Mineralogical Society of Korea
• /
• v.9 no.2
• /
• pp.71-81
• /
• 1996

Dissolution experiments were conducted to understand chemical nature of weathering of anorthosite from the Hadong area. Anorthosite and plagioclase from it were reacted with HCl or KOH solutions under various conditions concerning such as grain size, initial pH of solutions, and shaking Average composition of plagioclase used in the experiment was Na0.32Ca0.71Al1.71Si2.28O8.Under acidic conditions, solution pH increases rapidly in the initial stage and then gradually to reach palteau. Shaking agitates the reaction rate in the initial stage but does not affect after the system reached steady state. Ca and si concentrations show rapid increase and then gradual increase. Al concentration increases rapidly in the early stage and then decreases. Later decrease was interpreted as the precipitation of an Al-bearing material. Different dissolution rates of different constituents of plagioclase together the with precipitation of al-bearing material might be responsible for the non-stoichiometric dissolution of plagioclase.X-ray diffraction analyses on anorthosite before and after dissolution experiment show dissolution rates differ with different lattice planes of plagioclase. It suggests the crystallographic control on dissolution reaction. X-ray photoelectron spectroscopic result shows that the average composition of plagioclase surface reacted with HCL of initial pH 1.97 for 2000 hours is Na0.20Ca0.26Al1.7Si2.3O8. It means that Na- and Ca-depleted H-feldspar is developed without Al-depleted layer on the surface of plagioclase by reaction with HCl and that dissolution reaction takes place sparsely on the surface of plagioclase. Al and Si are dissolved preferentially over Ca from anorthosite powder in KHO solution. Reaction of acid-reacted anorthosite with KOH solution shows the same Si dissolution behavior as in the fresh anorthosite. This indicates that the Al-depleted and Si-enriched layer does not build up on the acid-reacted surface.

• Journal of the Korean Chemical Society
• /
• v.48 no.6
• /
• pp.561-567
• /
• 2004

The influence of ultrasound frequency, dissolved gases, and initial concentration on the decomposition of sodium dodecylbenzene sulfonate(DBS) aqueous solution was investigated using ultrasound generator with 200 W ultrasound power. The decomposition rates at three frequencies(50, 200, and 600 kHz) examined under argon atmosphere were highest at 200 kHz. The highest observed decomposition rate at 200 kHz occurred in the presence of oxygen followed by air and argon, helium, and nitrogen. The effect of initial concentration of DBS on the ultrasonic decomposition was decreased with increasing initial concentration and would depend upon the formation of micelle in aqueous solution. It appears that the ultrasound frequency, dissolved gases, and initial concentration play an important role on the sonolysis of DBS. Sonolysis of DBS mainly take place at the interfacial region of cavitation bubbles by both OH radical attack and pyrolysis to alkyl chain, aromatic ring, and headgroup.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.5
• /
• pp.1333-1336
• /
• 2014

Expanded polytetrafluoroethylene (ePTFE) grafts have been used as vascular access for many patients suffering from end stage renal disease. However, the vascular graft can cause significant clinical problems such as stenosis or thrombosis. For this reason, many studies have been performed to make drug eluting graft, but initial burst is major problem in almost drug eluting systems. Therefore we used biodegradable polymer to reduce initial burst and make sustained drug delivery. The ePTFE grafts were dipped into a paclitaxel-dissolved solution and then PLGA-dissolved solution was passed through the lumen of ePTFE. We analyzed whether the dose of paclitaxel is enough and the loading amount of PLGA on ePTFE graft increases according to the coating solution's concentration. Scanning electron microscope (SEM) images of various concentration of PLGA showed that the porous surface of graft was more packed with PLGA by tetrahydrofuran solution dissolved PLGA. In addition, in vitro release profiles of Ptx-PLGA graft demonstrated that early burst was gradually decreased as increasing the concentration of PLGA. These results suggest that PLGA coating of Ptx loaded graft can retard drug release, it is useful tool to control drug release of medical devices.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.28 no.6
• /
• pp.688-696
• /
• 2004

Nonlinear dynamic behavior of diffusive-thermal instability in diluted CH$_4$/O$_2$ diffusion flames is numerically investigated by adopting detailed chemistry and transport. Counterflow diffusion flame is adopted as a model flamelet. Particular attention is focused on the pulsating-instability regime, which arises for Lewis numbers greater than unity, and the instability occurs at high strain rate near extinction condition in this flame configuration. Once a steady flame structure is obtained for a prescribed value of initial strain rate, transient solution of the flame is calculated after a finite amount of strain-rate perturbation is imposed on the steady flame. Transient evolution of the flame depends on the initial strain rate and the amount of perturbed strain rate. Basically, the dynamic behaviors can be classified into two types, namely non-oscillatory decaying solution and diverging solution leading to extinction. The peculiar oscillatory solution, which has been found in the previous study adopting one-step chemistry and constant Lewis numbers, is net observed in this study, which is attributed to both convective flow and preferential diffusion effects.

• 한국연소학회:학술대회논문집
• /
• 2004.06a
• /
• pp.95-101
• /
• 2004

Dynamic behavior of diffusive-thermal instability in diluted $CH_4/O_2$ diffusion flames is numerically investigated by adopting detailed chemistry and transport. Counterflow diffusion flame is adopted as a model flamelet. Particular attention is focused on the pulsating-instability regime, which arises for Lewis numbers greater than unity, and the instability occurs at high strain rate near extinction condition in this flame configuration. Once a steady flame structure is obtained for a prescribed value of initial strain rate. transient solution of the flame is calculated after a finite amount of strain-rate perturbation is imposed Oil the steady flame. Transient evolution of the flame depends on the initial strain rate and the amount of perturbed strain rate. Basically, the dynamic behaviors can be classified into two types, namely non-oscillatory decaying solution and diverging solution leading to extinction. The peculiar oscillatory solution. which has been found in the previous study adopting one-step chemistry and constant Lewis numbers, is not observed in this study, which is attributed to both convective flow and preferential diffusion effects.

• Journal of Korean Neurosurgical Society
• /
• v.37 no.4
• /
• pp.272-274
• /
• 2005

Objective: Surgical treatment of focal axillary hyperhidrosis is often unsatisfactory because of compensatory hyperhidrosis. The purpose of this study is to evalute the effect of decreased sweating production using 20% aluminum chloride on axillary hyperhidrosis. Methods: From February to December, 2002, 10 patients (mean age 25.2 male 2, female 8) with clinical diagnosis of axillary hyperhidrosis were treated by 20% aluminum chloride solution. Until the desired degree of symptom relief was obtained, they were educated to apply every day and thereafter, the agent would be applied as often as is necessary. We analyzed patient's satisfaction and application time at onset of desired dryness, application interval to maintain the relief of symptom and side effects. Results: Aluminum chloride solution was effective in treatment of axillary hyperhidrosis showing excellent result in 60% of patients and good in 40%. Application time at onset of desired dryness ranged from 1 to 6 days(mean 3 days). Application interval to maintain the relief of symptom ranged from 5 to 45 days(mean 12 days). There were no significant complications but just mild irritation and miliaria in seven patients. Conclusion: 20% aluminum chloride solution is the simple, safe and less expensive method for initial treatment for axillary hyperhidrosis not accompanying osmidrosis.

• Journal of Environmental Science International
• /
• v.26 no.5
• /
• pp.609-619
• /
• 2017

The removal characteristics of 2,4-dinitrophenol (2,4-DNP) from an aqueous solution by commercial Wood-based Activated Carbon (WAC) have been studied. The effects of various experimental parameters were investigated using a batch adsorption technique. The adsorption capacity of 2,4-DNP by WAC increased with a decrease in the dosage and particle size of WAC, temperature and the initial pH of the solution, and increased with an increase in the initial concentration of the solution. The adsorption equilibrium data were best described by the Redlich-Peterson isotherm model. The maximum adsorption capacities of 2,4-DNP by WAC were 573.07 mg/g at 293 K, 500.00 mg/g at 313 K, and 476.19 mg/g at 333 K, decreasing with increasing temperature. The kinetic data were well fitted to the pseudo-second-order model, and the results of the intra-particle diffusion model suggested that the adsorption process was mainly controlled by particle diffusion. The thermodynamic analysis indicated that the adsorption of 2,4-DNP by WAC was an endothermic and spontaneous process.

• Journal of Ginseng Research
• /
• v.5 no.2
• /
• pp.122-131
• /
• 1981

An aqueous extract s of fresh ginseng roots was heated at loot for 64 hrs. and the changes of color intensity, pH and the amount of free sugars and amino acids during the various intervals of the heating time were investigated. Color intensity and absorbance of the solution at 490nm were increased in proportion to the length of the heating time. Most of brown pigments produced during the treatment were water soluble, and pH 5.1 at initial stage of the solution, was slightly decreased at the final stages of the reaction. Sucrose, glucose and fructose were major free sugars in ginseng roots, and the amounts of sucrose was over 90 % of total free sugars. Sucrose. was largely decreased approximately 50%, by 64 hrs of the treatment, whereas sharp increase in the amount of glucose and fructose was observed during the reaction in the solution. The observed increase in reducing sugars, glucose and fructose was presumed due to hydrolysis of sucrose. Evidently, glucose and fructose were not important factor to control the browning reaction of the solution. Most of free amino acids and peptides except alanine and isoleucine especially arginine, serine and threonine, were sharply decreased up to 40 : 50% of the original concentration within 2 hrs. Accordingly, the content of free amino acids and peptides seems to be extremely important factor to control the browning reaction in ginseng. A free amino acid, presumed to be nor-leucine, was found in fresh ginseng root on the basis of re mention on liquid chromatography. Kinetic analysis of the browning reaction indicated a pseudo second order with respect to amino acid concentration at the initial stage.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.29 no.10 s.241
• /
• pp.1369-1376
• /
• 2005

In structural design, the design variables are frequently selected from certain discrete values. Various optimization algorithms have been developed fDr discrete design. It is well known that many function evaluations are needed in such optimization. Recently, sequential algorithm with orthogonal arrays (SOA), which is a search algorithm for a local minimum in a discrete space, has been developed. It considerably reduces the number of function evaluations. However, it only finds a local minimum and the final solution depends on the initial values of the design variables. A new algorithm is proposed to adopt a genetic algorithm (GA) in SOA. The GA can find a solution in a global sense. The solution from the GA is used as the initial design of SOA. A sequential usage of the GA and SOA is carried out in an iterative manner until the convergence criteria are satisfied. The performance of the algorithm is evaluated by various examples.